共查询到17条相似文献,搜索用时 125 毫秒
1.
近十几年来 ,结晶性间同立构 1 ,2 -聚丁二烯引起人们的广泛关注 ,但绝大多数研究工作集中在聚合物的制备、物理性质和应用方面[1~ 3] ,对于其结晶行为和晶体结构则未见报道 .原因是间同立构 1 ,2 -聚丁二烯分子侧链含有大量的双键 ,在较高温度下很容易交联 ,特别是高间规度的聚合物 ,由于其熔融温度高 (>2 0 0℃ )则更易产生交联 ,这给结晶行为和结构研究带来很大困难 .结晶性间同立构 1 ,2 -聚丁二烯的晶体结构为平面锯齿链正交堆砌 ,Pacm空间群[4 ] .我们曾报道了结晶性间同立构 1 ,2 -聚丁二烯的合成和溶液浇铸膜的板条状结构[5] ,本… 相似文献
2.
间同立构 1 ,2 -聚丁二烯自 1 95 5年问世以来 ,引起人们的广泛关注 ,但其形态结构方面的研究却很少报道 [1] .原因是间同立构 1 ,2 -聚丁二烯分子侧链含有大量双键 ,在较高温度下 ( >1 5 0℃ )很容易产生热交联 ,严重影响该聚合物的结晶行为 .我们曾报道了结晶性间同立构 1 ,2 -聚丁二烯的合成和溶液浇铸膜的板条状结构以及单晶结构 [2 ,3] .本文研究了间同立构 1 ,2 -聚丁二烯的自成核过程、结晶行为和形态结构 .自成核 ( Self- seeding nu-cleation)是指聚合物自身的微小晶粒作为晶核而诱导结晶生长的一种成核方式 ,它具有很高的成核效… 相似文献
3.
间同立构聚丙烯在聚乙烯(100)晶面上的附生行为研究 总被引:1,自引:1,他引:0
利用电子显微镜的欠焦成像和电子衍射技术对间同立构聚丙烯(sPP)在高密度聚乙烯(HDPE)的(100)晶面上的结晶行为进行了研究,明场结果表明,sPP能在HDPE的(100)晶面上附生生长,形成相互交叉的草席状片晶结构,电子衍射结果证明,附生生长的sPP与HDPE的接触面为(100)晶面,sPP与HDPE的分子链方向成固定的±37.交角,说明sPP在纤维取向的HDPE基质上附生结晶不仅仅是HDPE的(110)晶面对sPP有取向成核作用,(100)HDPE晶面也可作为sPP晶体的取向成核点. 相似文献
4.
拉伸和退火诱导间同立构聚丙烯的构象转变 总被引:2,自引:1,他引:2
90年代以来,随着锆和铪茂金属催化剂的出现,人们已能得到高立构度的sPP[1].由于sPP具有无毒,软硬适中,尤其是在高度结晶时仍具有很好的透明性等优点,越来越受到人们的广泛注意. 相似文献
5.
6.
7.
8.
9.
考察了不同磷化合物、催化剂组成、加料方式及反应温度对2-乙基己酸铁(Fe)-三异丁基铝(Al)催化剂上1,3-丁二烯(BD)聚合反应的影响,发现以三苯基磷酸酯(P)为配体的铁系催化剂在己烷中,n(Fe)∶n(P)∶n(Al)=1∶4∶25,加料方式为BD+Fe+P+Al和θ=50 ℃的条件下具有最高的催化活性,聚合产物的分子量分布指数为250,GPC淋出曲线呈单峰分布,表明该催化剂具有单一的活性中心. 经NMR,GPC,DSC和XRD测定,所得聚丁二烯具有较高的1,2-结构含量(95%),较高的间同立构规整度(95%),较高的结晶度(68%),较高的分子量(Mn=74×105)及较高的熔点(189 ℃). 反应条件对聚合产物的立构规整性无明显影响. 相似文献
10.
分子结构对1,2-聚丁二烯橡胶性能的影响 总被引:1,自引:0,他引:1
本文研究了分子链结构、分子量及其分布对钼催化聚合1,2-聚丁二烯(1,2-PB)的加工工艺性能及硫化胶性能的影响.实验发现,1,2-PB的加工工艺行为随分子量降低和分子量分布加宽而得以改善,其抗湿滑性能随分子链中1,2-结构含量增加而提高,而1,2-结构的空间规整性—间同含量的增加则导致1,2-PB应变诱导结晶、降低硫化胶的弹性和增加生热值。 相似文献
11.
ZHANG Cheng-wu HUANG Yu-dong WANG Sheng-chao ZHANG Chun-yu ZHANG Xue-quan 《高等学校化学研究》2008,24(5):640-643
Morphologies,crystallization behavior and mechanical properties of polypropylene(PP)/syndiotactic 1,2-polybutadiene(s-1,2 PB)blends were investigated.Morphology observation shows the well dispersed domains of s-1,2 PB in PP matrix with the rather small domain sizes from 0.1 to 0.5μm when the s-1,2 PB content increases from 5%to 20%(mass fraction)in the blends,and the phase structure tends to become co-continuous as s-1,2 PB content further increases.Crystallization temperature(Tc)of PP component in the blends is fluctuated with the variation of s-1,2 PB content in the blends.Compatibilization,to some extent,between the two components is inferred from the examination of both morphology and crystallization behavior.Improvement of impact strength of PP toughened by s-1,2 PB becomes significant only in the case of s-1,2 PB content above 20%(mass fraction). 相似文献
12.
间规1,2-聚丁二烯的非等温结晶动力学 总被引:7,自引:1,他引:7
结合Avrami和Ozawa方程,构筑了一个新的聚合物非等温结晶动力学方程.以铁催化体系间规1,2聚丁二烯(st- 1,2PB)为例,将新方法与其他常用的Jeziony和Ozawa方法的处理结果进行比较.发现由Jeziony方法分析得到的表观Avrami指数不能直接用于预测st -1,2PB的非等温结晶机理.由Ozawa方法分析实验数据,得到的线性关系很差,因此也很难得到可靠的动力学参数.而采用新方法可得到一系列线性关系较好的直线.根据新参数a与表观Avrami指数n和Ozawa指数m的关系,st -1,2PB的结晶机理可以预测且与等温方法获得的结果有可比性.这种新方法已应用于聚醚酮、聚酰胺、聚烯烃、烷基取代聚噻吩、聚(β-羟基丁酸酯)及其共混物等多种聚合物体系中. 相似文献
13.
Thermal stability, crystallization, structure and morphology of syndiotactic 1,2-polybutadiene/organoclay nanocomposite 总被引:1,自引:0,他引:1
Syndiotactic 1,2-polybutadiene/organoclay nanocomposites were prepared and characterized by thermogravimetry analysis (TGA), X-ray diffraction (XRD), polarized optical microscopy (POM), and differential scanning calorimetry (DSC), respectively. The XRD shows that exfoliated nanocomposites are formed dominantly at lower clay concentrations (less than 2%), at higher clay contents intercalated nanocomposites dominate. At the same time, the XRD indicates that the crystal structures of sPB formed in the sPB/organoclay nanocomposites do not vary, only the relative intensity of the peaks corresponding to (0 1 0) and (2 0 0)/(1 1 0) crystal planes, respectively, varies. The DSC and POM indicate that organoclay layers can improve cooling crystallization temperature, crystallization rate and reducing the spherulite sizes of sPB. TGA shows that under argon flow the nanocomposites exhibit slight decrease of thermal stability, while under oxygen flow the resistance of oxidation and thermal stability of sPB/organoclay nanocomposites were significantly improved relative to pristine sPB. The primary and secondary crystallization for pristine sPB and sPB/organoclay (2%) nanocomposites were analyzed and compared based on different approaches. The nanocomposites exhibit smaller Avrami exponent and larger crystallization rate constant, with respect to pristine sPB. Primary crystallization under isothermal conditions displays both athermal nucleation and three-dimensional spherulite growth and under nonisothermal processes the mechanism of primary crystallization becomes very complex. Secondary crystallization shows a lower-dimensional crystal growth geometry for both isothermal and nonisothermal conditions. The activation energy of crystallization of sPB and sPB/organoclay nanocomposites under isothermal and nonisothermal conditions were also calculated based on different approaches. 相似文献
14.
15.
氯甲酸乙酯和3,6-二苯基-1,2-二氢-1,2,4,5-四嗪反应生成的是标题化合物3,6-二苯基-1,2-二氢-1,2,4,5-四嗪-1,2-二甲酸乙酯,而不是预期的3,6-二苯基-1,4-二氢-1,2,4,5-四嗪-1,4-二甲酸乙酯,其结构通过X射线单晶结构分析得以证实.此晶体属三斜晶系,P-1空间群,晶胞参数分别为:a=0.8915(2)nm,b=1.0444(2)nm,c=1.1509(3)nm,α=103.268(3)°,β=102.844(3)°,y=100.765(3)°,Z=2,R1=0.0593和wR2=0.1691.结果表明该化合物中心六元环的2,3-二氮杂丁二烯基团不共平面,没有很好地共轭.且该化合物中心六元环呈扭式构象,N(1)和N(2)原子分别偏离环平面-0.03611(41)和0.02944(40)nm. 相似文献
16.
This work presents the synthesis of novel unsymmetrical bolaamphiphiles bearing a sugar residue and a cationic glycine betaine moiety connected to both ends of a C22 or C32 oligomethylene bridging chain possessing or not a diacetylenic unit. Preliminary transmission electron microscopy (TEM) studies revealed the polymorphism of these bola lipids with regard to their self-assembled morphologies in water depending on the presence or not of the diacetylenic functionality and on alkyl chain length. 相似文献
17.
间规聚苯乙烯具有复杂的同质多晶现象,有α,β,γ,δ四种晶型和两种介晶型。本文综述了间规聚苯乙烯的晶体结构、晶型转变以及其结晶和熔融行为等方面的研究进展。 相似文献