Enhanced transmission by a grating composed of left-handed materials

We present a detailed theoretical analysis about the influence of surface polaritons on the transmission properties of electromagnetic waves at the periodically corrugated interface between the vacuum and left-handed material by using nonlinear boundary condition approach. The principle behind this approach is to match the wave fields across the grating interface by using a set of linear wave equation with nonlinear boundary conditions. The resonant transmission of the incident electromagnetic radiation in this structure is feasible within a certain frequency band, where there is a range of frequency over which both the electric permittivity and the magnetic permeability are simultaneously negative. The enhanced transmission is attributed to the coupling of the incident electromagnetic wave with the excited surface polaritons on grating interface. Finally, we present the numerical results illustrating the effect of the structural parameters and angle of incidence on the transmission spectra of a TM polarized electromagnetic wave.     

Influence of Non-uniform Temperature Field on Spectra of Fibre Bragg Grating

We simulate the spectrum characteristics of fibre Bragg grating （FBG） with non-uniform temperature using the transmission matrix method, and the results are analysed. It is found that firstly the modulated coefficient of average refractive index is a very important parameter that influences the spectrum characteristic of the fibre Bragg grating, and secondly the spectrum curves are different in different temperature fields at the same parameter. Hence, we can determine the metrical temperature by analysing the spectrum of fibre Bragg grating.     

Magnetic response of dendritic structures at infrared frequencies

We propose a quasi-periodic dendritic resonant magnetic model that can be used for the realization of the negative permeability at infrared frequencies. The numerical simulation exhibits a magnetic response when the incident light is perpendicular to the plane of the model. The copper dendritic structures are prepared by the electro-deposition method. And the transmission spectrum of this dendritic structure shows a magnetic response at infrared frequencies with a maximum transmission −7.95 dB. Further studies demonstrate that the magnetic response relate to the fractal dimension of the dendritic structure to a certain extent.     

Design, Fabrication and Test of a Soft X-Ray Even-Order Transmission Grating

Most transmission gratings in the x-ray region work with their first orders and dispersion is limited by the line density achievable with current fabrication technology. We present a novel design of a two-dimensional x-ray transmission grating. The grating works with higher dispersion using its second orders, and the influence from first and third orders can be suppressed. A grating according to the novel design is fabricated and its diffraction performance is tested in comparison with a traditional x-ray transmission grating with the same line density. The novel grating could be especially useful when high dispersion is desired while the fabrication of high-density gratings becomes more difficult.     

Extraordinary optical transmission for TE wave through metallic sub-wavelength grating with slits filled with dielectric

A metallic sub-wavelength grating with slits filled with dielectric was proposed to achieve broadband and enhanced Extraordinary Optical Transmission (EOT) for Transverse Electric (TE) wave. The physical mechanism for the improvements of the transmission spectrum was also revealed. It was found that the Fabry–Perot cavity resonance in the grating slits was the cause of the enhancement of the EOT and the waveguide modes theory was the fundamental mechanism for the broadened bandwidth of the transmission.     

Development of narrow-linewidth diode lasers by use of volume holographic transmission gratings

We present two diode laser setups that employ volume holographic transmission gratings to provide optical feedback. The advantage of this kind of grating is high diffraction efficiency and the possibility to place optical elements on both sides of the grating. This allows for advanced external cavities and adjustable feedback efficiency. The first setup is a diode laser in the Littman configuration with the transmission grating replacing the conventional reflection grating. The second setup improves the frequency selectivity by substituting the feedback mirror with a passive resonator. This grating-enhanced external cavity diode laser (GECDL) achieves excellent frequency stability. A prototype of the GECDL setup demonstrates an intrinsic linewidth of 7 kHz and an operation range that covers the full amplification profile of the laser diode.     

Analytical Investigation of Transmission Properties of Metallic Gratings

We re-examine the classical one-dimensional transmission grating to explain the enhanced transmission in the surface impedance approximation. The nearly zero transmission and extraordinary transmission phenomena related to the surface plasmon are presented by analysing the scattering amplitude of waveguide mode at the output surface of grating. It is revealed that the transmission peaks are related to the Fabry-Perot factor and the interaction of surface plasmon and other diffractive orders.     

介质覆层下金属周期结构变化对TE波异常透射特性的影响

根据金属光栅结构变化对TE波异常透射特性影响的研究需要,建立了相应的模型。应用时域有限差分(FDTD)方法分别计算了单缝结构、多缝结构、不同宽度和不同周期等结构下的透射分布特征。研究发现添加凹槽会对金属表面能量的传递起阻碍作用。透射频域宽度随薄膜宽度增加而增加。随着狭缝宽度的增加,透射率分布曲线包络线趋于平坦,主透射峰短波长侧透射曲线分布基本不变,而主透射峰及其长波长侧的透射曲线分布变宽。这说明宽度的变化影响了表面共振模式,从而影响透射的分布。单个狭缝的透射与多周期结构相比,透射率曲线几乎重合,表明狭缝对表面模式没有调制作用,各狭缝的透射相对独立。     

三角形谱啁啾光纤光栅的制备及其在光纤无线单边带调制系统中的应用

本文涉及一种三角形谱啁啾光纤光栅的制备以及其在光纤无线(radio over fiber,RoF)单边带调制系统中的应用.基于相位掩模法和变速度折射率调制,实验制备了底部变化范围1.9 nm、透射深度0—15 dB的三角形谱啁啾光纤Bragg光栅,利用其透射谱具有较大负向斜边,研究了其在RoF系统中的应用.方案仅使用一个三角形谱光纤光栅,实现了以下两种功能: 1)双边带调制信号到单边带调制信号转换; 2)降低信号的载波边带比(carrier-to-sideband ratio,CSR),提高接收灵敏度.并 关键词： 光纤通信 微波光子 光纤布拉格光栅 单边带调制     

透射光栅的实验标定和衍射效率的理论模拟

透射光栅广泛应用于软X射线能谱测量.为了获得用于惯性约束聚变研究的透射光栅的各级衍射效率及其他参数,在北京同步辐射源上200—1600 eV能量范围内对其进行了标定,获得了透射光栅衍射效率的实验结果.扩展了透射光栅衍射效率的计算方法,提出了7边准梯形截面衍射效率计算模型.分析拟合了实验数据,理论结果与实验结果很好符合.得到了7边准梯形的透射光栅栅线截面结构. 关键词： 透射光栅 衍射效率 实验标定 光栅模型     

Influence of grooves in the electromagnetic transmission of a periodic metallic grating filter

The light transmittance of metal film with periodic slits and grooves structure has been investigated. It was demonstrated that the grooves significantly affect the transmittance of the metal film. The structure excavating two grooves symmetric to the central slit in a cell of a period grating displays a dent in the transmission spectrum comparing with the structure with only one slit in the cell. Deepening the grooves moves the dents to the longer wavelengths in the transmission spectrum. An analytical equation is also provided to approximately locate the dents. The grooves in the grating filter supply the advantage of removing the needless transmission of certain frequency.     

Long period polymer waveguide grating device with positive temperature sensitivity

A long-period waveguide grating (LPWG) was demonstrated in a low-loss negative tone UV-sensitive epoxy novolak resin polymer. The grating structure was fabricated on top of the waveguide using a standard UV lithography process, and no other subsequent process is required after the development step. It is shown that with an appropriate design of the structure a transmission peak at the desired wavelength can be achieved. The LPWG exhibits an attenuation of -18 dB using a grating length of 17 mm. The temperature sensitivity of the LPWG is linear and is found to be 0.89 nm/°C. A red shift of the transmission peak wavelength was also observed and is discussed. PACS 42.70.Jk; 42.79.Dj; 42.79.Gn     

A transmission line model for subwavelength metallic grating with single cut

A transmission line model for subwavelength metallic grating with single cut is presented. The model is based on analogy between the subwavelength metallic structure and the microwave transmission line theory. The analytical expression for the transmission is derived by the transfer matrix method. To confirm our model, the finite-difference time-domain (FDTD) method simulations are carried out. The influences of the position of the cuts on the higher modes of slit are presented. It is found that the transmission line model gives analytical prediction about the evolution of the transmission spectra.     

Extraordinary Transmission through Metallic Grating with Subwavelength Slits for S-Polarization Illumination

Based on the rigorous coupled-wave analysis algorithm, we have systematically analysed the effect of the geometrical parameters of a dielectric film coated metallic grating with subwavelength slits on extraordinary optical transmission for s-polarization illumination. Results show that the dielectric film which sustains a waveguide electromagnetic mode on the top of the metallic lamellar grating can strongly enhance the transmittance, the positions of the transmission peaks are mainly determined by the period of the metallic grating, the thickness and refractive index of the dielectric film. This structure shows potential applications in excellent polarizers or polarization-isotropic devices at infrared spectral range by appropriately choosing the geometrical parameters.     

Negative role of surface plasmons in the transmission of metallic gratings with very narrow slits

It is generally admitted that the extraordinary transmission of metallic grating with very narrow slits is mainly due to the excitation of surface plasmons on the upper and lower interfaces of the grating. We show that the surface plasmon contribution is not the prime effect and that waveguide mode resonance and diffraction are responsible for the extraordinary transmission. Additionally and surprisingly, we reveal that the transmittance of subwavelength metallic gratings is always nearly zero for frequencies corresponding to surface plasmon excitation. This finding implies that surface plasmons play a negative role in the transmission.     

Numerical Investigation of Surface Plasmons Associated Subwavelength Optical Single-Pass Effect

Surface plasmons （SPs） associated optical single-pass effect has been investigated in novel subwavelength metallic structures, including single slit and grating structures. With influence of SPs, these metallic structures can enhance transmission in incident direction and suppress it in the opposite direction, exhibiting a single-pass effect. The finite difference time domain method is employed to study the influences of structure parameters on far-field transmission, near-field electric field distribution and extinction ratio of the single-pass transmission effect. A maximal extinction ratio of 47.83dB is achieved in the grating structure.     

Slow and fast light using fiber Bragg grating F-P cavity

In this paper, we analyzed the properties of fiber Bragg grating F-P cavity with different grating parameters at two ends. The features of transmission spectra and group velocity were investigated under different parameters including slight increase for the differences of the lengths of the two gratings, the periods of the two gratings, the refractive index modulation depths of the two gratings. The characteristics of the slow light in fiber Bragg grating and fiber Bragg grating F-P cavity were also compared. The results of this study can be useful for actual experiments and applications in using the fiber Bragg grating F-P cavity in the slow light.     

垂直入射条件下厚金属环结构的负磁导率与左手材料行为

用矩形波导法实验研究了微波垂直入射于具有一定厚度的金属铜圆环结构的微波电磁响应行为.结果表明,当金属铜环的厚度增加到一定值时,在中心频率为145GHz处出现透射禁带,并且相位在透射禁带处发生跃变.采用双各向异性媒质理论计算了铜圆环结构的磁导率随频率变化关系,在透射禁带处磁导率为负.对厚金属圆环与金属线一一对应组合的样品,微波沿环面垂直入射时测量到左手透射通带和相位超前,通带带宽达到15GHz,强度为-21dB. 关键词： 负磁导率 垂直入射     

透射光栅衍射率的实验标定和数值计算

简要介绍了实验室中使用的三种透射光栅的结构，在北京同步辐射源上实验标定了这些光栅的相对衍射效率。借助于光栅模型，得到了光栅的重要结构参数，并对光栅的绝对衍射效率进行模拟计算和讨论。     

Effective magnetic properties of a composite material with circular conductive elements

Effective magnetic properties of a composite meta-material consisting of periodically arranged circular conductive elements are studied theoretically. A general expression for the effective bulk permeability is obtained with mutual effects and lattice ordering being taken into account. The resonance frequency of the permeability is found to be strongly dependent on the size and shape of the unit cell. Frequency dispersion of the permeability is studied with special attention paid to the frequency range, where negative values of the permeability are possible. Corresponding recommendations for optimisation of the meta-materials with negative permeability are made. The results are confirmed by numerical simulations of the finite structure behaviour in an external magnetic field. Received 19 April 2002 Published online 31 July 2002