Fluorescence measurements in a Low-pressure Kr/F2 medium

The time-resolved measurement of the sidelight fluorescence of KrF* formed by a short electron-beam pumping pulse (20 ns FWHM, 19 kA, 860 kV) was performed as a function of both the total pressure ranging from 100 Torr to 400 Torr and the partial F₂ concentration (0.1–1.0%). We have estimated the fluorescence yields (FY) for various laser-gas conditions experimentally and the results were compared with numerical predictions. This study indicates a superior amplification performance for a single ultrashort pulse in a low-pressure medium because of the higher FY for KrF*.     

Two-wavelength operation of a tunable KrF excimer laser — A promising technique for combustion diagnostics

A KrF excimer laser was operated on two independently tunable lines. This was achieved by a double-resonator configuration with two gratings. Tuning range and gain competition were investigated. The narrow line width (<1 cm^–1) and the independent tunability make this laser ideal for simultaneous spectroscopic detection of two species and temperature measurements in combustion processes.     

Kinetic study of a short-pulse electron-beam pumped Kr/F2 laser amplifier medium at very low pressure operation

A numerical investigation has been performed for very low pressure (200 Torr) buffer-free KrF laser-amplifier medium pumped by a short pulse (10 ns FWHM) electron beam with low excitation rate operation (200 kW/cm³). The small-signal-gain coefficient (g ₀) and absorption coefficient () have been estimated for this new operational mode. The formation and quenching processes are also discussed kinetically.     

Gas density measurement of pulsed gas jets using XeF four-photon fluorescence induced by a KrF laser

The gas densities of two pulsed gas jets were measured together with spatial and temporal distributions by the XeF fluorescence induced by a KrF laser. The B-X and C-A transitions of XeF showed a biquadratic dependence on laser intensity when SF₆ was used as the F donor instead of F₂, and quadratic and cubic dependences on gas density, respectively.     

80 A/cm2 electron beams from metal targets irradiated by KrCl and XeCl excimer lasers

Due to the growing demand for high-current and long-duration electron-beam devices, laser electron sources were investigated in our laboratory. Experiments on electron-beam generation and propagation from aluminium and copper targets illuminated by XeCl (308 nm) and KrCl (222 nm) excimer lasers, were carried out under plasma ignition due to laser irradiation. This plasma supplied a spontaneous accelerating electric field of about 370 kV/m without an external accelerating voltage. By applying the modified one-dimensional Poisson equation, we computed the expected current and we also estimated the plasma concentration during the accelerating process. At 40 kV of accelerating voltage, an output current pulse of about 80 A/cm² was detected from an Al target irradiated by the shorter wavelength laser.On leave from Institute of General Physics, Moscow, Russia     

Thomson-scattering diagnostics of Kr/Ne and Kr/He plasmas using a picosecond laser

Thomson scattering from plasmas in high-pressure discharges for rare-gas-halide excimer-laser pumping was observed using a frequency-doubled 300 ps Nd: YAG laser. A temporal resolution of 1 ns was realized for the Thomson-scattering measurement, and detailed temporal changes of the electron density and temperature were measured in Kr/Ne and Kr/He plasmas. Calculations using a computer simulation showed good agreement with the experimental results, implying that the plasma dynamics is properly treated in the simulation.     

Direct generation of sub-nanosecond pulses in a high-pressure miniature excimer laser

Direct generation of subnanosecond pulses in a 9.0 cm discharge-length high-pressure XeCl laser is reported. The shortest pulse obtained was 670 ps (FWHM) with an energy of 1.2 mJ corresponding to 1.8 MW peak power.     

Surface ablation by excimer laser irradiation of Ti and Ti6Al4V alloy

This paper presents the surface microstructure of Ti and Ti6Al4V alloy irradiated with a high output energy XeCl ( = 308 nm) excimer laser. The treatments are carried out on both materials at two beam fluences and the effects of single- and multiple-pulse irradiation are compared. The results of the scanning electron microscopy and of the X-ray diffraction techniques suggest the possible influence of both time-behaviour and energy fluence of the laser pulse on the relative weight of the ablation rate and of the reaction product deposition rate at the sample surface.     

Production of intensities of ∼ 1019 W/cm2 by a table-top KrF laser

We report on the generation of intensities of 10¹⁹ W/cm^–2 by focusing the output beam of a table-top hybrid dye-excimer laser system operating at 248 nm. The laser system uses a pulsed dye laser and a single, commercially available excimer gain module. Considerations and optical arrangements for the optimization of the phase-front and the beam homogeneity of ultraviolet excimer amplifiers are presented.Prof. F.P. Schäfer on the occasion of his 65th birthday.     

Single picosecond UV pulse generation by mode-locking of an excimer laser-pumped dye laser

A single picosecond ultraviolet pulse has been generated based on mode-locking of a dye laser pumped by a long pulse XeCl laser to serve as the input source for a high-power ps KrF laser system. A short-pulse uv dye laser (BBQ) pumped by an additional XeCl laser was used to selectively amplify a single pulse from a mode-locked pulse train with the pulse separation of 3.2 ns. The amplified single pulse was frequency-doubled to 248 nm with the pulse duration of 20 ps.     

Gain and saturation measurements in a discharge excited F2 laser using an oscillator amplifier configuration

The small-signal gain coefficient and the saturation intensity of a F₂ pulsed discharge molecular laser at 157 nm have been measured using two discharge devices in an oscillator-amplifier configuration. The small signal gain coefficient was measured to be 5.2±0.4% cm^–1 at 3 atm total pressure and 1.5 cm electrode spacing and 4.1±0.4% cm^–1 at 2 atm total pressure and 2 cm electrode spacing while the values of the saturation intensity were 5 MW/cm² and 4.6 MW/cm², respectively.     

Spectroscopic diagnostics of the onset of discharge instabilities in a XeCl phototriggered laser

Study of the output power of a XeCl phototriggered laser at high energy loading has shown a multipulse operating mode. Above a critical value giving the maximum output energy, an increase of the applied electric field induces a dramatic decrease of the power emitted in the later peaks as well as the onset of a strong increase of the densities of various excited states, while such an increase is not observed for ionic states. Continuous-Wave (cw) laser-absorption spectroscopy is proved a very sensitive diagnostic tool to study the dynamics of these processes.On leave from Centre Técnico Aerospacial, S.J. Campos, Sao Paulo, Brazil     

Experimental verification of a zero-dimensional model of the kinetics of XeCl* discharges by XeCl*(B)-, XeCl*(C)-, and Xe2Cl*-density measurements

Absolutely calibrated emission spectroscopy has been used to determine the particle number densities of XeCl^*(B), XeCl^*(C), and Xe₂Cl^* in a small scale Ne/Xe/HCl discharge with well-defined current and voltage pulses for a wide range of parameters. The measured particle number densities could be reproduced quite well by numerical model calculations using the rate-coefficient values of Quiñones et al. [1] for the quenching of XeCl^*(B,C) by Ne, Xe, and 2Xe, but 3.0 × 10^–31 cm⁶/s for the formation of Xe₂Cl^* by (Ne + Xe)-quenching. For the electron quenching, we recommend a rate coefficient value of 3.2 × 10^–8 cm³/s. From the equilibrium ratio of the particle number densities of XeCl^*(C) and XeCl^*(B), the energy separation between these states has been estimated to be 72 ± 33 cm^–1 with the B state placed above the C state.     

A study of the electron quenching of excimers in a KrF* laser excited by a coaxial electron beam

Measurements of the output energy, the optical pulse length and the build-up time of the laser pulse, obtained with a coaxially e-beam pumped KrF^* laser, were performed varying the total gas fill pressure, the F₂ content and the e-beam current from 1–5 bar, 0.1–0.8% and 13.3–26.6 kA, respectively. The maximum specific extraction energy amounts to 64 J/l. The large range of measurements, especially at low F₂ concentrations, reveals the necessity to extend the kinetics of the F₂ chain in the usual computer model. With the introduction of electron quenching of KrF^* and ArF^* by dissociative attachment the predictions are also for low F₂ concentration in agreement with experiments.     

Ablation of poly(methyl methacrylate) and poly(2-hydroxyethyl methacrylate) by 308, 222 and 193 nm excimer-laser radiation

Data on the ablation of Poly(Methyl MetAcylate) (PMMA) and Poly(2-Hydroxyethyl MetAcylate) (PHEMA) with 0%, 1% and 20% of Ethylene Glycol DiMethAcrylate (EGDMA) as crosslinking monomer by 193, 222 and 308 nm laser radiation are presented. Direct photoetching of PMMA at 308 nm is demonstrated for laser fluences ranging from 2 to 18 J/cm². The ablation rate of PHEMA is lower than the corresponding to PMMA and decreases when the amount of EGDMA increases. The determination of the absorbed energy density required to initiate significant ablation suggests that the photoetching mechanism is similar for all the polymers studied and is a function of the irradiation wavelength. The Beer-Lambert law, the Srinivasan, Smrtic and Babu (SSB) theory and the kinetic model of the moving interface are used to analyze the experimental results. It is shown that only the moving interface theory fits well the etch rate for all the selected polymers at the three radiation wavelengths.     

Kinetic studies of Ar2F* in fast transverse-discharge-excited He-Ar-F2 mixtures

Time-resolved and time-integrated spectra for various He-Ar-F₂ mixtures excited by a fast transverse discharge were recorded. The fluorescence of ArF^* and Ar₂F^* was investigated and the radiative lifetime and emission characteristics of Ar₂F^* were determined. A mechanism for the formation of Ar₂F^* is suggested.     

Parametric study of Xe2 * dimer in high-pressure electrical discharges

Optical and electrical properties of a high-pressure discharge of pure xenon and xenon-helium and xenon-neon mixtures are studied experimentally. Uniform discharge at total gas pressure as high as 10 atm is achieved in xenon-lean mixtures. Vacuum ultraviolet emissions due to the first and second continua of Xe₂ ^* are examined spectroscopically. The vibrational relaxation rate constant k_He of Xe₂ ^* by helium is determined to be of the order of 10^-11 cm³ s^-1 from spectroscopic data. Laser oscillation for the 172-nm band was attempted without success. Discharge instability at high gas pressures is considered to the cause of the unsuccessful laser experiments. Some issues related to discharge instability in a high-pressure rare-gas discharge are discussed. Received: 1 October 2001 / Revised version: 11 June 2002 / Published online: 25 October 2002 RID="*" ID="*"Corresponding author. Fax: +852-2603/5204, E-mail: dlo@phy.mhk.edu.hk     

Upconverted 5d-4f luminescence from Er and Nd ions doped into fluoride hosts excited by ArF and KrF excimer lasers

We report on observation of upconverted VUV luminescence due to 5d-4f radiative transitions in Er³⁺ and Nd³⁺ ions doped into some fluoride crystals, under excitation by ArF and KrF excimer lasers, respectively. Only spin-forbidden 5d-4f luminescence of Er³⁺ (at 165 nm) was detected from the LiYF₄:Er³⁺ crystal whereas both spin-forbidden (at 169 nm) and spin-allowed (at 160.5 nm) components are observed from the BaY₂F₈:Er³⁺ crystal, the latter being much weaker than in the case of one-photon excitation. Nd³⁺ 5d-4f luminescence at 180 and 173 nm has been detected from the LiYF₄:Nd³⁺ and LaF₃:Nd³⁺ crystals, respectively. The shift of short-wavelength edge of 5d-4f emission spectra towards longer wavelengths is observed under temperature increase from 15 to 293 K. The observed effects in the spectra of Er³⁺ and Nd³⁺ doped crystals were interpreted as a result of reabsorption of 5d-4f luminescence escaping from the bulk of the crystals.     

The production of excimer molecules and excited atoms in a positive corona discharge in He/Xe(Kr)/SF6/CCl4 mixtures

Electrical and optical characteristics of a positive corona discharge in He/Xe(Kr)/SF₆/CCl₄ mixtures, which are of interest for the use in multiwavelength excimer radiation sources, are studied in the needle-grid electrode configuration. The length of the discharge, which is usually used to pump repetitive high-pressure multiwavelength radiation sources, is equal to the length of the electrodes of an excimer laser or lamp pumped by a transverse electric discharge. The discharge current-voltage and frequency characteristics, panoramic emission spectra, and the dependences of the relative emission intensity from the halogenides and excited noble gas atoms on the corona discharge current are investigated. The main processes resulting in the production of halogenides, as well as xenon and krypton excited atoms, in the generation regions of a corona discharge are studied.     

Detailed vibrational population distributions in a CO2 laser discharge as measured with a tunable diode laser

A tunable diode laser (TDL) operating in the 2150–2350 cm^–1 wavenumber region is used to probe a conventional cw CO₂ laser discharge. Absorption lines in more than 25 different vibrational bands are observed, enabling us to determine absolute vibrational populations inall levels of concern to the dynamics of the 10 m CO₂ laser. Levels in thev ₃ mode of CO₂ as high as 00°9 are monitored, and it is found that anharmonic effects play a significant role in the populations of such levels. Thev ₁ andv ₂ mode populations are also investigated in detail, and it is found that these modes are strongly coupled and maintain a common vibrational temperature under all discharge conditions. The use of a TDL is shown to be a powerful technique for investigating the dynamics of infrared molecular lasers.This work was supported in part by the National Science and Engineering Research Council, Canada