LD侧泵Nd:YAG/S-KTP腔内倍频高功率660 nm连续红光激光器

报道了LD侧面泵浦NdYAG/S-KTP腔内倍频高功率660 nm连续红光激光器.泵浦组件(呈三角形等间距分布)由9个20 W的激光二极管组成,最大泵浦功率为180 W.通过对谐振腔参数进行优化设计,用LD连续抽运3 mm×65 mm NdYAG激光棒时,获得了波长为1 319 nm的基频光振荡.利用S-KTP Ⅱ类临界相位匹配腔内倍频技术,当泵浦电流为22 A时,获得了6.8 W的连续红光激光输出,光-光转换效率为4.3%.     

高稳定LD泵浦腔内倍频Nd∶YVO4/KTP连续绿光激光器

设计出一种能够较好地补偿激光晶体热效应的激光谐振腔，实现了高稳定LD单端泵浦KTP腔内倍频Nd∶YVO₄连续绿光激光器.当晶体吸收的泵浦功率为24.56 W时，532 nm激光功率达到5.3 W，光-光转换效率达到21.6％，激光模式为TEM00模.在输出功率5W左右时，激光器1 h功率不稳定度优于0.6％     

全固态腔内倍频被动调Q黄光激光器理论研究

考虑晶体热衍射损耗以及在倍频过程中的非线性腔内损耗的影响,给出了LD泵浦Cr:YAG被动调Q556nm激光的耦合速率方程,数值求解了该方程组获得输出激光的重复频率,平均输出功率,峰值功率随泵浦功率的变化特性,理论值与实验结果符合较好.     

高稳定LD泵浦腔内倍频Nd∶YVO4/KTP连续绿光激光器

设计出一种能够较好地补偿激光晶体热效应的激光谐振腔,实现了高稳定LD单端泵浦KTP腔内倍频Nd∶YVO4连续绿光激光器·当晶体吸收的泵浦功率为24.56W时,532nm激光功率达到5.3W,光-光转换效率达到21.6%,激光模式为TEM00模·在输出功率5W左右时,激光器1h功率不稳定度优于0.6%·     

1.57μm被动调Q光学参量振荡器

在半导体泵浦被动调QNd∶GdVO4/Cr4+∶YAG激光腔内,利用KTP晶体实现了高重复频率的内腔OPO的稳定运转。OPO其信号光转换效率为7%,斜效率为10.3%。当泵浦功率7.3W时,可获得平均功率为0.48W,重频15kHz,脉宽6ns,峰值功率达13KW的1570nm激光输出。     

Cr4+∶YAG被动调Q微晶片激光器重复频率稳定性研究

对连续激光二极管抽运Nd∶YVO4/Cr4+∶YAG被动调Q微晶片激光器输出激光重复频率的稳定性进行了理论和实验研究.结果表明,谐振腔内存在最佳净增益,可以使激光器工作在稳定区.通过优化腔内的净增益,耦合输出镜反射率为85%,饱和吸收体初始透射率为70%,抽运功率从1.05 W到1.20 W的情况下,激光器工作在稳定区.当抽运功率为1.16 W时,获得了重复频率为19.48 kHz,稳定性优于0.68%(RMS)的高重复频率激光输出.进一步分析了抽运功率抖动对输出激光重复频率稳定性的影响.结果表明,激光器进入稳定区之后,抽运功率的抖动是制约输出激光重复频率稳定性进一步提高的最主要因素.针对抽运功率抖动带来的影响,讨论了增益预抽运技术,并比较了其优缺点.     

二极管泵浦被动调Q Nd:YAG/ KTP绿光激光器

报道了LD泵浦的Nd:YAG/KTP/Cr:YAG结构被动调Q绿光激光器.当注入泵浦功率为750mW时,获得了平均功率38mW,脉冲宽度14.7ns,重复频率20.4kHz,峰值功率126.6W的调Q绿激光输出.     

Cr4+:YAG被动调Q激光器输出特性

采用理论与实验相结合的方法研究了激光二极管阵列泵浦的Cr4+:YAG被动调Q Nd:YAG激光器的输出特性.重点分析了调Q晶体小信号透过率和反射镜的反射率对激光器的输出能量、脉冲宽度的影响.对数值模拟结果进行了实验验证,数值计算与实验结果基本一致.研究结果表明,在特定的激光晶体参数下,Cr4+:YAG被动调Q激光器的输出能量与脉冲宽度由调Q晶体的小信号透过率和输出镜的反射率决定:输出能量随着小信号透过率增加而减小,对应于一个调Q晶体透过率,有一个最佳反射率使输出能量最大;脉冲宽度随着初始透过率与反射率的增大而增大.     

LD泵浦的Nd：YAG调Q激光器腔内倍频研究

DPL的调Q倍频是获得高重复率绿光输出的有效方法,本文研究了这种激光器的动态特性,提出存在使转换效率最高的最佳非线性耦合系数,它是调Q时反转粒子数超阈值倍数的函数.实验用国产200mWR的MQW—LDA泵浦Nd:YAG激光器,声光调Q,KTP腔内倍频,输出0.4μJ的倍频光,脉宽70ns,峰功率6W.     

LD侧泵Nd∶YAG/S-KTP腔内倍频高功率660nm连续红光激光器

报道了LD侧面泵浦Nd∶YAG/S-KTP腔内倍频高功率660nm连续红光激光器。泵浦组件（呈三角形等间距分布）由9个20W的激光二极管组成，最大泵浦功率为180W。通过对谐振腔参数进行优化设计，用LD连续抽运3mm×65mm Nd∶YAG激光棒时，获得了波长为1319nm的基频光振荡。利用S-KTP II类临界相位匹配腔内倍频技术，当泵浦电流为22A时，获得了6.8W的连续红光激光输出，光-光转换效率为4.3％。     

Laser-diode end-pumped intracavity frequency doubling semiconductor saturable absorber mirror passively mode-locked picosecond lasers

A diode pumped Nd:YVO₄ semiconductor saturable absorber mirror (SESAM) passive mode-locked intracavity frequency doubled laser was studied. A type II phase matching KTiOPO₄(KTP) crystal and a type I phase matching LiB₃O₅ (LBO) frequency doubling crystal were respectively inserted in the cavity. With a pump power of 4.5 W, a 90 mW output of frequency doubled beam and 29.7 ps pulse duration were achieved with frequency doubled by KTP. With the same pump power a 140 mW output of frequency doubled beam and 3.67 ps pulse duration were achieved with LBO.     

High-power high-stability Q-switched green laser with intracavity frequency doubling of diode-pumped composite ceramic Nd:YAG laser

We successfully obtain high-average-power high-stability Q-switched green laser based on diode-side-pumped composite ceramic Nd:YAG in a straight plano-concave cavity. The temperature distribution in composite ceramic Nd:YAG crystal is numerically analyzed and compared with that of conventional Nd:YAG crystal. By use of a composite ceramic Nd:YAG rod and a type-II high gray track resistance KTP (HGTR-KTP) crystal, a green laser with an average output power of 165 W is obtained at a repetition rate of 25 kHz, with a diode-to-green optical conversion of 14.68%, and a pulse width of 162 ns. To the best of our knowledge, both the output power and optical-to-optical efficiency are the highest values for green laser systems with intracavity frequency doubling of this novel composite ceramic Nd:YAG laser to date. The power fluctuation at around 160 W is lower than 0.3% in 2.5 hours.     

被动调Q激光器输出特性的实验研究

被动调Q晶体Cr∶YAG对激光器的性能起着重要的作用。对Cr∶YAG被动调Q Nd∶YAG激光器进行了实验研究。着重研究了抽运功率、腔长、输出镜透过率以及初始透过率等因素对激光输出脉冲序列的重复率、脉冲宽度以及输出功率的影响。实验结果表明，抽运功率是影响重复率的最大因素，抽运功率的增大可以提高重复率，并减小脉冲宽度；它对腔长的影响效果刚好相反；存在一个可使输出功率最大的最佳输出镜透过率；不同的初始透过率对输出有一定的影响。分析表明被动调Q技术适用于DPL。     

Diode-laser pumped passively Q-switched green laser by intracavity frequency-doubling with periodically poled LiNbO3

A continuous-wave (CW) laser-diode (LD) pumped passively Q-switched intra-cavity frequency-doubling green laser is reported in this paper. We used 3% at Nd doped YVO₄ as gain medium, Cr⁴⁺:YAG as a saturable absorber for passively Q-switch and periodically poled LiNbO₃ (PPLN) as a frequency doubler. The output energy of the green laser is 1.96 μJ with the pulse-width of 15.6 ns. No green-noise problem exists in the green laser. Some theoretical results on the passive Q-switching and intra-cavity frequency-doubling are also discussed.     

Optimization of intracavity Q-switched laser frequency doubling

The optimization theory for intracavity frequency-doubled Q-switched lasers is discussed. Nonlinear loss effects caused by the frequency doubler were introduced into the rate equations. The harmonic pulse characteristics such as peak power, pulse energy, pulsewidth were studied. Lagrange multiplier technique was adopted to maximize the peak power of the second-harmonic pulse for a given pumping level. It was found that the optimal frequency-doubling factor is constant and equals 1. Design curves for the laser characteristics parameter were established. The curves and expressions presented help in designing an optimal Q-switched intracavity frequency-doubled miniature laser and predict the pulse characteristics.     

Characterization of laser-diode end-pumped intracavity frequency doubled, passively Q-switched and mode-locked Nd:YVO4 laser

Simultaneous Q-switching and mode-locking in a laser-diode end-pumped intracavity frequency doubled Nd:YVO₄/KTP green laser using Cr⁴⁺:YAG saturable absorber is experimentally demonstrated. The influence of the initial transmission (T₀) of the Cr⁴⁺:YAG crystal on the Q-switched mode-locked green pulses as well as on the average green power is characterized by using Cr⁴⁺:YAG crystal with various T₀. The effect of T₀ on the pulse build-up time in intracavity second harmonic configuration is theoretically investigated. It was found that the depth of modulation for the mode-locked pulses is greatly improved at the second harmonic wavelength as compared to that for the fundamental wavelength. The average pulse duration of the individual mode-locked pulse for the second harmonic beam measured to be less than 500 ps with a repetition rate of 400 MHz.