A titanium-rich (111) surface of SrTiO3 single crystals by thermal annealing

A very smooth (111) titanium-rich surface was obtained by annealing SrTiO₃ single crystals in UHV. The surface structure was investigated with SEM, STM and LEED and was found to consist of terraces, interrupted by multi-unit-cell high steps, obviously a result of step bunching. The surface unit cell, is enlarged as a result of our particular preparation procedure. Received: 18 December 1996/Accepted: 18 December 1996     

Surface states calculation for the (100), (110) and (111) faces of Si

Using essentially the Heine and Jones model of the band structure for diamond-type semiconductors and a 3-dimensional surface state secular equation, we have calculated the bands of surface states for the (100), (110) and (111) orientations of the surface plane of ideal Si. Our bands for the (110) surface are very similar to those obtained by Jones. Based on these bands of surface states, we can explain reasonably both optical and electrical measurements on the (111) surface.     

Angular distributions of H2 desorbed from the (100), (110), and (111) faces of copper crystals

The angular distributions of hydrogen molecules desorbed from copper have been measured for single-crystal surfaces of three different orientations: (100), (110), and (111). The surfaces were cleaned to the degree that the impurities were below the level of detection by Auger electron spectroscopy. The angular distributions were all significantly more peaked at the surface normal than the distribution corresponding to diffuse emission, i.e., where the molecular flux is proportional to cos θ, where θ is the angle measured from the surface normal. We have characterized the observed angular distributions by fitting the emperical expression cos^dθ to the data, where d is an adjustable parameter. The results are: d ≈ 5 for (100); d ≈ 2.5 for (110); d ≈ 6 for (111). The distributions are nearly symmetric about the azimuthal angle between the plane of detection and the principal axes of the surface lattice. Possible models are considered.     

High-resolution photoemission from Ag(100), Ag(110), and Ag(111)

Energy distribution curves of photoelectrons emitted normal to (100), (110), and (111) faces of silver have been obtained at photon energies of 21.22, 16.85, and 11.83 eV. The results are compared with Christensen's relativistic band structure calculation of bulk silver yielding a close correspondence between experiment and theory. A surface state in the L gap immediately below the Fermi level is identified.     

Cu(100),(111),(110)表面晶格振动和力常数

采用嵌入原子方法得到了描述Cu基态相互作用性质的半经验函数;推导了表面面间力常数的计算公式,并计算了Cu(100),(111),(110)表面面间力常数,由此揭示了原子间相互作用在体内和在表面附近的区别,以及它们在不同表面结构中的差异。采用递推方法计算了相应的表面振动的投影态密度,与电子能量损失谱(EELS)所得到的实验结果符合得较好。 关键词：     

Relaxation and electronic states of Au(100), (110) and (111) surfaces

Using a first-principles method based on density functional theory, we investigate the surface relaxation and electronic states of Au(100), (110) and (111) surfaces. The calculated results show that the relaxations of the (100) and (110) surfaces of the metal are inward relaxations. However, the Au(111) surface shows an ‘anomalous’ outward relaxation, although several previous theoretical studies have predicted inward relaxations that are contrary to the experimental measurements. Electronic densities of states and the respective charge density distribution along the Z-axis of the relaxed surfaces are analyzed, and the origin of inward and outward relaxation is discussed in detail.     

Angle-resolved resonant photoemission of Ni(100) and Ni(110) single crystals

We have studied the valence band photoemission spectra of Ni(100) and Ni(110) single crystals near the excitation threshold for 3p core electrons. The resonant behavior of the 6 eV satellite does not depend on both the surface orientation and the polarization of the electric vector of an incident light for excitation. These results indicate that the 6 eV satellite should be under little influence of spatial symmetry of the valence band. In the angle-resolved photoemission spectra of Ni(100), we have observed another broad feature near the 6 eV satellite. It shows the large energy dispersion and is interpreted as due to the interband transition. In Ni(110), we have observed the weak valence band satellites at binding energies of about 9.3 eV and 13.4 eV. They do not show well-defined resonance around the 3p threshold.     

Planar channeling of helium ions along (100), (110) and (111) MgO

Planar channelling of 1, 1.5 and 2 MeV ⁴He⁺ ions along (100), (110) and (111) MgO have been studied experimentally using Rutherford backscattering. Values of the half angle $\text{ψ}{}^{\mathrm{P}}{}_{\mathrm{<mtext>1</mtext><mtext>2</mtext>}}$, shoulder half angle $\text{ψ}{}^{\mathrm{s}}{}_{\mathrm{<mtext>1</mtext><mtext>2</mtext>}}$ and surface minimum yield x^P_min have been determined for channelling with respect to the two sublattices. Agreements and discrepancies with existing theories are discussed.     

Strain-gradient-induced polarization in SrTiO3 single crystals

Piezoelectricity is inherent only in noncentrosymmetric materials, but a piezoelectric response can also be obtained in centrosymmetric crystals if subjected to inhomogeneous deformation. This phenomenon, known as flexoelectricity, can significantly affect the functional properties of insulators, particularly thin films of high permittivity materials. We have measured strain-gradient-induced polarization in single crystals of paraelectric SrTiO3 as a function of temperature and orientation down to and below the 105 K phase transition. Estimates were obtained for all the components of the flexoelectric tensor, and calculations based on these indicate that local polarization around defects in SrTiO3 may exceed the largest ferroelectric polarizations. A sign reversal of the flexoelectric response detected below the phase transition suggests that the ferroelastic domain walls of SrTiO3 may be polar.     

The (100), (111) and (110) surfaces of diamond: an ab initio B3LYP study

We present an accurate ab initio study of the structure and surface energy of the low-index (100), (111) and (110) diamond faces, by using the hybrid Hartree–Fock/density functional B3LYP Hamiltonian and a localised all-electron Gaussian-type basis set. A two-dimensional periodic slab model has been adopted, for which convergence on both structural and energetic parameters has been thoroughly investigated. For all the three surfaces, possible relaxations and reconstructions have been considered; a detailed geometrical characterisation is provided for the most stable structure of each orientation. Surface energy is discussed for all the investigated faces.     

Steady state shapes of periodic profiles on (110), (100), and (111) surfaces of nickel

Periodic surface profiles with amplitudes of ≦0.4 μm and periodicities of 4–20 μm were prepared on Ni(110), (100), and (111) single crystal surfaces. These crystals were annealed in ultra-high vacuum (UHV) at 1073–1327 K after they had been cleaned by Ar ion bombardment and investigated by Auger electron spectroscopy. The geometry of the profiles was studied in UHV by laser diffraction and outside the vacuum by interference microscopy. The profiles have sinusoidal shapes on Ni(110) but trapezoidal shapes on both the (100) and (111) surfaces. This type of faceting can be understood on the basis of the anisotropic surface energy of Ni, with cusps at the (100) and (111) orientations. Model calculations show in the case of anisotropic surface energy that periodic profiles develop facets which correspond to the low surface energy orientations (close-packed surfaces).     

Interaction of carbon dioxide with Fe(110), stepped Fe(100) and Fe(111)

The adsorption of CO₂ on single crystal surfaces of Fe(110), regularly stepped Fe(110) and Fe(111) in the temperature range between 77 and 340 K was studied by means of He(I) UPS and measurements of the change in work function. The smooth Fe(110) face proved to be completely inactive with respect to CO₂ adsorption. On a stepped Fe(110) and an Fe(111) face CO₂ is adsorbed at 77 K in the form of a linear molecule and in the form of a species the nature of which is not yet clarified. This latter form is predominant at 140 K. With increasing temperature decomposition into CO and O and finally into C and O takes place.     

Directional UV photoemission from clean and sulphur saturated (100), (110) and (111) nickel surfaces

Angle resolved photoemission energy distribution curves (EDC's) were obtained on clean and sulphur saturated (100), (110) and (111) nickel surfaces for excitation energies equal to 10.2, 13.5, 16.8 and 21.2 eV. The EDC's of clean surfaces are weakly structured at θ = 0° and become more rich in features for oblique angles. In the explored energy range, adsorption of sulphur produces two extra-structures at initial energies depending on surface orientation. One of which situated at about ?4.5 eV below the Fermi level is in good agreement with Hagstrum ion neutralization spectroscopy results, the other at around ?1.8 cV has never been observed before. A remarkable similarity of adsorption effects on the three surfaces is found. These results are compared with experimental data obtained previously on equivalent sulphur saturated surfaces by INS and discussed in relation to recent theoretical calculations on chalcogen adsorption on nickel.     

Adsorption of silver on (001), (011) and (111) oriented tungsten single crystals

Work function changes caused by silver adsorption were measured on (001), (011) and (111) tungsten single crystal planes using electron beam method. The decrease of the work function was observed on all planes studied in the small coverage region. The result evidences that the increase previously observed for the average work function in this coverage region can not be connected with negative dipole formation with silver atoms.     

Oxygen adsorption on the LaB6(100), (110) and (111) surfaces

Oxygen adsorption on the LaB₆(100), (110) and (111) clean surfaces has been studied by means of UPS, XPS and LEED. The results on oxygen adsorption will be discussed on the basis of the structurs and the electronic states on the LaB₆(100), (110) and (111) clean surfaces. The surface states on LaB₆(110) disappear at the oxygen exposure of 0.4 L where a c(2 × 2) LEED pattern disappears and a (1 × 1) LEED pattern appears. The work function on LaB₆(110) is increased to ～3.8 eV by an oxygen exposure of ～2 L. The surface states on LaB₆(111) disappear at an oxygen exposure of ～2 L where the work function has a maximum value of ～4.4 eV. Oxygen is adsorbed on the surface boron atoms of LaB₆(111) until an exposure of ～2 L. Above this exposure, oxygen is adsorbed on another site to lower the work function from ～4.4 to ～3.8 eV until an oxygen exposure of ～100L. The initial sticking coefficient on LaB₆(110) has the highest value of ～1 among the (100), (110) and (111) surfaces. The (100) surface is most stable to oxygen among these surfaces. It is suggested that the dangling bonds of boron atoms play an important role in oxygen adsorption on the LaB₆ surfaces.     

Temperature dependence of photo-hole decay in 4d derived Quantum Well States in monolayer Ag(111) films on Pd(111), Ni(111), Mo(110) and Cu(100)

We present experimental data on the temperature dependence of photo-hole decay obtained by Angle Resolved Photoemission (ARPES) measurements from 4d derived Quantum Well States (QWS) on Ag(111) monolayer films deposited on Pd(111), Ni(111), Mo(110) and Cu(100). We have found a significant increase of the Ag 4d electron–phonon (e-ph) coupling strength with respect to the bulk values. The increase is attributed to different mechanisms that are associated with the interaction of the Ag film with under laying substrate. It is proposed that the main channels that contribute to the increased e-ph coupling originate from the inter-band transitions that involve bulk states of the substrates.