Sulfuration of Pt/Al2O3, Pt?Re/Al2O3 and Pt?Ir/Al2O3 catalysts

Three reforming catalysts Pt/Al₂O₃, Pt–Ir/Al₂O₃ and Pt–Re/Al₂O₃ have been sulfurated by H₂S and tested by their activities in benzene hydrogenation. By treatment at 500°C under hydrogen flow only a part of the initial activity of the non-sulfurated catalyst is retained. So only a part of the adsorbed sulfur is easily removed in these conditions. The remaining sulfur for each of the catalysts (Pt/Al₂O₃, Pt–Ir/Al₂O₃ and Pt–Re/Al₂O₃) gives the same atomic ratio of 0.5 sulfur atom per accessible metallic atom.

---

Pt/Al₂O₃, Pt–Ir/Al₂O₃ Pt–Pe/Al₂O₃ . 500°C H₂ . . ., . (Pt/Al₂O₃, Pt–Ir/Al₂O₃ Pt–Pe/Al₂O₃) 0,5.

     

Effect of Sn addition on the catalytic properties of the metallic phase in Pt?Sn/Al2O3 catalysts

Platinum-tin/alumina supported catalysts have been studied. The TPR results show an assisted reduction of tin by platinum. The effect of alloying in cyclohexane dehydrogenation, o-xylene hydrogenation and cyclopentane hydrogenolysis is discussed.

---

- , . . , - .

     

Effect of pretreatment conditions on the activity and selectivity of Pt/Al2O3 reforming catalysts

The optimal reduction conditions for Pt/Al₂O₃ vary depending on whether the catalyst is fresh or lined-out and chlorine is present or absent. Optimal pretreatment conditions proposed by previous workers for fresh catalysts therefore have no meaning for industrial reformers since reforming catalysts spend most of their life under line-out conditions. Results from this work lend support to the strong hydrogen chemisorption theory.

---

Pt/Al₂O₃ , , . , , , , .. . .

     

Sulfurization of Pt/Al2O3?Cl catalysts. IV. Adsorption sites of H2S on Al2O3, Al2O3?Cl and Pt/Al2O3?Cl

Chemisorption of H₂S on Al₂O₃, Al₂O₃–Cl and Pt/Al₂O₃–Cl has been studied by gravimetry and IR spectroscopy. The influence of the amount of Cl on the H₂S adsorption equilibrium value and the nature of the adsorption sites at low and high coverages are discussed.

---

H₂S Al₂O₃, Al₂O₃–Cl Pt/Al₂O₃–Cl . Cl H₂S, .

     

Coke deposits on Pt/Al2O3 catalysts of varying dispersities

Coke deposition during cyclopentane reaction was investigated on Pt/Al₂O₃ catalysts of varying dispersity. For all working pressures the higher the metallic accessibility, the higher the amount of coke deposited on the catalyst. Nevertheless, coke deposited on the less dispersed catalysts is more toxic for the metallic function. An increasing metal accessibility improves the graphitization of coke on the support and so, prevent the deactivation of the metal of a bifunctional catalyst.

---

Pt/Al₂O₃ . , , , . , , , . , .

     

Effect of pressure on the rate of n-heptane conversion on Pt/Al2O3 catalysts

The effect of pressure on the rates of product formation in n-heptane conversion on Pt/Al₂O₃ has been studied at 490 °C over the pressure range of 10–50 atm. It has been shown that the rate of isomerization is practically independent of pressure, and the dependence of the rates of dehydrocyclization and hydrocracking on pressure is described by simple kinetic equations. The reaction order of dehydrocyclization with respect to hydrogen tends to –2.0 at high pressures.

---

- 10–50 490°C. , , . –2,0.

     

Structure sensitivity and coke formation on Pt/Al2O3 catalysts

The initial rate of carbon formation during cyclopentane reaction has been studied on different Pt/Al₂O₃ catalysts of varying metal dispersity. It has been shown that coke deposition on the metal is a structure sensitive reaction which is preferably produced on large metallic particles. On the other hand, coke deposition on the whole catalyst is relevant to cyclopentadiene formation and is a structure insensitive reaction since the initial rate of coke deposition on the whole catalyst is proportional to the metallic surface area.

---

Pt/Al₂O₃ . , , . , , , .. .

     

Influence of the preparation method on the pore spectrum of Pt?Cr/Al2O3 and Pt?Sn/Al2O3 catalysts

It is shown that, in contrast to classical impregnation methods, in bimetallic catalyst production the texture of the carrier is stabilized by introducing the promoting ion on the surface of Pt/Al₂O₃ with vapors of CrO₂Cl₂ or SnCl₄. This is shown by a relatively slower decrease of the specific area and the volume of the pores upon calcination.

---

, Pt/Al₂O₃- CrO₂Cl₂ SnCl₄ . .

     

X-ray study of Re/Al2O3 and Re+Pt/Al2O3 catalysts using synchrotron radiation

Uning synchrotron radiation, L_III rhenium absorption spectra have been studied for Re/Al₂O₃ and Re+Pt/Al₂O₃ catalysts obtained by impregnation. For individual rhenium compounds a linear dependence between the shift of absorption edge and the state of rhenium oxidation has been found. The absorption spectra of reduced catalysts are significantly broadened as compared with those of individual compounds of the same valency. This points to the presence of rhenium compounds in different oxidation states.

---

L_III- , Re/Al₂O₃ Re+Pt/Al₂O₃, . . . .

     

Investigation of n-heptane conversion over Pt?Al2O3 catalysts under gradientless reforming conditions

The rates of the total and individual directions of n-heptane conversion in reforming over platinum-on-alumina catalysts were shown to be independent of dilution with hydrogen. They can be described by simple equations following from kinetic concepts in ideal adsorbed layers.

---

, - , .

     

Two-stage catalytic system of Sn/Al2O3 and Pt/Al2O3for NO reduction by propene in lean conditions

The Pt/Al₂O₃, Sn/Al₂O₃catalysts were prepared by the single sol-gel method. The two-stage Sn/Al₂O₃and Pt/Al₂O₃catalyst in series for NO reduction with propene were investigated. The coexistance of water vapor enhanced the activity at medium temperature of 300-400^oC, and the NO conversion was above 50% at 225 to 500^oC even in the presence of water vapor and SO₂. This revised version was published online in August 2006 with corrections to the Cover Date.     

Catalytic properties of metallic and electron-deficient platinum in reforming over Pt/Al2O3 catalysts

The activity of Pt/Al₂O₃ catalysts with various contents of metallic (Pt^o) and electron-deficient (Pt) platinum has been examined in dehydrocyclization of n-heptane and dehydrogenation of cyclohexane. In the former case it is proportional to the number of surface Pt atoms and in the latter case it is proportional to the BET surface of metallic platinum Pt^o.

---

(Pt^o) (Pt) - . , Pt, — Pt^o.

     

氧化铝载体硫酸化对锰铈催化剂SCR脱硝性能的影响

分别以硫酸改性前后的氧化铝为载体,采用浸渍法制备了锰铈催化剂,对其NH_3-SCR脱硝性能进行评价,并采用XRD、BET、NH_3-TPD、H_2-TPR以及FT-IR对催化剂进行了表征。结果表明,改性降低了金属的分散性和氧化性,增加了酸量,特别是B酸量;催化剂的最佳脱硝温度窗口向高温扩展,活性温度窗口范围变宽,并且,改性液浓度越大变化幅度越大。当反应温度在200-250℃时,未改性催化剂与采用0.2 mol/L硫酸改性的催化剂具有接近的催化活性,但改性后的催化剂具有更高的抗水抗硫活性,250℃时脱硝率可达70%。     

Modification effect of Cu upon Pt In Pt?Cu?Al2O3 catalysts

In Pt–Cu–Al₂O₃ catalysts Cu might display either Electronic Ligand Effect or Ensemble Effect, depending on the preparation method of catalysts. For catalysts with Pt added before Cu, the latter exhibits an Electronic Ligand Effect. However, for catalysts with Cu added before Pt or with co-added Pt and Cu, Cu mainly demonstrates an Ensemble Effect.

---

Pt–Cu/Al₂O₃ , . Pt Cu, , .

     

制备方法对Fe2O3/Al2O3-ZrO2在乙苯脱氢反应中催化性能的影响

为提高含铁催化剂的脱氢活性,采用浸渍法和一步沉淀法制备了Fe、Al和Zr含量相同的F4AZ10-imp和F4AZ10-pre催化剂,在550 ℃考察了其在乙苯CO₂氧化脱氢制苯乙烯反应过程中的催化性能,并结合XRD、N₂-吸附、NH₃-TPD、CO₂-TPD和H₂-TPR等表征手段对催化剂进行了分析。结果表明,与浸渍法相比,一步沉淀法制备的催化剂更有利于活性组分Fe₂O₃在催化剂表面的分散及反应物CO₂的转化。     

Thermal activation of Al2O3 supported MoO3 and WO3 metathesis catalysts

Alumina-supported MoO₃ and WO₃ catalysts were activated for the metathesis of propene by thermal treatment in Ar. Temperatures up to 1140 K are required for catalysts with low metal contents. These exhibit the highest specific activities though they are known to be highly resistant to reduction. It is proposed that the active sites are formed from Mo(VI) and W(VI) species under the conditions employed.

---

MoO₃ WO₃, Al₂O₃, . 1140 . , , . , , Mo W.

     

低温下Pt/Al_2O_3和Pd/Al_2O_3光辅助乙二醇水相重整制氢研究

采用浸渍还原法制备了氧化铝负载的Pt和Pd纳米颗粒催化剂,用于光辅助乙二醇水相重整制氢反应。结果表明,光照能够有效降低乙二醇水相重整制氢的活化能,Pt/Al_2O_3比Pd/Al_2O_3具有更高的H_2转换频率(TOF)和更低的CO选择性。采用XRD、TEM、UV-vis等技术对催化剂的结构和形貌进行了表征,原位漫反射红外光谱(DRIFTS)表明,光照能促进乙二醇分子O-H键的断裂。理论计算表明,Pt/Al_2O_3催化乙二醇重整制氢反应产物中较低的CO选择性主要归因于CO在Pt表面较小的反应能垒,能够较快与H_2O解离的O反应生成CO_2。     

Pt/Al2O3 and Pt/Ba?Al2O3 catalysts studied by temperature programmed desorption of oxygen: Evidence for a low temperature desorbing species

For fresh and aged Pt/Al₂O₃ catalysts, TPD of oxygen is fairly well related to the noble metal surface areas and to the catalytic activity in butane combustion, whereas for aged Pt/Ba−Al₂O₃ solids, the catalytic activity is still preserved despite a tremendous sintering of the metallic phase and seems to be connected to a surface barium superoxide.     

Studies on the active sites for dehydrocyclization reaction over Pt?Al2O3 catalysts

The work represents a search for direct evidence of the existence of low temperature and high temperature active sites over Pt–Al₂O₃ for dehydrocyclization reaction. It is suggested that the former consists of dispersed metallic Pt and the latter of super-dispersed metallic Pt or isolated atomic Pt and ionic Pt.

---

- - Pt/Al₂O₃ . , Pt, Pt, Pt.