On-chip methane sensing by near-IR absorption signatures in a photonic crystal slot waveguide

We demonstrate a 300?μm long silicon photonic crystal (PC) slot waveguide device for on-chip near-infrared absorption spectroscopy, based on the Beer-Lambert law for the detection of methane gas. The device combines slow light in a PC waveguide with high electric field intensity in a low-index 90?nm wide slot, which effectively increases the optical absorption path length. A methane concentration of 100?ppm (parts per million) in nitrogen was measured.     

A novel electrode structure with a reverse-biased p⿿n diode for high speed polymer-infiltrated slot modulators

This paper demonstrates an alternative electrode structure for low power optical modulation based on a slotted waveguide geometry filled with E-O polymers. A reverse-biased p?n junction is constructed inside the slot waveguide for apply modulation voltage. With this structure, the fabrication tolerance of the slot based E-O modulator should be more flexible. Analysis shows that the modulation speed of our design is comparable with the through-etched slot modulator, at the level of picoseconds.     

Enhanced localization of light in slow wave slot photonic crystal waveguides

A flexible design of slot photonic crystal waveguide with a wide comb is investigated. Introduction of a carefully designed comb within the photonic crystal waveguide allows an accurate dispersion engineering in order to achieve slow light and increase the optical confinement within the comb. The strong light confinement results in an extremely small nonlinear effective area around 0.015 μm². We report experimental realization of a comb photonic crystal waveguide with measured group indices higher than 100 in a Mach-Zehnder interferometer configuration and extract losses limited to 3.7?dB for a 100?μm device at n_g=37.     

The study of electro-optical sensor based on slotted photonic crystal waveguide

A compact and sensitive electro-optical sensor based on slotted photonic crystal waveguide (S-PhCW) is demonstrated. The electro-optical sensor can be realized in photonic crystal (PhC) slabs of silicon in Silicon-on-Insulator (SOI). Nonlinear optical polymer is used as infiltration. By applying three-dimensional finite difference time domain (3D-FDTD), the sensitivity and quality factor of electro-optical sensor with different slotted waveguide width are calculated. In addition, sensitivity and the optical properties such as transmission spectrum and field distributions are compared between electro-optical sensor based on line defect photonic crystal waveguide (W1-PhCW) and that based on slotted photonic crystal waveguide (S-PhCW). Simulation results demonstrate that, compared with electro-optical sensor based on line defect photonic crystal waveguide, the sensitivity and quality factor is improved by 30 times and 6.6 times respectively in sensor based on slotted photonic crystal waveguide. Besides, the proposed PhC sensor devices have the advantage of a compact structure with the potential for monolithic integration with optical-to-electrical on-chip conversion and detection.     

Optimal tunability of waveguides based on silicon photonic crystals infiltrated with liquid crystals

In this work we study the optimization of the tunability range in waveguides based on two-dimensional silicon photonic crystal infiltrated with liquid crystal. The analyzed structure consists of a two-dimensional silicon photonic crystal with a triangular lattice of circular holes where a line of scatterers in the direction Γ–K has been replaced by a line of circular holes with different radius infiltrated by E7 liquid crystal. To this end, we use the plane-wave expansion method considering anisotropy and modelling supercells to account for the lattice defects that define the waveguide. Finally we study the field distributions of the guided modes in order to analyze their symmetries and confinement.     

Athermal silicon arrayed waveguide grating with polymer-filled slot structure

In this paper, an athermal silicon arrayed waveguide grating (AWG) with the assistance of a polymer-filled slot structure is proposed. Arrayed slot waveguides were used to replace arrayed silicon photonic wires (SPWs). By carefully controlling the temperature dependence of the effective index of the polymer-filled slot waveguides, the athermal silicon AWG is realized. Analysis shows that the center wavelength shift of the AWG can be down to 0.14 pm/°C.     

Efficient input and output fiber coupling to a photonic crystal waveguide

The efficiency of evanescent coupling between a silica optical fiber taper and a silicon photonic crystal waveguide is studied. A high-reflectivity mirror on the end of the photonic crystal waveguide is used to recollect, in the backward-propagating fiber mode, the optical power that is initially coupled into the photonic crystal waveguide. An outcoupled power in the backward-propagating fiber mode of 88% of the input power is measured, corresponding to a lower bound on the coupler efficiency of 94%.     

Investigations of the E-O behavior in the poled polymer waveguide

The electro-optic (E-O) properties of the slab polymer waveguide induced by electric poling have been studied experimentally. The thin film waveguide was prepared by a synthesized polymer polypelargonamide and poled by applying voltage between the electrodes. I–V curves and E-O characteristics of the polymer films were in-situ measured during poling. In order to evaluate the molecular dipole orientation under the poling field, the absorption spectra of this film was observed by FTIR. The E-O performance of the polymer slab film was also estimated by the Mach–Zehnder interferometer.     

Spontaneous emission rate and optical amplification of Er3+ in double slot waveguide

The spontaneous emission(SE) of Er3+ embedded in a double slot dielectric structure was studied by a quantum-electrodynamical formalism. The study shows that the slot width and the position of Er3+ in slot structure have a significant effect on the SE. The double slot waveguides were fabricated by embedding two low-index Er/Yb silicate material layers into high-index silicon. The radiative efficiency of Er3+ in the double slot waveguides is found to be higher than that of the single slot waveguide, which is consistent with the theory simulation. The 0.67 d B signal enhancement at 1.53 ?m in a 4.6-mm-long slot waveguide was observed pumped by 1476 nm laser. These results show the relevance of our model to study the SE processes in multilayer structures and are important for future realization of silicon-compatible active optical devices.     

Numerical studies of 2D photonic crystals: Waveguides,coupling between waveguides and filters

In photonic crystals, light propagation is forbidden in a certain wavelength range, the bandgap. In a two-dimensional crystal composed of parallel high-refractive index rods in a low-index background a line defect can be formed by removing a row of these rods, which can act as a waveguide for frequencies in the bandgap of the crystal. In order to get more insight into the main features of such waveguides we have studied a number of properties, using simulation tools based on the finite difference time domain method and a finite element Helmholtz solver. We show conceptually simple methods for determining the bandgap of the crystal as well as the dispersion of a waveguide for wavelengths in this bandgap. For practical applications, it is also important to know how much light can be coupled into the waveguide. Therefore, the coupling of light from a dielectric slab waveguide into the photonic crystal waveguide has been examined, showing that a coupling efficiency of up to 83% can be obtained between a silicon oxide slab and a waveguide in a crystal of silicon rods. Finally, calculations on an ultra-compact filter based on reflectively terminated side-branches of waveguides (similar to tuned stubs in microwave engineering) are shown and discussed.     

Low group velocity in a photonic crystal coupled-cavity waveguide

A two-dimensional photonic crystal coupled-cavity waveguide is designed and optimized, the transmission spectrum is calculated by using the finite-difference time-domain method, and the group velocity of c/1856 is obtained. To our knowledge, this value of group velocity is the lowest group velocity in a photonic crystal waveguide calculated from its transmission spectrum so far. The result is confirmed by the photonic band structure calculated by using the plane wave expansion method, and it is found that the photonic crystal waveguide modes in a photonic band structure are in accordance with those in the transmission spectrum by using the finite-difference time-domain method. The mechanism of slow light in the coupled-cavity waveguide of photonic crystal is analysed.     

Slotted Photonic Crystal Microring Resonators

We propose using a slotted photonic crystal nanobeam to construct a microring resonator. The transmission characteristics of the slotted photonic crystal nanobeam and the microring resonator are demonstrated by two-dimensional finite-difference time-domain simulation, and the mechanism of these characteristics is analyzed considering the introduction of the slot. The refractive index sensitivity of the slotted photonic crystal microring resonator is evaluated to be larger than those of a slot waveguide microring resonator and a nonslotted photonic crystal microring resonator.     

Edge-emitting photonic crystal double-heterostructure nanocavity lasers with InAs quantum dot active material

We report what is, to the best of our knowledge, the first demonstration of an edge-emitting photonic crystal nanocavity laser that is integrated with a photonic crystal waveguide. This demonstration is achieved with a double-heterostructure photonic crystal nanocavity incorporating an InAs quantum dot active region.     

Magneto-optical defects in two-dimensional photonic crystals

We analyze the properties of magneto-optical defect states in two-dimensional photonic crystals. With out-of-plane magnetization, the magneto-optical coupling splits doubly-degenerate TE states into two counter-rotating modes at different frequencies. The strength of magneto-optical coupling strongly depends on the spatial overlap of the cavity domain structures and the cross product of the modal fields. The transport property of the resultant nonreciprocal states is demonstrated in a junction circulator structure with a magneto-optical cavity coupled to three waveguides. By a proper matching of the magneto-optical frequency splitting with the cavity decay rate into the waveguide, ideal three-port circulator characteristics with complete isolation and transmission can be achieved, with an operational bandwidth proportional to the magneto-optical constant. The proposed optical circulator in a bismuth-iron-garnet/air photonic crystal is demonstrated with finite-difference time-domain calculations and is compared to an alternative implementation of silicon/air crystal infiltrated with a single bismuth-iron-garnet domain.     

用于折射率传感的聚合物基狭缝波导的模拟与制备

设计了在极近红外波段(890 nm)的聚合物基狭缝波导微环折射率传感器.分析了波导高度、宽度及狭缝宽度对灵敏度的影响,以找到最佳的设计标准用于折射率传感.采用电子束光刻工艺制备了硅母版模,并用独特的氟化聚合物PFPE从硅母版模上成功制备了柔性软模具.采用紫外软压印工艺制备了聚合物基狭缝波导.波导的宽度和高度以及狭缝波导的宽度分别约为510 nm、830 nm和234 nm,聚合物狭缝波导残留层的厚度约为350 nm.制备的狭缝波导具有高的高宽比并与低成本批量生产工艺相兼容.     

基于KH560修饰的有机/无机杂化材料电光波导制备

利用溶胶-凝胶法制备了硅烷偶联剂KH560修饰的有机/无机杂化电光材料,分析了KH560的水解缩合的反应机理.对制备好的电光薄膜进行了表面形貌、折射率和电光特性的表征,并用反射法测量得出了该材料的电光系数为3.5pm/V.针对这种材料柔韧的特性,设计了上加载条形电光波导,并利用Opti-BPM软件模拟了二维和三维光场.摸索了其制备的加工工艺,制备了该结构的光波导,最后得到了这种波导的近场输出.     

Optical surface modes of photonic crystals for dual-polarization waveguide

In this study, the design of a polarization-independent (dual-polarization) waveguide is presented by utilizing surface modes of photonic crystals. The waveguide structure operates in a frequency interval that is commonly shared by both transverse-electric (TE) and transverse-magnetic (TM) polarizations. The numerical calculations based on plane wave expansion and finite-difference time-domain methods are carried out to design and demonstrate a surface mode waveguide that provides confinement and guiding for both TE and TM modes. Once the relevant modes are properly excited, the high transmission efficiency of the photonic crystal surface waveguide is ensured. The demand to have polarization-insensitive devices makes our proposed design an important component for the photonic integrated circuit applications. Finally, we also propose a broadband surface mode photonic crystal waveguide with a bandwidth value of 28% for only TE polarization.     

Tunable photonic crystal circuits: concepts and designs based on single-pore infiltration

We demonstrate that the infiltration of individual pores of certain two-dimensional photonic crystals with liquid crystals and (or) polymers provides an efficient platform for the realization of integrated photonic crystal circuitry. As an illustration of this principle, we present designs for monomode photonic crystal wave-guides and certain functional elements, such as waveguide bends, beam splitters, and waveguide intersections. These devices exhibit very low reflection over broad frequency ranges. In addition, we discuss the inherent tunability of these devices that originates in the tunability of the infiltrated material.     

Liquid refractive index sensor based on slow light in slotted photonic crystal waveguide

A high sensitive and compact refractive index sensor based on slotted photonic crystal waveguide (S-PhCW) is demonstrated. This design is worked on a Mach–Zehnder interferometer (MZI) configuration with S-PhCW as the measuring arm, which can be used to detect any changes in refractive index that correspond to different concentration of the measuring liquid. Combining the slow light enhancement in photonic crystal waveguide (PhCW) with the advantage of excellent optical confinement in slot waveguide, the sensitivity of this simple scheme can reach to 2.3 × 10⁹ nm/RIU with the active region of only 1 mm long.     

二维硅基平板光子晶体器件

硅材料在红外通讯波段具有低损耗和高折射率的特性,使得其成为集成光学领域中应用最广的材料之一.主要介绍了本课题组在二维硅基平板光子晶体中实现微纳尺度上光调控的研究进展,讨论了利用光子晶体的缺陷态实现各种集成光学器件,包括光子晶体波导、微腔和利用光子晶体波导和微腔形成的滤波器.还介绍了光子晶体中特殊的光折射现象,包括红外波...