Renormalization phenomena in Ba-diluted ferroelastic lead phosphate, (Pb1-x Ba x )3(PO4)2

Abstract

In the improper ferroelastic palmierite-type lead phosphate order parameter coupling with a defect induced conjugate field leads to the renormalization of the two different critical temperatures of three order parameter components {Q ₃} and {Q ₁ Q ₂}. The influence of the lead dilution by barium on the ferroelastic domain pattern, the critical temperature of the ferroelastic transformation R m–C2/c and the development of the intermediate regime in (Pb_1–x Ba _x )₃(PO₄)₂ is studied using optical birefringence measurements, Raman and infrared spectroscopy. At the ferroelastic transition temperature T _c the orientational contribution of the three-states Potts model becomes critical. T _c is reduced from 453 K (x = 0) to zero K at x? 0.12. Modifications of the shape of zigzag needle domains as well as the angle between the monoclinic binary axis and the W walls along [031] with temperature and increasing Ba-content are reported. Above the ferroelastic transition point the component Q ₃, which corresponds to the displacive part in the Gibbs free energy, leads to dynamic short-range monoclinic deformation in the trigonal matrix. The temperature where Q ₃ shows critical behaviour is renormalized to 720 K (x = 0.12) as compared with 563 K in pure lead phosphate. For x>0.13 no monoclinic precursor clusters were found.     

Synchrotron‐based X‐ray diffraction of the lead apatite series Pb10(PO4)6Cl2–Pb10(AsO4)6Cl2

A number of compounds of the pyromorphite–mimetite solid solution series were synthesized at room temperature and analyzed with infrared spectroscopy and powder X‐ray diffraction. High‐resolution high‐quality powder diffraction data were obtained by means of the state‐of‐the‐art instrument at the 11‐BM beamline of the Advanced Photon Source at Argonne National Laboratory, Argonne, IL, USA. The unit‐cell dimensions, atomic position and atomic displacement parameters, as well as site occupancy for analyzed phases, were refined by the Rietveld method and reported herein for the first time. The results of this study indicate that the pyromorphite–mimetite series is continuous in near‐Earth‐surface environments. Detailed structural changes caused by P⁵⁺–As⁵⁺ substitutions in minerals from the pyromorphite–mimetite solid solution series are reported.     

The Mössbauer spectrum of synthetic hureaulite: Fe5 2+(H2O)4(PO4H)2(PO4)2

The crystal structure of synthetic ferrous hureaulite, Fe₅ ²⁺ (H₂O)₄(PO₄H)₂(PO₄)₂, was refined from single-crystal X-ray data. It is monoclinic, space group C2/c, with a=17.487(4), b=9.017(2), c=9.338(2) Å, β=96.27(3)°, V=1463.6(6) Å³, Z=4 and D _calc=3.327 g/cm³. This end member of the hureaulite series was crystallized under distinctly acidic conditions, by a method that gives perfect crystals, large enough for X-ray single crystal studies. The main feature of the hureaulite structure is that it has an equal number of normal (PO₄)³⁺ and acid (PO₄H)²⁺ tetradentate groups. These are centered on Fe²⁺ atoms and share corners with edge-linked octahedra, forming pentamer units. The five Fe²⁺ atoms are distributed on three distinct sites in these units. This can be directly observed in the Mössbauer spectrum at 295 K, which contains three doublets whose relative intensities correspond to the 1:2:2 distributions of crystallographic sites.     

Raman spectroscopic study of the uranyl phosphate mineral dumontite Pb2 [(UO2)3O2(PO4)2]·5H2 O

Raman spectra of dumontite were measured at 298 and 77 K. Observed bands were attributed to the stretching and bending vibrations of uranyl and phosphate units and OH stretching vibrations of water molecules. U–O bond lengths in uranyls and approximate O–H···O bond lengths were calculated. The values of the U–O bond lengths are in agreement with the data from the single crystal structure analysis of dumontite. Copyright © 2008 John Wiley & Sons, Ltd.     

Order-disorder transition in Na3Bi(PO4)2

Na₃Bi(PO₄)₂ exhibits several phase transitions at about 575, 820 and 905°C. The structure was determined at ambient temperature (α-form) and above the first transition (β-form). The α-form cell is monoclinic with a = 19.86(1), b = 5.353(6), c = 13.96(3) Å, β = 110.64(7)°, Z = 8, space group P2₁/ _c ; the structure was solved from 3769 independent reflections to an R value, calculated on intensities, of 0.069. The β-form cell is orthorhombic with a = 18.71(3), b = 7.18(2), c = 5.429(7) Å, Z = 4, space group Pnam; the structure was solved to an R value, calculated on structure factors, of 0.055 using intensities of 858 unique reflections measured on a single crystal at 650°C. Both structures are related to that of glaserite. At high temperature, one of the PO₄ tetrahedra is statistically disordered over two positions related by the m-mirror. Below the transition, ordering of this ion leads to a unit cell of lower symmetry. At the transition, two individuals grow on the two sides of the m-mirror which disappears; thus, at ambient temperature, the crystals are systematically twinned. Above the second transition, the unit cell is hexagonal.     

X-ray and Mössbauer study of structural changes in K3Na(FeO4)2

Mixed potassium–sodium ferrate(VI), K₃Na(FeO₄)₂, has been synthesized by precipitation from alkaline solution. At room temperature it decomposes spontaneously giving Fe(III) compounds and ferrate(VI) with a structure similar to that of K₂FeO₄, which is confirmed by X-ray diffraction and Mössbauer spectroscopy.     

Structural and electrical impedance study of Pb(Sr1/3Nb2/3)O3

Lead-based ceramic Pb(Sr_1/3Nb_2/3)O₃ (PSN) is prepared by the columbite precursor method and structurally characterized using XRD. The X-ray diffraction shows a perovskite structure with cubic pyrochlore phase. Detailed studies of ε′ and ε″ of the compounds show that the compounds exhibit dielectric anomaly. Impedance spectroscopy is used to characterize the electrical behaviour. Results indicate that the relaxation mechanism of the material is temperature dependent and has dominant bulk contribution in different temperature ranges. Modulus spectroscopic data were used to gain an insight into the electrical properties of the samples and with a view to observe the relaxations in them. Frequency dependence dielectric permittivity shows typical Debye-type dielectric dispersion. Temperature-dependent DC resistivity shows that resistance decreases with the increase in temperature and follows Arrhenius behaviour in different temperature regions.     

新型特效Na离子吸附剂Li1+xAlxTi2-x(PO4)3的光谱研究

采用高温固相法合成了新型特效Na离子吸附剂Li1 xAlxTi2-x(PO4)3.用XRD,FTIR,Raman等手段研究了其结构形态;对材料的激光拉曼光谱和红外光谱进行了研究和指认;并对其吸附性能进行了研究.结果表明少量Al的加入未影响到LiTi2(PO4)3的晶体结构,但使Li1 xAlxTi2-x(PO4)3对Na离子产生了特效吸附作用,可用于高纯锂盐制备过程中微量杂质钠离子的分离.其最佳吸附条件为:当x=0.4时,在pH值为10.0～11.0条件下,Li1 xAlxTi2-x(PO4)3的吸附容量达到11.76 mg·g-1.     

High pressure X-ray diffraction study on icosahedral boron arsenide (B12As2)

The high pressure properties of icosahedral boron arsenide (B₁₂As₂) were studied by in situ X-ray diffraction measurements at pressures up to 25.5 GPa at room temperature. B₁₂As₂ retains its rhombohedral structure; no phase transition was observed in the pressure range. The bulk modulus was determined to be 216 GPa with the pressure derivative 2.2. Anisotropy was observed in the compressibility of B₁₂As₂—c-axis was 16.2% more compressible than a-axis. The boron icosahedron plays a dominant role in the compressibility of boron-rich compounds.     

Structural study by X-ray diffraction and Mössbauer spectroscopy of a new synthetic iron phosphate: K4MgFe3(PO4)5

A new iron phosphate K₄MgFe₃(PO₄)₅ has been synthesized by the flux method and characterized by single-crystal X-ray diffraction and Mössbauer spectroscopy. It crystallizes in the tetragonal system with the space group and the unit cell parameters a=9.714(3) Å and c=9.494(5) Å. The crystal structure is of a new type. It exhibits a three-dimensional framework built up from corner-sharing MO₅ (M=0.75Fe+0.25Mg) trigonal bipyramids and PO₄ tetrahedra. The K⁺ ions are occupying large eight-sided tunnels running along c. A room temperature Mössbauer study confirmed the +3 valence state of iron and its five-coordination.     

Inelastic neutron scattering study of the ferroelastic phase transition of lead phosphate (PO4)2Pb3

A soft phonon mode is observed above 395°C at zone boundary points of the high temperature β phase. A quasi-elastic scattering exists above the ferroelastic transition at 180°C and progressively vanishes when the temperature is raised. A cross over from 3d to 2d regime is observed in the same temperature range.     

Dielectric properties of Pb(Mg1/4Zn1/4Nb1/2)O11/4

Polycrystalline samples of Pb(Mg_1/4Zn_1/4Nb_1/2)O_11/4 have been synthesized by high temperature columbite precursor solid state reaction technique. Using X-ray diffraction (XRD) technique, compound formation in single phase cubic structure was observed and XRD analysis provided preliminary structural data. Detailed studies of dielectric properties of the compound reveal that this compound has high dielectric constant and diffuse phase transition in a wide range of temperatures around the Curie temperature. The charge deficiency of the compound presumably gets compensated in the high temperature columbite precursor process of sample preparation which is supported by single phasic form of the material.     

Synthesis and properties of a new copper(II)-hafnium phosphate Cu0.5Hf2(PO4)3

Phosphates of general formula M_0.5Hf₂(PO₄)₃ with M=Cd²⁺, Ca²⁺, Sr²⁺ and Cu²⁺ were prepared by coprecipitation and characterized by several physical techniques. The compounds containing Cd²⁺, Ca²⁺, Sr²⁺ belong to the Nasicon-type structure, whereas Cu_0.5Hf₂(PO₄)₃ exhibited substantially different DRX patterns. Combined temperature programmed reduction (TPR) and temperature-programmed oxidation (TPO) showed that the copper in Cu_0.5Hf₂(PO₄)₃ was distributed between two energetically different sites in proportions respectively equal to 40 and 60%. Electron Paramagnetic Resonance (EPR) investigations confirmed the TPR/TPO results and revealed that the two sites hosting the Cu²⁺ ions are of orthorhombic symmetry. Moreover, the Cu²⁺ ions might be reduced by hydrogen to Cu⁺. These results were also supported by the UV–visible studies that showed the disappearance, under reducing conditions, of the band corresponding to crystal field transitions of Cu²⁺ ions and the emergence of a new peak attributed to the transitions between (3d)¹⁰ and (3d)⁹(4s)¹ Cu⁺ levels. At the same time, IR spectroscopy confirmed that protons entered the open lattice framework of the material and gave rise to a new protonated phase containing monovalent copper Cu_0.5^IH_0.5Hf₂(PO₄)₃. This redox process was proven to be reversible without any subsequent change in the network of the phosphate.     

Neutron diffraction study of ammonium tartrate (NH4)2C4H4O6

A neutron diffraction study of ammonium tartrate has been carried out. Using the diffractometer in symmetrical setting, intensities of 750 reflections have been measured. The positions of all the hydrogen atoms have been determined. A good agreement is noticed between the present neutron and the earlier x-ray heavy atom parameters. The tartrate ion consists of two nearly identical planar halves, with an interplanar angle of 62°. Tre structure is stabilized by a net-work of hydrogen bonds. Details of hydrogen bonding and the ammonium ions environment are discussed.