Treatment of N‐aryl‐2‐(benzylthio)benzamides with phenyliodine(III) bis(trifluoroacetate) containing trifluoroacetic acid resulted in an interrupted Pummerer‐type reaction in ionic liquid 1‐n‐butyl‐3‐methylimidazolium hexafluorophosphate, [bmim][PF6] to give 2‐aryl‐1,2‐benzisothiazol‐3(2H)‐ones rather than the normal Pummerer‐type products. 相似文献
The room temperature ionic liquid, 1‐n‐butyl‐3‐methylimidazolium hexafluorophosphate [bmim][PF6] is used as a ‘green’ recyclable alternative to classical molecular solvents for the cyclocondensation of α‐tosyloxyketones with thiobenzamide to prepare 2‐phenylthiazoles in good yields. 相似文献
Summary: The controlled/living radical polymerizations of methyl acrylate in 50% v/v of an ionic liquid initiated by the alkoxyamine generated in situ from 4‐oxo‐2,2,6,6‐tetramethyl‐1‐piperidinyl‐N‐oxyl (4‐oxo‐TEMPO) and 2,2′‐azoisobutyronitrile (AIBN) at 140–155 °C are reported. The number‐average molecular weights increased linearly with conversion, and polydispersity indices are approximately 1.4 in the best case. The rates of polymerization were greater than in anisole, and similar to the rate of spontaneous polymerization in the ionic liquid.
(filled symbols) and (open symbols) vs. conversion for the MA polymerization in the presence of [4‐oxo‐TEMPO]/[AIBN] (2.8:1) in 50% v/v anisole with 0.03 M AIBN (squares) and 50% v/v [hmim][PF6] with 0.03 M AIBN (circles), and 0.06 M AIBN (triangles). 相似文献
The Baylis–Hillman reaction is accelerated in the presence of ionic liquids. Of various 1‐butyl‐3‐methylimidazolium (bmim)‐based ionic liquids tested, [bmim][PF6] has been found to result in the highest rate increase. In the company of Lewis acid and H‐bond‐donor additives, the reaction rates further improve, albeit only modestly. A preparatively useful Baylis–Hillman procedure prescribes the use of [bmim][PF6] with La(OTf)3 and 2,2′2″‐nitrilotris[ethanol], in which the net effect of the ionic liquid is to bring about a more than twofold rate increase over the otherwise same reaction in MeCN. 相似文献
The effect of addition of a room temperature ionic liquid, 1‐butyl‐3‐methyl imidazolium hexafluorophosphate [bmim][PF6], on the electrochemical behavior of different free‐base para‐substituted meso‐tetraphenylporphyrins in dichloromethane solution has been studied using cyclic voltammetric technique. It has been found that the ionic liquid has the ability to regenerate platinum electrode surface and improves the reversibility of electrode processes. This has been true for the case of all the porphyrins studied. 相似文献
The enzymatic synthesis of polyesters by ring-opening polymerization (ROP) and polycondensation in three ionic liquids, i.e., [bmim][Tf2N], [bmim][PF6] and [bmim][BF4] was investigated. For the enzymatic ROP of ε-caprolactone it was found that [bmim][PF6] and [bmim][BF4] result in an inhomogeneous reaction mixture upon polymerization, causing polymerization characteristics similar to bulk polymerization. In contrast, for [bmim][Tf2N] characteristics similar to toluene were observed. Molecular weights of 7000-9500 g/mol were obtained. In the polycondensation of dimethyl adipate and dimethyl sebacate, respectively, with 1,4-butanol the low volatility of ionic liquids was successfully utilized to perform the reactions in an open vessel at temperatures close to the boiling point of the condensation by-product. Molecular weights up to 5400 g/mol were obtained. This, in combination with the tunable solvent hydrophilicity of ionic liquids could offer an advantage in the polymerization of highly polar monomers with low solubility in organic solvents. 相似文献
Summary: Cationic ring‐opening polymerization of 3‐ethyl‐3‐hydroxymethyloxetane (EOX) in a neutral ionic liquid (1‐butyl‐3‐methylimidazolium tetrafluoroborate, [bmim][BF4]) leading to a multihydroxyl, branched polyether proceeds readily to nearly quantitative conversion. Because of the relatively high polarity of ionic liquids, intermolecular hydrogen bonding leading to the formation of aggregates is reduced considerably. On the other hand, intramolecular hydrogen bonding facilitating intramolecular chain transfer is not significantly affected and the molecular weights of polymers are in the same range as those obtained in bulk polymerization or polymerization in organic solvents.
The permeability of carbon dioxide (CO2) through imidazolium-based ionic liquid membranes was measured by a sweep gas method. Six species of ionic liquids were studied in this work as follows: [emim][BF4], [bmim][BF4], [bmim][PF6], [bmim][Tf2N], [bmim][OTf], and [bmim][dca]. The ionic liquids were supported with a polyvinylidene fluoride porous membrane. The measurements were performed at T = (303.15 to 343.15) K. The partial pressure difference between feed and permeate sides was 0.121 MPa. The permeability of the CO2 increases with temperature for the all ionic liquid species. Base on solution diffusion theory, it can be explained that the diffusion coefficient of CO2 in an ionic liquid affects the temperature dependence more strongly than the solubility coefficient. The greatest permeability was obtained with the [bmim][Tf2N] membrane. The membrane of [bmim][PF6] presents the lowest permeability.The separation coefficient between CO2 and N2 through the ionic liquid membranes was also investigated at the volume fraction of CO2 at feed side 0.10. The separation coefficient decreases with the increase of temperature for the all ionic liquid species. The membrane of [emim][BF4] and [bmim][BF4] gives the highest separation coefficient at constant temperature. The lowest separation coefficient was obtained from [bmim][Tf2N] membrane which presents the highest permeability of CO2. 相似文献
The behavior of an ionic liquid (IL) within aqueous micellar solutions is governed by its unique property to act as both an electrolyte and a cosolvent. The influence of the surfactant structure on the properties of aqueous micellar solutions of zwitterionic SB‐12, nonionic Brij‐35 and TX‐100, and anionic sodium dodecyl sulfate (SDS) in the presence of the “hydrophobic” IL 1‐butyl‐3‐methylimidazolium hexafluorophosphate ([bmim][PF6]) is assessed along with the possibility of forming oil‐in‐water microemulsions in which the IL acts as the “oil” phase. The solubility of [bmim][PF6] within aqueous micellar solutions increases with increasing surfactant concentration. In contrast to anionic SDS, the zwitterionic and nonionic surfactant solutions solubilize more [bmim][PF6] at higher concentrations and the average aggregate size remains almost unchanged. The formation of IL‐in‐water microemulsions when the concentration of [bmim][PF6] is above its aqueous solubility is suggested for nonionic Brij‐35 and TX‐100 aqueous surfactant solutions.相似文献
Room temperature ionic liquid (bmim)PF6 was evaluated for recycling an organocatalyst (4S)-phenoxy-(S)-proline for direct asymmetric aldol reactions. The desired aldol products were obtained with good yields up to 93.2% and enantioselectivities up to 88.5%, and isolation of the products by simple extraction allowed recycling the ionic liquid containing the immobilized catalyst in subsequent reactions without significant decrease of yields and enantioselectivities. 相似文献