Time-resolved infrared diode laser spectroscopy of the ν1 (C-O stretch) band of the CoCO radical

Infrared spectrum of the cobalt carbonyl radical CoCO produced by the 193 nm excimer laser photolysis of cobalt tricarbonyl nitrosyl Co(CO)₃NO was observed by time-resolved diode laser spectroscopy. More than 600 lines were identified as belonging to the ν₁ (C-O stretch) fundamental band, consisting of the Ω=5/2 and 3/2 subbands, and the associated hot bands , , , and . The ²Δ_i electronic ground state of CoCO was experimentally confirmed. The ν₁ band origins are 1974.172582(93) cm⁻¹ and 1973.53178(14) cm⁻¹ for the Ω=5/2 and 3/2 subbands, respectively. The rotational constant in the ground state was determined as B₀=4427.146(50) MHz. The centrifugal distortion constant D₀=1.1243(68) kHz was obtained for the Ω=5/2 substate of the ground state. The equilibrium rotational constant B_e=4435.44(14) MHz was derived, together with the vibration-rotation interaction constants.     

Aromatic interactions in the close packing of phenyl-imides at Cu(1 1 0) surfaces

The oxidation of aniline at Cu(1 1 0) surfaces at 290 K has been studied by XPS and STM. A single chemisorbed product, assigned to a phenyl imide (C₆H₅N(a)), is formed together with water which desorbs. Reaction with preadsorbed oxygen results in a maximum surface concentration of phenyl imide of 2.8 × 10¹⁴ mol cm⁻² and a surface dominated by domains of three structures described by , and unit meshes. However, concentrations of phenyl imide of up to 3.3 × 10¹⁴ mol cm⁻² were obtained from the coadsorption of aniline and dioxygen (300:1 mixture) resulting in a highly ordered biphasic structure with and domains. Comparison of the STM and XPS data shows that only half the phenyl imides at the surface are imaged. Pi-stacking of the phenyl rings is proposed to account for this observation.     

Measurement of the 4d-photoionization cross section via two-photon and two-step excitation in sodium

We present a comparison of the photoionization cross sections of the 4d excited levels of sodium by using the two-step resonant laser excitation and by two-photon non-resonant excitation from the ground state. Dye lasers, pumped with a Nd: YAG laser, have been used in conjunction with a thermionic diode ion detector to measure cross sections and the atomic densities as a function of laser energy. By applying the saturation technique, the measured values of the cross sections and atomic densities for the 4d level by two-photon excitation are 12.2(2.4) Mb and , respectively. Where as in the case of two-step excitation, the cross section and number density for the 4d level via 3p level and for the 4d levels via 3p level are determined as 9.6(1.9) Mb, and 12.8(2.5) Mb, , respectively.     

Atomic structure of thin dysprosium-silicide layers on Si(1 1 1)

We report on scanning tunneling microscopy results of thin dysprosium-silicide layers formed on Si(1 1 1). In the submonolayer regime, both a and a 5 × 2 superstructure were found. Based on images taken at different tunneling conditions, a structure model could be developed for the superstructure. For one monolayer, a 1 × 1 superstructure based on hexagonal DySi₂ was observed, while several monolayers thick films are characterized by a superstructure from Dy₃Si₅.     

Coadsorption of CO and C6H6 on Co(0 0 0 1)

We have studied the influence of CO on the adsorption of benzene on the Co(0 0 0 1) surface using LEED, XPS, TDS and work function measurements. CO was found to reduce the benzene adsorption, but even at saturation CO exposure no complete blocking was observed. Thermal desorption of the coadsorbed layer featured CO and H₂ peaks indicating partial dehydrogenation of benzene and retaining of the CO bond. Ordered LEED structures were found with all coverages: Pre-adsorption of CO led to patterns already seen for pure carbon monoxide adsorption. Pre-adsorption of benzene showed the known structure of pure benzene also with small CO exposures, but higher CO exposures yielded a mixture of and patterns.     

Time-resolved spectroscopy of Al, Ti, and Mo X pinch radiation using an X-ray streak camera

Time-resolved spectroscopic measurements of the radiation emitted from Al, Ti, and Mo X pinches have been made with time resolution. The radiation is emitted from micropinch plasmas with sizes of order in times in the 10- range. Spectra implied that dense, plasmas were produced, such as a lifetime, 1.5- electron temperature and near solid-density Ti plasma. The experimental systems and analysis methods are described in detail, including line ratio calculations for μm-scale Ti and Al plasmas with ion densities of 10¹⁹-10²⁴ cm⁻³ and electron temperatures.     

STM study of l-serine adsorption on Cu(0 0 1)

The adsorption of l-serine on Cu(0 0 1) surface at 310 K was studied by scanning tunneling microscope (STM). l-serine molecules on the Cu(0 0 1) initially formed a domain of thick lines with a order structure along the direction on the terraces regardless of the coverage of serine. The thick lines were partly replaced by thin line along the direction, and completely disappeared in 2 h. It is considered that in these structures hydrogen bonds involved in hydroxymethyl group between adsorbates play some role in addition to intermolecular hydrogen bond between a hydrogen atom of amino group and an oxygen atom of carboxy group for alanine adsorption.     

Sapphire (0 0 0 1) surface modifications induced by long-pulse 1054 nm laser irradiation

We have investigated modifications of sapphire (0 0 0 1) surface with and without coating, induced by a single laser pulse with a 1054 nm wavelength, 2.2 s duration, 7.75 mm spot and energy of 20-110 J. A holographic optical element was used for smoothing the drive beam spatially, but it induced small hotspots which initiated damage on the uncoated and coated surfaces. The individual damage effects of hotspots became less pronounced at high fluences. Due to high temperature and elevated non-hydrostatic stresses upon laser irradiation, damage occurred as fracture, spallation, basal and rhombohedral twinning, melting, vitrification, the formation of nanocrystalline phases, and solid-solid phase transition. The extent of damage increased with laser fluences. The formation of regular linear patterns with three-fold symmetry ( directions) upon fracture was due to rhombohedral twinning. Nanocrystalline -Al₂O₃ formed possibly from vapor deposition on the coated surface and manifested linear, triangular and spiral growth patterns. Glass and minor amounts of -Al₂O₃ also formed from rapid quenching of the melt on this side. The - to -Al₂O₃ transition was observed on the uncoated surface in some partially spalled alumina, presumably caused by shearing. The nominal threshold for laser-induced damage is about 47 J cm⁻² for these laser pulses, and it is about 94 J cm⁻² at the hotspots.