Thermodynamics of the oxidation–reduction reaction {2 glutathionered(aq) + NADPox(aq)=glutathioneox(aq) + NADPred(aq)}

Microcalorimetry, spectrophotometry, and high-performance liquid chromatography (h.p.l.c.) have been used to conduct a thermodynamic investigation of the glutathione reductase catalyzed reaction {2 glutathione_red(aq) + NADP_ox(aq)=glutathione_ox(aq) + NADP_red(aq)}. The reaction involves the breaking of a disulfide bond and is of particular importance because of the role glutathione_red plays in the repair of enzymes. The measured values of the apparent equilibrium constant K^′ for this reaction ranged from 0.5 to 69 and were measured over a range of temperature (288.15 K to 303.15 K), pH (6.58 to 8.68), and ionic strength I_m (0.091 mol · kg⁻¹ to 0.90 mol · kg⁻¹). The results of the equilibrium and calorimetric measurements were analyzed in terms of a chemical equilibrium model that accounts for the multiplicity of ionic states of the reactants and products. These calculations led to values of thermodynamic quantities at T=298.15 K and I_m=0 for a chemical reference reaction that involves specific ionic forms. Thus, for the reaction {2 glutathione_red⁻(aq) + NADP_ox³⁻(aq)=glutathione_ox²⁻(aq) + NADP_red⁴⁻(aq) + H⁺(aq)}, the equilibrium constant K=(6.5±4.4)·10⁻¹¹, the standard molar enthalpy of reaction Δ_rH^o_m=(6.9±3.0) kJ · mol⁻¹, the standard molar Gibbs free energy change Δ_rG^o_m=(58.1±1.7) kJ · mol⁻¹, and the standard molar entropy change Δ_rS^o_m=−(172±12) J · K⁻¹ · mol⁻¹. Under approximately physiological conditions (T=311.15 K, pH=7.0, and I_m=0.25 mol · kg⁻¹ the apparent equilibrium constant K^′≈0.013. The results of the several studies of this reaction from the literature have also been examined and analyzed using the chemical equilibrium model. It was found that much of the literature is in agreement with the results of this study. Use of our results together with a value from the literature for the standard electromotive force E^o for the NADP redox reaction leads to E^o=0.166 V (T=298.15 K and I=0) for the glutathione redox reaction {glutathione_ox²⁻(aq) + 2 H⁺(aq) + 2 e⁻=2 glutathione_red⁻(aq)}. The thermodynamic results obtained in this study also permit the calculation of the standard apparent electromotive force E^′o for the biochemical redox reaction {glutathione_ox(aq) + 2 e⁻=2 glutathione_red(aq)} over a wide range of temperature, pH, and ionic strength. At T=298.15 K, I=0.25 mol · kg⁻¹, and pH=7.0, the calculated value of E^′o is −0.265 V.     

Synthesis,characterization and thermochemistry of Cs(ASP) · nH2O (n = 0, 1)

New compounds of aspartic acid Cs(ASP) · nH₂O (n = 0, 1) have been synthesized and characterized by XRD, IR and Raman spectroscopy as well as TG. The structural formula of this new compound was Cs(ASP) · nH₂O (n = 0, 1). The enthalpy of solution of Cs(ASP) · nH₂O (n = 0, 1) in water were determined. With the incorporation of the standard molar enthalpies of formation of CsOH(aq) and ASP(s), the standard molar enthalpy of formation of −(1202.9 ± 0.2) kJ · mol⁻¹ of Cs(ASP) and −(1490.7 ± 0.2) kJ · mol⁻¹ of Cs(ASP) · H₂O were obtained.     

The (p, ρ, T) properties and apparent molar volumes Vϕ of (ZnBr2 + C2H5OH)

The (p, ρ, T) properties and apparent molar volumes V_? of ZnBr₂ in ethanol at temperatures (293.15 to 393.15) K and pressures up to p = 40 MPa are reported. The measurements were made with a recently developed vibration-tube densimeter. The system was calibrated using double-distilled water, methanol, ethanol, and aqueous NaCl solutions. The experiments were carried out at molalities of m = (0.05681, 0.16958, 0.30426, 0.43835, 0.93055, 1.49016, and 1.88723) mol · kg^?1 using zinc bromide. An empirical correlation for the density of (ZnBr₂ + C₂H₅OH) with pressure, temperature, and molality has been derived. This equation of state was used to calculate other volumetric properties such as isothermal compressibility, isobaric thermal expansibility, the differences in specific heat capacities at constant pressures and volumes, apparent molar volumes of ZnBr₂ in ethanol, and partial molar volumes of both components.     

Modelling (vapour + liquid) and (vapour + liquid + liquid) equilibria of {water (H2O) + methanol (MeOH) + dimethyl ether (DME) + carbon dioxide (CO2)} quaternary system using the Peng–Robinson EoS with Wong–Sandler mixing rule

The (vapour + liquid) equilibria (VLE) and (vapour + liquid + liquid) equilibria (VLLE) binary data from literature were correlated using the Peng–Robinson (PR) equation of state (EoS) with the Wong–Sandler mixing rule (WS). Two group contribution activity models were used in the PRWS: UNIFAC–PSRK and UNIFAC–Lby. The systems were successfully extrapolated from the binary systems to ternary and quaternary systems. Results indicate that the PRWS–UNIFAC–PSRK generally displays a better performance than the PRWS–UNIFAC–Lby.     

Synthesis and Crystal Structure of Cobalt(II) Complex [Co(H_2O)_2(bpe)(OAc)_2]·4,4''''-dpdo

1 INTRODUCTION Recently construction of new coordination poly-mer networks through the rational combination oforganic ligands ‘spacers’and metal ‘nodes’ is an areaof intense interest[1～3] because of their capability ofshowing novel magnetic[4], nonl     

Synthesis and structural mechanisms of the 2201-type ferrites and polytypes: Fe2(Sr2 − xAx)FeO6.5 − δ/2 (A = Ba,La, Tl,Pb and Bi)

The Fe₂(Sr_2 ? xA_x)FeO_6.5 ? δ/2 systems have been investigated, by doping the iron rich 2201-type parent structure with Ba²⁺, La³⁺ and 5d¹⁰ post-transition cations. The syntheses have been carried out up to the limit of the 2201-type solid solutions, in order to test the role of the double iron layer Fe₂O_2.5 ? δ/2. The localisation of the charge carriers in these compounds is consistent with their strong antiferro-magnetism. The investigation was then carried out in the transition part of the diagram up to the formation of stable phases. The study of structural mechanisms was carried using high resolution electron microscopy (transmission and scanning transmission), electron diffraction and energy dispersive spectroscopy. Different non-stoichiometry mechanisms are observed, depending on the electronic structure and chemical properties of the doping elements. The specific behavior of the modulated double iron layer is discussed.     

Viscosity of {xCO2 + (1 − x)CH4} with x = 0.5174 for temperatures between (229 and 348) K and pressures between (1 and 32) MPa

A vibrating wire instrument, in which the wire was clamped at both ends, was used to measure the viscosity of {xCO₂ + (1 − x)CH₄} with x = 0.5174 with a combined uncertainty of 0.24 μPa · s (a relative uncertainty of about 0.8 %) at temperatures T between (229 and 348) K and pressures p from (1 to 32) MPa. The corresponding mass density ρ, estimated with the GERG-2008 equation of state, varied from (20 to 600) kg · m⁻³. The measured viscosities were consistent within combined uncertainties with data obtained previously for this system using entirely different experimental techniques. The new data were compared with three corresponding states-type models frequently used for predicting mixture viscosities: the Extended Corresponding States (ECS) model implemented in REFPROP 9.1; the SUPERTRAPP model implemented in MultiFlash 4.4; and a corresponding states model derived from molecular dynamics simulations of Lennard Jones fluids. The measured viscosities deviated systematically from the predictions of both the ECS and SUPERTRAPP models with a maximum relative deviations of 11 % at (229 K, 600 kg · m⁻³) and −16 % at (258 K, 470 kg · m⁻³), respectively. In contrast, the molecular dynamics based corresponding states model, which is predictive for mixtures in that it does not contain any binary interaction parameters, reproduced the density and temperature dependence of the measured viscosities well, with relative deviations of less than 4.2 %.     

Ternary mutual diffusion coefficients of aqueous {l-dopa (1) + β-CD (2)} solutions at T = 298.15 K

Ternary mutual diffusion coefficients (D₁₁, D₂₂, D₁₂ and D₂₁) measured by the Taylor dispersion method are reported for aqueous solutions of {levodopa (l-dopa) + β-cyclodextrin (β-CD)} solutions at T = 298.15 K and concentrations up to 0.007 mol · dm⁻³. Significant effects on the diffusion were observed, suggesting interactions between this carbohydrate and l-dopa. Support for this came from ¹H NMR spectroscopy, which shows that these effects are due to formation of 1:1 (β-CD:l-dopa) complexes.     

Thermally-driven processes on rutile TiO2(1 1 0)-(1 × 1): A direct view at the atomic scale

The technological importance of TiO₂ has led to a broad effort aimed at understanding the elementary steps that underlie catalytic and photocatalytic reactions. The most stable surface, rutile TiO₂(1 1 0), in particular, has became a prototypical model for fundamental studies of TiO₂. In this critical review we have selected oxygen, water, and alcohols to evaluate recent progress relevant for applications in the areas of water splitting and oxidation of organic contaminants. We first focus on the characterization of defects and the distribution of excess charge that results from their formation. The subsequent section concentrates on the role of individual surface sites and the effect of available charge in the adsorption processes. The discussion of adsorbate dynamics follows, providing models for intrinsic and extrinsic diffusion processes as well as rotational dynamics of anchored alkoxy species. The final section summarizes our current understanding of TiO₂(1 1 0) catalyzed reactions between water, oxygen, and their dissociation products.     

Experimentally determined thermodynamic properties of schapbachite (α-AgBiS2) below T = 700 K

Thermodynamic properties of schapbachite (α-AgBiS₂) in the phase assemblage α-AgBiS₂–AgBi₃S₅–Bi have been studied by an EMF-technique. The EMF-measurements were made on the galvanic cell Pt(−)|Ag|AgI|AgBiS₂ + AgBi₃S₅ + Bi|C|Pt(+), over the temperature range from (429 to 699) K. According to the EMF vs. temperature relations obtained, the enthalpy of the phase transformation from β-AgBi_1+xS₂ to α-AgBi_1+xS₂, at T = (465.55 ± 5) K, was calculated to be (7.3 ± 2.1) kJ · mol⁻¹. New experimentally determined thermodynamic properties of the bismuth-saturated schapbachite (α-AgBi_1+xS₂), for each temperature region of the stable phases Bi(s) and Bi(l), were generated and analysed in detail. Based on the experimental results, Gibbs free energies of sulfidation reactions including Ag, Bi(l), S₂(g), Ag₂S and Bi₂S₃ to produce the bismuth-saturated schapbachite (α-AgBi_1+xS₂) have been evaluated. It has been observed that within the temperature range from (474 to 680) K, schapbachite saturated with bismuth (α-AgBi_1+xS₂) is thermodynamically more stable than the stoichiometric schapbachite (α-AgBiS₂).     

Gas-tight proton-conducting Nd2 − xCaxZr2O7 − δ (x = 0, 0.05) ceramics

Journal of Solid State Electrochemistry - Gas-tight Nd2 − xCaxZr2O7 − δ (x = 0, 0.05) pyrochlore materials have been prepared via...     

Vibrational relaxation rates for H on a Si(1 0 0):(2×1) surface: a two-dimensional model

The results of calculations based on perturbation theory of vibrational relaxation rates due to coupling to substrate phonons for hydrogen atoms adsorbed on a Si(1 0 0):(2×1) surface are presented. For this purpose a two-dimensional model is adopted in which both the H–Si stretching and bending motions are included. It is shown that within this model the multiphonon emission and absorption processes play a negligible role. The calculated lifetimes agree well with available experimental data.