An investigation of the effect of ultrasonic waves on the efficiency of silicon extraction from coal fly ash

Burning of coal accounts for an enormous proportion of the current energy supply, especially in developing countries. Burning of coal produces large amounts of coal fly ash, which causes serious environmental problems unless it is managed properly. Using chemical analysis, we found that coal fly ash could be a promising source of Si, Al, Ca and some rare earth elements, especially with the assistance of some measures such as ultrasound. In this study, we extracted silicon from coal fly ash using an alkaline dissolution strategy and investigated the effects of temperature and ultrasonic power on the efficiency of silicon extraction. During a 70 min reaction, the efficiency of silicon extraction increased markedly, from 9.41% to 34.96%, as the reaction temperature increased from 70 °C to 110 °C. With ultrasound assistance, ultrasonic waves enhanced the extraction of silicon at both 80 °C and 110 °C at 720 W ultrasound, increasing the efficiency of silicon extraction from 6.01% to 15.36% and from 34.96% to 54.42%, respectively. However, at 900 W ultrasonic power, extraction was slightly inhibited at both temperatures, causing a little decrease in efficiency.     

HL-2A装置中性束离子源引出系统束流分析

在中性束离子源引出过程中,详细分析了引出束流的产生,这有利于得到更准确的引出功率和引出电极表面的热功率沉积情况。根据HL-2A装置中性束离子源引出电极的电连接方式和束流引出的物理过程,对离子源束流引出过程进行了分析,给出抑制极电流产生的主要来源。通过分析放电气压扫描实验中的结果发现:随着放电气压的增加,不同弧放电电流情况下抑制极电流均逐渐增加,且抑制极电流与引出电流的比值近似线性增加。针对引出离子束流经过引出电极的过程建立了物理模型。计算了抑制极电流与引出电流的比值与放电气压的依赖关系,计算结果与实验结果一致,验证了引出束流分析结果的合理性。     

Influence of ion-beam plasma on ion extraction efficiency in a single-grid ion source

The influence of ion-beam plasma on ion extraction efficiency in a single-grid ICP ion source is researched. The single-grid ion source is considered as a system with two plasmas, ion-beam plasma and the source plasma, separated by an extraction grid. Results of experimental measurements of the potentials of the two plasmas and the ion beam current dependence on these potentials are presented. It is shown that the ion extraction efficiency depends equally on both the acceleration potential and on the potential of the ion-beam plasma. The obtained results demonstrate the key role of the ion-beam plasma in the ion source operation, which is important in technological applications and space thrusters.     

磁场调控型离子源的设计与实验

磁场调控型离子源在离子源等离子体扩散空间中引入轴向强脉冲磁场,磁场起两方面的作用,一是形成潘宁放电效应,使原子、气体分子碰撞电离效率增加;二是在脉冲强磁场的作用下,强轴向磁场将质量较轻的离子约束在轴线上,对质量较重的金属离子约束能力较弱,导致其在等离子体膨胀引出通道中碰壁损失,能够提升引出轻离子的比例。开展了磁场调控的离子源放电结构、强脉冲螺线管磁场以及引出束流光学结构的设计;测量分析了引出离子流强和离子打靶束斑形貌。研究结果表明,强轴向磁场通过等离子体对混合离子成分的筛选作用,可有效提高引出离子流强中的轻离子成分比例。     

一台2.45GHz强流中子源

A 2.45GHz microwave-driven ion source is being used to provide 40mA of deuterium ion beam (peak current) for an RFQ accelerator as part of a neutron source system.We have also designed a 60kV electrostatic LEBT using computer simulations.In our experiment,we measured the hydrogen and deuterium ion beam currents as functions of discharge power,gas flow,and magnetic field strength.The required beam current was obtained using leas than 700W of net microwave power with a gas flow of less than 1.5sccm.From the rise time data,it was determined that in order to obtain a high percentage of atomic ions in the beam, the beam extraction should start after 1ms of switching on the microwave power.At steady state,the proton fraction was above 90%.     

不同磁路电子回旋共振离子源引出实验

空间推进所用的电子回旋共振离子源(ECRIS)应具有体积小、效率高的特点. 本文研究的ECRIS使用永磁体环产生磁场, 有效减小了体积, 该离子源利用微波在磁场中加热电子, 电子与中性气体发生电离碰撞产生等离子体. 磁场在微波加热电子的过程中起关键作用, 同时影响离子源内等离子体的约束和输运. 通过比较四种磁路结构离子源的离子电流引出特性来研究磁场对10 cm ECRIS性能的影响. 实验发现: 在使用氩气的条件下, 特定结构的离子源可引出160 mA的离子电流, 最高推进剂利用率达60%, 最小放电损耗为120 W·A^-1; 所有离子源均存在多个工作状态, 工作状态在微波功率、气体流量、引出电压变化时会发生突变. 离子源发生状态突变时的微波功率、气体流量的大小与离子源内磁体的位置有关. 通过比较不同离子源的引出离子束流、放电损耗、气体利用率、工作稳定性的差异, 归纳了磁场结构对此种ECRIS引出特性的影响规律, 分析了其中的机理. 实验结果表明: 保持输入微波功率、气体流量、引出电压不变时, 增大共振区的范围、减小共振区到栅极的距离, 离子源能引出更大的离子电流; 减小共振区到微波功率入口、气体入口的距离能降低维持离子源高状态所需的最小微波功率和最小气体流量, 提高气体利用率, 但会导致放电损耗增大. 研究结果有助于深化对此类离子源工作过程的认识, 为其设计和性能优化提供参考.     

平行板静电场法离子引出的对称收集

离子引出的研究在AVLIS工程中有重要的意义，离子引出量和引出时间直接关系到整个系统 的离子收集效率. 在静电场中，由于等离子体屏蔽效应的存在，等离子体电位要高于正、负 极板的电位，而且在靠近正、负极板的两侧均存在鞘层. 理论模拟表明在正极板一边也可以 引出离子. 选取铯（Cs）作为实验对象，研究静电场对Cs等离子体的离子引出，使用安装在 两个极板上的法拉第筒收集离子引出信号. 实验结果表明，正极板确实可以引出离子，随着 外加电压的升高，从正极板一边引出离子的比率降低. 关键词： AVLIS 离子引出 等离子体     

Field evaporation of doubly charged ions from a polar liquid

The effect of charge on field evaporation of ions from polar liquids is considered. Using the electromembrane ion source, we performed mass-spectral analysis of field evaporation of ions from the solution of sodium sulfate in a water-glycerol mixture. The composition of doubly charged cluster ions in the field evaporation from glycerol is determined. The rates of the field evaporation of doubly charged ions and singly charged ions are compared. It is shown that the ion charge as well as its localization considerably influences the efficiency of field evaporation of ions from polar liquids.     

重离子治癌引出BUMP电源控制器设计

引出凸轨(BUMP)电源是负责医用重离子加速器束流引出的关键设备,其电流上升的同步性影响束流的引出效率,而电流波形的多样性与治疗模式和治疗精度密切相关.要在凸轨磁铁(0.2～0.4 mH)上产生1～5 ms上升且精确同步的励磁电流,并确保电流的跟踪性和波形的多样性,采用了实时调整强励电压及基于特征参数的电流波形控制方法...     

C235-V3 cyclotron for a proton therapy center to be installed in the hospital complex of radiation medicine (Dimitrovgrad)

Proton therapy is an effective method of treating oncologic diseases. In Russia, construction of several centers for proton and ion therapy is slated for the years to come. A proton therapy center in Dimitrovgrad will be the first. The Joint Institute for Nuclear Research (Russia) in collaboration with Ion Beam Application (IBA) (Belgium) has designed an C235-V3 medical proton cyclotron for this center. It outperforms previous versions of commercial IBA cyclotrons, which have already been installed in 11 oncologic hospital centers in different countries. Experimental and calculation data for the beam dynamics in the C235-V3 medical cyclotron are presented. Reasons for beam losses during acceleration are considered, the influence of the magnetic field radial component in the midplane of the accelerator and main resonances is studied, and a beam extraction system is designed. In 2011–2012 in Dubna, the cyclotron was mounted, its magnetic field was properly configured, acceleration conditions were optimized, and beam extraction tests were carried out after which it was supplied to Dimitrovgrad. In the C235-V3 cyclotron, an acceleration efficiency of 72% and an extraction efficiency of 62% have been achieved without diaphragming to form a vertical profile of the beam.