Temperature dependence of the inelastic scattering in a GaAs/n-AlGaAs selectively doped heterojunction with InGaAs quantum dots

Inelastic scattering processes of two-dimensional electron gas (2DEG) have been investigated in a inverted GaAs/n-AlGaAs heterojunction with self-organized InGaAs quantum dots (QDs) embedded near the 2DEG channel where the electron population in the QDs is controllable by the gate voltage V_g. By analyzing magnetoresistance, the inelastic scattering time τ_ε have been evaluated as functions of V_g at 0.6, 0.8, 1.2, and 1.7 K. It is found that τ_ε increases with V_g below 0.8 K and decreases above 1.2 K, which suggests that the dominant scattering mechanisms below 0.8 K and above 1.2 K are different. To interpret this behavior, we have calculated the inelastic scattering time theoretically. It is found that the experimental data are well explained by a theoretical model where a 2D electron is considered to be inelastically scattered both by the other 2D electrons and by the trapped electrons in QDs. It is also found that the 2DEG–2DEG scattering is dominant at low temperature, while the 2DEG-QDs scattering becomes important as the temperature increases.     

Analysis of inelastic scattering processes of electrons by localized electrons in quantum dots

The inelastic Coulomb scattering rate 1/τ_in of conduction electrons has been theoretically evaluated in the presence of localized states such as quantum dots. By a diagrammatical method, we have formulated 1/τ_in and its relation to the conductivity σ_loc(ω) through localized states. The dependence of τ_in on temperature T is examined in the case that σ_loc(ω) follows the Mott's model. It is found that 1/τ_in varies as T²(ln Δ/T)^d+1 where d is the dimensionality and Δ is tunneling energy between the localized states in the asymptonic T = 0 limit, in agreement with Imry's calculation. It is also found that calculated 1/τ_in deviates from T²(ln Δ/T)^d+1 as T increases, suggesting the importance of correction term at high temperature.     

Single-electron transistor spectroscopy of InGaAs self-assembled quantum dots

A single-electron transistor (SET) is used to detect tunneling of single electrons into individual InGaAs self-assembled quantum dots (QDs). By using an SET with a small island area and growing QDs with a low density we are able to distinguish and measure three QDs. The bias voltage at which resonant tunneling into the dots occurs can be shifted using a surface gate electrode. From the applied voltages at which we observe electrons tunneling, we are able to measure the electron addition energies of three QDs.     

Regular array of InGaAs quantum dots with 100-nm-periodicity formed on patterned GaAs substrates

Regular arrays of InGaAs quantum dots (QDs) with a 100-nm-periodicity have been successfully fabricated by controlling the nucleation sites on artificially prepared nano-hole arrays. The nucleation probability of a single QD at each nano-hole reached 100% by depositing InGaAs at low temperature and subsequent annealing. Four InGaAs QD layers were vertically stacked while conserving the regularity, and the stacked QD array has shown a clear photoluminescence peak at room temperature. We discuss the effects of several growth conditions on the nucleation probability of QDs.     

Observation of monolayer-splitting for InAs/GaAs quantum dots

A pronounced modulation is observed in the photoluminescence (PL) spectrum of self-organized InAs/GaAs quantum dots (QDs), recorded at low excitation densities. The clearly distinguishable peaks are identified as a multimodal distribution of the ground state transition energy, originating from a discrete, stepwise variation of the structural properties of the QDs, which is associated with an increase of the QD height in monolayer (ML) steps. The observation of a ML splitting implies a flat QD shape with well-defined upper and lower interfaces as well as negligible indium segregation. The electronic properties of the InAs/GaAs QDs were investigated by PL and PL-excitation spectroscopy and are discussed based on realistic calculations for flat InAs/GaAs QDs with a truncated pyramidal shape based on an extended 8-band k·p model. The calculations predict a red shift of the ground state transition with each additional ML, which saturates for heights above 9 ML, is in good agreement with experiment.     

Optical and transport studies in coupled InAs quantum dots embedded in GaAs

We studied optical and electron transport properties of coupled InAs quantum dots (QDs) embedded in GaAs. Photoluminescence (PL) from the high dot density samples indicated asymmetry in the PL spectra when the ambient temperature is lower than about 50 K. Comparing this result with theoretical calculations, it is shown that this phenomenon is explained by the inter-dot electronic coupling effect. In the photo-conductance measurement, resonance peaks in the current–voltage characteristics were observed in the low-temperature region. The dependence of the resonance voltage on the magnetic field intensity was studied to extract the g-factor. It is also shown that the resonances are attributed to the current corresponding to the electron transport through QDs. According to these results, it is concluded that the inter-dot electronic coupling in the self-assembled InAs/GaAs QD systems occurs when the inter-dot spacing is as low as several nanometers and the ambient temperature is less than about 50 K.     

Nano-probe-assisted technology of indium-nano-dot formation for site-controlled InAs/GaAs quantum dots

We have successfully and reproducibly fabricated uniform indium (In) nano-dots at a selected point. Nano-dot formation was realized using an atomic force microscope (AFM) probe with a specially designed cantilever, which was equipped with a hollow pyramidal tip with a sub-micron size aperture on the apex and an In-reservoir tank within the stylus. The In nano-dots formed in this study can be directly converted to InAs quantum dots by subsequent irradiation of arsenic flux in the molecular beam epitaxy chamber, which is connected to the AFM chamber through an ultra-high-vacuum tunnel.     

Long-wavelength light emission from InAs quantum dots covered by GaAsSb grown on GaAs substrates

We fabricated InAs quantum dots (QDs) with a GaAsSb strain-reducing layer (SRL) on a GaAs(0 0 1) substrate. The wavelength of emission from InAs QD is shown to be controllable by changing the composition and thickness of the SRL. An increase in photoluminescence intensity with increasing compositions of Sb and thickness of the GaAsSb SRL is also seen. The efficiency of radiative recombination was improved under both conditions because the InAs/GaAsSb/GaAs hetero-interface band structure more effectively suppressed carrier escape from the InAs QDs.     

Coulomb blockade in triangular lateral small-size quantum dots

An AlGaAs/GaAs lateral quantum dot of triangular shape with a characteristic size L<100 nm containing less than ten electrons was studied. Single-electron oscillations of the conductance G of this dot were measured at G<e²/h. When going from Ge²/h to G≈0.5e²/h, a decrease was found not only in the amplitude but also in the period of the oscillations. A calculation of the 3D-electrostatics demonstrated that this effect is due to a change in the dot size produced by control voltages.     

Systematic reduction of the permanent exciton dipole for charged excitons in individual self-assembled InGaAs quantum dots

The nature of the few particle wavefunctions for neutral and positively charged excitons is probed in individual InGaAs quantum dots using Stark-effect perturbation spectroscopy. A systematic reduction of the vertical component of the permanent excitonic dipole (p_z) is observed as additional holes are added to the dot. A comparison with calculations reveals that this reduction (Δp_z/e15–20%) is accompanied by a significant lateral expansion of the hole (2 nm) and contraction (1 nm) of the electron wavefunctions. We suggest that this lateral redistribution of the charged exciton wavefunctions provides an optical means to probe the lateral composition profile of the dot.     

Spontaneous one-dimensional lateral alignment of multistacked InGaAs quantum dots on GaAs (n 1 1)B substrates

In_0.45Ga_0.55As/GaAs multistacking quantum dot (QD) structures were fabricated on a GaAs (n 1 1)B (n=2–4) substrate by metalorganic vapor-phase epitaxy. QDs spontaneously aligned in the [0 1 1] direction were observed on stacked QDs, whereas QDs were randomly distributed in the initial In_0.45Ga_0.55As layer growth. The formation mechanism of this self-alignment was studied by changing the number of In_0.45Ga_0.55As/GaAs multilayers and crystallographic arrangement. Photoluminescence spectra showing clear polarization dependence indicate carrier coupling in the QD arrays. This growth technique results in spontaneously aligned InGaAs QDs without any preprocessing technique prior to growth.     

Energy-selective charging of type-II GaSb/GaAs quantum dots

The hole confinement in type-II self-organized GaSb/GaAs quantum dots (QDs) was investigated by combining optical excitation and time-resolved capacitance spectroscopy. The experimental results indicate energy-selective charging even for type-II QDs. With increasing excitation energy the apparent hole activation energy decreases, which is attributed to light absorption in sub-ensembles of QDs with decreasing hole localization. The large localization energy of about 450 meV and the possibility of optical-multiplexing makes type-II GaSb/GaAs QDs a potential material system for QD memory concepts.     

Investigations of backscattering peaks and of the nature of the confining potential in open quantum dots

The properties of open quantum dots are examined in magneto-transport. The quantum dots are prepared from a two-dimensional electron system (2DES) in AlGaAs/GaAs by lateral gate structures. These quantum dots are open, i.e. they are still connected to the surrounding 2DES regions. The low magnetic field magnetoresistance shows peak structures. These structures can be related to semi-classical ballistic trajectories in the confining potential of a dot. The calculations of different confining potentials (abrupt “hard-wall” and parabolic “soft-wall”) are compared with the experimental results. The experiments are better described by a soft-wall potential.     

Polaron relaxation dynamics in InAs/GaAs self-assembled quantum dots

Polaron decay in n-type InAs quantum dots has been investigated using energy dependent, mid-infrared pump–probe spectroscopy. By studying samples with differing ground state to first excited state energy separations the relaxation time has been measured between 40 and 60 meV. The low-temperature decay time increases with increasing detuning between the pump energy and the optical phonon energy and is maximum (55 ps) at 56 meV. From the experimentally determined decay times we are able to extract a low-temperature optical phonon lifetime of 13 ps for InAs QDs. We find that the polaron decay time decreases by a factor of 2 at room temperature due to the reduction of the optical phonon lifetime.     

Lateral electron transport through single InAs quantum dots grown by molecular beam epitaxy

The transport properties of single InAs quantum dots (QDs) grown by molecular beam epitaxy have been investigated by metallic leads with nanogaps. It was found that the uncapped InAs QDs grown on the GaAs surfaces show metallic conductivities, indicating that even the exposed QDs are not depleted. On the contrary, it was found that no current flows through the exposed wetting layers. For the case of the QDs covered with GaAs capping layers, clear Coulomb gaps and Coulomb staircases have been observed at 4.2 K.     

Exciton relaxation in self-assembled semiconductor quantum dots

The present study focuses on the effect of excited states on the exciton–polaron spectrum for self-assembled InAs/GaAs semiconductor quantum dots. The analytical model takes into account the Coulomb interactions between the electron and the hole as well as, each carrier, the coupling with the longitudinal optical phonon field. Furthermore, the key role played by the exciton continuum in the dot spectrum is also introduced. Such an approach is well fitted to analyze recent experimental findings about single-dot spectroscopy and allows peaks assignment, line width estimation, relaxation time evaluation, etc., necessary steps toward an understanding of the internal dynamics of quantum dots.     

Inelastic scattering of hot electrons in n-GaAs/AlAs types I and II multiple quantum wells doped with silicon

We have studied the dependence of hot electron scattering rate on temperature in n-GaAs/AlAs types I and II multiple quantum wells. For a sample with well width 37 Å, which is on the borderline between types I and II band alignment, the increase of the temperature in the range 6–80 K leads to the strong decrease of the hot electron scattering rate. We explain this result by ionization of donors and transfer of cold electrons from the Γ-valley of GaAs to the X-valley of AlAs.     

Enhanced exciton–LO phonon coupling in doped quantum dots

We present photoluminescence measurements under strong magnetic field done on a sample with charged (n-doped) quantum dots. We have shown that the broadening of the luminescence line does not give a measure of the QDs size dispersion, and that the coupling of electron/hole pairs with LO phonons is greatly enhanced, because of the presence of the ionised impurities nearby the charged dots.     

Emission and strain in InGaAs/GaAs quantum wells with InAs quantum dots obtained at different temperatures

The photoluminescence (PL), its temperature dependence and X ray diffraction (XRD) have been studied in the symmetric In_0.15Ga_0.85As/GaAs quantum wells (QWs) with embedded InAs quantum dots (QDs), obtained with the variation of QD growth temperatures (470–535 °C). The increase of QD growth temperatures is accompanied by the enlargement of QD lateral sizes (from 12 up to 28 nm) and by the shift non monotonously of PL peak positions. The fitting procedure has been applied for the analysis of the temperature dependence of PL peaks. The obtained fitting parameters testify that in studied QD structures the process of In/Ga interdiffusion between QDs and capping/buffer layers takes place partially. However this process cannot explain the difference in PL peak positions.     

Enhanced photoluminescence of InGaAs quantum dots induced by nanoprobe indentation

We have found in the nanoprobe-photoluminescnece (PL) measurement that the PL from InGaAs quantum dots was enhanced remarkably by small elastic indentation of the nanoprobe onto the sample surface. In order to clarify the mechanism of the PL enhancement, the nanoprobe-induced strain distribution and the energy-band profiles in the bulk GaAs have been calculated on the bases of linear continuum elastic theory and six-band strain Hamiltonian. It was found that the nm-scale strain modulation by the nanoprobe indentation results in the confinement potential for light holes 50–70 nm beneath the nanoprobe, revealing that the hole accumulation into the minimum causes the PL enhancement.