Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.     

Fiber Modal Index Measurements Based on Fiber Gratings

A novel method based on fiber gratings for measuring the effective indices of fiber modes is proposed. The effective index difference between the core mode and a cladding mode was obtained by analyzing the interference fringe of a pair of cascaded long-period fiber gratings. In order to extract the core mode index from the measured index difference, an index matching oil immersion method is proposed. By analyzing the interaction between the cladding mode and the oil applied on the cladding surface, the mode order and the effective index of the involved cladding mode might be calculated. Experimental results about the interference fringe shifts induced by the oil index and the oil-applied length are also presented.     

Optical Pulse Compression Schemes That Use Nonlinear Bragg Gratings

Nonlinear optical pulse compression of picosecond pulses typically requires long lengths of optical fiber and multiple components. Periodic structures, such as fiber Bragg gratings, are highly dispersive at wavelengths outside of the photonic bandgap. This implies that such gratings can be used as very short all-fiber compressors. In this paper a number of such compression schemes are reviewed involving uniform and nonuniform fiber Bragg gratings, relying on both soliton and nonsoliton compression principles. Experimental results supporting the corresponding underlying theory are also presented. Finally, an extension of one of the compression schemes is shown, which allows the generation of adjustable high-repetition rate soliton trains.     

Energy loss correction for a crystal calorimeter

Material effect of inner-detectors on the performances of the BESⅢ Electromagnetic Calorimeter (EMC)is investigated.The BESⅢ Time-Of-Flight counters(TOF)have been utilized to improve the energy resolution and detection efficiency for photons after a careful energy calibration.A matching algorithm between TOF and EMC energy deposits is developed,and the effects of beam-related background are discussed.The energy resolution is improved and the photon detection efficiency can be increased by the combined measurement of EMC and TOF detectors.     

Loss Behavior of Single-mode Optical Fiber Microbend Sensors

Periodic microbending has been studied to develop an insight into the loss behavior of single-mode microbend sensors by using the finite-difference beam propagation method. Loss sensitivity variations with wavelength are examined, as well as the optical loss dependence on the number of microbends and the modal field perturbations caused by the microbending.     

Photonic Architectures for Broadband Adaptive Nulling with Linear and Conformal Phased Array Antennas

This paper presents several photonic architectures for independently steering multiple broadband nulls for linear and conformal phased array antennas. Analytic expres sions that quantify bandwidth requirements are developed and both experimental and simulation results which demonstrate the antenna system performance are presented. In a fully integrated, optimized system, null depths in excess of 50 dB across a multigigahertz bandwidth are anticipated and the critical factors that influence this performance are examined.     

Fiber Grating Based Optical Recirculating Filter with an Optimized Response

A novel optical recirculating filter for RF applications is described, which exploits a specially designed fiber grating with a ramped spectral profile to enable optimization of the filter response. The design overcomes the limitations imposed by loss in conventional fiber recirculating filters. Additionally, a tunable free spectral range is demonstrated by using the device in a grating array. Both theoretical and experimental results are presented and discussed.     

Temperature Sensitivity Control and Mechanical Stress Effect of Boron-Doped Long-Period Fiber Gratings

We will present in this work the quantitative analysis of the relationship between the doping concentrations of GeO 2 and B 2 O 3 in the core and cladding regions and the temperature sensitivity of the resonance wavelength shift in long-period fiber gratings (LPFGs). Based on this analysis, the temperature sensitivity was suppressed and enhanced to 0.002 nm/°C and 0.28 nm/°C, respectively. We will also discuss the effect of the residual mechanical stress on the optical and mechanical properties of LPFGs. In particular, we will present the measurement results of the dependence of the refractive index change and mechanical strength on the residual mechanical stress in the boron-doped fibers with depressed clad and matched clad.     

Effect of charge compensation on emission spectrum of Ca2SiO4:Dy3+ phosphor

The Ca2SiO4:Dy3+ phosphor was synthesized by the high temperature solid-state reaction method in air.The emission spectrum of Ca2SiO4:Dy3+ phosphor shows several bands at 486, 575, and 665 nm under the 365-nm excitation. The effects of Li+, Na+, and K+ on the emission spectrum of Ca2SiO4:Dy3a+ phosphor were studied. The results show that the emission spectrum intensity is greatly influenced by Li+, Na+,and K+. The charge compensation concentration corresponding to the maximum emission intensity is different with different charge compensations.     

Integrated optical electric field sensor with telescopic dipole

An integrated optical electric field sensor based on a Mach-Zehnder interferometer with the telescopic dipole is designed and fabricated, and its electrodes are segmented and connected with a telescopic dipole. The measured results show that when the frequency response is from 10 kHz to 6 GHz with the antenna length of 55 mm, the minimum detectable electric field of 20 mV/m can be obtained, and the linear dynamics range can reach 90 dB at 250 MHz.     

Conductively cooled all-solid-state zigzag slab laser

A diode pumped, Q-switched Nd：YAG zigzag slab laser is developed using passive conduction cooling. Flat-flat and unstable resonators are adopted in this experiment. The 150-mJ multi-mode and 100-mJ single-mode laser outputs with pulse width of 10 ns are achieved, corresponding to optical efficiencies of 19% and 13%, respectively. The experimental result demonstrates that the laser has the property of compact structure, high efficiency, reliability, and high beam quality. The design of laser has a potential application in space environment.