A facile approach to polymer nanocomposites with single‐wall carbon nanotubes and cationic polymers is reported. The composite material was synthesized by producing carboxylic acid groups at the nanotube termini followed by a reaction with poly(allylamine) in water. Fourier transform infrared spectral and thermogravimetric analyses corroborate that the poly(allylamine) chains were wrapped on the surface of the carbon nanotubes. The scanning electron microscopic (SEM) image shows that the nanotubes were dispersed with little aggregation, thus, strongly suggesting that the poly(allylamine) chains have covered the single‐wall carbon nanotubes, which was further evidenced by transmission electron microscopy. The composites are soluble in water, and this solubilization process opens up new opportunities in the solution chemistry on pristine nanotubes.
One‐dimensional methyl orange fibrils can be easily prepared. They are stable in acidic aqueous solutions and soluble in neutral water. When used to synthesize conducting polymer microtubules, the fibrils act as “hard templates” formally but as “soft templates” effectively. Microtubular structures of polypyrrole, polyaniline, and poly(3,4‐ethylenedioxythiophene) have been achieved successfully via such water‐soluble versatile templates.
A PDA based sensor, derived from a di‐(2‐picolyl) amine (DPA) substituted diacetylene monomer, displayed a selective colorimetric change and a large fluorescence enhancement in the presence of lead ions. The lead selective PDA‐based chemosensor enabled easy detection of the presence of lead in 100% aqueous solution by the naked‐eye.
Summary: Magnetic nanoparticles have been prepared by a co‐precipitation method and modified with methacryloxypropyltrimethoxysilane. Magnetic molecularly imprinted polymer particles have been prepared by suspension polymerization in silicone oil. The particles possess a high affinity to the template molecules and are rapidly separated under a magnetic field.
We report the simple one‐pot synthesis of size tunable zinc oxide nanoparticles (ZnO NPs) out of an organometallic ZnO precursor using the self‐assembly of solution phase polystyrene‐block‐poly(2‐vinylpyridine) micelles. The resulting hybrid material could be deposited on various substrates in a straightforward manner with the NPs showing size‐dependent absorption and photoluminescence due to the quantum‐size effect. We compare the results to the assembly of preformed NPs which are selectively incorporated in the poly(2‐vinylpyridine) core of the micelles due to the high affinity of ZnO to vinylpyridine.
A unique example of macromolecular self‐assembly, where a mono‐component homopolyimide bearing carboxy end‐groups spontaneously forms nanopartilces with novel dimple‐like morphology in a single good solvent, is presented. The self‐assembly process is dramatically affected by the solution concentration and the temperature. It is proposed that such an unexpected self‐assembly behavior is a synergistic result of the self‐complementary hydrogen bonding between carboxy end‐groups and the propensity to parallel packing of polyimide chains through aromatic interactions.
Summary: To mimic the emergence of gradient morphology in polymer nanofibers, a new theoretical approach has been developed in the context of Cahn‐Hilliard time evolution equation, alternatively known as time‐dependent Ginzburg‐Landau equation (Model B) involving concentration order parameter. The effects of solvent evaporation on the morphology evolution of the nanofibers have been demonstrated. The numerical simulation showed that the formation of skin layers is governed by the competition between solvent evaporation rate and mutual diffusion rate. That is to say the skin layers are formed in the nanotube whenever the rate of evaporation exceeds a critical value; otherwise, a solid fiber is formed. In hollow nanofibers, the layer can grow to a substantial fraction of the fiber diameter, allowing it to remain intact, albeit often in a collapsed form.
The cross‐sectional concentration profile of the emerging fiber. 相似文献
A new soluble conjugated copolymer based on 2,7‐dibenzosilole and 4,7‐dithien‐2‐yl‐2,1,3‐benzothiadiazole units has been synthesized (PBSDTBT). Bulk heterojunction solar cell devices are fabricated using this material as the donor and [6,6]‐phenyl‐C61 butyric acid methyl ester (PCBM) as the acceptor. The power conversion efficiency is 1.6% under AM1.5 illumination. This material also shows a good VOC (0.97 V). The results are quite promising considering the relatively large bandgap (1.9 eV) of this polymer.
Camphor sulfonic acid (CSA) doped polyaniline (PANI) nanotubes (175 nm in outer diameter and 120 nm in inner diameter) were synthesized successfully by a self‐assembly method. It is found that the room‐temperature conductivity of an individual PANI nanotube is 30.5 S · cm−1; in particular, the intrinsic resistance of an individual nanotube (30 kΩ) is much smaller than the contact resistance of crossed nanotubes (500 kΩ).
A SEM image of two crossed PANI‐CSA nanotubes and the attached Pt electrodes. 相似文献
Specific losses of water are observed from the molecular anions of monoximes of α-diketones. Labelling studies, kinetic energy release values and the +E spectra of ions have been used to aid in the elucidation of the fragmentation pathways. It is proposed that the majority of ions have α-keto nitrile structures. 相似文献
Disulfide‐functionalized hyperbranched poly(amido amine)s (HPAMAMs) were synthesized by Michael addition polymerization of N,N'‐cystaminebisacrylamide and 1‐(2‐aminoethyl)piperazine. The novel HPAMAMs displayed bright fluorescence, and the emissions bands cover nearly the whole visible wavelength range. When polymer solutions were excited at 330–385, 460–490, and 510–550 nm, blue, green, and red solutions were observed, respectively. The HPAMAMs are biodegradable and they can be easily cleaved by 2‐mercaptoethanol or glutathione, leading to a decrease in the fluorescence intensity. Studies of applications of the biocompatible and biodegradable HPAMAMs in fluorescence imaging technology and biological science are in progress.
Summary: We describe an interesting approach to the fabrication of wettability gradients from hydrophobicity to superhydrophobicity in low‐density polyethylene (LDPE) films by first forming high porosity surfaces and placing the specimens onto linear temperature gradients. While the polymer chosen for the study is non‐polar, its microporous layer provides sufficient superhydrophobicity. Lateral gradient heating of the layer results in partial melting of the polymer and correspondingly decreases porosity thus decreasing hydrophobicity.
The synthesis and polymerization of novel diallyldimethylammonium ionic liquid monomers is described. A free‐radical polymerization follows a ring‐closing cyclopolymerization mechanism similar to the one observed previously for diallyldimethylammonium halides that leads to pyrrolidinium functional polymers. As previously observed in other families of polymeric ionic liquids, their physico‐chemical properties are seriously affected by the nature of the counter‐anion. As an example, the thermal stability increases following the trend SCN− < < < bis(trifluoromethane)sulfonamide. Interestingly, this polymerization route may lead to the synthesis of a new family of random copolymers that have a similar poly(diallyldimethylammonium) backbone and a mixture of counter‐anions determined by the comonomer selection.
Summary: New polymer gelators consisting of poly(propylene glycol) or poly(ethylene glycol) and L ‐lysine‐based low‐molecular‐weight gelators have been developed. These polymer gelators were synthesized according to a simple procedure with high reaction yield, and formed organogels in many organic solvents. The organogelation mechanism was proposed from the transmission electron microscopy and FTIR spectroscopy studies.
Structures of the polymer gelators synthesized here. 相似文献
A direct access to photochromic polymeric vesicles was demonstrated via polymerization‐induced self‐assembly and reorganization (PISR). The resulting vesicles displayed interesting photochromic behaviors different from that of their free polymer chains in DMF, and the vesicles exhibited stronger fluorescence and excellent photostability due to confinement of conformational flexibility of the polymer chains in aggregates.
