Asymmetric radical polymerization of butadiene 1-carboxylic acid

Optically active S(?)-α-phenethylammonium butadiene 1-carboxylate was prepared and polymerized in methanol, using azobisisobutyronitrile as initiator. The optical rotation, optical rotatory dispersion and circular dichroism spectra of the polymers, before and after removal of chiral amine, have demonstrated that the asymmetric induction occurred in the main chain. An asymmetric inductive polymerization mechanism is discussed.     

Effect of pH on radical polymerization of butadiene 1-carboxylic acid in aqueous solutions

Radical polymerization of butadiene 1-carboxylic acid (Bu-1-Acid) was carried out in aqueous solutions at 50°C with ammonium persulfate (APS) as an initiator. Kinetic studies led to the rate equation, R_p = k[APS]^1/2 [Bu-1-Acid]¹ at pH 6.8. The overall activation energy for the polymerization was 16.0 kcal/mole. The polymerization rate R_p of Bu-1-Acid decreased with an increase of pH in the range 2.4–6.8 and increased with an increase of pH in the range 6.8–8.4. Moreover, in the pH range 8.4–13, the rate of polymerization was not affected by the pH of the system. In copolymerization with acrylonitrile, the trends of changes in the monomer reactivity ratios r₁, r₂ and Q-e values caused by changes in pH were similar to trends found in homopolymerization described above. In addition, it was observed that the resultant polymer was extended in alkaline solution and contracted in acidic solution.     

Radical polymerization of butadiene-1-carboxylic acid

The homopolymerization and copolymerization of butadiene-1-carboxylic acid (Bu-1-Acid) (M₁) were studied in tetrahydrofuran at 50°C with azobisisobutyronitrile as an initiator. The initial rate of polymerization was proportional to [AIBN]^1/2 and [Bu-1-Acid]¹. The overall activation energy for the polymerization was 22.87 kcal/mole. For copolymerization with styrene (M₂) and acrylonitrile (M₂), the monomer reactivity ratios r₁, r₂ were determined by the Fineman-Ross method, as follows; r₁ = 5.55, r₂ = 0.08 (M₂ = styrene); r₁ = 11.0, r₂ = 0.03 (M₂ = acrylonitrile). Alfrey-Price Q-e values calculated from these values were 6.0 and +0.11, respectively. The Bu-1-Acid unit in the copolymer as well as the homopolymer was found from infrared and NMR spectral analyses to be composed of a trans-1,4 bond. The hydrogen-transfer polymerization of Bu-1-Acid leading to polyester was attempted with triphenylphosphine as initiator, but did not occur.     

Effect of solvent on radical polymerization of vinyl benzoate

Absolute rate constants of the vinyl benzoate polymerization have been measured by use of the intermittent illumination method in various aromatic solvents and ethyl acetate at 30°C. The determination of absolute rate constants showed that effects of solvent on the polymerization rate of vinyl benzoate were mainly ascribed to the variation of k_p values with solvents rather than that of k_t values. The k_p values for solvents used increased in the order: benzonitrile < ethyl benzoate < anisole < chlorobenzene < benzene < fluorobenzene < ethyl acetate. There was an eightfold difference between the largest and the smallest values The large variation among k_p values was explained neither by the copolymerization through solvents nor the chain transfer to solvents, but by a reversible complex formation between the propagating radical and aromatic solvents. This explanation was supported by a correlation between k_p values and calculated delocalization stabilizations for the complexes.     

Effect of DMSO used as solvent in copper mediated living radical polymerization

The use of DMSO as solvent for transition metal mediated living radical polymerization was investigated using copper (I) bromide/N‐(n‐propyl)‐2‐pyridyl‐methanimine catalyst system and ethyl‐2‐bromoisobutyrate as initiator. The best conditions for polymerization in DMSO of different methacrylates (MMA, BMA, DMAEMA, HEMA) were determined. In all cases, the measured number‐average molar mass of the product increased linearly with monomer conversion in agreement with the theoretical M_n with low polydispersity products (1.16 < PDI < 1.4) achieved. Solvent was found to play a crucial role in the process. The effect of the polar solvent has been investigated and it was shown that DMSO could coordinate copper (II), increasing the activation process, or copper (I), changing the nature of the copper catalyst by competitive complexation of ligand and DMSO. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 6299–6308, 2004     

Controlled/living radical polymerization of isoprene and butadiene in emulsion

A process for RAFT-controlled radical polymerization in emulsion [36] has been applied to the polymerizations of isoprene and of butadiene in emulsion systems, with the goal of producing latex particles containing block copolymers of acrylic acid (stabilizer and starting polymer), styrene (second polymer) and isoprene or butadiene (third polymer). The microstructure of the polymer chains was examined using dual-detection size-exclusion chromatography, and the nanostructure of the materials was investigated by differential scanning calorimetry and solid-state nuclear magnetic resonance. Reactions were always slow (although faster than the corresponding processes in solution), and exhibited limited reinitiation by isoprene when in emulsion. The materials containing isoprene exhibit a nanostructure with a phase separation into high-T_g polystyrene-rich domains and low-T_g polyisoprene-rich domains, revealed by DSC and NMR. This has the potential to lead to barrier materials with novel physical properties.     

Effect of solvent on chain propagation and termination reaction rates in radical polymerization

The radical polymerizations of acrylamide and methacrylamide and of acrylic, methacrylic and fluoroacrylic acids have been studied in various solvents. The nature of the solvent affects the overall rate due to changes in k_p and E_p. It has been shown that the effect of solvent also depends on the nature of the monomer. A possible explanation of the observed behaviour is discussed.     

Effect of solvent on the termination rate constant in initial stages of free radical polymerization

The effect of solvent on the termination rate constant K_t, in the initial stages of free radical polymerizations has been estimated by considering its effect on the viscosity of the medium and on the overall dimensions of the macroradicals. The expression derived predicts that K_t is inversely proportional to the viscosity of the reaction medium, η₀, and that K_t, increases as the overall dimensions of the radicals decrease in poorer solvents. The effect of solvent on the η₀K_t, product depends on the average size and concentration of polymer in the system. For relatively high concentrations of high-molecular-weight polymers η₀K_t can be greater in a better solvent than in a poorer solvent. This trend would be reversed for low concentrations and/or low polymer molecular weights. Good agreement has been found between experimental and estimated values of η₀K_t.     

Chain transfer to solvent in BN 2-vinylnaphthalene radical polymerization

The synthesis of vinyl alcohol copolymers is limited due to the poor radical reactivity of vinyl acetate (VAc), the traditional precursor to polyvinyl alcohol (PVA). Main group monomers such as BN 2-vinylnaphthalene (BN2VN) have attracted attention as alternatives to VAc to form side chain hydroxyls via oxidation, but outstanding questions of molecular weight control remain. Herein we report systematic investigation of solvent, temperature, and initiator concentration as factors influencing BN2VN degree of polymerization. We find increased chain transfer to toluene, hypothesized to arise from differences in radical stabilization and reactivity by aromatic and BN aromatic rings. As a result of these combined efforts, high molecular weight (M_w ~ 10⁵ g mol⁻¹) BN2VN homopolymers and BN2VN-styrene copolymers were obtained.     

Synthesis of 1-aminocyclopropane-1-carboxylic acid

A three-stage method of synthesizing the natural plant growth regulator 1-aminocyclopropane-l-carboxylic acid by the interaction of cyanoacetic ester with 1,2-dibromoethane has been studied.Institute of the Chemistry of Plant Substances, Academy of Sciences of the Republic of Uzbekistan, Tashkent, fax (3712) 89 14 75. Translated from Khimiya Prirodnykh Soedinenii, No. 6, pp. 855—857, November-December, 1995. Original article submitted November 28, 1994.     

Electroinitiated polymerization of butadiene sulfone

Electroinitiated polymerization of butadiene sulfone was achieved by direct electron transfer in acetonitrile—tetrabutylammonium fluoroborate system by controlled potential electrolysis technique. High conversions were obtained at reasonable temperatures and polymerization times. The polymer was found to be composed of linear segments along with some cyclic units. The effect of monomer concentration, temperature, and polymerization potential on the rate of polymerization was investigated. Temperature and polymerization potential have positive effects on the rate of polymerization. The effect of ultrasonic vibration was also investigated by conducting electrolyses at different monomer concentrations in the presence and absence of ultrasonic vibration. It was observed that the rate of polymerization increases significantly in the presence of ultrasonic vibration. The inverse relationship between the rate of polymerization and monomer concentration was observed in presence and absence of ultrasonic vibration.     

Transformations of pyrrolanthrone-1-carboxylic acid

The preparative possibilities of syntheses based on pyrrolanthrone-1-carboxylic acid were studied. Methylation of the acid or its ester leads to N-methylpyrrolanthrone-1-carboxylic acid esters. The esters were converted to amides and hydrazides, and the latter were converted to 1-amino derivatives through the azides. The indicated transformations and decarboxylation in phosphoric acid give the products in high yields.Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 6, pp. 785–788, June, 1978.     

Chain transfer to solvent in the radical polymerization of N‐isopropylacrylamide

Chain transfer to solvent has been investigated in the conventional radical polymerization and nitroxide‐mediated radical polymerization (NMP) of N‐isopropylacrylamide (NIPAM) in N,N‐dimethylformamide (DMF) at 120 °C. The extent of chain transfer to DMF can significantly impact the maximum attainable molecular weight in both systems. Based on a theoretical treatment, it has been shown that the same value of chain transfer to solvent constant, C_tr,S, in DMF at 120 °C (within experimental error) can account for experimental molecular weight data for both conventional radical polymerization and NMP under conditions where chain transfer to solvent is a significant end‐forming event. In NMP (and other controlled/living radical polymerization systems), chain transfer to solvent is manifested as the number‐average molecular weight (M_n) going through a maximum value with increasing monomer conversion. © 2011 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2011     

Derivatives of 1-hydroxytetrazole-5-carboxylic acid

Conclusions We have developed a method for obtaining ethyl 1-hydroxytetrazole-5-carboxylate from ethoxycarbonylchloroaldoxime. Various derivatives of 1-hydroxytetrazole-5-earboxylic acid have been obtained.Translated from Izvestiya Akademii Nauk SSSR, Seriya Khimicheskaya, No. 11, pp. 2540–2543, November, 1987.     

Anionic polymerization of a fluorinated butadiene

1,1-Bis(trifluoromethyl)-1,3-butadiene (I) is cleanly prepared in three steps. I produces an amorphous polymer by free-radical catalysis. Crystalline poly-I is produced by butyllithium catalysis in tetrahydrofuran at ?78°C. Qualitative kinetic experiments indicate that the anionic polymerization proceeds by a “living polymer” process. An AB block copolymer may be formed by adding I to anionically propagating butadiene; however, the reverse does not occur.