火药燃气作用下电离种子产生等离子体研究

为研究电离种子在火药燃气作用下产生等离子体的规律，建立了密闭爆发器(定容)条件下电离种子产生等离子体的数学模型，设计了火药燃气作用下电离种子产生等离子体的试验系统。采用某型火炮发射药和不同种类的电离种子分别进行了试验，结果表明：电离种子在火药燃气作用下可以产生等离子体，加入钾盐和铯盐后电子密度分别为2.25×10¹⁸m⁻³ 和4.63×10¹⁸m⁻³，铯盐电离效果优于钾盐。通过试验数据和仿真结果比对，发现它们保持在同一数量级内。     

HL-2A װ�������ÿɼ����׶����·��������Ч���ӵ����

The multichannel bremsstrahlung measurement system on HL-2A tokamak has been using to observe the intensity of visible (535.1nm) bremsstrahlung radiation. Combined the intensity with plasma electron density and electron temperature, the effective ion charge measurements can be obtained on HL-2A tokamak. The 1×10¹⁹m⁻³ to4×10¹⁹m⁻³ experimental results show that when the plasma electron density increases from 1×10 m to 4×10 m , the effective ion charge number changes from 5 down to around 2. The bremsstrahlung radiation signal intensity is proportional to the quadratic plasma density. When the electron density is higher than 3×10¹⁹m⁻³, the multichannel bremsstrahlung measurement system can collect sufficient signal through the plasma, which enables the measurement of effective ion charge radial profile.     

HL-2A 装置中利用可见光谱段轫致辐射测量有效离子电荷数

通过测量可见光谱段的轫致辐射(λ=535.1nm)强度,结合等离子体电子密度和电子温度,HL-2A     

Experimental study of CF4 conical theta pinch plasmaexpanding into vacuum

Langmuir probe, photodiode, and optical multichannel analyzer (OMA) measurements have been made on a pulsed CF₄ conical theta-pinch plasma. A cloud of CF₄ was puffed into a conical theta-pinch coil, converted to plasma, and propelled into the vacuum region ahead of the expanding gas cloud. At a position 67 cm away from the conical theta-pinch coil, the plasma arrived in separate packets that were about 20 μs in duration. The average drift velocity of these packets corresponded to an energy of about 3 eV. The OMA measurements showed that the second packet contained neutral atomic fluorine as well as charged particles. The electron temperature and ion density in the second packet were 2.0 eV and 1.5×10¹³ cm^-3, respectively. The electron temperature and ion density in the wake plasma were 8.3 eV and 4×10¹¹ cm^-3 , respectively. This device can be used for plasma processing or as a laboratory test of numerical and analytical models of the expansion of plasma into vacuum     

S—Ka频段电磁波在等离子体中传输特性的实验研究

在感应耦合等离子体风洞上开展了等离子体中电磁波传输特性实验研究,获得了不同频率电磁波在等离子体中的传输衰减.通过微波诊断技术,获得了等离子体射流的电子数密度和碰撞频率.通过矢量网络分析仪和标准增益天线组成的电磁波传输特性测试系统,获得了电磁波经过等离子体之后的衰减,研究了电子数密度范围7.0×10~(10)-1.0×10~(13)cm~(-3)、等离子体碰撞频率在109 Hz量级的等离子体对2.6—40 GHz不同频率电磁波传输特性的影响,分析了经典传输理论和薄层理论预测结果与实验结果的差异.该实验工作为等离子体中电磁波传输特性的理论研究和数值仿真提供了基础数据.     

Photo-ionized lithium source for plasma accelerator applications

A photo-ionized lithium source is developed for plasma acceleration applications. A homogeneous column of lithium neutral vapor with a density of 2×10^15-3 is confined by helium gas in a heat-pipe oven. A UV laser pulse ionizes the vapor. In this device, the length of the neutral vapor and plasma column is 25 cm. The plasma density was measured by laser interferometry in the visible on the lithium neutrals and by CO₂ laser interferometry on the plasma electrons. The maximum measured plasma density was 2.9×10 ¹⁴ cm^-3, limited by the available UV fluence (≈83 mJ/cm²), corresponding to a 15% ionization fraction. After ionization, the plasma density decreases by a factor of two in about 12 μs. These results show that such a plasma source is scaleable to lengths of the order of 1 m and should satisfy all the requirements for demonstrating the acceleration of electrons by 1 GeV in a 1-GeV/m amplitude plasma wake     

温稠密钛电导率计算

温稠密物质是惯性约束核聚变、重离子聚变、Z箍缩动作过程中物质发展和存在的重要阶段. 其热力学性质和辐射输运参数在聚变实验和内爆驱动力学模拟过程中有至关重要的作用. 本文通过建立非理想Saha方程, 结合线性混合规则的理论方法模拟了温稠密钛从10^-5-10 g·cm^-3, 10⁴ K到3×10⁴ K区间的粒子组分分布和电导率随温度密度的变化, 其中粒子组分分布由非理想Saha方程求解得到. 线性混合规则模型计算温稠密钛的电导率时考虑了包括电子、原子和离子之间的多种相互作用. 钛的电导率的计算结果与已有的爆炸丝实验数据相符. 通过电导率随温度密度变化趋势判断, 钛在整个温度区间, 密度0.56 g·cm^-3时发生非金属相到金属相相变. 对于简并系数和耦合系数的计算分析, 钛等离子体在整个温度和密度区间逐渐从弱耦合、非简并状态过渡到强耦合部分简并态.     

A cold thermionically emitting dusty air plasma formed by radiativeheating of graphite particulates

Formation of an atmospheric pressure dusty air plasma is explored experimentally in this paper. The plasma is created by seeding an air flow with graphite particles and irradiating the particulates with a focused CO₂ laser beam. The graphite particles are, thus, heated to thermionically emitting temperatures, and average particle temperatures and average particle number densities are measured. The presence of charges is inferred both from these measured quantities using a simple theoretical transient model, and experimentally by applying a dc bias across the irradiated region. It is found that an electron density of ~6.7 × 10⁵ cm^-3 (6.7 × 10¹¹ m^-3) can be produced at steady state in the presence of O₂. This value can be increased to 3.6 × 10⁷ cm^-3 (3.6 × 10¹³ m ^-1) in the ideal case where an electron attachment to O₂ is suppressed and where a lower work function particulate is used     

超短超强激光脉冲辐照超薄碳膜电离状态研究

为了进一步理解极端条件下物质的电离特性, 特别是超短超强激光脉冲辐照超薄靶时等离子体的形成与分布, 本文以超薄碳膜为例, 细致研究了超短超强激光脉冲辐照下原子的离化过程. 分析和比较了强激光场直接作用电离和靶内静电场电离等两种场致电离形式, 在碰撞电离可以忽略的情况下, 发现更多的电离份额是来自靶内静电场的电离方式. 研究了激光脉冲强度对电离的影响, 发现激光脉冲强度越强, 电离速度越快, 产生的高价态离子所占比例也越高.当激光强度为1×10²⁰ W/cm²时, 尽管该强度高于电离生成C⁺⁶所需要的激光强度阈值, 但该激光脉冲并不能将整个靶电离成C⁺⁶离子, 对此本文进行了详细的分析. 在研究激光脉冲宽度的影响时, 发现激光脉宽越小, 电离速度越快, 但越小的激光脉冲电离获得的高价态离子越少.     

Spectroscopic investigation of a low current arc in pure fluorine

A pure fluorine 10-A DC arc has been operated in an Al₂O₃ tube of 18 mm diameter at atmospheric pressure. This arc was used to perform radially resolved spectroscopic end-on measurements in the visible and UV-spectral regions. An excitation temperature of 7800 K on the arc axis was determined from the intensity of atomic fluorine lines, and an ion density of 1.7×10 ²¹ m^-3 was determined from the half-width of the contamination line H_β. A Boltzmann plot of the affinity continuum in the UV-spectral region yields two groups of electrons. A group of hot electrons is characterized by a temperature that agrees with the excitation temperature, and a group of cold electrons has a temperature in accordance to the gas temperature of 4000 K. The absolute intensity of the affinity continuum gives and electron density of 1.3×10²⁰ m^-3 on the arc axis, which is lower than the density of both positive and negative ions in the discharge. From the difference between the electron and gas temperature, an elastic collision cross section between the electrons and F-atoms of 2×10^-20 m² is determined