Surface chemical analysis of raw cotton fibres and associated materials

The surface chemical composition of raw unscoured cotton was successfully investigated by the surface analytical techniques X-ray Photoelectron Spectroscopy (XPS) and Time of Flight Secondary Ion Mass Spectrometry (ToF-SIMS). The presence of non-cellulosic material at the fibre surface was established and determined to be a complex mixture of fatty acids, alcohols, alkanes, esters and glycerides. The effect of scouring and bleaching was to reduce the surface concentration of these materials but even after aqueous processing some non-cellulosic material residue was still detected at the fibre surface.     

On the catalytic effect of thiolactams on the electrochemical reduction of Zn(II) ions

Summary The electroeduction of Zn(II) ions in 1M NaClO₄ in the presence of thiolactams has been studied by means of the faradaic impedance method in wide frequency ranges. The standard rate constants are found to be a linear function of the surface excesses of thiolactams. Catalytic activity of thiolactams increases in the following order: thiopyrrolidone, thiopiperidinone, thiocaprolactam; the enthalpies of activation decrease in this order. The differences in the catalytic activity of thiolactams result mainly from the double layer effect.

---

Zum katalytischen Effekt von Thiolactamen auf die elektrochemische Reduktion von Zn(II)-Ionen

Zusammenfassung Die Elektroeduktion von Zn(II)-Ionen in 1M NaClO₄ in Gegenwart von Thiolactamen wurde mittels derFaradayschen Impedanzmethode über große Frequenzbereiche untersucht. Die Standardgeschwindigkeitskonstanten sind eine lineare Funktion der Überschußoberfläche der Thiolactame. Deren katalytische Aktivität steigt in der Reihenfolge Thiopyrrolidon — Thiopiperidinon — Thiocaprolactam; die Aktivierungsenthalpien sinken in der angegebenen Reihenfolge. Die Unterschiede in der katalytischen Aktivität der Thiolactame sind hauptsächlich auf den Doppelschichteffekt zurückzuführen.

     

Solvent effects on catalytic activity of manganese porphyrins with cationic,anionic and uncharged meso substituents: Indirect evidence on the nature of active oxidant species

Oxidation of cyclohexene and styrene with sodium periodate and tetra‐n‐butylammonium periodate (TBAP) catalyzed by MnT(3‐MePy)P(OAc), MnT(4‐SO₃)PP(OAc) and MnTPP(OAc) has been studied in water, methanol, acetonitrile and dichloromethane as solvents. The results show significant dependence of the product distribution on the type of solvent and the electronic nature of the aryl substituents introduced at the porphyrin periphery. While the oxidation of cyclohexene and styrene in the presence of MnT(3‐MePy)P(OAc) and MnTPP(OAc) in water (also in methanol) gave the corresponding epoxides as nearly the sole product, performing the reactions in the presence of MnT(4‐SO₃)PP(OAc) yielded the products of allylic oxidation, cyclohexene‐2‐ol and cyclohexene‐2‐one and acetophenone as the major products. In the case of styrene, performing the reaction in the presence of MnT(4‐SO₃)PP(OAc), MnT(3‐MePy)P(OAc) and MnTPP(OAc) in acetonitrile gave a mixture of styrene oxide and acetophenone as the products. Under the same conditions, the oxidation of cyclohexene afforded cyclohexene oxide as approximately the exclusive product. Furthermore, the oxidation of olefins in dichloromethane gave the corresponding epoxide as the exclusive products. The product distributions observed in the protic and aprotic solvents were used to provide indirect evidence on the relative contribution and reactivity of high valent manganese oxo and periodato Mn(III) porphyrin species to the oxidation reactions.     

New peripherally tetra-[trans-3,7-dimethyl-2,6-octadien-1-ol] substituted metallophthalocyanines: synthesis,characterization and catalytic activity studies on the oxidation of phenolic compounds

In this paper, we elucidated the synthesis, characterization, and investigation of catalytic activity studies of new metallophthalocyanines 4 and 5 as the catalyst for phenolic compounds oxidation by trying different types of oxygen sources. The structural characterization of the products was made by a combination of elemental analysis, FT-IR, LC-MS/MS (for phthalonitrile derivative 3), MALDI-TOF mass spectral data (for metallophthalocyanines 4–7), UV–vis spectroscopy (for metallophthalocyanines 4–7), ¹H NMR and ¹³C NMR spectroscopies (for compounds 3 and 6). The synthetic routes for the (trans-3,7-dimethyl-2,6-octadien-1-ol) substituted phthalonitrile derivative 3 and corresponding metallophthalocyanines 4–7 are outlined in Scheme 1. The MPc complexes 4–7 were synthesized via cyclotetramerization of compound 3 in the presence of the corresponding anhydrous metal salts (CoCl₂ for 4, CuCl₂ for 5, Zn(CH₃COO)₂ for 6 and MnCl₂ for 7) in dry n-pentanol as solvent and 1,8-diazabicyclo[5.4.0]undec-7-ene (DBU) as strong base at reflux temperature under nitrogen gas. Phthalocyanines and their metal complexes, in general, display poor solubility in most of the organic solvents, however, the synthesized metallophthalocyanine complexes 4–7 were highly soluble in common organic solvents because of the introduction of the methyl groups on alkyl chains of peripheral arms. The catalytic activity of compounds 4 and 5 was evaluated for the oxidation of phenolic compounds such as 4-nitrophenol, o-chlorophenol, 2,3-dichlorophenol, and p-methoxyphenol. CoPc 4 displayed good catalytic performance with a full oxidation of 4-nitrophenol into the corresponding benzoquinone and hydroquinone with the highest TON and TOF values within 3 h.     

铁铈复合氧化物催化剂SCR脱硝的改性研究

利用共沉淀法制备了铁铈催化剂,考察添加钛、锆、钨和钼对其SCR脱硝的改性规律。结果表明,钨和钼的添加提高了铁铈催化剂高温脱硝性能,却使其低温活性有所降低;钛的添加对铁铈催化剂脱硝性能具有促进作用,尤其提高了其低温活性,并拓宽了其完全转化温度窗口,为最佳改性物。当钛的物质的量比逐渐由0.10增至0.40,铁铈钛催化剂低温脱硝效率先增大后减小,但其高温脱硝效率逐渐增大至100%,钛的最佳物质的量比为0.15。XRD和N₂吸附分析结果表明,钛能优化铁铈催化剂的孔隙结构,增大其比表面积和比孔容,细化其孔径,并与催化剂中铁、铈氧化物形成良好的固溶体,从而提高了铁铈催化剂的SCR脱硝性能。Fe_0.8Ce_0.05Ti_0.15O_z催化剂在150～400℃取得了高于90%的NO_x转化率。     

Effect of the Nature of the Precursor on the Activity of Copper-Containing Catalysts Based on Erionite in Oxidation of CO

We have studied the catalytic activity of copper-containing zeolite catalysts based on erionite (ERI) in oxidation of CO. We have established that the activity of Cu-ERI systems is due to isolated coordination unsaturated Cu²⁺ cations which are stabilized in the catalyst on sites with strong tetragonal distortion and are reduced to Cu⁺ during catalysis. According to X-ray photoelectron spectroscopy (XPS), diffuse reflection electronic spectra, and temperature programmed reduction by hydrogen (TPR-H₂) spectra, activity differences between 3% Cu-ERI catalysts obtained from different precursors are determined by the different numbers of Cu²⁺ cations capable of being reduced during the reaction at T < 400 °C: the higher the content of such cations in the samples, the higher the activity of the Cu-ERI systems. __________ Translated from Teoreticheskaya i Eksperimental'naya Khimiya, Vol. 41, No. 5, pp. 317–322, September–October, 2005.     

Co‐catalyst effects on the thermal stability/activity of N,N,N‐Co ethylene polymerization Catalysts Bearing Fluoro‐Substituted N‐2,6‐dibenzhydrylphenyl groups

The unsymmetrical bis (arylimino)pyridines, 2‐[CMeN{2,6‐{(4‐FC₆H₄)₂CH}₂–4‐t‐BuC₆H₂}]‐6‐(CMeNAr)C₅H₃N (Ar = 2,6‐Me₂C₆H₃ L1 , 2,6‐Et₂C₆H₃ L2 , 2,6‐i‐Pr₂C₆H₃ L3 , 2,4,6‐Me₃C₆H₂ L4 , 2,6‐Et₂–4‐MeC₆H₂ L5 ), each containing one N‐aryl group bedecked with ortho‐substituted fluorobenzhydryl groups, have been employed in the preparation of the corresponding five‐coordinate cobalt (II) chelates, LCoCl₂ ( Co1 – Co5 ); the symmetrical comparator [2,6‐{CMeN(2,6‐(4‐FC₆H₄)₂CH)₂–4‐t‐BuC₆H₂}₂C₅H₃N]CoCl₂ (Co6) is also reported. All cobaltous complexes are paramagnetic and have been characterized by ¹H/¹⁹F NMR spectroscopy, FT‐IR spectroscopy and elemental analysis. The molecular structures of Co3 and Co6 highlight the different degrees of steric protection given to the metal center by the particular N‐aryl group combination. Depending on the aluminoxane co‐catalyst employed to activate the cobalt precatalyst, distinct variations in thermal stability and activity of the catalyst towards ethylene polymerization were exhibited. In particular with MAO, the resultant catalysts reached their optimal performance at 70 °C delivering high activities of up to 10.1 × 10⁶ g PE (mol of Co)^?1 h^?1 with Co1  >  Co4  >  Co2  >  Co5  >  Co3 >>  Co6 . On the other hand, using MMAO, the catalysts operate most effectively at 30 °C but are by comparison less productive. In general, the polyethylenes were highly linear, narrowly disperse and displayed a wide range of molecular weights [M_w range: 18.5–58.7 kg mol^?1 (MAO); 206.1–352.5 kg mol^?1 (MMAO)].