Quantification of ultrasound-induced chain scission in PdII-phosphine coordination polymers

A kinetically inert, reversible coordination polymer (3) was obtained through complexation of dicyclohexylphosphine telechelic poly(tetrahydrofuran) with palladium(II) dichloride. This coordination polymer is unreactive towards palladium(II) dichloride bis(1-diphenylphosphino)dodecane (4), because ligand dissociation in the coordination polymer is slow. However, upon ultrasonication of solutions of 3 in toluene in the presence of 4, formation of palladium(II) heterocomplexes was observed with (31)P NMR spectroscopy. Heterocomplex formation, the consumption of 4, and changes in molecular weight were used to quantify the scission process. In the presence of 60 equivalents of the alkyldiphenylphosphine stopper complex, the reduction in molecular weight was strongly enhanced; over a period of eight hours the weight-averaged molecular weight was reduced from 1.1x10(5) to 2.3x10(4) g mol(-1) while 47 % of the palladium(II) complexes in the coordination polymer had been converted into heterocomplexes. These results show that the system of 3 in combination with scavenger 4 is a suitable system to study the efficiency of ultrasound-induced chain scission of coordination polymers.     

Direct determination of crosslinking and chain scission in polymers

A direct method has been developed for determining G(crosslinks) for irradiated polymers using the analytical ultracentrifuge. The sedimentation velocity technique is employed to follow changes in the molecular weight of a narrow distribution polystyrene sample irradiated in vacuum with ⁶⁰Co γ-rays. It is shown that G(crosslinks) can be determined at low doses before significant structural changes have occurred in the polymer. At about one-fifth of the gel dose G(crosslinks) was found to be 0.019 compared to a value of 0.040 obtained from gel-sol fraction measurements. It is concluded that G(crosslinks) may increase with dose due to processes such as the addition of radicals to double bonds formed during the irradiation.     

The role of chain scission in fracture of amorphous polymers

We have investigated the role of chain scission in glassy polymers by monitoring the molecular weight changes induced by microtoming thin slices of monodisperse polystyrenes. The changes in number-average molecular weight allow determination of N_f, the number of bond scissions per unit area. It is found that N_f is independent of initial molecular weight and has the value 6.50 × 10¹³ scissions/cm² at room temperature; N_f decreases with increasing temperature, suggesting that chain pullout increases with temperature. The work required to create unit surface area in polystyrene is several orders of magnitude greater than the energy required to break N_f bonds, indicating that plastic deformation plays a major role in deformation and fracture of glassy polymers.     

Study of dynamics of glucose-glucose oxidase-ferricyanide reaction

This work is focused on dynamics of the glucose-glucose oxidase-ferricyanide enzymatic reaction with or without sodium hydroxide in a continuous-flow stirred tank reactor (CSTR) and in a batch reactor. This reaction exhibits pH-variations having autocatalytic character and is reported to provide nonlinear dynamic behavior (bistability, excitability). The dynamical behavior of the reaction was examined within a wide range of inlet parameters. The main inlet parameters were the ratio of concentrations of sodium hydroxide and ferricyanide and the flow rate. In a batch reactor we observed an autocatalytic drop of pH from slightly basic to medium acidic values. In a CSTR our aim was to find bistability in the presence of sodium hydroxide. However, only a basic steady state was found. In order to reach an acidic steady state, we investigated the system in the absence of sodium hydroxide. Under these conditions the transition from the basic to the acidic steady state was observed when inlet glucose concentration was increased.     

Properties of fracture surfaces of glassy polymers: Chain scission versus chain pullout

Fresh fracture surfaces formed by tensile failure of craze in molded polystyrene (PS) bars have been compared with the molded surfaces of the same bars, using an atomic force microscope with a thermal probe and operated in local thermal analysis. The results indicate that molecular weight is much higher in the interior of the sample than at the surface. No evidence was found for degradation of the PS chains via chain scission during crazing. Alternative explanations for the low‐molecular weights at the molded surface are discussed. © 2010 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2010     

Gelation of spontaneously formed catanionic vesicles by water soluble polymers

The gelation of two spontaneously formed charged catanionic vesicles by four water soluble polymers was systematically studied by tube inversion method and rheology. Eight phase maps were successfully documented for the catanionic vesicle–polymer mixtures. The experimental results, as represented by the relaxation time and the storage modulus at 1 Hz, revealed that the catanionic vesicle–polymer interactions at play were of electrostatic and hydrophobic origin. Firstly, no association between charged catanionic vesicles and the polymer without charge/hydrophobic modification was observed due to lack of both electrostatic and hydrophobic effects. Secondly, hydrophobic interactions accounted for the association between the hydrophobically modified polymer without charge and charged catanionic vesicles with hydrophobic grafts of the polymer inserting in the catanionic vesicle bilayer. Thirdly, the positively charged polymer without hydrophobic modification could interact with negatively charged catanionic vesicles through electrostatic force on one hand but could not interact with positively charged catanionic vesicles on the other hand. Finally, the positively charged polymer with hydrophobic modification could interact both electrostatically and hydrophobically with negatively charged catanionic vesicles, resulting in the formation of strong gels. The hydrophobic interaction might even overcome the unfavorable electrostatic interaction between the positively charged vesicles and the polymer with positive charge/hydrophobic modification.     

Main chain scission reaction of poly(methyl methacrylate) caused by two-photon ionization of dopant

The main chain scission reaction of poly(methyl methacrylate) (PMMA) doped with N,N,N,′,N′-tetramethyl-p-phenylenediamine (TMPD) was examined by ESR spectroscopy and GPC measurement, and the scission mechanism was analyzed. The two-photon ionization of TMPD with excimer laser excitation at 77 K produced an ester radical anion of PMMA (PMMA·m?), which becomes the main chain tertiary radical ? CH₂? C˙(CH₃)? CH₂? after the detachment of the ester side group by annealing of the sample at room temperature. The main chain scission radical ˙C(CH₃)(COOCH₃)? (PMMA˙) which was produced by the β-scission from? CH₂? ˙C(CH₃)? CH₂? showed the 13-line ESR spectrum instead of the ordinary 9-line, due to the fast quenching of the sample to 77 K. The change of the molecular weight distribution was measured by GPC after several irradiation-and-annealing operations. The simulation of the GPC curve confirmed that the scission re-action occurs at random in the PMMA chain in the solid and the main chain scission yield from the ester radical anion, [PMMA˙]/[PMMA·m?], is 0.30. © 1995 John Wiley & Sons, Inc.     

Reaction of water soluble polymers with oxidising agents: reaction of dextran with tetravalent cerium

Dextran, an extracellular bacterial polysaccharide, was subjected to reaction with ceric ammonium nitrate in aqueous nitric acid at varying temperatures. The polymer has been found to be degraded due to the selective oxidative cleavage of vicinal glycol units present in the monosaccharide unit of each chain. The aldehyde groups produced upon cleavage at low temperature were found to undergo further oxidation to acids and formic acid with rise in temperature of the reaction. The course of the reaction has been followed by cerimetry and by spectrophotometrical measurements. The effect of the concentration of reacting components on the reaction has been studied and various kinetic aspects have been evaluated. Depending on the kinetic results, a plausible reaction mechanism for the oxidative degradation and the subsequent reactions have been suggested by the study of the changes of solution viscosity and initiation of graft copolymerization of vinyl monomers by Ce(IV)/dextran mixture. Various thermodynamic parameters have been evaluated.     

Photo-oxidation of polymers—Part V: A new chain scission mechanism in polyolefins

The photo-oxidation of an ethylene-propylene copolymer has been studied at 310 and 365 nm. The results indicate that the Norrish type II reaction occurs but that another chain scission mechanism is also operative. This involves the reaction of free radicals produced by the photo-decomposition of hydroperoxide groups with neighbouring ketones.     

Interaction between water soluble polymers and surfactants

Based on literature data and some own results a short review of regularities, driving forces and mechanisms of interaction for different classes of polymers and surfactants is given. The main investigation methods of polymer‐surfactant systems are described.     

Dimensions of branched polymers formed in simultaneous long‐chain branching and random scission

In free‐radical olefin polymerizations, the polymer‐transfer reactions could lead to chain scission as well as the formation of long‐chain branches. The Monte Carlo simulation for free‐radical polymerization that involves simultaneous long‐chain branching and random scission is used to investigate detailed branched structure. The relationship between the mean‐square radius of gyration 〈s²〉 and degree of polymerization P as well as that between the branching density and P is the same for both with and without random scission reactions—at least for smaller frequencies of scission reactions. The 〈s²〉 values were larger than those calculated from the Zimm–Stockmayer (Z‐S) equation in which random distribution of branch points is assumed, and therefore, the Z‐S equation may not be applied for low‐density polyethylenes. The elution curves of size exclusion chromatography were also simulated. The molecular weight distribution (MWD) calibrated relative to standard linear polymers is much narrower than the true MWD, and high molecular weight tails are clearly underestimated. A simplified method to estimate the true MWD from the calibrated MWD data is proposed. The MWD obtained with a light scattering photometer in which the absolute weight‐average molecular weight of polymers at each retention volume is determined directly is considered a reasonable estimate of the true MWD. © 2001 John Wiley & Sons, Inc. J Polym Sci Part B: Polym Phys 39: 2960–2968, 2001     

Synthesis of novel hydrophobically modified water soluble polymers by ring-opening metathesis polymerization

Ring-opening metathesis polymerization has been used to prepare a series of water soluble polymers based on the Diels-Alder adducts of furan and cyclopentadiene. Hydrophobically modified forms of these polymers were obtained either by copolymerization with 5-decylbicyclo[2.2.1]hept-2-ene, post-polymerization modification of the acid forms of the polymers with 1-decylamine or chain transfer to 1-hexadecene. Polymers were characterized by NMR specroscopy and viscometry.     

A general approach to determining the evolution of molecular weight distribution curves of linear polymers undergoing chain scission

A numerical method is developed to compute the development of molecular weight distribution (MWD) curves of linear polymers undergoing chain scission. The method can be applied to complex chain scission kinetics and for arbitrarily complex initial MWD curves. Our method is based on the method of lines (MoL). Different from the existing numerical scheme, we propose the use of logarithmically spaced points. This development ensures the accuracy of the computed MWD curves at low molecular weights, and it does not require a very fine discretization to produce an accurate result.     

Dextran oxidized by a malaprade reaction shows main chain scission through a maillard reaction triggered by schiff base formation between aldehydes and amines

Although periodate‐oxidized dextran is widely used in biomedical applications, the degradation mechanism of oxidized dextran has not yet been elucidated. Herein, we propose a novel main chain scission mechanism of oxidized dextran triggered by reaction with amine. NMR analysis revealed four hemiacetal substructures during oxidation by periodate. Kinetic analysis showed that the degradation time constant of the C3‐removed substructure and increasing time constant of the reducing end protons are consistent with the decrease in molecular weight determined by gel permeation chromatography. A methylene group is generated at the same time constant of degradation, indicating that oxidized dextran degradation proceeds via a Maillard reaction. Oxidized dextran does not degrade in saline solution without reactive amine species. Thus, we conclude that oxidized dextran is degraded in the main chain via Schiff base formation through a Maillard reaction, depending on the oxidation ratio and amino acid concentration. These findings help to elucidate the reaction mechanism of polysaccharide degradation and develop novel biodegradable polysaccharide materials for biomedical applications. © 2016 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2016 , 54, 2254–2260     

Photo-oxidation of polymers: Part IX—Additional comments about a new chain scission mechanism in polyolefins

The mechanism of production of carboxylic acids during the photo-oxidation of an ethylene-propylene copolymer is discussed. It involves the photolysis of a complex between neighbouring hydroperoxide and ketone groups.     

Highly efficient mechanochemical scission of silver-carbene coordination polymers

The ultrasound-induced scission of silver carbene coordination complexes with polytetrahydrofuran-functionalized N-heterocyclic carbene ligands is reported. In solution, scission is very efficient, with complete conversion within 10 min when the polymers have a molecular weight of 6.7 kDa. The mechanochemical origin of the scission is supported by the molecular weight dependence of the scission rate and by the low reactivity of the silver complex with low molecular weight ligands. The mechanochemical process at room temperature is much faster than thermal scission at 60 degreesC, which has a conversion of 30% in 18 h.     

Synthesis and characterization of soluble conjugated polymers having pyrene moiety in the main chain

Three new alternating conjugated polymers consisting of pyrene and 3‐dodecylthiophene ( PPyMT ), 4,4′‐didodecyl‐2,2′‐bithiophene ( PPyBT ), or 9,9‐didodecylfluorene ( PPyFlu ) moieties have been prepared using Suzuki coupling reaction or Sugimoto approaches. The polymers were readily soluble in common organic solvents and exhibited good thermal stability in nitrogen and air atmospheres. The structures and optical properties of the polymers were characterized by NMR, FTIR, XRD, UV–vis, and fluorescence spectroscopy. PPyMT and PPYBT showed blue‐light emission in solution, whereas PPyFlu performed blue‐light emitting in film state. The polymers exhibited an intermolecular aggregation and structural ordering due to pyrene–pyrene π–π stacking interaction. © 2010 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2010     

Statistical theories of main chain scission and crosslinking of polymers—application to the photolysis and radiolysis of polystyrene studied by gel permeation chromatography

The statistical theories of main chain scission and crosslinking resulting from either homogeneous or inhomogeneous energy dissipation in polymers are summarized. The molecular weight distributions of polystyrene samples subjected in vacuo to y-rays (homogeneous energy dissipation) or to U.V. irradiation (inhomogeneous energy dissipation) have been measured by GPC for various absorbed doses. The results are discussed according to these theories.