Rotor-synchronized dipolar-filter sequence at fast MAS in solid-state NMR

Dipolar filters are of considerable importance for eliminating the ¹H NMR signal of the rigid components of heterogeneous compounds while selecting the signal of their mobile parts. On the basis of such filters, structural and dynamical information of these compounds can often be acquired through further manipulations (e.g. spin diffusion) on the spin systems. To overcome the destructive interferences between the magic angle spinning (MAS) speed and the cycle-time of the widely-used Rotor-Asynchronized Dipolar Filter (RADF) sequence, we introduce a new method called Rotor-Synchronized Dipolar Filter (RSDF). This communication shows that this sequence does not present any interference with the spinning speed and is more compatible than RADF with high MAS frequencies (ν_R > 12 kHz). This new pulse sequence will potentially contribute to future researches on heterogeneous materials, such as multiphase polymer and membrane systems.     

High-speed 1H MAS NMR investigations of the weathered surface of a phosphate glass

Solid-state high-speed 1H MAS NMR spectroscopy was used to investigate the weathered surface of a potassium aluminum phosphate (KAP) glass exposed to a humid environment (30K2O10Al2O360P2O5, mol%). Through the combination of spin-spin relaxation and double quantum (DQ) filtering it was possible to resolve seven or eight different proton environments within the weathered surface of the KAP glass. Two-dimensional (2D) DQ and 2D NOESY NMR correlation experiments were performed to probe the spatial proximity of these different proton species. These 1H-1H correlation experiments helped confirm the spectral assignments. The analysis of these different 1H environments provides additional information about the chemical processes that occur at the weathered glass surface.     

Oxygen sites in the zeolite stilbite: a comparison of static, MAS, VAS, DAS and triple quantum MAS NMR techniques

Static, magic angle spinning (MAS), variable angle spinning (VAS), dynamic angle spinning (DAS) and triple quantum magic angle spinning (3QMAS) NMR techniques were applied to separate and quantify oxygen signals from Al–O–Si and Si–O–Si sites of ¹⁷O-enriched samples of the mineral stilbite, a natural zeolite. DAS experiments showed that there was a distribution of quadrupolar coupling constants, asymmetry parameters and isotropic chemical shifts. Two methods were used to study the quantification problem of DAS and 3QMAS. Our results showed that DAS was quantitative. In 3QMAS, signal intensity from sites with larger quadrupolar coupling constants was reduced because of less efficient excitation. All techniques have shown a clear difference in rates of exchange between the two types of sites with interchannel H₂O molecules.     

Characterization of the surface of positive electrodes for Li-ion batteries using 7Li MAS NMR

The growth and evolution of the interphase, due to contact with the ambient atmosphere or electrolyte, are followed using ⁷Li magic-angle spinning nuclear magnetic resonance (MAS NMR) in the case of two materials amongst the most promising candidates for positive electrodes for lithium batteries: LiFePO₄ and LiMn_0.5Ni_0.5O₂. The use of appropriate experimental conditions to acquire the NMR signal allows observing only the «diamagnetic» lithium species at the surface of the grains of active material. The reaction of LiMn_0.5Ni_0.5O₂ with the ambient atmosphere or LiPF₆ (1 M in Ethylene Carbonated/DiMéthyl Carbonate (EC/DMC)) electrolyte is extremely fast and leads to an important amount of lithium-containing diamagnetic species compared to what can be observed in the case of LiFePO₄. The two studied materials display a completely different surface chemistry in terms of reactivity and/or kinetics of the surface towards electrolyte. Moreover, these results show that MAS NMR is a very promising tool to monitor phenomena taking place at the interface between electrode and electrolyte.     

Quadrupole interactions of fluorine at implantation sites in germanium and silicon

Implantations of F in crystalline Ge has been examined by the DPAD method. Two unique fluorine EFG sites are found. The results show a strong resemblance to similar data obtained earlier for Si, e.g., in either host an axial symmetric EFG oriented along the <111> crystal direction is observed, also the temperature dependences of site populations follow similar trends. A thorough comparison of the Ge and Si data is given.     

Temperature calibration for high-temperature MAS NMR to 913 K: 63Cu MAS NMR of CuBr and CuI, and 23Na MAS NMR of NaNbO3

The solid-state phase transitions of CuBr, CuI and NaNbO₃ can be readily observed using ⁶³Cu and ²³Na high-temperature magic-angle spinning nuclear magnetic resonance spectroscopy. Temperature has large, linear effects on the peak maximum of ⁶³Cu in each solid phase of CuBr and CuI, and there is large jump in shift across each phase transition. The ²³Na MAS NMR peak intensities and the line widths in NaNbO₃ also clearly show its high-temperature transition to the cubic phase. These data can be used to calibrate high-temperature MAS NMR probes up to 913 K, which is two hundred degrees higher than the commonly-used temperature calibration based on the chemical shift of ²⁰⁷Pb in Pb(NO₃)₂.     

Solid-state S MAS NMR of inorganic sulfates

Solid-state (33)S MAS NMR spectra of a variety of inorganic sulfates have been obtained at magnetic field strengths of 4.7, 14.1, 17.6, and 18.8 T. Some of the difficulties associated with obtaining natural abundance (33)S NMR spectra have been overcome by using a high magnetic field strength and magic angle spinning (MAS). Multiple factors were considered when analyzing the spectral linewidths, including magnetic field inhomogeneity, dipolar coupling, chemical shift anisotropy, chemical shift dispersion, and quadrupolar coupling. In most of these sulfate samples, quadrupolar coupling was the dominant line broadening mechanism. Nuclear electric quadrupolar coupling constants (C(q)) as large as 2.05 MHz were calculated using spectral simulation software. Spectral information from these new data are compared with X-ray measurements and GAUSSIAN 98W calculations. A general correlation was observed between the magnitude of the C(q) and the increasing difference between S-O bond distances within the sulfate groups. Solid-state (33)S spin-lattice (T(1)) relaxation times were measured and show a significant reduction in T(1) for the hydrated sulfates. This is most likely the result of the modulation of the time-dependent electric field gradient at the nuclear site by motion of water molecules. This information will be useful in future efforts to use (33)S NMR in the compositional and structural analysis of sulfur containing materials.     

Estimation of the specific surface area of apatites in human mineralized tissues using 31P MAS NMR

Specific surface areas of apatites in whole human mineralized tissues were estimated from (31)P MAS NMR linewidths: 77 m(2)g(-1) for enamel and 94 m(2)g(-1) for dentin, dental cementum and cortical bone.     

Long-term stability of rotor-controlled MAS frequencies to 0.1 Hz proved by 14N MAS NMR experiments and simulations

Experimental and simulated 14N MAS NMR spectra of the NH4+ ions in the two polymorphs, mS60 and mP60, of (NH4)2MoO4 are used to illustrate that a long-term stability of rotor-controlled MAS frequencies to 0.1 Hz can be achieved using commercial instrumentation (MAS speed controller and 7.5 mm MAS probe with a single marked rotor) attached to a highly pressure-stabilized air supply. A new modification of the STARS simulation software employs a Gaussian distribution for the experimental spinning frequency around the frequency set for the MAS speed controller. A simulated spectrum is then obtained by summation of several calculated spectra for evenly spaced spinning frequencies around the set frequency with relative weight factors corresponding to the Gaussian distribution.     

Diffusion studies in confined nematic liquid crystals by MAS PFG NMR

Pulsed field gradient (PFG) NMR and magic-angle spinning (MAS) NMR have been combined in order to measure the diffusion coefficients of liquid crystals in confined geometry. Combination of MAS NMR with PFG NMR has a higher spectroscopic resolution in comparison with conventional PFG NMR and improves the application of NMR diffusometry to liquid crystals. It is found that the confinement of the liquid crystal 5CB in porous glasses with mean pore diameters of 30 and 200 nm does not notably change its diffusion behavior in comparison with the bulk state.     

A general protocol for temperature calibration of MAS NMR probes at arbitrary spinning speeds

A protocol using (207)Pb NMR of solid lead nitrate was developed to determine the temperature of magic-angle spinning (MAS) NMR probes over a range of nominal set temperatures and spinning speeds. Using BioMAS and FastMAS probes with typical sample spinning rates of 8 and 35 kHz, respectively, empirical equations were devised to predict the respective sample temperatures. These procedures provide a straightforward recipe for temperature calibration of any MAS probe.     

Solid-state 33S MAS NMR of inorganic sulfates

Solid-state (33)S MAS NMR spectra of a variety of inorganic sulfates have been obtained at magnetic field strengths of 4.7, 14.1, 17.6, and 18.8 T. Some of the difficulties associated with obtaining natural abundance (33)S NMR spectra have been overcome by using a high magnetic field strength and magic angle spinning (MAS). Multiple factors were considered when analyzing the spectral linewidths, including magnetic field inhomogeneity, dipolar coupling, chemical shift anisotropy, chemical shift dispersion, and quadrupolar coupling. In most of these sulfate samples, quadrupolar coupling was the dominant line broadening mechanism. Nuclear electric quadrupolar coupling constants (C(q)) as large as 2.05 MHz were calculated using spectral simulation software. Spectral information from these new data are compared with X-ray measurements and GAUSSIAN 98W calculations. A general correlation was observed between the magnitude of the C(q) and the increasing difference between S-O bond distances within the sulfate groups. Solid-state (33)S spin-lattice (T(1)) relaxation times were measured and show a significant reduction in T(1) for the hydrated sulfates. This is most likely the result of the modulation of the time-dependent electric field gradient at the nuclear site by motion of water molecules. This information will be useful in future efforts to use (33)S NMR in the compositional and structural analysis of sulfur containing materials.     

Fast acquisition of multi-dimensional spectra in solid-state NMR enabled by ultra-fast MAS

The advantages offered by ultra-fast (>60 kHz) magic angle spinning (MAS) rotation for the study of biological samples, notably containing paramagnetic centers are explored.It is shown that optimal conditions for performing solid-state ¹³C NMR under 60 kHz MAS are obtained with low-power CW ¹H decoupling, as well as after a low-power ¹H,¹³C cross-polarization step at a double-quantum matching condition. Acquisition with low-power decoupling highlights the existence of rotational decoupling sidebands. The sideband intensities and the existence of first and second rotary conditions are explained in the framework of the Floquet–van Vleck theory.As a result, optimal ¹³C spectra of the oxidized, paramagnetic form of human copper zinc superoxide dismutase (SOD) can be obtained employing rf-fields which do not exceed 40 kHz during the whole experiment. This enables the removal of unwanted heating which can lead to deterioration of the sample. Furthermore, combined with the short ¹H T₁s, this allows the repetition rate of the experiments to be shortened from 3 s to 500 ms, thus compensating for the sensitivity loss due to the smaller sample volume in a 1.3 mm rotor. The result is that 2D ¹³C–¹³C correlation could be acquired in about 24 h on less than 1 mg of SOD sample.     

MAS NMR Strategies for the Characterization of Supported Molybdenum Catalysts

After recalling a few advances made by ¹H, ²⁹Si, and ²⁷Al on the understanding of hydro-desulfuration (HDS) molybdenum-based catalysts supported on amorphous oxides, we critically evaluate the potential of ⁹⁵Mo magic-angle spinning nuclear magnetic resonance (MAS NMR) for gaining further insight into the structure of uncalcined precursors and sulfided HDS catalysts. It is shown that when performed at a very high field (19.6 T), it is indeed sensitive to the nature of the molybdenum–support interaction. In particular, a wide distribution of the molybdenum environment present on the surface was evidenced. However, the possibility to characterize sulfided catalysts by ⁹⁵Mo MAS NMR appeared still an unmet challenge. Authors' address: Jean-Baptiste d'Espinose de Lacaillerie, PPMD, Ecole Supérieure de Physique et de Chimie Industrielles, 10 rue Vauquelin, Paris 75231, Cedex 05, France     

H MAS and H[Na] double resonance NMR studies on the modification of surface hydroxyl groups of γ-alumina by sodium

The modification of surface hydroxyl groups with sodium in a series of Na₂CO₃-γ-Al₂O₃ catalysts was investigated as a function of both the Na₂CO₃ loading and the calcination temperature by means of ¹H magic angle spinning (MAS) and ¹H[²³Na] spin-echo double resonance NMR techniques. The ¹H NMR experiments revealed that sodium ions are homogeneously distributed over the alumina surface and closely coordinated with the surface hydroxyl groups. In the catalysts calcined at 250 °C, the acidic hydroxyl groups (with a chemical shift of 2.0 ppm) are preferentially associated with sodium ions at low Na₂CO₃ coverages (5 and 10%), while both the acidic and the basic (0 ppm) hydroxyl groups are accessible for sodium ions at high coverages (15 and 20%). The coordination causes a low-field shift of about 2 ppm in the ¹H MAS spectra, and a broad signal at 4.5 ppm appears. It is interesting that the 4.5 ppm signal is completely suppressed in the ¹H[²³Na] MAS experiments, providing direct evidence that a strong interaction exists between adsorbed sodium ions and the surface hydroxyl groups. Increasing the calcination temperature to 450 °C results in preferential removal of the acidic hydroxyl groups, and only the most basic hydroxyl groups remain when the calcination temperature is raised to 600 °C. This is attributed to the formation of the coordinated species which enhances the acidity of the surface hydroxyl groups and prompts their dehydroxylation, especially at high calcination temperature. Correlation of the ¹H MAS NMR results and catalytic activity measurements indicates that the basic hydroxyl groups are essential for the carbonyl sulfide hydrolysis reaction.