Intracavity optical parametric oscillator pumped by passively Q-switched Nd:YLF laser

We report on a passively Q-switched end pumped Nd:YLF laser including a noncritically phase-matched KTP singly resonant intracavity optical parametric oscillator (IOPO-KTP). For the Q-switching operation we have used Cr:YAG saturable absorber. The optimized passively Q-switched Nd:YLF laser without IOPO generated linearly polarized pulses of 11.5 ns and 1.07 mJ at 1047 nm. The conversion efficiency of the optimized Q-switched pulse energy at 1047 nm to 1547 nm of a signal approached about 47%. For optimizing both Nd:YLF laser and IOPO we have numerically solved a theoretical model. We have achieved 1.6-ns duration pulses at 1547 nm with energy of 0.5 mJ and peak power of above 300 kW. The beam quality was excellent (M² ≈1).     

Diode-laser pumped high-power and actively mode-locked Nd:YLF laser with fast switching

In an actively mode-locked laser, self-phase modulation can make pulse shorter at the expanse of causing instability at high pumping power. Using fast switching on the acousto-optic modulator, we can generate an actively mode-locked pulse train with shorter pulse width and higher average power than that driven by a sinusoidal signal. A 9-ps pulse train was generated in a mode-locked laser with an average power of 600 mW whose power level, to our knowledge, is the highest for diode-pumped and mode-locked Nd:YLF lasers.     

High repetition rate, tunable, Q-switched diode pumped Tm:YLF laser

The aim of work was to characterize a simple oscillator consisted of Tm:YLF crystal end-pumped by a fiber coupled diode laser and active Q-switch with tunability option. About 7 W with near 35% slope efficiency was demonstrated in a free-running mode. The divergence angle was about 4.3 mrad and estimated parameter M² < 1.3. Continuous tuning by means of Lyot’s filter, consisted of 2 quartz plates in the range of 1879.0–1939.4 nm with less than 1-nm linewidth, was achieved. For the best case (10-ms pump pulse duration, 42-A pump current corresponding to 266 mJ of pump energy), the Q-switched energy was 10.5 mJ with pulse duration of 22 ns corresponding to near 0.5 MW peak power. The 2.5 W of average power with 12.6-kW peak power and 2000-Hz repetition rate was demonstrated for cw pumping regime.     

MQW-LDA泵浦Nd:YLF激光器调Q的动力学过程及双机制作用

本文报道了国产多量子阱半导体激光列阵(MQW-LDA)泵浦Nd:YLF调Q脉冲脉宽.峰值功率与输出耦合率、泵浦速率、调制深度及延迟时间之间关系的实验,得到稳定的(起伏<1%)调Q脉冲输出,脉冲能量为0.8μJ,FWHM为70ns,脉冲重复率为100Hz,光-光效率2.5%;利用增益开关和Q开关双机制作用,压窄了调Q脉宽,提高了输出功率.用速率方程理论对过程计算,与实验结果较符合.     

高功率高光束质量脉冲Nd: YAG激光器

以实现高功率、高光束质量的脉冲激光输出为目的,对非对称平-凹谐振腔的结构进行了理论分析。设计出了高功率、高光束质量非对称放置的平-凹谐振腔、双氙灯泵浦的脉冲Nd: YAG激光器。当占空比为9%时,实现输出激光平均功率近480 W,光束参数积优于12.7 mm·mrad,电光转化效率近4%,与理论分析吻合,可用芯径300 μm的光纤传输,不稳定性优于±1%。加工实验证明有较好的质量：切割材料为不锈钢,厚度为3 mm时、切割速度为0.6 m/min和厚度为1.5 mm、切割速度为1.2 m/min时,两种情况下所得切缝宽度均为250 μm,且切割上下沿光滑。     

高功率高光束质量脉冲Nd: YAG激光器

 以实现高功率、高光束质量的脉冲激光输出为目的,对非对称平-凹谐振腔的结构进行了理论分析。设计出了高功率、高光束质量非对称放置的平-凹谐振腔、双氙灯泵浦的脉冲Nd: YAG激光器。当占空比为9%时,实现输出激光平均功率近480 W,光束参数积优于12.7 mm·mrad,电光转化效率近4%,与理论分析吻合,可用芯径300 μm的光纤传输,不稳定性优于±1%。加工实验证明有较好的质量：切割材料为不锈钢,厚度为3 mm时、切割速度为0.6 m/min和厚度为1.5 mm、切割速度为1.2 m/min时,两种情况下所得切缝宽度均为250 μm,且切割上下沿光滑。     

885 nm pumped,high efficiency single-frequency Nd:YAG ring laser

We report an efficient single-frequency ring laser pumped directly into emitting level by a fiber-coupled laser diode (FCLD) at 885 nm for the first time. 4.8 W laser at 1064 nm was obtained in a 0.7 at % Nd:YAG with 63% slope efficiency and 51.7% light-light efficiency in absorbed pump power. At the same time, the line width of the longitudinal mode was about 50 MHz, and the beam was nearly diffraction-limited with M2 ≈ 1.07.     

High optical-to-optical efficiency of LD pumped cw Nd:YAG laser under pumping distribution control

00 operation have been investigated under different pump light distributions that have been formed by a virtual-point-source pumping system. Compared with a central uniform distribution, a centrally depressed distribution is found to have a lower thermal lensing effect and a higher optical-to-optical efficiency for operations performed using the same resonator parameters or within a similar stable range, and the improvement in optical-to-optical efficiency is explained as a result of a reduction in thermally induced aberrations. Received: 10 June 1997     

Epitaxial Nd:YLF linear waveguide laser

We report laser operation in planar and linear Nd:YLF waveguide structures grown by liquid-phase epitaxy (LPE). We could reduce the relatively high threshold of 115-mW incident pump power observed for the planar waveguide to 8 mW in a ridge-type structure that we obtained by mechanical polishing and subsequent growth of a cladding layer. Substantial improvements seem possible with reduction of the losses caused by imperfect end-face reflection and scattering, as well as by use of techniques capable of producing smaller structures than the 40-mum-wide triangular ridge cross section that was obtained with polishing. Since the LPE technique is applicable to other activator ions as well, it might offer a route to development of low-threshold upconversion lasers.     

Comparison of eye-safe KTA OPOs pumped by Nd:YVO4 and Nd:YLF lasers

An eye-safe KTA OPO pumped by a Nd:YLF laser is demonstrated and a comparison with that pumped by a Nd:YVO₄ laser is performed. Although the slope efficiency of the continuous-wave free-running Nd:YLF laser is lower than that of the Nd:YVO₄ laser, the performance of KTA OPOs pumped by the Q-switched Nd:YLF laser is better, especially at lower repetition rates. The slope efficiency of KTA OPO pumped by a Nd:YLF laser is 14.6% at 30 kHz and 11.04% at 10 kHz. The better energy storage ability of Nd:YLF makes it an excellent laser medium in IOPOs.     

二极管激光器泵浦钕玻璃固体激光器

用脉冲输出功率50mW,中心波长为800nm的双异质结激光二极管列阵泵浦磷酸盐钕璃璃激光器,得到1.053μm波长激光输出.泵浦阈值功率为9mW.计算了DPL输出的尖峰功率、脉冲宽度和弛豫振荡波形,与实验结果一致.     

Electro-optical cavity-dumped Ce:Nd:YAG laser for aesthetic medicine

An electro-optical cavity-dumped 20 Hz Ce:Nd:YAG laser with an optimized thermal-insensitive concavo-convex cavity for aesthetic medicine was demonstrated. The pulse width remained constant at 6.0 ns. The maximum output energy and peak power were 120 mJ and 20 MW, respectively. The average output energy was very stable. The fluctuations of average output energy within 6 cycles and 10 min were 0.89% and 7.9%, respectively.     

LD端面泵浦Nd：YLF激光放大器研究

 描述了对高功率LD端面泵浦Nd：YLF激光放大器的研究。放大器的耦合结构采用微透镜对泵浦光进行准直，透镜导管（Lensduct）对其汇聚，耦合效率达72.2%。用该放大器构成的振荡器的斜效率为35.9%。该激光放大器的口径为Φ 10mm，在1053nm处具有2.66的小信号增益。     

All-solid-state high-power conduction-cooled Nd:YLF rod laser

A high-average-power conduction-cooled diode-pumped Nd:YLF rod laser has been developed. A new conduction-cooled side-pumping scheme with a solid prismatic pump-light confinement cavity was employed. A transparent, high-thermal-conductivity MgF>(2) prism was used as a highly efficient pump cavity as well as a low-thermal-resistance heat spreader. The pumping efficiency and thermal resistance of the cavity were 85% and 0.20 degrees C degrees W, respectively. When this scheme was combined with heat pipes for heat removal, a maximum average output power of 72 W was demonstrated, with an optical slope efficiency as high as 49%.     

Solar pumped Nd:YAG laser

We report the high efficiency of solar pumped laser. The sunlight is concentrated by the concentrator system, which is composed by the Fresnel lens and the cone-channel condenser. The power density of sunlight concentrated by the concentrator system surpasses the lasing threshold for pumping laser. In the experiment, the sunlight concentrated is coupled into the conical chamber pumping Nd:YAG laser media. Laser output of 3.5 W has been achieved; the collect efficiency is 3.5 W/m². The conversion efficiency is 1.0% from solar power into laser, and the slope efficiency is achieved 1.86%.     

High efficiency diode laser side-pumped Nd:YAG rod laser

High efficiency laser performance of 2 mm diameter and 20 mm long Nd:YAG crystal rod transversely pumped by laser diode array is presented. Using the directly side-coupled geometry enclosed by cylindrical pump cavity plated with gold, we obtained long pulse energy of 4.6 mJ corresponding to optical-to-optical slope efficiency of 37%. The complete solid-state Nd:YAG laser is described to be simple, compact and highly efficient. Q-switching of the laser is also reported.     

Diode-end-pumped double Nd:YLF slab laser with high energy, short pulse width, and diffraction-limited quality

We have developed a novel electro-optic Q-switched diode-end-pumped solid slab laser that combines high energy, short pulse width, high repetition rates, and diffraction-limited beam quality. With two partially end-pumped Nd:YLF slabs and a 100 mm long off-axis positive branch stable-unstable oscillator, 24.2 mJ, 7.1 ns electro-optic Q-switched pulse at 1 kHz repetition rate with a beam quality of M(x)(2)=1.4 and M(y)(2)=1.3 was generated. The peak power reached 3.5 MW. Efficient external second-harmonic generation was achieved by use of lithium triborate with low peak-power intensity.     

Diode both ends pumped two crystals Tm:YLF laser

In this paper, we report two crystals Tm:YLF laser pumped by a fiber coupled diode laser with total power of 180 W at 792 nm. When the incident power reached up to 117.0 and 37.3 W of the emission wave-length at 1.91 μm was achieved. Through linear fit, the corresponding slope efficiency of 38.5%, optical-to-optical conversion efficiency of 31.9% and the beam quality factor of M ² ∼ 1.1 were obtained, indicating nearly diffraction limited beam propagation. To our best knowledge, this is the best beam quality among the reported paper results under the similar experiments.     

Ho:YAG laser intracavity pumped by a diode-pumped Tm:YLF laser

We report a compact Ho:YAG laser that is intracavity pumped by a diode-pumped Tm:YLF laser. Both lasers exhibit pulse mode behavior. Operating both crystals at room temperature (25 degrees C), we obtained 1.6 W of average output at 2.09 microm from the Ho:YAG laser for 15.4 W of diode power incident upon the Tm:YLF rod and a slope efficiency of 21%.