Convenient Deoxygenation of Aromatic Ketones by Silica-Supported Chitosan Schiff Base Palladium Catalyst

Abstract

A novel and effective catalytic system, silica-supported chitosan Schiff base palladium complex (SiO₂–CS–Schiff base–Pd) was described for catalytic hydrogenation of aromatic ketones to corresponding hydrocarbons at ambient temperature and normal pressure of H₂.     

Synthesis of gem-Dihydroperoxides from Ketones and Aldehydes Using Silica Sulfuric Acid as Heterogeneous Reusable Catalyst

Silica sulfuric acid (SSA) was found to efficiently catalyze the conversion of aldehydes and ketones directly into the corresponding gem-dihydroperoxides (DHPs) on treatment with aqueous 30% H₂O₂ at room temperature. Mild reaction conditions, good to excellent yields, short reaction times, low environmental impact, and recyclability of the catalyst are the main advantages of this synthetic method.     

Dicyano-Functionalized MCM-41-Supported Palladium Complex as An Efficient Catalyst for Allylation of Aldehydes and Ketones

Dicyano-functionalized MCM-41-supported palladium complex was prepared from dicyano-functionalized MCM-41 and palladium chloride. This complex exhibited high catalytic activity in the allylation of aldehydes and ketones with allylic chlorides in the presence of SnCl2. This polymeric palladium complex can be recovered and reused without noticeable loss of activity.     

Facile Protocol for Catalytic Frustrated Lewis Pair Hydrogenation and Reductive Deoxygenation of Ketones and Aldehydes

A series of ketones and aldehydes are reduced in toluene under H₂ in the presence of 5 mol % B(C₆F₅)₃ and either cyclodextrin or molecular sieves affording a facile metal‐free protocol for reduction to alcohols. Similar treatment of aryl ketones resulted in metal‐free deoxygenation yielding aromatic hydrocarbons.     

Mechanistic study of a Pd/C-catalyzed reduction of aryl sulfonates using the Mg-MeOH-NH(4)OAc system

A method for the deoxygenation of phenolic hydroxy groups via aryl triflates or mesylates has been established by using a combination of Pd/C-Mg-MeOH. The addition of NH(4)OAc to the system markedly accelerated the reaction rate and expanded the scope of the reaction. Mechanistic studies suggested that a single-electron transfer process from the Pd(0) center to the benzene ring is involved in the reduction of aryl sulfonates and that NH(4)OAc works as a solubilization reagent of the Mg salt and as an accelerator of the electron transfer, thus enhancing the reaction process. Our method was also applicable to the regioselective deuteration of benzene derivatives with CH(3)OD as the solvent and deuterium source: the original hydroxy group could be efficiently replaced with a deuterium atom.     

Reductive Amination of Aldehydes and Ketones with Primary Amines by Using Lithium Amidoborane as Reducing Reagent

A variety of secondary amines were obtained in high isolated yields in the reductive amination of aldehydes and ketones by using lithium amidoborane as reducing agent. Compared to ammonia borane, lithium amidoborane has higher reducibility, and thus, exhibits faster reaction rate.     

Selective Hydrogenation of Aromatic Aminoketones by Pd/C Catalysis

We report an alternative hydrogenation of aromatic aminoketones by heterogeneous catalyst of palladium on carbon (Pd/C) in which nitro, in particular carbonyl groups in the ketones, could be selectively transformed to corresponding amino ketone, secondary alcohol, or methylene compound.     

UC Pd: A New Form of Pd/C for Sonogashira Couplings

Screening of different sources of Pd/C shows reagents of highly variable nanoparticle sizes and oxidation states of the metal. Typically, catalysts with higher surface area are viewed as likely to be the more reactive. In this paper a new form of Pd/C, “UC Pd” is described that is shown to contain larger nanoparticles yet it is the most reactive catalyst of those sold commercially for Sonogashira coupling reactions. UC Pd functions efficiently in the absence of a copper co‐catalyst, under very mild and “green” conditions using inexpensive 95 % EtOH at 50 °C. It is also the only form of Pd/C that can be recycled. In side‐by‐side reactions with several commercially available forms of Pd/C, none compete successfully with UC Pd under standardized conditions. Physical data obtained from extensive surface analysis using TEM, XRD, XPS, and CO‐TPD measurements lead to an explanation behind the unique reactivity of this new recyclable form of Pd/C.     

Ir-Catalyzed Transfer Hydrogenation and Alkylation of Aldehydes and Ketones Using Ethanol as the Hydrogen Source

Bio-derived ethanol is a promising green and sustainable hydrogen-donor solvent. Herein, we have developed Ir-catalyzed transfer hydrogenation of ketones and aldehydes using ethanol as a hydrogen source with amides as simple ligands. Furthermore, the alkylation of ketones and tandem alkylation/transfer hydrogenation of acetophenones is reported with ethanol.     

Pd/C as Heterogeneous Catalyst for the Direct Arylation of (Poly)fluorobenzenes

The potential of the heterogeneous catalyst 10 % Pd/C in the direct arylation of (poly)fluorobenzene derivatives with aryl bromides has been investigated. In general, high yields of biaryl derivatives were obtained by using tri-, tetra-, and pentafluorobenzenes, whereas mono- and difluorobenzenes exhibited poor reactivity. The regioselectivities of the arylation reactions were similar to those observed with homogeneous palladium catalysts. Both electron-withdrawing and -donating substituents, such as nitrile, nitro, acetyl, ester, trifluoromethyl, tert-butyl, methoxy, or methyl, on the aryl bromide were tolerated. Unexpectedly, tetrafluoro-substituted [1,1′-biphenyl]-4-ols were obtained from pentafluorobenzene at 150 °C due to a formal regioselective hydroxylation, whereas at lower temperatures the expected pentafluorobiphenyls were obtained. However, no C−F bond cleavage was observed with the other polyfluorobenzene derivatives. These arylation reactions were carried out with only 1 mol % Pd/C as the catalyst and KOAc as an inexpensive base. Therefore, this protocol represents a very attractive access to (poly)fluoro-substituted biphenyls in terms of cost, simplicity, and sustainable chemistry because the Pd/C catalyst can be easily removed at the end of the reaction, there is no contamination with phosphine ligand residues, and the major side-product of the reaction is KOAc ⋅ HBr.     

Mild and Efficient Deoxygenation of Amine-N-oxides with BiCl3/Indium System

The BiCl₃/indium system was found to be a new reagent for deoxygenation of various amine-N-oxides to the corresponding amines in good to excellent yields under mild conditions.     

碱熔-碲共沉淀分离-ICP-OES法测定脱氧催化剂中的铂钯含量

采用碱熔-碲共沉淀分离富集、电感耦合等离子体发射光谱(ICP-OES)法测定脱氧催化剂中铂、钯的含量。研究了碱熔和碲共沉淀富集分离的条件,并确定了ICP-OES法测定铂、钯的条件。结果表明,过氧化钠熔解-碲共沉淀法能够充分分离富集样品中的铂、钯,方法的检出限分别为4.6μg/L,7.2μg/L;相对标准偏差分别为1.3%,1.5%;加标回收率分别为98.2%~101%,97.6~101%。方法简单可靠,完全满足样品中铂、钯含量分析的要求,已经应用于生产样品的分析。     

Mechanochemical Reaction of Aromatic Ketones and Aldehydes in the Presence of Zn-ZnCl2

The solvent-free reactions of aromatic ketones and aldehydes in the presence of Zn-ZnCl2 were performed with the aid of high-speed vibration mill, Retsch MM200 mixer mill and Retsch RM100 mortar grinder to give pinacol coupling and reduction products in varying yields.     

Mild and Efficient Deoxygenation of Sulfoxides with MoCl5/Indium System

It has been demonstrated that dialkyl, diaryl, and aryl alkyl sulfoxides can be efficiently converted into the corresponding sulfides by the reaction with a MoCl₅/In system in good to excellent yields under mild conditions.     

Pd/C: An efficient and reusable catalyst for the synthesis of flavones via carbonylation of aryl halides

This work describes an efficient and mild approach for the synthesis of flavones via catalytic carbonylation of aryl halides with 2‐hydroxyacetophenone using the commercial Pd/C as an efficient, heterogeneous and recyclable catalyst. Under balloon pressure of CO, 0.6 mol% Pd/C is sufficient for moderate yields of flavones for the carbonylation of aryl iodides under phosphine‐free conditions and aryl bromides in the presence of phosphine ligand. The catalyst is easily separable and shows significant recyclability. Moreover, the reaction mechanism was discussed, and a possible mechanism that contains two different cyclisation pathways was proposed.     

Polystyrene‐supported Pd(II)–N‐heterocyclic carbene complex as a heterogeneous and recyclable precatalyst for cross‐coupling of acyl chlorides with arylboronic acids

Palladium‐catalysed cross‐coupling reaction of aroyl chlorides with arylboronic acids was achieved in the presence of polystyrene‐supported palladium(II)–N‐heterocyclic carbene complex, using K₂CO₃ in acetone–water, providing diaryl ketones in high yields. Furthermore, the heterogeneous catalyst could be reused up to four times without significant loss of activity.     

分子氧氧化醇的研究进展

鉴于分子氧具有经济、环保、易得的优势,本文从均相催化、多相催化以及新材料的角度阐述了近年来液态醇选择氧化到醛酮的进展。着重介绍了过渡金属作为活性组分构成的催化体系,较详细的对新催化材料的研究做了一下归类,并对其在醇的氧化反应中的应用做了介绍,认为传统催化领域的研究仍然具有魅力,同时新材料的开发与运用在未来的具有诱人的前景。     

Ligand-free Sonogashira coupling reactions with heterogeneous Pd/C as the catalyst

A variety of aryl iodides were coupled with aromatic and aliphatic terminal alkynes to give the corresponding 1,2-disubstituted aromatic alkynes in good yields by using only 0.4 mol % of the heterogeneous 10 % Pd/C as the catalyst without a ligand, copper salt, or amine in an aqueous medium.