Characterization of semiconductor core-shell nanoparticles by resonant Raman scattering and photoluminescence spectroscopy

Colloidal CdSe nanoparticles (NPs), passivated with CdS and ZnS, were characterized by resonant Raman scattering and photoluminescence (PL). The effect of the passivating shell, its volume and formation procedure on optical and vibrational spectra is discussed. Analyzing the Raman peaks due to optical phonons inside the core and those related to the core-shell interface allows some understanding of the relation between the core-shell structure and its PL properties to be achieved. In particular, a compositional intermixing at the core/shell interface of the NPs was deduced from the Raman spectra, which can noticeably affect their PL intensity.     

Raman spectroscopic and photoluminescence study of single-crystalline SnO2 nanowires

Single-crystalline SnO₂ nanowires with sizes of 4-14 nm in diameter and 100-500 nm in length were produced in a molten salt approach by using hydrothermal synthesized precursor. Structural characters of the nanowires were examined by X-ray diffraction and high-resolution electron transmission microscopy. Raman, photoluminescence and X-ray photoelectron spectra of the samples were examined under heat treatments. Three new Raman modes at 691, 514 and 358 cm⁻¹ were recorded and assigned. The former two are attributed to activation of original Raman-forbidden A_2uLO mode and the third is attributed to defects in small-sized nanowires. A strong photoluminescence is observed at about 600 nm, the temperature effects is examined and the origin of the PL process is discussed via X-ray photoelectron spectra.     

Raman and photoluminescence spectroscopy of zinc tungstate powders

ZnWO₄ powders, synthesized using co-precipitation technique and annealed in air at different temperatures in the range of 80-, were studied by Raman and photoluminescence spectroscopy. ZnWO₄ single crystal was used for comparison. The interpretation of the observed variations of the Raman spectra and intrinsic photoluminescence band upon annealing is suggested.     

Decay dynamics of ultraviolet photoluminescence in ZnO nanocrystals

Time resolved photoluminescence (PL) measurements at low temperature are performed on colloidal ZnO nanocrystals dispersed in t-butanol. Considering the particle size dependence of the decay times we conclude that the luminescence is composed of two trap related emissions one of which undergoes lifetime shortening due to a non-radiative process. Initial fast shift of the spectrum within 30 ps is observed and it is interpreted as a fast hole cooling just after the excitation.     

A comparative study of microstructure of RuO2 nanorods via Raman scattering and field emission scanning electron microscopy

Raman scattering (RS) and field emission scanning electron microscopy (FESEM) have been used to extract microstructural information of RuO₂ nanorods (NRs) and a two-phase system comprising NRs embedded in polycrystalline matrix deposited on different substrates by the metal-organic chemical vapor deposition method. The red shifts and asymmetric broadening of the Raman line shape for the NRs are analyzed by the spatial correlation model. The deduced spatial correlation length l is found to be much smaller than that of the average size L₀ estimated from the FESEM images. The Raman features for the two-phase system can be resolved into two parts: a Lorentzian line shape feature corresponding to the polycrystallite at higher frequency side and an asymmetrically broadened NRs' signature located at lower frequency end. The volume fraction of NRs in the two-phase system can be determined from the analysis. These results demonstrate the significance of RS as a structural characterization method when used in conjunction with FESEM.     

Terahertz signatures of the exciton formation dynamics in non-resonantly excited semiconductors

A microscopic theory for the induced terahertz (THz) absorption of semiconductors is applied to study the time-dependent system response after non-resonant optical excitation. The formation of excitonic populations from an interacting electron-hole plasma is analyzed and the characteristic THz signatures are computed. Good qualitative agreement with recent experiments is obtained.     

Photoluminescence scanning on InAs/InGaAs quantum dot structures

The photoluminescence spectra of InAs quantum dots (QDs) embedded into four types of In_xGa_1−xAs/GaAs (x = 0.10, 0.15, 0.20 and 0.25) multi quantum well MBE structures have been investigated at 300 K in dependence on the QD position on the wafer. PL mapping was performed with 325 nm HeCd laser (35 mW) focused down to 200 μm (110 W/cm²) as the excitation source. The structures with x = 0.15 In/Ga composition in the In_xGa_1−xAs capping layer exhibited the maximum photoluminescence intensity. Strong inhomogeneity of the PL intensity is observed by mapping samples with the In/Ga composition of x ≥ 0.20-0.25. The reduction of the PL intensity is accompanied by a gradual “blue” shift of the luminescence maximum at 300 K as follows from the quantum dot PL mapping. The mechanism of this effect has been analyzed. PL peak shifts versus capping layer composition are discussed as well.     

Low-energy signatures of charge and spin fluctuations in Raman and optical spectra of the cuprates

We calculate the optical and Raman response within a phenomenological model of fermion quasiparticles coupled to nearly critical collective modes. We find that, whereas critical scaling properties might be masked in optical spectra due to charge conservation, distinct critical signatures of charge and spin fluctuations can be detected in Raman spectra exploiting specific symmetry properties. We compare our results with recent experiments on the cuprates.     

Porous silicon as efficient surface enhanced Raman scattering (SERS) substrate

Silver nanocrystallites are obtained through immersion of porous silicon samples in AgNO₃ solutions and a successive thermal annealing. The efficiency of nanostructures as surface enhanced Raman scattering (SERS) substrates is checked on cyanine-based dyes and horseradish peroxidase, evidencing detectable concentrations as low as 10⁻⁷ to 10⁻⁸ M. The substrate efficiency is strictly related to the Ag particle morphology, which could yield to either local surface plasmons (LSP) coupled to individual particles or to inter-particle short-range interaction.     

Nano-star formation in Al-doped ZnO thin film deposited by dip-dry method and its characterization using atomic force microscopy, electron probe microscopy, photoluminescence and laser Raman spectroscopy

Zinc oxide doped with Al (AZO) thin films were prepared on borosilicate glass substrates by dip and dry technique using sodium zincate bath. Effects of doping on the structural and optical properties of ZnO film were investigated by XRD, EPMA, AFM, optical transmittance, PL and Raman spectroscopy. The band gap for ZnO:Al (5.0 at. wt.%) film was found to be 3.29 eV compared with 3.25 eV band gap for pure ZnO film. Doping with Al introduces aggregation of crystallites to form micro-size clusters affecting the smoothness of the film surface. Al³⁺ ion was found to promote chemisorption of oxygen into the film, which in turn affects the roughness of the sample. Six photoluminescence bands were observed at 390, 419, 449, 480, 525 and 574 nm in the emission spectra. Excitation spectra of ZnO film showed bands at 200, 217, 232 and 328 nm, whereas bands at 200, 235, 257 and 267 nm were observed for ZnO:Al film. On the basis of transitions from conduction band or deep donors (CB, Zn_i or V_OZn_i) to valence band and/or deep acceptor states (VB, V_Zn or O_i or O_Zn), a tentative model has been proposed to explain the PL spectra. Doping with Al³⁺ ions reduced the polar character of the film. This has been confirmed from laser Raman studies.     

Design and fabrication of an intrinsically gain flattened Erbium doped fiber amplifier

We report design and subsequent fabrication of an intrinsically gain flattened Erbium doped fiber amplifier (EDFA) based on a highly asymmetrical and concentric dual-core fiber, inner core of which was only partially doped. Phase-resonant optical coupling between the two cores was so tailored through optimization of its refractive index profile parameters that the longer wavelengths within the C-band experience relatively higher amplification compared to the shorter wavelengths thereby reducing the difference in the well-known tilt in the gains between the shorter and longer wavelength regions. The fabricated EDFA exhibited a median gain ?28 dB (gain excursion below ±2.2 dB within the C-band) when 16 simultaneous standard signal channels were launched by keeping the I/P level for each at −20 dBm/channel. Such EDFAs should be attractive for deployment in metro networks, where economics is a premium, because it would cut down the cost on gain flattening filter head.     

On the contribution of nearly critical spin and charge collective modes to the Raman spectra of high-Tc cuprates

We discuss how Raman spectra are affected by nearly critical spin and charge collective modes, which are coupled to charge carriers near a stripe quantum critical point. We show that specific fingerprints of nearly critical collective modes can indeed be observed in Raman spectra and that the selectivity of Raman spectroscopy in momentum space may also be exploited to distinguish the spin and charge contribution. We apply our results to discuss the spectra of high-T_c superconducting cuprates finding that the collective modes should have masses with substantial temperature dependence in agreement with their nearly critical character. Moreover, spin modes should be more diffusive than charge modes indicating that in stripes the charge is nearly ordered, while spin modes are strongly overdamped and fluctuate with high frequency.     

The pressure effect on the photoluminescence and Raman spectra of Nd(DBM)3·Phen

Photoluminescence and Raman spectra of rare earth complex Nd(DBM)₃·Phen (DBM, dibenzoylmethane; Phen, 1,10-phenanthroline) are measured at high pressures. A new Raman band appearing at 1070 cm⁻¹ indicates a second-order phase transition around 5.0 GPa. Although the crystal lattice is destroyed for pressures higher than 7.1 GPa, photoluminescence spectra show that the emission intensity of Nd³⁺ is enhanced dramatically with the pressure increasing up to 9.9 GPa, which is attributed to an efficient intramolecular energy transfer from the ligand to Nd³⁺. By analyzing the energy of the ground and excited states at 9.9 GPa, the ⁴H_11/2 energy level is considered as the main resonance energy level that efficiently accepts the transferred energy from the ligand.     

Dispersion measurement technique based on the self-seeding laser oscillation of a Fabry-Perot laser diode

A simple dispersion measurement technique has been proposed and demonstrated by using the self-seeding laser oscillation of a Fabry-Perot laser diode through an optical closed-loop path. When the multi-mode optical pulses emitted from the laser are re-injected into the laser after traversing a fiber-under-test, a single mode laser oscillation occurs through the closed-loop path due to the group velocity difference between the pulses of different wavelengths. We measured the dispersion parameter of the fiber-under-test from the modulation frequency changes required to induce single-mode laser oscillations through the optical closed-loop path. The maximum measurement error was less than 1.5% for the optical fibers as compared with a commercial instrument.     

Fabrication of highly ordered and stepped ZnO comb-like structures

Highly ordered and stepped ZnO comb-like structures were fabricated using conventional thermal evaporation method. Zn powder covered by a layer of a mixture of ZnO and graphite was employed as the Zn source. The obtained ZnO comb-like structures are several tens of micrometers and some of them are even up to 100 μm. Both the widths of the belts and the lengths of the branches gradually decrease along the growth direction of ZnO comb-like structures. Under the most suitable condition, ZnO nanorods branches have uniform diameters and are evenly distributed on the belt-like stem. Possible growth process of ZnO comb-like structures was discussed. The effect of growth temperature on the morphology of the obtained products was also investigated. Room-temperature photoluminescence spectra from the ZnO comb-like structures and the nanorods film reveal weak UV emission and strong green emission.     

General theory for the interference of two-photon and one-photon processes in semiconductor heterostructures

We develop a general theory for the dynamics of multi-photon processes in semiconductor heterostructures. The resulting effective multi-band Bloch equations describe the dynamics of electrons in the reduced set of bands between which the optical pulses induce quasi-resonant transitions. The model is specialized to the case of interfering one- and two-photon transitions across the band gap. The withdrawn bands are included as intermediate states for an effective interaction that is quadratic in the electromagnetic fields. The benefit of this perturbative approach is to lead to equations of motion for slowly varying quantities only, in the spirit of the rotating wave approximation. Coulomb interaction and relaxation can also easily be included. Finally, a general expression for the time dependent polarization current that is consistent with the approximations involved by the effective multi-band Bloch equations is derived.     

Non-intrusive polarization dependent loss monitoring in fiber-optic transmission systems

A method for non-intrusively monitoring the polarization dependent loss (PDL) of an installed fiber-optic transmission system is proposed using live dense wave division multiplexing (DWDM)-based traffic as the probing signal. The method extracts the statistical parameters of system PDL from the measured partial PDL data. Field measurements of PDL were performed on long-haul DWDM systems deployed in Sprint’s network and the results validated our theoretical model.     

Influence of hydrogenation on the structure and visible photoluminescence of germanium oxide thin films

Substoichiometric germanium oxide thin films were prepared by evaporation of GeO₂ powder. The as-deposited samples showed a luminescence band in the visible range. Hydrogen was used to passivate the dangling bond defects and therefore to determine the origin of photoluminescence in the germanium oxide films. Hydrogen was introduced in the films from an electron cyclotron resonance (ECR) plasma source during or after the evaporation. The films hydrogenated during evaporation contain little oxygen because of an etching mechanism. In the post-hydrogenated films, the oxygen content is higher. With the hydrogenation treatment, the oxygen dangling bonds are suppressed. It is proposed that the photoluminescence in the visible range is attributed to the structural defects.     

Rapid and quantitative detection of ethanol proportion in ethanol-gasoline mixtures by Raman spectroscopy

The paper reports a Raman spectral in-situ detection technique to measure the ethanol proportion in an ethanol-gasoline mixture rapidly and quantitatively. The transformed information of Raman spectra for different mixtures of gasoline and ethanol have been observed and recorded. The relative intensity ratio of two typical Raman peaks for ethanol and gasoline satisfies a linear relation with a variation in volume ratio which could be used as a quantitative measure. This method, compared with the direct intensity measurement of a Raman peak, may not only eliminate the random measurement error due to dark current, but also confirm the accurate the proportion of ethanol and gasoline.