Physicochemical properties of structured phosphatidylcholine in drug carrier lipid emulsions for drug delivery systems

Drug carrier emulsions were prepared with structured phosphatidylcholine (PC-LM) which has both a long hydrocarbon chain and a medium hydrocarbon chain, and the characteristics of PC-LM as an emulsifier were investigated by measuring the creaming ratio, the surface tension of the emulsion system, and the mean particle size and zeta potential of the oil droplets in emulsions. The emulsion prepared with PC-LM as an emulsifier kept the condition and the ratio of separation was lower than those with purified egg yolk lecithin (PEL). The mean particle size of the emulsion prepared with PC-LM was smaller than that with PEL when using only sonication, approximately 250 nm. When using a high-pressure homogenizer after sonication, the mean emulsion size with PC-LM was also smaller than with PEL, approximately 150 nm. The surface tension of the various emulsions and the zeta potential of the emulsion droplets were measured to investigate the stability of the systems. In emulsions with PC-LM or PEL, the surface tension as an index of stability increased as the pressure of the homogenizer increased. Moreover, the zeta potential of the emulsion droplets prepared with PC-LM also increased with an increase in pressure of the homogenizer. As a result, it was found that the drug carrier emulsion prepared with PC-LM had significant advantages in terms of stability and mean diameter. We considered it could be used for the preparations of nanoparticle dispersion systems in drug delivery systems.     

Physicochemical and biological properties of polyampholytes: Quaternized derivatives of poly(4-vinylpyridine)

The modification of poly(4-vinylpyridine) with ω-bromocarboxylic acids and alkyl bromides yields three types of polyampholytes: polyampholytes containing both cationic and anionic groups in each monomer unit (polybetaines), polyampholytes containing betaine and cationic units, and polyampholytes containing betaine units and side cetyl radicals. Their complex formation with liposomes formed from zwitterionic (electroneutral) phosphatidylcholine and anionic diphosphatidylglycerol (cardiolipin) is investigated. The method for fixation of polymers on the liposomal membrane and the stability of the formed complexes are determined by the chemical structure of macromolecules. For the most part, polyelectrolytes are electrostatically adsorbed on the membrane and are fully removed from it with an increase in the salt concentration in the surrounding solution. An exception is the polybetaine obtained through the modification of poly(4-vinylpyridine) with ω-bromobutyric acid, which irreversibly binds to liposomes probably owing to the incorporation of macromolecular fragments into the hydrophobic part of the lipid bilayer. The insertion of side cetyl radicals into polybetaine molecules stabilizes their complexes with liposomes in the presence of salts. The cytotoxicity of the synthesized polyampholytes is one to two orders of magnitude lower than that of a cationic polymer with the same degree of polymerization.     

Synthesis and biological activity of some new aminoacylcarbazole derivatives. Part I

The syntheses of different 9-(N-phthalyl- or N-tosyl- or free aminoacyl)carbazoles and the corresponding derivatives of 3,6-dinitrocarbazoles and some derivatives of 3,6-diamino-9-(N-phthalylaminoacyl)carbazoles (II-XXXII) are described. Compounds VIII, XIII-XVII and XXIII-XXVII were found to be active against a number of microorganisms.     

Synthesis and properties of phenothiazine derivatives. I. Synthesis and properties of bisoxytriazenes containing the phenothiazine fragment

3, 7-Bis(1-phenyl-3-hydroxytriazenyl)phenothiazine has been synthesized from phenothiazine. This compound decomposes to phenyl radicals, nitrogen and 3, 7-bisnitrosophenothiazine under the influence of nitroso compounds and oxidizing agents (PbO₂, Ag₂O). The reaction of bishydroxytriazenylphenothiazene with 2, 4, 6-tribromonitrosobenzene has been studied by EPR spectroscopy.N. P. Ogarev Mordov State University, Saransk 430000. Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 9, pp. 1284–1287, September, 1996. Original article submitted March 21, 1996.     

Studies on antiinflammatory agents. I. Synthesis and pharmacological properties of 2'-phenoxymethanesulfonanilide derivatives.

Various 2'-phenoxymethanesulfonanilide derivatives were synthesized and evaluated for antiinflammatory and analgesic activities. Some compounds bearing an electron-attracting substituent at the 4'-position strongly inhibited adjuvant-induced arthritis in rats and acetic acid-induced writhing syndrome in mice without causing gastro-intestinal irritation. Among them, 4'-cyano-(FK867) and 4'-acetyl-(FK3311) 2'-(2,4-difluorophenoxy)methanesulfonanilides were selected as the candidates for further development.     

Study of cryostructuring of polymer systems. 42. Physicochemical properties and microstructure of wide-porous covalently cross-linked albumin cryogels

Chemically cross-linked wide-porous protein cryogels have been obtained by freezing aqueous bovine serum albumin (BSA) solutions (30–50 g/L) at–15,–20, or–25°C in the presence of water-soluble carbodiimide (CDI) as a coupling agent. It has been shown that the gel-fraction yield and the swelling extent of the polymer phase of the formed spongy matrices depend primarily on the initial concentration of albumin and the amount of CDI added to a system, while the morphometric characteristics of the porous microstructure of the BSA cryogels are mainly determined by the temperature of the cryogenic treatment. The sizes of macropores in the obtained cryogels range from ≈50 to ≈200 μm. A high-sensitivity differential scanning calorimetric study of the conformational state of protein macromolecules incorporated into the spatial network of the polymer phase (gel walls of macropores) of the cryogels has shown that, during the cryotropic gelation, the native structure of albumin globules is subjected to “cold denaturation,” and the partly unfolded conformation of the protein is, simultaneously, fixed by intermolecular covalent cross links.     

Polymerization of para-xylylene derivatives (parylene polymerization). I. Deposition kinetics for parylene N and parylene C

Kinetic aspects of parylene N [unsubstituted poly(para-xylylene)] and Parylene C [monochlorosubstituted poly(para-xylylene)] were studied. The conversion of starting material (dimer of either p-xylylene or chloro-para-xylylene) to polymer is quantitative (ca. 100%). Consequently, the total polymer formed in a closed system is directly proportional to the amount of dimer charged. However, the percentage of the total amount of polymer formed which deposits on substrate surfaces, placed in the deposition chamber, as well as the polymer film growth rate are dependent on operational factors such as the temperature of the substrate, sublimation of dimer temperature, flow pattern of the reactive species, etc. Parylene C, being a heavier and more polar molecule, has the tendency to deposit easily in the deposition chamber compared to the deposition of Parylene N. Parylene C also has a higher ceiling temperature for deposition than Parylene N. This situation has been investigated from the viewpoint of excess thermal energy which hinders polymer formation (deposition) due to the exceedingly high entropy change necessary for polymer deposition to occur. The addition of a cool (i.e., room temperature) inert gas was shown to increase the deposition of Parylene N on substrate surfaces placed in the deposition chamber. The deposition increase and acceleration of deposition (film growth) rate were found to be related to the size and molecular weight of the inert gas pressure maintained in the system. The accelerating effect is explained by the increase in third-body collisions to dissipate the excess thermal energy of the reactive species.     

A study of sesquiterpene lactones by13C NMR spectroscopy. I.13C NMR spectra of badkhyzin and its derivatives

The¹³C NMR spectra of badkhyzin and its derivatives have been studied.     

Unified analysis of thermodynamic and rheological properties of high polymer solutions. I. Binary systems

We present a comprehensive experimental study of thermodynamic and rheological properties of semidilute polymer solutions in good solvent. Osmotic pressure and viscosity measurements have been done in several polymer‐solvent systems at different temperatures. A renormalization group technique was applied to analyze the data using de Gennes's blobs model to connect dynamic and conformational quantities. The behavior of polymer systems in the whole range from dilute to semidilute solutions can be satisfactorily described using only a few nonuniversal quantities experimentally determined. An adequate agreement between experiments and theory was found, showing universal behavior with a system‐dependent constant β that does not depend on molecular weight or concentration. © 2001 John Wiley & Sons, Inc. J Polym Sci Part B: Polym Phys 40: 290–301, 2002