Self-seeded multiwavelength Brillouin-erbium laser using NOLM-NALM

In this paper, we demonstrate a new architecture of a self-seeded multiwavelength Brillouin-erbium laser by using a nonlinear optical-loop mirror and a nonlinear amplifying-loop mirror (NOLM-NALM). A stable operation of 61 Brillouin-Stokes lines with a 0.08-nm spacing was obtained and the laser exhibited satisfied the flatness of the output spectrum with a low-threshold pump power. It is shown that the four-wave mixing (FWM) contributes to the generation of high-order Brillouin-Stokes and anti-Stokes and, consequently, results in the increase of the Stokes number and the reduction of its peak power.     

Tunable multiwavelength Brillouin-erbium ring-cavity fiber laser with short-length photonic crystal fiber

A multi-wavelength Brillouin-erbium ring-cavity fiber laser utilizing 2-m erbium doped fiber (EDF) and 70-m high nonlinear photonic crystal fiber (PCF) is proposed and demonstrated. The output characteristics and also the impacts of pump and Brillouin pump (BP) on the output spectra are investigated in detail. The output number and wavelength location of Brillouin lines are tunable by adjusting the power of 1465 nm pump and BP, and a 5-channel output within 11 nm (1551–1562 nm) tuning range is achieved by choosing appropriate pump power.     

Broadly tunable multiwavelength Brillouin-erbium fiber laser using a twin-core fiber coupler

A tunable multiwavelength Brillouin-erbium fiber laser (MW-BEFL) using a twin-core fiber (TCF) coupler is proposed and demonstrated. The TCF coupler is formed by splicing a section of TCF between two single-mode fibers. By simply applying bending curvature on the TCF coupler, the peak net gain is shifted close to the Brillouin pump (BP), which has advantage for suppressing self-lasing cavity modes with low-BP-power injection. In this work, the dependency of the Stokes signals tuning range on the free spectral range (FSR) of TCF coupler is studied. It is also found that the tuning range of MW-BEFL can exceed the FSR of TCF coupler by adopting proper BP power and 980-nm pump power. Up to 40 nm tuning range of MW-BEFL in the absence of self-lasing cavity modes is achieved.     

Flattening effect of four wave mixing on multiwavelength Brillouin-erbium fiber laser

A multiwavelength Brillouin-erbium fiber laser with enhanced output uniformity is demonstrated and its performance with and without the assistance of four wave mixing (FWM) is compared. The presence of FWM effect is proven by the generation of anti-Stokes wave and higher-order Stokes wave. This scheme is successful in flattening the multiwavelength output. At Brillouin pump wavelength of 1,550 nm, between the first and the last output channel, peak power differences of 4.59 and 8.32 dB are recorded for the scheme with and without the assistance of FWM, respectively. This represents 3.73 dB improvement in the multiwavelength output power uniformity.     

Double Brillouin frequency spaced multiwavelength Brillouin-erbium fiber laser with 50 nm tuning range

A 50 nm tuning range multiwavelength Brillouin-erbium fiber laser (MWBEFL) with double Brillouin frequency spacing is presented. Two separated gain blocks with symmetrical architecture, consisted by erbium-doped fiber amplifiers (EDFAs) and Brillouin gain media, are used to generate double Brillouin frequency spacing. The wider tuning range is realized by eliminating the self-lasing cavity modes existing in conventional MWBEFLs because of the absence of the physical mirrors at the ends of the linear cavity. The Brillouin pump (BP) is preamplified by the EDFA before entering the single-mode fiber (SMF), which leads to the reduction of threshold power and the generation enhancement of Brillouin Stokes (BS) signals. Four channels with 0.176 nm spacing are achieved at 2 mW BP power and 280 mW 980 nm pump power which can be tuned from 1525 to 1575 nm.     

Multiwavelength Brillouin-erbium fiber laser incorporating a fiber Bragg grating filter

In this paper, we demonstrate a multiwavelength Brillouin erbium fiber laser in a Fabry-Perot cavity. The design utilized a bidirectional oscillation provided by a fiber Bragg grating filter and a fiber loop mirror at each end of the laser cavity. A stable operation of 25 Brillouin-Stokes lines was obtained at around a 1559-nm band.     

Optical carrier-suppression technique with a Brillouin-erbium fiber laser

We demonstrate a new concept in optical carrier control that uses a simple arrangement based on a hybrid Brillouin-erbium fiber laser. The system offers precise tunable control of the optical carrier amplitude independently of the characteristics of the transmitter or the optical modulation format. As much as 55 dB of carrier attenuation is demonstrated, which to our knowledge is the highest reported attenuation for a carrier-suppression system.     

Multiwavelength self-seeded Brillouin-erbium fiber laser with 45-nm tunable range

We have demonstrated a tunable multiwavelength self-seeded Brillouin-erbium fiber laser (BEFL) without externally Brillouin pumping. In this scheme, the stable multiwavelength comb can be produced within a ∼45-nm wavelength tuning range through adjusting the polarization controllers (PCs) in a high-birefringent Sagnac loop mirror. The generation of ∼200-line Stokes comb has been achieved by adjusting PCs under bidirectional pumping of two laser diodes, which is the largest wavelength number to the best of our knowledge. The effect of 980 nm pump power on the multiwavelength generation was also investigated.     

Switchable Brillouin frequency multiwavelength and pulsed fiber laser

Switchable single and double Brillouin multiwavelength and pulsed laser is successfully demonstrated. Brillouin spacing can be switched from single(0.08 nm) to double spacing(0.16 nm) or vice versa by swapping the ports of the coupler in the proposed configuration. The proposed configuration can also be used to produce pulsed laser by inserting a home-made carbon nanotubes saturable absorber into the laser cavity. The proposed system is very versatile and flexible as it can be used as a multiwavelength laser or pulsed laser to cater for different types of applications.     

Full L-band coverage of multiwavelength erbium-doped fiber laser

We propose and experimentally demonstrate a dual-pass unbalanced in-line Sagnac interferometer as a novel comb filter for implements in erbium-doped fiber lasers to obtain wide wavebands of multiwavelength radiations with enhancements of signal-to-noise ratios (SNRs). The hybrid combinations of the comb filter with the two schemes of nonlinear polarization rotation and intensity dependent loss have successfully not only enlarged the lasing bandwidth up to 47 nm but also enhanced the SNR up to 40 dB. The simultaneous lasing-wavelengths of 117 channels are also obtained. The multiwavelength lasing spectra with free spectral range of 0.4 nm covering the full L-band are useful for the applications of DWDM and WDM-PON systems.     

Directivity influence of signals propagation through EDFA gain medium of Brillouin-erbium fiber laser

We experimentally demonstrate a multiwavelength Brillouin-erbium fiber laser in two configurations; uni-directional and bi-directional propagation of Brillouin pump and Brillouin Stokes signals through an Erbium-doped fiber gain. The influence of these configurations on the performance of the output parameters in terms of lasing threshold, output channel generation and tuning range of the generated output channels are investigated. We discovered that there is a trade-off between these two fiber laser configurations. The uni-directional amplifier configuration provides greater tuning range of 46.8 nm against 23 nm at maximum Brillouin pump power of 2 mW and 1480-nm pump power of 130 mW. On the other hand, the bi-directional amplifier configuration provides 13 output channels against 6 output channels obtained from the uni-directional amplifier configuration at the same pumping powers. Nevertheless, the bi-directional amplifier configuration requires much lower pump power to initiate lasing.     

Room-temperature multiwavelength erbium-doped fiber ring laser employing sinusoidal phase-modulation feedback

An effective method for achieving a room-temperature multiwavelength erbium-doped fiber ring laser is presented. Simultaneous multiwavelength lasing with 0.5-nm intervals is achieved both experimentally and theoretically by addition of sinusoidal phase modulation in the ring cavity to prevent single-wavelength oscillation.     

Wideband multiwavelength erbium-doped fiber ring laser with frequency shifted feedback

Wideband multiwavelength erbium-doped fiber ring lasers with frequency shifted feedback are described. The use of an intra-cavity gain flattening filter (GFF) was proposed in order to increase the lasing spectral bandwidth, leading to a demonstration of 34 lasing wavelengths in 28 nm bandwidth in C-band. The GFF induced spectral output power fluctuation is discussed. Multiwavelength operation was also demonstrated for the first time in L-band, where wideband laser operation was obtained without a GFF. Optical bistability and Kerr effect induced pulsation were determined to be limiting factors to stable operation range in this kind of multiwavelength lasers.     

Widely tunable linear-cavity multiwavelength fiber laser with distributed Brillouin scattering

We demonstrate a multiple wavelength Brillouin/erbium fiber laser in a linear cavity configuration.The laser cavity is made up of a fiber loop mirror on one end of the resonator and a virtual mirror generated from the distributed stimulated Brillouin scattering effect on the other end.Due to the weak reflectivity provided by the virtual mirror,self-lasing cavity modes are completely suppressed from the laser cavity.At Brillouin pump and 1480-nm pump powers of 2 and 130 mW,respectively,11 channels of the demonstrated laser with an average total power of 7.13 dBm can freely be tuned over a span of 37-nm wavelength from 1530 to 1567 nm.     

Investigation of a multiwavelength raman fiber laser based on few-mode fiber Bragg gratings

We propose and experimentally demonstrate a simple multiwavelength Raman fiber laser based on few-mode fiber Bragg gratings without additional multichannel filters. The multiwavelength Raman laser output has a high extinction ratio of more than 45 dB. The multiwavelength output is so stable that the peak power fluctuation is less than 0.5 dB. The number of lasing wavelengths can be adjusted, corresponding to the properties of few-mode Bragg gratings with multiple resonant wavelengths. By the thermal tuning method, the lasing wavelength of each channel can be effectively controlled, and the laser's tunability is measured to be 10.5 pm/ degrees C.     

Broadly tunable multiwavelength fiber laser with bismuth-oxide EDF using large effective area fiber

A multiwavelength laser comb using 2.49 m Bismuth-oxide erbium-doped fiber (Bi-EDF) with different lengths of large effective area fiber (LEAF) in a ring cavity configuration is realized. The Bi-EDF is used as the linear gain medium and LEAF is used as the non-linear gain medium for stimulated Brillouin scattering. Out of the four different lengths, the longest length of 25 km LEAF exhibits the widest tuning range of 44 nm (1576 to 1620 nm) in the L-band at 264 mW pump power and 5 mW Brillouin pump power. In addition, a total of 15 output channels are achieved with total average output power of −8 dBm from this laser structure. All Brillouin Stokes signals exhibit high peak power of above −20 dBm per signal and their optical signal-to-noise ratio of greater than 15 dB.     

Simple tunable multiwavelength Brillouin/Erbium fiber laser utilizing short-length photonic crystal fiber

We have demonstrated a simple ring cavity tunable multiwavelength Brillouin/Erbium fiber laser (MWBEFL), in which 70 m highly nonlinear photonic crystal fiber (HNL-PCF) is used as the Brillouin gain medium. The fiber laser utilizes recycling mechanism to enhance stimulated Brillouin scattering (SBS). The configuration that consists of only 3 optical components is easy to be integrated and improves the practicality. At the maximum 1480 nm pump power of 110 mW and the Brillouin pump power of 3 dBm, 10 stable output channels with more than 10 dB optical signal to noise ratio (OSNR) and 0.078 nm channel spacing could achieve 10 nm tuning ranges.     

Wavelength-spacing tunable multiwavelength erbium-doped fiber laser based on four-wave mixing of dispersion-shifted fiber

We experimentally demonstrate a wavelength-spacing tunable multiwavelength erbium-doped fiber laser based on degenerate four-wave mixing in a dispersion-shifted fiber incorporating multiple-fiber Bragg gratings. We have achieved stable operation of the multiwavelength erbium-doped fiber laser, which has 0.8 nm spacing ten-channel lasing wavelengths and a high extinction ratio of more than approximately 45 dB, at room temperature. The output power of the multiwavelength erbium-doped fiber laser is stable, so the peak fluctuation is less than approximately 0.2 dB. By changing the properties such as loss and polarization state of multiple fiber Bragg grating cavities, we can exercise flexible control of the wavelength spacing of the multiwavelength output. We can also obtain switchable multiwavelength lasing operation by elimination of the effects of alternate single-fiber Bragg gratings.     

Stable double spacing multiwavelength Brillouin-Erbium doped fiber laser based on highly nonlinear fiber

A double frequency spaced multiwavelength Brillouin-Erbium doped fiber laser (BEDFL) with figure-of-eight cavity have been successfully developed and tested. Double frequency spacing is achieved by using a piece of 2 km of highly nonlinear fiber (HNLF) as a gain medium. Figure-of-eight configuration removes the odd order Stokes signals via a four-port circulator. Fifteen Stokes channels are simultaneously generated with a spacing of 0.154 nm that is around 20 GHz, when the Brillouin pump and 980 nm pump powers are fixed at the optimized values of 6 dBm and 40 mW, respectively. Fourteen anti stoke channels are also obtained, which are generated through four wave mixing (FWM) process in the laser cavity. The output is smooth triangular comb. The BEFL can also be tuned from 1526.5 to 1567.5 nm.     

A stable multiwavelength SOA-based fiber ring laser with ultra-narrow wavelength spacing

This investigation demonstrates a stable multiwavelength fiber ring laser with ultra-narrow wavelength spacing using a semiconductor optical amplifier (SOA). A delay interferometer and a mirror are used as a double-pass interferometer to improve the signal-to-noise ratio in this experiment. Up to 181 stable lasing wavelengths with a wavelength spacing of 10.7 GHz and a signal-to-noise ratio of over 24 dB are produced at room temperature.