Cu Nanoparticles Electrodeposited at Liquid–Liquid Interfaces: A Highly Efficient Catalyst for the Hydrogen Evolution Reaction

The electrochemical deposition of Cu nanoparticles with an average diameter of approximately 25–35 nm has been reported at liquid–liquid interfaces by using the organic‐phase electron‐donor decamethylferrocene (DMFc). The electrodeposited Cu nanoparticles display excellent catalytic activity for the hydrogen evolution reaction (HER); this is the first reported catalytic effect of Cu nanoparticles at liquid–liquid interfaces.     

预处理条件对高浓度过氧化氢分解用银网催化剂初始活性的影响

 通过电镀法制备了用于催化分解高浓度过氧化氢的银网催化剂,采用过氧化氢预处理的方法对其初始催化性能进行了改进. 结果表明,采用90%过氧化氢预处理可明显提高银网催化剂的初始活性,扫描电子显微镜和X射线光电子能谱表征结果显示90%过氧化氢预处理后的银网催化剂表面形成了大量1 μm的沟壑并有Ag2O的生成,这是其性能提高的主要原因.     

Hydrothermal Synthesis of Mixed Oxide Compositions of Cobalt-Zirconium and their Catalytic Activity in the Decomposition of Hydrogen Peroxide

The article presents the results of research on the hydrothermal synthesis of nanoscale oxide of cobalt and zirconium and their mixed oxide compositions. The synthesized samples have been characterized by the X-ray phase, scanning electron microscopy and nitrogen adsorption-desorption methods; the composition of the samples has been determined by chemical analysis methods, and their catalytic activity in the decomposition of hydrogen peroxide has been studied. It has been shown that during synthesis, highly dispersed cobalt and zirconium oxide are formed, and the sample of the composition (mol %): Co₃O₄(88)−ZrO₂(12) has the highest specific surface area (181.2 m²/g) and the highest activity (K=6.18 ⋅ 10⁻² s⁻¹) against the decomposition of hydrogen peroxide. The increasing of the ZrO₂ content in oxide compositions reduces their catalytic activity. The particle size in the synthesized samples is 7–38 nm.     

Chemical‐Reaction‐Induced Hot Electron Flows on Platinum Colloid Nanoparticles under Hydrogen Oxidation: Impact of Nanoparticle Size

Generation of hot electron flows and the catalytic activity of Pt nanoparticles (NPs) with different sizes were investigated using catalytic nanodiodes. We show that smaller Pt NPs lead to higher chemicurrent yield, which is associated with the shorter travel length for the hot electrons, compared with their inelastic mean free path. We also show the impact of capping on charge carrier transfer between Pt NPs and their support.     

Direct Insight into the Three‐Dimensional Internal Morphology of Solid–Liquid–Vapor Interfaces at Microscale

Solid–liquid–vapor interfaces dominated by the three‐phase contact line, usually performing as the active center in reactions, are important in biological and industrial processes. In this contribution, we provide direct three‐dimensional (3D) experimental evidence for the inside morphology of interfaces with either Cassie or Wenzel states at micron level using X‐ray micro‐computed tomography, which allows us to accurately “see inside” the morphological structures and quantitatively visualize their internal 3D fine structures and phases in intact samples. Furthermore, the in‐depth measurements revealed that the liquid randomly and partly located on the top of protrusions on the natural and artificial superhydrophobic surfaces in Cassie regime, resulting from thermodynamically optimal minimization of the surface energy. These new findings are useful for the optimization of classical wetting theories and models, which should promote the surface scientific and technological developments.     

A Synergistic Effect of Phthalimide-Substituted Sulfanyl Porphyrazines and Carbon Nanotubes to Improve the Electrocatalytic Detection of Hydrogen Peroxide

A sulfanyl porphyrazine derivative with peripheral phthalimide moieties was metallated with cobalt(II) and iron(II) metal ions. The purity of the macrocycles was confirmed by HPLC, and subsequently, compounds were characterized using various analytical methods (ES-TOF, MALDI-TOF, UV–VIS, and NMR spectroscopy). To obtain hybrid electroactive electrode materials, novel porphyrazines were combined with multiwalled carbon nanotubes. The electrocatalytic effect derived from cobalt(II) and iron(II) cations was evaluated. As a result, a significant decrease in the overpotential was observed compared with that obtained with bare glassy carbon (GC) or glassy carbon electrode/carbon nanotubes (GC/MWCNTs), which allowed for sensitive determination of hydrogen peroxide in neutral conditions (pH 7.4). The prepared sensor enables a linear response to H₂O₂ concentrations of 1–90 µM. A low detection limit of 0.18 μM and a high sensitivity of 640 μA mM⁻¹ cm⁻² were obtained. These results indicate that the obtained sensors could potentially be applied in biomedical and environmental fields.     

Spectrophotometric Determination of Trace Amounts of Vanadium Based on its Catalytic Effect on the Reaction of Diphenylamine and Hydrogen Peroxide

 In this work a kinetic spectrophotometric method for the determination of trace amounts of vanadium is presented. The method is based on the catalytic effect of the vanadium(V) on the reaction between diphenylamine (DPhA) and hydrogen peroxide in a concentrated solution of formic acid. The formation of the deep-blue oxidation product is followed by a filter spectrophotometer, equipped with an optical fiber assembly, on line with a PC provided with the suitable software. The measurements were taken at 583 nm, with an immersed type cell of 1 cm light path length. The optimization of the operating conditions regarding concentrations of the reagents, temperature and interferences are also investigated. The working curve is linear over the concentration range 0.40–4.0 μg/ml vanadium(V). The relative standard deviation for a standard solution of 0.6 μg/ml of vanadium is 0.5% (n = 5). The proposed method proved highly sensitive, selective and relatively rapid for the assay of vanadium, at low level of 0.40 μg/ml without any pre-concentration step. The method was applied to alloys and cosmetics samples. The results were compared to those received with a reference method. Good agreement was attained, with a mean error of 0.5%. Received February 25, 2000. Revision May 15, 2000.     

Kinetic Spectrophotometric Determination of Trace Aluminum by Catalytic Activity of Al<Superscript>3+</Superscript> on the Oxidation of Methylene Blue by Hydrogen Peroxide

A novel kinetic spectrophotometry for the determination of trace aluminum is described based on the catalytic activity of Al³⁺ on the redox reaction between methylene blue (MB) and hydrogen peroxide in acetate buffer (pH 3.8). The reaction is monitored spectrophotometrically by measuring the decrease in absorbance of the dye at the maximum absorption wavelength of 670nm. The variables that affected the reaction rate were fully investigated, and the optimum conditions were established. Aluminum can be determined in the range of 0–80ngmL^–1 with a detection limit of 1.0ngmL^–1. The relative standard deviation for 10 replicate determinations of 40ngmL^–1 aluminum is 0.9%. The method was used to determine aluminum in tap water and biological samples and produced satisfactory results.Received December 18, 2002; accepted May 5, 2003 published online August 22, 2003     

Dual Mechanism of an Intramolecular Charge Transfer (ICT)–FRET‐Based Fluorescent Probe for the Selective Detection of Hydrogen Peroxide

A dual‐mechanism intramolecular charge transfer (ICT)–FRET fluorescent probe for the selective detection of H₂O₂ in living cells has been designed and synthesized. This probe used a coumarin–naphthalimide hybrid as the FRET platform and a boronate moiety as the recognition group. Upon the addition of H₂O₂, the probe exhibited a redshifted (73 nm) fluorescence emission, and the ratio of fluorescence intensities at λ =558 and 485 nm (F ₅₅₈/F ₄₈₅) shifted notably (up to 100‐fold). Moreover, there was a good linearity (R ²=0.9911) between the ratio and concentration of H₂O₂ in the range of 0 to 60 μm , with a limit of detection of 0.28 μm (signal to noise ratio (S/N)=3). This probe could also detect enzymatically generated H₂O₂. Importantly, it could be used to visualize endogenous H₂O₂ produced by stimulation from epidermal growth factor.     

Adsorption Behavior of Asymmetrical Triblock Copolymers at the Solid‐Liquid Interface by Monte Carlo Simulation

Summary: Monte Carlo simulation on a simple lattice model has been used to study the adsorption of asymmetrical triblock copolymers from a non‐selective solvent at the solid‐liquid interface. The size distributions of train, loop and tail configurations for those copolymers are obtained as well as other details of the adsorption layer microstructure. Also the influence of adsorption energy and the role of molecular symmetry are investigated. A segment‐density profile, the adsorption amount, the surface coverage, and the adsorption layer thickness have been determined. Finally, it is shown that the adsorption behavior of an asymmetrical copolymer can be predicted from the symmetrical copolymer.

Size distributions of the tail configuration for A_8−kB₂₀A_k.     

A Microfluidic Approach to Chemically Driven Assembly of Colloidal Particles at Gas–Liquid Interfaces

Bubbling up : Dissolution of CO₂ bubbles in a suspension of colloidal particles chemically induces the assembly of particles on the surface of shrunken bubbles, and thus yields rapid continuous formation of a colloidal armor. This approach maintains the high colloidal stability of particles in bulk, has increased productivity, and allows the formation of bubbles with precisely controlled dimensions.

     

Urea–Hydrogen Peroxide Complex: A Selective Oxidant in the Synthesis of 2-Phenylselenyl-1,3-butadienes

2-Phenylselenyl-1,3-butadienes were synthesized via the selective oxidation of 2,4-diphenylselenyl-1-butenes with urea–hydrogen peroxide followed by the selenoxide elimination.     

Insights into the Mechanism of the Reaction between Tetrachloro‐p‐Benzoquinone and Hydrogen Peroxide and their Implications in the Catalytic Role of Water Molecules in Producing the Hydroxyl Radial

Detailed mechanisms for the formation of hydroxyl or alkoxyl radicals in the reactions between tetrachloro‐p‐benzoquinone (TCBQ) and organic hydroperoxides are crucial for better understanding the potential carcinogenicity of polyhalogenated quinones. Herein, the mechanism of the reaction between TCBQ and H₂O₂ has been systematically investigated at the B3LYP/6‐311++G** level of theory in the presence of different numbers of water molecules. We report that the whole reaction can easily take place with the assistance of explicit water molecules. Namely, an initial intermediate is formed first. After that, a nucleophilic attack of H₂O₂ onto TCBQ occurs, which results in the formation of a second intermediate that contains an OOH group. Subsequently, this second intermediate decomposes homolytically through cleavage of the O? O bond to produce a hydroxyl radical. Energy analyses suggest that the nucleophilic attack is the rate‐determining step in the whole reaction. The participation of explicit water molecules promotes the reaction significantly, which can be used to explain the experimental phenomena. In addition, the effects of F, Br, and CH₃ substituents on this reaction have also been studied.     

Spectroscopic Evidence for Ligand Substitution Reactions at the Solid–Liquid Interface of a Sub‐micrometer Gold(I) Carbene Complex

Colloidal coordination compounds in the sub‐micrometer range were synthesized from a chloro gold(I) carbene complex via the anti‐solvent procedure and stabilized by a surfactant shell of Tween 20. This compound was successfully applied as model system to monitor heterogeneous multiphase ligand substitution reactions at the solid–liquid interface.