共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
3.
4.
为了提高光子晶体波导与传统介质波导的耦合效率,设计了级联缓变结构.先将传统介质波导中的光耦合进尺寸相当的光子晶体W5波导中,然后W5波导中的光被耦合进尺寸较小些的W3波导中,最后光被耦合进尺寸最小的W1波导.各级波导之间由半径逐渐增大的空气孔连接,空气孔半径逐渐变化相当于波导有效折射率在变化,所以各级波导可以看作是被折射率缓变结构连接起来.由于折射率的缓变,使得光从前一级波导耦合进相邻的后一级波导时反射很小,从而能有效地提高耦合效率.数值计算表明,在光子晶体禁带范围内,除了波导有限长度和波导微小禁带造成的微小不通带外,耦合系数一般能达80%左右,最高可达到95%. 相似文献
5.
利用一维变周期谐振腔阵列和非线性缓变边界,可以实现光波从脊波导到光子晶体平面波导 (PCW)的高效耦合.基于平面波展开法(PWE)和时域有限差分法(FDTD),深入分析和讨 论了普通脊波导、2D-PCW结构和本征模以及工作模式、缓变边界形状等对耦合效率的影响, 从而得出光波从脊波导到2D-PCW、再返回脊波导的统一图景.指出考虑模式转换和采用缓变 边界条件可以极大提高PCW与脊波导间的耦合效率.对PC-PW边界采用线性和非线性缓变结构 进行了仿真,讨论了边界缓变程度对耦合效率的影响.结果表明,采用模式耦合和PC-PW余弦 缓变边界时的耦合效率在较宽的带宽内超过了95%.
关键词:
光子晶体波导
脊波导
PWE
FDTD
耦合边界 相似文献
6.
7.
提出了一种新型两通道光子晶体解波分复用器.首先使用平面波展开法分析了耦合缺陷波导的特性.接着对双耦合缺陷波导之间的耦合效应进行分析.然后,利用耦合效应设计了一种高效的解波分复用器,使用有限时域差分法研究了不同波长的光在解波分复用器中的传输特性,并计算出了电场分布图.仿真结果表明,该种结构可以实现波长分别为1 266nm和1 311nm两种光波的解波分复用.由于耦合缺陷波导具有更小的群速度,此种结构较基于线缺陷波导耦合的解波分复用器具有更小的耦合长度,从而减小了系统的体积. 相似文献
8.
在单线缺陷结构中引入两个附加的相邻介质柱,构成一种新型的光子晶体耦合腔波导结构.通过平面波展开法对波导结构的的慢光特性进行了仿真分析,研究了平移线缺陷上下两侧介质柱,以及改变腔体的长度对器件色散特性和群速度的影响.结果表明:与平移缺陷上下两侧介质柱相比,通过改变腔体的长度,不仅可将光群速度低到0.03c(c为真空下的光速),而且器件的有效波长范围接近20nm.利用时域有限差分法得到波导结构的传输场分布图,研究波长的选取对入射激励光在光子晶体耦合腔波导中传输场的影响,发现结构参量优化后的光子晶体耦合腔波导仍然具有良好的传输特性. 相似文献
9.
10.
光子晶体异质结耦合波导光开关 总被引:2,自引:0,他引:2
以二维三角晶格光子晶体为研究对象,在该光子晶体中引入两行平行的单模线缺陷波导,以一行耦合介质柱为间距,通过调节部分耦合介质柱的折射率,构筑了光子晶体异质结耦合波导光开关结构。利用平面波展开法和定向耦合原理计算了在不同入射光频率下,缺陷波导间耦合介质柱的折射率不同时的耦合长度,确定了合适的光子晶体异质结耦合波导光开关的结构参数。利用时域有限差分法研究了该光开关中耦合介质柱的折射率变化及异质结构介质柱的位置分布对光信号输出路径的影响。结果表明,通过改变该结构中耦合介质柱的折射率可以改变光的输出路径,可实现光的开关行为。并且异质结构介质柱位置的随机分布对该光开关的影响不大,有助于光子晶体新型滤波器、定向耦合器、波分复用器以及光开关等光子器件的研究。 相似文献
11.
提出了一种基于六角格子光子晶体波导微腔和Fabry-Perot(FP)腔非对称耦合的全光二极管结构, 它由一个包含非线性Kerr介质的高Q值微腔与一个光子晶体波导中的FP腔组成. 通过有限时域差分方法对其传输特性进行了仿真, 发现通过两腔的非对称耦合可以实现在特定光强度下的正向传输、反向截止的功能. 在靠近微腔方向光入射时, 特定强度的光可以激发非线性微腔的Kerr效应, 改变了Fano腔的共振频率, 从而变成透射状态. 而远离微腔方向光入射, 由于这个不对称的结构造成场局域的分布不对称, 激发微腔Kerr效应的光强还不够, 所以光不能透射. 所设计的全光二极管结构具有良好的性能参数: 最大透射率高和高透射比、光强阈值低和易于集成等. 相似文献
12.
A two-dimensional (2D) photonic crystal waveguide in the
\Gamma--K direction with triangular lattice on a
silicon-on-insulator (SOI) substrate in the near-infrared band is
fabricated by the combination of electron beam lithography and
inductively coupled plasma etching. Its transmission characteristics
are analysed from the stimulated band diagram by the effective index
and the 2D plane wave expansion (PWE) methods. In the experiment, the
transmission band edge in a longer wavelength of the photonic crystal
waveguide is about 1590\,nm, which is in good qualitative agreement
with the simulated value. However, there is a disagreement between
the experimental and the simulated results when the wavelength ranges
from 1607 to 1630\,nm, which can be considered as due to the
unpolarized source used in the transmission measurement. 相似文献
13.
2D triangular photonic crystals (PCs) have been integrated as laser mirrors in electrically pumped InGaAs/AlGaAs ridge waveguide lasers. The investigated PC lattice constants range from 160 to 400 nm with light incident along both main symmetry directions M and K. The observed cw laser performance is strongly dependent on both orientation and period of the PC. This behaviour is discussed using a 2D transfer matrix calculation of the PC reflectivity. As a demonstrator device relying on the 2D light confining properties of the PC, an active beamsplitter with a bending radius of 5 m is presented. Here, the PC is successfully used as cladding material in the S-bent regions of the ridge waveguide, significantly reducing the bending loss. 相似文献
14.
15.
16.
A two-dimensional photonic crystal coupled-cavity waveguide is designed and optimized, the transmission spectrum is calculated by using the finite-difference time-domain method, and the group velocity of c/1856 is obtained. To our knowledge, this value of group velocity is the lowest group velocity in a photonic crystal waveguide calculated from its transmission spectrum so far. The result is confirmed by the photonic band structure calculated by using the plane wave expansion method, and it is found that the photonic crystal waveguide modes in a photonic band structure are in accordance with those in the transmission spectrum by using the finite-difference time-domain method. The mechanism of slow light in the coupled-cavity waveguide of photonic crystal is analysed. 相似文献
17.
为了解决光子晶体波导出射端光场控制, 同时解决二维三角晶格光子晶体波导出射光辐射困难的问题。利用二维三角晶格光子晶体设计了一种新型光子晶体波导出射口结构。在二维三角晶格光子晶体波导出射端引入两个微腔, 通过光波与微腔发生共振, 形成类似于三个点光源干涉的出射光, 同时进一步提出波导出射端喇叭口干涉出射光定向辐射的设计。通过这种微腔喇叭口设计, 利用时域有限差分法分析结果表明光波实现很好的定向辐射, 并且辐射距离显著提高。 相似文献
18.
Based on the present coupled mode theory of the photonic crystal resonator array in this paper,we propose a novel side-coupled waveguide to achieve highly efficient coupling of photonic crystal devices.It is found that the coupling efficiency is sensitive to the interval,the total number and the quality factor of the resonator.Considering the coupling efficiency and the coupling region,we select five resonators with an interval of six lattice periods.By optimizing the structure parameters of the waveguide and resonator,the quality factors of the resonator can be modulated and the coupling efficiency of the side-coupled waveguide reaches 95.47% in theory.Compared with other coupling methods,the side-coupled waveguide can realize efficient coupling with a compact structure,a high level of integration and a low degree of operational difficulties. 相似文献
19.
Based on the present coupled mode theory of the photonic crystal resonator array in this paper, we propose a novel side-coupled waveguide to achieve highly efficient coupling of photonic crystal devices. It is found that the coupling efficiency is sensitive to the interval, the total number and the quality factor of the resonator. Considering the coupling efficiency and the coupling region, we select five resonators with an interval of six lattice periods. By optimizing the structure parameters of the waveguide and resonator, the quality factors of the resonator can be modulated and the coupling efficiency of the side-coupled waveguide reaches 95.47% in theory. Compared with other coupling methods, the side-coupled waveguide can realize efficient coupling with a compact structure, a high level of integration and a low degree of operational difficulties. 相似文献
20.
研究了慢光模式在SOI(silicon-on-insulator)材料光子晶体线缺陷弯折波导中的传输特性. 通过优化波导弯折处的结构参数,慢光模式在光子晶体60°与120°弯折波导中的透射率提高10倍以上,归一化透射率分别达到80%和60%以上. 为了进一步减慢光速,设计了新颖的高Q值耦合腔弯折波导结构,在归一化透射率达到75%的基础上,光波群速度低至c/170(c为真空光速). 研究结果对于增强光子晶体的慢光效应,提高光子晶体慢光器件的微型化和集成化都有一定的积
关键词:
光子晶体
慢光
弯折波导
透射率 相似文献