Influence of chemistry and hot rolling conditions on high permeability non-grain oriented silicon steel

This paper discusses the influence of chemical composition on the final electromagnetic properties in higher permeability material. Furthermore, the effect of the hot rolling practice and the end of austenite transformation temperature range on the hot band microstructure is described. The magnetic polarization J₅₀₀₀ better than 1.7 T, using hot rolling conditions 40 mm transfer bar thickness, finish mill entry temperature 1000 °C, and finishing temperature 800–840 °C and after decarburization heat treatment and grain growth treatment, was obtained.     

一种计算剪切模量温度系数的方法

采用理论计算与动高压实验相结合的方法，提出了一个计算剪切模量温度系数G′T的新方法.首先用理论方法计算一个中间数据G(PS)，然后再与动高压实验数据G(PH)结合在一起计算出G′T,并针对93钨合金材料进行了计算.计算结果表明剪切模量温度系数G′T开始是随温度和压力变化的，但在高温高压下，它趋近于一常数.对于93钨合金，这个常数约为-004GPa／℃.同时，这也是对Steinberg本构模型中的剪切模量温度系数为常数的一个证明.并且，当把这一常数代入剪切模量温度系数的计算式中，将重新计算出的剪切模量与实验测得的剪切模量结果进行了比较，结果表明二者符合得很好，从而证明了本计算的剪切模量温度系数的正确性. 关键词： 有限应变物态方程 剪切模量温度系数 Steinberg本构模型 动高压实验     

Pressure and temperature derivatives of the isotropic polycrystalline shear modulus for 65 elements

Experimental values are tabulated for the temperature derivative of the isotropic polycrystalline shear modulus for 47 elements and for the pressure derivative for 39 elements. Equations are derived to estimate these derivatives, and the estimated values generally compare well with the experimental data. These equations have been used to determine pressure and temperature derivatives of the isotropic polycrystalline shear modulus for other elements for which no experimental data are available.     

An exafs investigation on the effect of cold rolling on copper

An EXAFS study has been performed on annealed and cold-rolled copper foils in order to understand the structural change after deformation. Data taken from a cold-rolled specimen showed nearly identical nearest neighbor structure as compared to an annealed specimen. However, larger Debye-Waller factors and static displacements were observed for atoms in the higher coordination shells. Furthermore, increased disorder in the deformed specimen resulted in a reduced EXAFS amplitude. The determination of the electron mean free path and the effect of specimen non-uniformity on the transmission EXAFS amplitude are also discussed.     

钢丝的切变模量与扭转角度关系

研究了钢丝的切变模量随其扭转角度变化而变化的情况,观察到扭转角大于某一角度时,切变模量趋于定值的规律,得出扭摆实验准确测量的方法.     

Determination of the copper diffusion coefficient in silicon from transient ion-drift

We use the transient ion drift in a depletion region of a Schottky barrier to determine ion diffusivities at moderate temperatures. The pulsed reverse bias leads to temperature dependent capacitance transients similar to deep level carrier emission transients. A simple theoretical model together with classical transient signal analysis provide the means to extract the ion diffusion constant. When applied to copper in silicon, diffusion data are obtained in a not yet investigated temperature range (280–400 K) which agree well with both low and high temperature diffusion data.     

Influence of supersaturation by point defects on the shear modulus of nickel and nickel-boron alloy

The influences of supersaturation of samples by point defects on the shear modulus is investigated by the internal-friction method. It is found that, in the temperature range 0.25–0.5T_m, the shear modulus of such samples is less. A mechanism associated with increase in mobility of the dislocations on account of diffusional influx of the point defects formed on irradiation is proposed, and an expression is obtained for estimating the magnitude of the effect.Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 1, pp. 53–56, January, 1984.     

Influence of anisotropy on the dispersion of surface plasmon-phonon polaritons in silicon carbide

Surface plasmon-phonon polaritons (SPPP’s) of types 3 and 4 are investigated in doped anisotropic single crystals of hexagonal silicon carbide (6H-SiC) in the orientation corresponding to K⊥C and xy⊥C. It is shown that a dispersion dependence of the type-3 SPPP’s bounded by K appears in 6H-SiC when the plasmon frequency increases to ν _p⊥⩾350 cm⁻¹. At ν _p⊥⩾400 cm⁻¹, ν _s(K) exists for type-4 SPPP’s in the frequency range Ω _∥ ⁺ <ν< _⊥ ⁺ . When the concentration of free charge carriers is increased, the dispersion curves are displaced toward higher frequencies. The conditions for the existence of type-3 and type-4 SPPP’s in 6H-SiC are determined. Fiz. Tverd. Tela (St. Petersburg) 40, 636–639 (April 1998)     

Influence of oxygen concentration on optical properties of semi-insulating polycrystalline silicon films

Optical properties of semi-insulating polycrystalline silicon (SIPOS) films were investigated over the wide region of wavelengths. The vibrational modes of Si-O-Si and Si-Si bonds were studied by IR and Raman spectroscopy. A pronounced effect of oxygen content on the measured spectra was observed. Optical constants of SIPOS films have been compared with those of amorphous silicon and glassy silicon dioxide and their values have been successfully interpreted in terms of the theory of effective medium. The results have shown that the amorphous character prevails in the as-deposited SIPOS films.     

Effect of vacancies and interstitials in the dumbbell configuration on the shear modulus and vibrational density of states of copper

It has been shown by the molecular dynamics method that the introduction of interstitials in the dumbbell configuration into the copper crystal leads to a significantly stronger shear modulus reduction than the vacancy introduction. Specific low-frequency modes appear in the spectrum of vibrational states of “defect” atoms. The vacancy formation enthalpy weakly depends on their concentration, and the interstitial dumbbell formation enthalpy at high concentrations can decrease by a factor of 8. In this case, the radial distribution function takes the form characteristic of noncrystalline materials. The results obtained confirm the interstitial theory of the condensed state.     

Influence of light on interstitial copper in p -type silicon

In this work, the influence of light absorption on copper related defect reactions in p-type silicon is investigated by transient ion drift measurements. It is found that copper out-diffusion and formation of copper complexes are two competitive processes whose relative importance depends on light intensity. At low intensities, a reduced surface potential allows complete copper out-diffusion. Above a certain threshold value, however, copper complexes are formed which could be responsible for the earlier reported optically activated recombination activity of copper in silicon. It is shown that the observed Fermi-level dependence of the defect formation rate cannot be explained in terms of an optically induced change in the interstitial copper charge state. The high thermal stability of the formed copper complexes further points out that the formation of electrostatically bound copper-defect pairs may be ruled out. PACS 61.72.Cc; 61.72.Ss; 66.30.Jt     

Influence of grain sizes on the ionic conductivity and the chemical diffusion coefficient in copper selenide

Ionic conductivity and chemical diffusion coefficient have been studied for superionic polycrystalline Cu_1.75Se copper selenide within the temperature interval 300–500 K. An increase in ionic conductivity with an grain size increase is observed. In our opinion, this fact is caused by lower activation energy for the bulk diffusion than that for the grain boundary diffusion.     

Influence of direct current plasma magnetron sputtering parameters on the material characteristics of polycrystalline copper films

Physical vapor processes using glow plasma discharge are widely employed in microelectronic industry. In particular magnetron sputtering is a major technique employed for the coating of thin films. This paper addresses the influence of direct current (DC) plasma magnetron sputtering parameters on the material characteristics of polycrystalline copper (Cu) thin films coated on silicon substrates. The influence of the sputtering parameters including DC plasma power and argon working gas pressure on the electrical and structural properties of the thin Cu films was investigated by means of surface profilometer, four-point probe and atomic force microscopy.     

Influence of the dimension of a polycrystalline film and the optical anisotropy of crystallites on the effective dielectric constant of the film

The dimension D of a polycrystalline film and the optical anisotropy m = ε_z/ε_x of uniaxial crystallites with the principal components ε_x = ε_y and ε_z of the tensor of the dielectric constant have been shown to produce a strong influence on the effective dielectric constant ε_D^* and the effective refractive index n_D^* = (ε_D^*)^1/2 of the film in the optical transparency region, as well as on the boundaries of the intervals B_Dl ≤ ε_D^* ≤ B_Du. The intervals Δ₂(m) = B_2l–B_2u and Δ₃(m) = B_3l–B_3u are separated by a gap for m in the range 1 < m < 2, whereas the theoretical dependence ε₂^*(m) is separated by a gap from the interval Δ₃(m) for m in the range 1 < m < 4. This is confirmed by a comparison of the experimental (n_oP) and theoretical (n_D^*) ordinary refractive indices for uniaxial polycrystalline films of the conjugated polymer poly(p-phenylene vinylene) (PPV) with uniaxial crystallites and appropriate values of m. In the visible transparency region of the PPV films with a change in m(λ) in the range 2 < m(λ) < 3 due to the dependence of the components ε_x,z(λ) on the light wavelength λ, the refractive indices n_oP²(λ) = ε_oP(λ) are consistent with the theoretical values of ε₂^*(λ) and lie outside the interval Δ₃(m). For m(λ) > 3 near the electronic absorption band of the crystallites, the values of ε_oP(λ) lie in the region of the overlap of the intervals Δ₂(m) and Δ₃(m). The boundaries mc of the range 1 < m < m_c are determined, for which the interval Δ₂(m) is separated by a gap from the dependences ε₃^*(m) corresponding to the effective medium theory with spherical crystallites and hierarchical models of a polycrystal, as well as from the proposed new dependence ε₃^*(m).     

振动法同时测定动态杨氏模量和剪切模量

在运用传感器、数据采集卡、LabVIEW虚拟仪器测定矩形板材在弯曲和剪切振动频率基础上,同时测定材料的动态杨氏模量、剪切模量和泊松比.     

Influence of anisotropy on the electrical conductivity and diffusion coefficient of dry K-feldspar: Implications of the mechanism of conduction

The electrical conductivities of single-crystal K-feldspar along three different crystallographic directions are investigated by the Solartron-1260 Impedance/Gain-phase analyzer at 873 K–1223 K and 1.0 GPa–3.0 GPa in a frequency range of 10-1 Hz–106 Hz. The measured electrical conductivity along the ⊥ [001] axis direction decreases with increasing pressure, and the activation energy and activation volume of charge carriers are determined to be 1.04 ± 0.06 e V and 2.51 ± 0.19 cm~3/mole, respectively. The electrical conductivity of K-feldspar is highly anisotropic, and its value along the⊥ [001] axis is approximately three times higher than that along the ⊥ [100] axis. At 2.0 GPa, the diffusion coefficient of ionic potassium is obtained from the electrical conductivity data using the Nernst–Einstein equation. The measured electrical conductivity and calculated diffusion coefficient of potassium suggest that the main conduction mechanism is of ionic conduction, therefore the dominant charge carrier is transferred between normal lattice potassium positions and adjacent interstitial sites along the thermally activated electric field.     

Wave anisotropy of shear viscosity and elasticity

The paper presents the theory of shear wave propagation in a “soft solid” material possessing anisotropy of elastic and dissipative properties. The theory is developed mainly for understanding the nature of the low-frequency acoustic characteristics of skeletal muscles, which carry important diagnostic information on the functional state of muscles and their pathologies. It is shown that the shear elasticity of muscles is determined by two independent moduli. The dissipative properties are determined by the fourth-rank viscosity tensor, which also has two independent components. The propagation velocity and attenuation of shear waves in muscle depend on the relative orientation of three vectors: the wave vector, the polarization vector, and the direction of muscle fiber. For one of the many experiments where attention was distinctly focused on the vector character of the wave process, it was possible to make a comparison with the theory, estimate the elasticity moduli, and obtain agreement with the angular dependence of the wave propagation velocity predicted by the theory.