Thin amorphous tantalum films are prepared on Si(111) substrates in a metallic glassy state. The amorphous monoatomic state of the film is characterized by X‐ray diffraction studies. The glassy state leads to a negative t emperature c oefficient of the r esistivity (TCR) for low sample temperatures <200 K which is attributed to incipient localization. Above 200 K a positive TCR is observed as expected for a normal Boltzmann transport regime. Upon heating the Si substrate to 1200 K TaSi2 is formed out of the amorphous tantalum film and the silicon substrate. The TaSi2 layer is crystalline as evident from X‐ray diffraction data.
We study graphene growth on hafnia (HfO2) nanoparticles by chemical vapour deposition using optical microscopy, high resolution transmission electron microscopy and Raman spectroscopy. We find that monoclinic HfO2 nanoparticles neither reduce to a metal nor form a carbide while nucleating nanometer domain‐sized few layer graphene. Hence we regard this as an interesting non‐metallic catalyst model system with the potential to explore graphene growth directly on a (high‐k) dielectric.
Write‐once–read‐many‐times memory (WORM) devices were fabricated using Ti/Au and Au as top contacts on ZnO thin films on Si. Electrical characterization shows that both types of WORM devices have large resistance OFF/ON ratio (R ratio), small resistance distribution range, long retention and good endurance. WORM devices with Au top contact have better performance of higher R ratio because of a larger work function of Au compared to Ti.
Heteroepitaxial growth of III‐Sb nanowires allows for the formation of various interesting complex structures and enables the combination of their remarkable properties. In this Letter, we investigate the heteroepitaxial growth of Au‐seeded InSb and GaSb nanowires using metalorganic vapor phase epitaxy. We demonstrate successful single and double axial InSb–GaSb heterostructures in both directions. The formation properties of the grown nanowires including the compositional change of the particle and the interface sharpness are further discussed. In addition, the decomposition of InSb and GaSb segments and their side facet evolution are explained.
Light‐induced degradation of charge carrier lifetime was observed in indium‐doped silicon. After defect formation, an annealing step at 200 °C for 10 min deactivates the defect and the initial charge carrier lifetime is fully recovered. The observed time range of the defect kinetics is similar to the well known defect kinetics of the light‐induced degradation in boron‐doped samples. Differences between defect formation in boron‐ and indium‐doped silicon are detected and discussed. A new model based on an acceptor self‐interstitial ASi–Sii defect is proposed and established with experimental findings and existing ab‐initio simulations.
Ordered Sr2CrReO6 has been synthesized recently. It is measured to be ferrimagnetic semiconductor, in contrary to the previous reports of metallic properties. To solve the discrepancy, we have investigated the compound by using the density functional theory. The semiconducting behavior is reproduced by including the electron correlation and spin–orbit coupling simultaneously. The calculated band gap is 0.22 eV, close to the experimental value of 0.21 eV. A large orbital moment of 0.69µB is found for Re, which is caused by the Coulomb‐enhanced spin–orbit coupling. By applying pressure, a semiconductor to half‐metal transition is observed through 5% volume compression.
We prepared and investigated grain boundary Josephson junctions based on SrTiO3 bicrystal substrates. During the deposition of YBa2Cu3O7–δ (YBCO) gold nanocrystals forming from an intermediate gold layer can modify the crystalline structure and thus the properties of the YBCO grain boundaries. The variation of the film thickness of the Au seed layer changes the growth conditions of the YBCO film and the Au nanocrystals. The values of the characteristic ICRN product do not change whereas the values of the critical current IC decrease.
We have fabricated multi‐peak and chromaticity‐stable top‐emitting white organic light‐emitting diodes (TEWOLEDs) using single blue emitter. Besides the intrinsic emission of blue emitter, the additional emission can be well realized by simply adjusting the thickness of hole transporting layer (HTL), thus modifying the optical cavity length to obtain different resonant wavelengths. The detailed variation process for multi‐peak spectra with the increase of HTL thickness is studied, which provides a guidance for the design of microcavity TEWOLEDs.
MgZnO‐based ultraviolet avalanche photodetectors (APDs) have been fabricated from Au/MgO/Mg0.44Zn0.56O/MgO/Au Schottky structures. The carrier avalanche multiplication is realized via an impact ionization process occurring in the MgO layer under relatively large electric field. The APDs exhibit an avalanche gain of 587 at 31 V bias, and the response speed of the APDs is in the order of microseconds.
Optically transparent and high‐quality hybrid ZnO nanoparticle and anthracene embedded polyphenylsiloxane (PPS) glass films were spin‐coated on quartz substrates. A strong Förster resonant energy transfer (FRET) process was indicated by the observation of quenching of the ZnO emission and an enhancement of the anthracene emission at room temperature. The efficiency of this energy transfer between ZnO and the S1 vibronic states of the anthracene molecules can be optimized to exceed 90%.
The fabrication of titania nanostructures with hierarchical order of different structural levels is investigated. The nanostructures are prepared with a diblock‐copolymer assisted sol–gel process. By iterative spin‐coating of the solution onto silicon substrates a thin polymer‐nanocomposite film is deposited and transformed to purely anatase titania nanostructures via calcination. In total, this procedure is repeated three times on top of the substrate. The approach is monitored with grazing incidence small angle X‐ray scattering after each fabrication step. With scanning electron microscopy the final hierarchical structure is imaged. From the characterization different structural levels are clearly identified.
Electric control of magnetism is demonstrated in a multiferroic metal–organic framework with a perovskite structure. A moderate electric field of a few kV/cm applied during the cooling process is able to cause a large (more than 50%) change of the magnetization at low temperature. This significant magnetoelectric effect is ascribed to the electric field manipulation of orientation of hydrogen bonds that modify the superexchange interaction between metal ions.
We report the fabrication procedure and the characterization of an Al0.3Ga0.7As solar cell containing high‐density GaAs strain‐free quantum dots grown by droplet epitaxy. The production of photocurrent when two sub‐bandgap energy photons are absorbed simultaneously is demonstrated. The high quality of the quantum dot/barrier pair, allowed by the high quality of nanostructured strain‐free materials, opens new opportunities for quantum dot based solar cells.
Here, we demonstrate the synthesis of graphene on Ag foil by an atmospheric‐pressure (AP) chemical vapor deposition (CVD) process as tarnish‐resistant coating. Synthesis of a continuous graphene film on Ag foil is achieved using the solid camphor as carbon precursor in a gas mixture of Ar and H2. Tarnishing of the Ag surface through sulfidation is investigated with and without coating of the graphene film. It is observed that the bare Ag surface immediately reacts with sulfur vapor to turn black, whereas graphene coating passivates the Ag surface robustly and thereby restrains the sulfur reaction to preserve from tarnishing. Our findings show that a large‐area graphene film can be effectively grown on Ag surface by a CVD process as a tarnish and corrosion resistance barrier.
We demonstrate the fabrication of a solid state heterojunction photovoltaic device with solution‐processed graphene oxide (GO) and n‐Si. Partially reduced GO with a high optical gap (2.8 eV) was spin‐coated on the n‐Si substrate and a heterojunction device was fabricated with the structure of Au/pr‐GO/n‐Si. In the fabricated device, incident light was transmitted through the thin GO film to reach the junction interface, generating photoexciton, and thereby a photovoltaic action was observed. By means of a built‐in electric potential at the GO/n‐Si junction, photoexcited electrons and holes can be separated, transported and collected at the electrodes.
Diffraction micro gratings have been written in ZnO:Al thin films using a picosecond laser operating at 355 nm. Micro gratings of 20 µm diameter with a period of 860 nm show a groove depth up to 120 nm. The total transmittance of square‐centimeter‐size grating‐textured ZnO:Al films was almost unchanged after grating formation, while the sheet resistance increased moderately. The textured films reached haze values of 9% at 700 nm. This simple texturing method can be applied also to ZnO:Al films that cannot be texture etched.
Steady‐state and time‐resolved photoluminescence of silicon nanoparticles dispersed in low‐polar liquids at above room temperature is studied. The roles of low‐polar liquids as well as mechanisms responsible for their temperature‐dependent photoluminescence are discussed. The thermal sensitivity of the photoluminescence is estimated and application of the nanoparticles as nanothermometers is proposed.
In this Letter, a novel modified anodization was utilized to synthesize high‐aspect‐ratio, top‐open and ultraflat‐surface TiO2 nanotubes. The interruption of voltage during anodization leads to the formation of a double‐layered structure. Due to the weak mechanical connection between the upper and the underlying layer, the two parts can be easily detached. Compared with the conventional ultrasonication method to remove the clusters of nanotubes where rough surfaces resulted, this efficient and reliable strategy may facilitate further applications of TiO2 nanotubes in diverse conditions.
