Efficient Conversion of Tetrahydropyranyl (THP) Ethers to Their Corresponding Thiocyanates With in-situ–Generated Ph3P(SCN)2

Immediate and efficient one-pot conversion of tetrahydropyranyl (THP) ethers to their corresponding thiocyanates by in-situ–generated Ph₃P(SCN)₂ is described. Primary and secondary alkyls and also benzylic THP ethers are converted to their corresponding thiocyanates in excellent yields at room temperature by this method.     

Spectrophotometric Determination of Metoclopramide and Oxybuprocaine Through Ion Pair Formation with Thiocyanate and Molybdenum(V) or Cobalt(II)

Abstract

Two spectrophotometric methods involve the formation of two different ion pairs between the drug and inorganic complexes, Mo(V) and Co(II) thiocyanates followed by their extraction with dichlor?methane and o-nitrotoluene, respectively. The optimum conditions for the ion pair formation are established. The methods permit the determination of metoclopramide and oxybuprocaine hydrochlorides over a concentration range of 1-20 μg ml^?1 and 20–240 μg ml^?1 using Mo(V) and Co(II) thiocyanates, respectively. Molar ratio of drug to Mo(V) or Co(II) indicates a 2:1 ratio for the two drugs studied in the presence of excess thiocyanate concentration. Results of the analysis of drug substances and their dosage forms by the proposed methods are in good agreement with those obtained by the official methods.     

Solvent extraction flow-injection manifold for the simultaneous spectrophotometric determination of free cyanide and thiocyanate ions based upon on-line masking of cyanides by formaldehyde

This study reports a sensitive solvent extraction flow-injection (FI) method for the simultaneous spectrophotometric determination of free cyanide and thiocyanate in human saliva and pralidoxime solutions. Cyanide and thiocyanate form colored (λ_max=540 nm) ternary complexes with copper and 2,2′-dipyridyl-2-quinolylhydrazone (DPQH) that are extractable into chloroform. The determination of thiocyanates in the presence of cyanides is accomplished after on-line masking of the latter with formaldehyde through a binary inlet static mixer (BISM). Total thiocyanates and cyanides are determined in a second run, without the use of the masking agent. The proposed method allows the determination of the analytes in the range of 0-4 mg l⁻¹ thiocyanates and 0-3 mg l⁻¹ cyanides, with the 3σ detection limits being 0.007 and 0.004 mg l⁻¹, respectively. The precision of the method (s_r<1.0% at 1 mg l⁻¹ CN⁻ or SCN⁻, n=12 in both cases) and the sampling rates were quite satisfactory (60 injections per hour). The method was applied to the analysis of human saliva and pralidoxime solutions and gave recoveries in the range of 98.0-102.2% for both analytes whereas the mean relative error was e_r=1.7%.     

Simultaneous Determination of Selenocyanate and Thiocyanate Ions in the Presence of Cyanide by Oxidation with bis (Trifluoroacetoxy) iodobenzene

Abstract

An investigation of the use of potentiometric titrations of selenocyanate and thiocyanate aqueous solutions, in the presence of cyanide ions, with bis (trifluoroacetoxy) iodobenzene in acetonitrile and then the gravimetric determination of the products of the reactions, elemental selenium and sulphate ions, has been carried out.

Selenocyanates are first oxidized to selenium and then thiocyanates are oxidized to sulphate ions. Break point curves are identified. The rose-pink precipitate is filtered and the clear filtrate is warmed on a hot plate for evaporation of acetonitrile. A solution of barium chloride is added to the hot solution in order to precipitate the sulphate ions.     

Some Tetrahedral Coordination Polymers of Zinc(II), Cadmium(II), and Mercury(II) Involving 4-Aminomethylpyridine

Abstract

Analytical data and infrared spectral measurements down to 200 cm^?1 on the 1:1 compounds formed by the interaction of zinc(II) and cadmium(II) thiocyanates and mercury(II) chloride and bromide with 4-aminomethylpyridine indicate that the compounds are coordination polymers having tetrahedral stereochemistry with bidentate bridging 4-aminomethylpyridine molecules and terminally bonded halogen/pseudohalogen groups in the solid state.     

Direct Determination of Zinc Using Dithizone in Micellar Solution

Abstract

A simple method for direct determination of Zn²⁺ by spectrophotometry using dithizone in micellar solutions is possible. Surfactants are used to overcome the solubility problems of dithizone in aqueous medium. The proposed method saves time and chemicals and is of extremely high sensitivity. Zn²⁺ concentrations of about 2×10^-7 M can be determined. The important analytical parameters and their effects on the reported system are investigated.     

Chlorodiphenylphosphine as Highly Selective and Efficient Reagent for the Conversion of Alcohols,Tetrahydropyranyl and Silyl Ethers to Thiocyanates and Isothiocyanates

Abstract

A simple, highly selective and efficient method is described for the conversion of primary alcohols, tetrahydropyranyl and silyl ethers to thiocyanates by use of chlorodiphenylphosphine and ammonium thiocyanate. Secondary substrates produce both the two isomeric products, thiocyanate and isothiocyanate, while tertiary ones give isothiocyanates as the only products by this new method. In contrast to previously reported methods based on trivalent phosphorus for this transformation, the present method does not require an electrophile in the presence of trivalent phosphorus (ClPPh₂). The order of activity of these substrates is silyl ether> alcohol > tetrahydropyranyl ether. The present method not only interestingly distinguishes between primary, secondary and tertiary substrates but also converts them to the corresponding thiocyanates with excellent chemoselectivity in the presence of several other functional groups.     

Electrochemical oxidation of thiocyanates on boron-doped diamond electrode in alkaline solutions

Electrochemical oxidation of thiocyanates on a boron-doped diamond electrode in an alkaline medium was studied. An analysis of polarization curves demonstrated that the process of SCN oxidation occurs at water deposition potentials and is controlled by the mass transfer of the substrate to the electrode surface. It is shown that the oxidation efficiency of thiocyanates and the specific electric energy expenditure depend on the current density and on the method by which the process is performed. At a current density of 8 mA cm^?2, more than 90% of thiocyanates is oxidized to CNO, carbon dioxide, and nitrogen with a specific energy expenditure of 26.3 kW h kg^?1 SCN.     

Using Ho3+ Fluorescence Enhancement as a Novel Probe in Monitoring of Human Serum Albumin

Abstract

In this work, for the first time, the fluorescence enhancement of Ho³⁺ ions is introduced as a novel probe for human serum albumin (HSA) determination in aqueous solution. Lanthanides express very specific luminescence emissions, due to their unfilled 4fⁿ electronic orbital, and thus, the fluorescence of the lanthanide ions can be radically improved when they are coordinated with the appropriate organic molecules. By applying this method, HSA can be determined up to 0.066 mg L^?1.     

A Rapid Fluorometric Method For The Determination Of Salicylic Acid In Serum And Urine

Abstract

A fluorometric method of Tb-SSA-EDTA-surfactant complex for determining salicylic acid in serum and urine is proposed. This method is fast, simple, sensitive in determining sallicylate ion in aqueous medium. Protein removal from serum is not required. 1.0 × 10^?-⁴ M- 1.0 × 10^?-² M of salicylic acid in samples can be determined by the proposed procedure. The percentage of recovery was satisfactory. This procedure can be used in emergency toxicology.     

Electrochemical Behaviour of Loprazolam and its Determination in Pharmaceutical Formulations

Abstract

The electrochemical behaviour of Loprrzoiam has been determined in aqueous solution at 37 > Cusing DC polarography, differential pulse polarography and voltammetry and linear sweep cyclic voltammetry. Loprazolam can be quantitavely determined up to 3.9 10^?6 M at pH 6.5 using DP polarography, the detection limit being established at 1.6 10^?7 M. The method developed was applied to the determination of the compound in its formulations, Somnovit 1 mg, obtaining errors lower than 4%.     

Voltammetric Measurement of [Cu(II)]/[Cu(I)] at a Platinum Rotating Disc Electrode and Control by Electrolysis at a Platinum Net Electrode in Chloride Solutions

ABSTRACT

A method has been described to measure and control the [Cu(II)]/[Cu(I)] bulk concentration ratio in aqueous chloride solutions. A variation of the ratio is achieved by controlled potential electrolysis at appropriate reducing or oxidizing potentials. The concentration ratio can be monitored by a repetitive double potential step amperometric method at a platinum rotating disc electrode. The amperometric signal can be used to control the electrolytic process in order to obtain and maintain a predetermined bulk concentration ratio. Diffusion coefficients of respectively 6.2 10^?6 and 5.6 10^?6 cm² s^?1 have been determined for Cu(II) and Cu(I). Potential applications of the method are the control of polymerisation reactions, of the reduction of textile dyes with the aid of a mediator system and of the colour characteristics of different kinds of glass.     

Fluorometric Determination of Traces Of Mg(II) Using 1, 5-Dihydroxyanthracuinone as Reagent

Abstract

The florescent characteristics of the complex formed by 1, 5-dihydroxyanthraquinone with Mg(II) in aqueous ethanol (λ_ex 490 nm,λ_em=600 nm; pH_ap=9.1-9.6; 10% H₂O; reagent concentration=4×10^?5M) are described. The stoichiometry and the stability constant (1:1 and log K=4.90) are determined. A new fluorometric method for the determination of 10-100 ppb Mg(II) is proposed.     

A concise and optimized four-step approach toward 2-(aryl-)alkylsulfanyl-, 4(5)-aryl-, 5(4)-heteroaryl-substituted imidazoles using alkyl- or arylalkyl thiocyanates

A convenient cyclization method leading to trisubstituted imidazoles in up to 84% yield is reported. Diverse 1-aryl-, 2-heteroaryl-substituted ethanones are converted into the corresponding α-oximino derivatives which are reduced under regioselective conditions. The obtained α-amino carbonyl intermediates are reacted with alkyl- or arylalkyl thiocyanates to directly yield C²-S-substituted imidazoles.     

Selective Determination of Hafnium with Solid Surface Room Temperature Phosphorescence Optosensing

Abstract

An optosensing method for selective determination of hafnium has be developed. It is based on the phenomenon that when the complex formed by 8-hydroxy-5-quinolinesulfonic acid with hafnium is absorbed on the strongly basic anion exchange resin, the phosphor can produce room temperature phosphora-scence (RTP) in aqueous medium. The hafnium can be determined selectively in the presence of zirconium. The RTP intensity is linear up to 4×10^-5 M of hafnium, the detection limit is found to be 5×10^-8 M of hafnium.     

Determination of Amitraz in Honey by First-Derivative Spectrophotometry

Abstract

A new method for the determination of 1,5-bis(2,4-dimethylphenyl)-3-methyl-1,3,5-triazopenta-1,4-diene (Amitraz) in honey by derivative spectrophotometry is proposed. Amitraz is extracted from aqueous honey solutions with CCI₄ and it is determined between 0.1 and 1.5 μg. ml^?1 from the first-derivative spectrum by measuring the peak amplitude at 332 nm (¹D₃₃₂), as the vertical distance from the peak to the baseline.     

Efficient and Convenient Method for Synthesis of Benzofuran-3-acetic Acids and Naphthafuran-acetic Acids

Herein, we report an efficient and convenient method for synthesis of benzofuran-3-acetic acids and naphthafuran-acetic acids 5a–p by the reaction of substituted-4-bromomethylcoumarins with aqueous sodium hydroxide at refluxing temperature. The obtained products are characterized by infrared, ¹H NMR, ¹³C NMR, and mass spectral data. Structures 5a and 5e are confirmed by their single x-ray diffraction studies. The advantages of this method are good yields, easy workup, and no chromatographic purifications.     

Theoretical studies on the geometric and electronic structure of substituted SCN isomers: Part 1. Non-empirical and MNDO results for some thiocyanates

Some well known thiocyanates have been studied by non-empirical and MNDO methods. The reliability of the adopted basis set and the unimportance of d orbitals on sulfur in describing thiocyanates have been tested on the HSCN molecule.The geometrical parameters computed at the STO—3G level are in good agreement with experimental data and indicate that thiocyanates are w shaped molecules with a high bending constant around the sulfur atom and quite important coupling between CSC and SCN angles.The MNDO method gives similar results, except for CS bond lengths, which are systematically underestimated.The correlation between geometry and electronic structure of thiocyanates is discussed, with special reference to cyanates, on the basis of PMO theory, Walsh diagrams and Mulliken population analysis.     

Liquid Anion Exchange Studies and Separation of Mercury

Abstract

A new method is developed for the extractive separation of mercury from associated elements. Mercury is quantitatively extracted from 0.5 M acetic acid solution by aliquat 336 S, which acts as a liquid anion exchanger. The metal ion from the organic phase is stripped with sodium hydroxide solution and determined in the aqueous phase complexometrically. The extracted species is [2(R₄N⁺), Hg(OAc)₄ ^?2]. A working procedure for the selective separation of mercury from zinc, cadmium, nickel, cobalt, copper, bismuth and manganese is described.     

Construction of a N-Acetyl-L-methionine Electrode and Determination of Acylase with an Ammonia Gas Sensor

Abstract

The N-acetyl-L-methionine electrode is based on a coupled enzymatic system consisting of acylase and L-amino acid oxidase with an ammonia gas sensor; conditions of imobilization are optimized. N-acetyl-L-methionine in the range 4×10^?5–2×10^?3M gives a linear potential vs. log(concentration) plot with a response time of 2–5 min over the range specified. This electrode combined with an L-methionine electrode, based only on L-amino acid oxidase and an ammonia gas sensor, can be used for the determination of both substrates in mixtures, thus extending the feasibility of the method. Acylase (0.1–2.00) is determined in aqueous solutions by adding N-acetyl-L-methionine to the sample, and measuring the ammonia evolved with the gas-sensing electrode.