Excess molar volumes and viscosities of the ternary systemn-butylamine + 1,4-dioxane + acetonitrile at 25°C

Densities and viscosities for the n-butylamine + 1,4-dioxane + acetonitrile system were determined at 25°C and molar excess volumes and excess viscosities were calculated. Of the different expressions existing in the literature that predict these excess properties for ternary mixtures from data for the binary mixtures, the empirical correlation of Singh et al. is the best for this system.     

Excess Molar Volumes of n-Pentanol + Cumene,n-Pentanol + 1,4-Dioxane and Cumene + 1,4-Dioxane at Different Temperatures

Abstract

Molar excess volumes (V^E ) and partial molar excess volumes ( ^VE ) are reported for non-electrolyte binary mixtures of n-pentanol + cumene, n-pentanol + 1,4-dioxane and cumene + 1,4-dioxane at four temperatures and over the whole concentration range. In these systems, the n-pentanol is a highly polar molecule with association in its pure state, while the others two show little polarity without association in their pure states. The results of V^E are discussed in terms of the interactions between components. The Prigogine–Flory–Patterson model of solution thermodynamics has been used to predict V^E . This work shows the importance of the three contributions δV _int, δV _p? and δV_F to V^E .     

Excess enthalpies of water+1,4-dioxane at 278.15, 298.15, 318.15 and 338.15 K

The excess molar enthalpies of (1–x)water+x1,4-dioxane have been measured at four different temperatures. All the mixtures showed negative enthalpies in the range of low mole fraction but positive ones in the range of high mole fraction of 1,4-dioxane. Excess enthalpies were increased with increasing temperature except those of at 278.15 K. Partial molar enthalpies have maximum around x=0.13 and minimum around x=0.75. Three different behaviors for the concentration dependence of partial molar enthalpies were observed for all temperature. Theoretical calculations of molecular interactions of three characteristic concentrations were carried out using the molecular orbital method.     

Volumetric Properties of the Ternary System 1,4-Dioxane + Butyl Acrylate + Ethyl Acrylate and Its Binary Butyl Acrylate + Ethyl Acrylate at 298.15 K

Densities of the ternary system 1,4-dioxane + butyl acrylate + ethyl acrylate and its binary butyl acrylate + ethyl acrylate have been measured in the whole composition range, at 298.15 K and atmospheric pressure, using an Anton Paar DMA 5000 oscillating U-tube densimeter. The calculated excess molar volumes of the binary system are positive and were correlated with the Redlich–Kister equation and with a series of Legendre polynomials. Several models were used to correlate the ternary behavior from the excess molar volume data of their constituent binaries and were found equally good to fit the data. The best fit was based on a direct approach, without information on the component binary systems.     

Excess thermodynamic properties and vapor-liquid equilibrium data for then-butylamine+p-dioxane system at 25°C

Excess values of molar volumes, viscosities, molar enthalpies, Gibbs molar energies, surface tensions and molar diamagnetic susceptibilities were calculated at 25°C for then-butylamine+p-dioxane system. The observed deviations from the ideality were explained on the basis of intermolecular interactions. Van Laar's equations were the best in predicting activity coefficients for this system.     

Volumetric and acoustic properties of the ternary system (1-butanol+1,4-dioxane+cyclohexane)

Densities and speeds of sound for the ternary system 1-butanol+1,4-dioxane+cyclohexane have been measured at the temperatures of 298.15 and 313.15 K. Excess molar volumes and excess isentropic compressibilities have been calculated from experimental data and fitted by the Redlich-Kister equation for ternary mixtures. The ERAS model has been used to calculate excess molar volumes of the ternary mixture from parameters obtained from the constituent binary mixtures.     

Excess molar volumes of methylcyclohexane+benzene, +methylbenzene, +1,4-dioxane,and +tetrahydrofuran at 303.15 K

Excess molar volumes V_m^E as function of mole fraction x for methylcyclohexane + benzene, + methylbenzene, + 1,4-dioxane, and + tetrahydrofuran are reported at 303.15 K. The excess molar volumes are positive and indicate the presence of weak interactions.     

Thermodynamic properties of aqueous-organic systems with low water contents. 2. Limiting partial molar volumes of D2O and H2O intert-butyl alcohol and 1,4-dioxane at 288.15–318.15 K

The densities of dilute solutions of H₂O and D₂O in 1,4-dioxane and tert-BuOD have been measured in the interval 288.15–318.15 K with an error of 2·10^–6 g/cm³. The limiting partial molar volumes of D₂O and H₂O in 1,4-dioxane andtert-butanol have been determined by using an original procedure; the changes in the partial molar volume of water due to H-D substitution in the water molecules have been calculated. The analysis of the temperature dependence of the partial volumes of the components of the binary mixtures H₂O (D₂O) + 1,4-dioxane and H₂O (D₂O) +tert-BuOH (tert-BuOD) showed on the basis of Maxwell's crossing equations that the addition of small amounts of water significantly alters the structure of the unary organic solvent. In the presence of trace amounts of water the expansibility of 1,4-dioxane increases and that oftert-butanol decreases.For previous communication, see [1].Institute of the Chemistry of Nonaqueous Solutions, Russian Academy of Sciences, Ivanovo 153018. Translated from Izvestiya Akademii Nauk, Seriya Khimicheskaya, No. 3, pp. 568–571, March, 1992.     

Distribution of 1,4-dioxane by combined inhalation plus oral exposure routes in rats

1,4-Dioxane is used in large amounts by industry. Human exposure to 1,4-dioxane is via both air and water. Recently we reported that the toxicity of chloroform is enhanced when exposure is by multiple exposure routes rather than a single exposure route. In this study, rats were exposed simultaneously to 1,4-dioxane by two routes, inhalation and oral, and the distribution of 1,4-dioxane in the blood, lung, liver, brain, kidney and abdominal fat of rats were determined. To assess the contribution of each route, unmodified 1,4-dioxane (DX) was administered by inhalation and deuterated 1,4-dioxane (DX-d₈) was administered orally, and DX and DX-d₈ were analyzed by mass spectrometer (MS). Exposure by both inhalation and oral administration resulted in DX and DX-d₈ concentrations in the blood and tissues which were higher than when exposure was by either inhalation or oral administration alone. The distribution of 1,4-dioxane in the combined inhalation plus oral administration conformed with its physicochemical properties and the tissue partition coefficients. Our results support the well accepted tenet that when investigating the toxicity of a chemical, the route of exposure is an important consideration, and in addition, our results suggest that when exposure is by multiple routes, exposure by one route may, to some extent, have an affect on exposure by the second route.     

Ternary excess molar enthalpies for the mixtures of methanol and ethanol with tetrahydropyran or 1,4-dioxane at 298.15 K

Ternary excess molar enthalpies, H_m^E, at 298.15 K and atmospheric pressure measured by using a flow microcalorimeter are reported for the (methanol+ethanol+tetrahydropyran) and (methanol+ethanol+1,4-dioxane) mixtures. The pseudobinary excess molar enthalpies for all the systems are found to be positive over the entire range of compositions. The experimental results are correlated with a polynomial equation to estimate the coefficients and standard errors. The results have been compared with those calculated from a UNIQUAC associated solution model in terms of the self-association of alcohols as well as solvation between unlike alcohols and alcohols with tetrahydropyran or 1,4-dioxane. The association constants, solvation constants and optimally fitted binary parameters obtained solely from the pertinent binary correlation predict the ternary excess molar enthalpies with an excellent accuracy.     

Density and Speed of Sound for Binary Mixtures of a Cyclic Ether with a Butanol Isomer

Densities and speeds of sound of the binary mixtures 1,3-dioxolane + 1-butanol, 1,3-dioxolane + 2-butanol, 1,4-dioxane + 1-butanol, and 1,4-dioxane + 2-butanol have been measured at 25 and 40°C. The excess molar volumes and excess isentropic compressibility coefficients were calculated from experimental data and fitted to a Redlich–Kister polynomial function. Results were analyzed in terms of molecular interactions and compared with literature data.     

Binary mixtures of cyclohexanone, 2-butanone, 1,4-dioxane and 1,2-dimethoxyethane

Densities and sound velocities of binary mixtures of cyclohexanone, 2-butanone, 1,4-dioxane and 1,2-dimethoxyethane were measured at 298.15 K and also the densities at 303.15 K. Excess volumes were determined from densities. Isentropic compressibilities were determined from densities and sound velocities, and excess thermal expansion factors were determined from excess volumes of two temperatures. Excess isothermal compressibilities and excess isochoric heat capacities were then estimated using excess isobaric heat capacities previously reported. Excess volumes and excess isentropic and isothermal compressibilities were negative except for cyclohexanone+1,4-dioxane system. This revised version was published online in August 2006 with corrections to the Cover Date.     

Molecular association ofn-alcohols in nonpolar solvents. excess volumes and viscosities ofn-pentanol+n-octane mixtures at 0, 5, 25, 35 and 45°C

Densities and viscosities of n-pentanol +n-octane mixtures in the temperature range 0 to 45°C are reported. The data are discussed in terms of molar excess volumes, molar excess fluidities and molar excess activation energies of viscous flow in order to obtain structural information of the mixtures. It is shown that the structural modifications of n-pentanol and n-octane upon mixing, significantly contribute to the parameters governing the viscous flow and the volume of the mixtures.     

Excess Molar Volumes and Thermal Expansivities of Aqueous Solutions of Dimethylsulfoxide,Tetrahydrofuran and 1,4-Dioxane

Densities, , of the systems water (W) + dimethylsulfoxide (DMSO), W + tetrahydrofuran (THF) and W + 1,4-dioxane (DO) have been determined in the temperature range 303.15-323.15 K. Excess molar volumes, $V_m^E $ , have been found to be negative and large in magnitude. Thermal expansivities, f , and excess thermal expansivities, f E , have been calculated. Densities, excess molar volumes, thermal expansivities and excess thermal expansivities have been plotted against mole fraction of solutes. All these properties have been expressed satisfactorily by appropriate polynomials. Attempt has been made to explain $V_m^E$ in terms of hydrophobic hydration and hydrophilic effect of the solutes.     

Excess molar volumes and excess viscosities of the n-pentanol-cumene-1,4-dioxane system at 298.15 K

Densities and viscosities were determined for the n-pentanol-cumene-1,4-dioxane system at 298.15 K. From the experimental results, molar excess volumes and excess viscosities were calculated. Different expressions exist in the literature to predict these excess properties from the binary data. The empirical correlation of Cibulka is shown to be the best for this system.     

Enthalpies of dilution and homotactic enthalpic interaction coefficients of THF and 1,4-dioxane at 298.15 k

Enthalpies of dilution at 298.15 K of aqueous solutions of THF and 1,4-dioxane have been determined using flow microcalorimetry. The results obtained were used to determine the homotactic enthalpic interaction coefficients that characterize pair interactions of THF and 1,4-dioxane in aqueous solution. These are briefly discussed from the point of view of intermolecular interaction between the hydrated solute species.     

Insight into the binary mixture of ethyl lactate+acetonitrile from density,speed of sound and refractive index measurements

Density, sound velocity and refractive index of ethyl lactate + acetonitrile mixtures were measured at five temperatures from 283.15 to 323.15 K. Excess molar volumes, partial molar volumes, thermal expansion coefficients, isentropic compressibility and molar refraction values were calculated. It is concluded that deviations from ideality in this system should be assigned to the ability of the smaller acetonitrile molecules to occupy free volume space of ethyl lactate.     

Excess Molar Volumes of Binary Mixtures of Acetonitrile with n-Alkanols at 25°C

Molar excess volumes of acetonitrile with ten n-alkanols (from methanol to decanol) were determined from density measurements at 25°C and normal atmospheric pressure, using a vibrating-tube densimeter. V ^E for acetonitrile + methanol mixtures are negative over the entire range of mole fractions. The ethanol and propanol mixtures exhibit sigmoidal curves and positive values are obtained for all remaining mixtures. The results for V ^E were compared with those obtained using several theoretical models.     

Structural Peculiarities of Dioxane Media in H/D Isotope Effects of Water Solvation at 288.15K-318.15K

Using the data of precision densimetry measurements for diluted solutions of H₂O and D₂O in 1,4-dioxane (1,4-DX) at 288.15 K-318.15 K we calculated the limiting partial molar volumes of the H/D isotopomers of water in dioxane and the excess molar volumes of the stated systems. The water molecules dispersed in 1,4-DX form complexes H-bonded into associates whose packing coefficient slightly exceeds that of the structural aggregates in liquid H₂O and D₂O. It is concluded that the structure of 1,4-DX is loosened and concomitantly undergoes volume expansion caused by the water microimpurities. The differentiating temperature effect on the volume solvation effects of H₂O and D₂O in 1,4-DX has been found.Original Russian Text Copyright © 2004 by. E. V. Ivanov, E. Yu. Lebedeva, and V. K. Abrosimov__________Translated from Zhurnal Strukturnoi Khimii, Vol. 45, No. 5, pp. 852–861, September–October, 2004.