The use of predicted boiling points for the identification of halobenzenes and substituted phenols in capillary gas chromatography

Quantitative correlations between physicochemical parameters and structure of various solutes and their gas chromatographic behavior were investigated in order to predict the retention values. The identification of unknown samples in gas chromatographic routine analysis of environmental samples is enhanced by the use of these correlations in conjuction with other chromatographic methods and with mass spectrometry. The boiling points of many compounds are easily found in literature and therefore their correlation with retention values obtained in isothermal or programmed temperature analysis permit restriction of the choice of names of unknown compound to within a narrow range. The correlation between the boiling points and the retention times of chloro- and bromo-benzenes and of some chloro- and nitro- substituted phenols was investigated on non-polar capillary columns and permitted the tentative identification of many compounds belonging to these homologous series.     

Chromatographic efficiency of polar capillary columns applied for the analysis of fatty acid methyl esters by gas chromatography

The chromatographic efficiency that could be achieved in temperature‐programmed gas chromatography was compared for four capillary columns that are typically applied for analysis of fatty acid methyl esters (FAME). Three different carrier gases, hydrogen, helium and nitrogen, were applied. For each experiment, the carrier gas velocities and the temperature rates were varied with a full 9 × 3 design, with nine levels on the carrier gas velocity and temperature rates of 1, 2 or 3°C/min. Response surface methodology was used to create models of chromatographic efficiency as a function of temperature rate and carrier gas velocity. The chromatographic efficiency was defined as the inverse of peak widths measured in retention index units. The final results were standardized so that the efficiencies that could be achieved within a certain time frame, defined by the retention time of the last compound in the chromatogram, could be compared. The results show that there were clear differences in the efficiencies that could be achieved with the different columns and that the efficiency decreased with increasing polarity of the stationary phase. The differences can be explained by higher resistance to mass transfer in the stationary phase in the most polar columns.     

Gas chromatographic analysis of high-molecular-mass polycyclic aromatic hydrocarbons II. Polycyclic aromatic hydrocarbons with relative molecular masses exceeding 328

Three columns were used for the gas chromatographic analysis of polycyclic aromatic hydrocarbons (PAHs) with relative molecular masses (M_r) up to 450. Two of the columns were commercially available, coated with a 50% methyltrifluoropropyl-substituted polysiloxane a 5% diphenyl-substituted methylpolysiloxane. The third column was laboratory made, coated with a biphenyl-substituted silarylene-siloxane copolymer. All three columns were utilized for the analysis of high-M_r PAHs as regards both thermal stability of the stationary phases, i.e., low bleeding rate, and chromatographic efficiency. The column coated with a trifluoropropyl-substituted stationary phase showed, however, a low separation efficiency, possibly owing to low solute stationary phase compatibility. The biphenyl-substituted stationary phase, on the other hand, showed a very high separation efficiency, but the retention of the PAHs was significantly higher on this column compared with the other two, leading to the demand for higher oven temperatures. Different retention mechanisms were observed on these columns, as shown by differences in the retention indices of the PAHs measured in a system using PAHs as retention index markers. A comparatively faster elution of non-planar PAHs was observed on the columns coated with the trifluoropropyl-substituted stationary phase and the biphenyl-substituted stationary phase compared with the column coated with the 5% diphenyl-substituted polymer. The usefulness of the columns for separations of high-M_r PAHs is demonstrated by gas chromatograms of carbon black extracts and a coal tar extract standard reference material.     

Gas chromatographic retention indices of biologically and environmentally important organic compounds on capillary columns with low-polar stationary phases

This work presents linear temperature programmed retention indices on the columns with stationary phases of 5% phenylpolydimethyl silicone of 389 organic compounds, including extractive substances of plant tissues and environmentally important compounds. Certain factors which influence the values and reproducibility of retention indices during gas chromatographic analysis of multicomponent mixtures are discussed.     

Characterization of high performance glass capillary gas chromatography

Summary High resolution gas chromatography requires the highest performance characteristics of gas chromatographic systems in terms of sampling and sample handling in strumentation, columns, and data handling. This paoper describes high precision computer measurements for characterizing capillary column efficiencies which are within 75% of the theoretical limit of capillary GC. Particular emphasis is given to detailed peak shape analysis, measurement accuracy and reproducibility, and system stability. Using known instrument performance parameters, it is then possible to characterize column performance with high accuracy in a meaningful manner. It is proposed that wall-coated tubular columns be characterized in terms of their chromatographic performance by the following parameters: Trennzahl (separation number), number of theoretical plates/meter, program temperature beseline stability, acid-base ratio, and the coefficient of skewness for 1-octanol. Statistical moments (m2) and hybrid moments are used to describe capillary column chromatographic performance because they may be related to basic physico-chemical column processes. These measurements are very sensitive parameters for characterizing GC columns. Using an online computer-based data system, the limits of capillary GC are shown to be limited by the sampling and injection steps.     

Behavior of n-alkanes on poly(oxyethylene) capillary columns. Evaluation of interfacial effects

The solvation behavior of n-alkanes on poly(oxyethylene) was studied employing capillary gas chromatography. Interfacial effects were discriminated and evaluated through the analysis of retention data from six commercial fused-silica capillary columns, having film thicknesses of 0.15-5 microm. Expressions for the mixed retention mechanism in capillary columns were deduced from assumptions of a general character. Partition coefficients were determined for the n-alkanes up to 28 carbon atoms, at temperatures ranging from 40 to 240 degrees C. In agreement with other authors, it was observed that interfacial phenomena contribute poorly to the chromatographic retention, being negligible over 140 degrees C for homologues with less than 16 carbons.     

Gas-liquid chromatography of submicrogram amounts of drugs. V. Preparation of low-activity packed columns and their application to the toxicological analysis of underivatized polar drugs in the low nanogram range.

When diatomaceous earth and glass columns are acylated prior to coating with a silicone liquid phase, then subjected to heat treatment in an atmosphere of nitrogen, gas chromatographic columns can be prepared that show a marked reduction in adsorption. These columns can be used with a nitrogen-specific detector to chromatograph unmodified polar compounds such as morphine and cyclobarbital in nanogram amounts. Virtually no alteration of peak shape and no variation of retention time are observed over the range 10(-6)-10(-9) g of polar drugs. This represents, for these polar drugs, an "improvement" in chromatographic capability of the order of about 1000-fold in comparison with the best conventional commercial columns. Application to toxicological analysis of morphine in urine is described.     

Are we using the full resolving power of capillary GC?

Precise evaluation of the chromatographic data by means of the relative retention will allow the full use of the resolution achieved by capillary columns. In practice, retention-index determination is best suited for this purpose. The reproducibility of retention-index determination strongly depends, among other factors, on the accuracy of retention time measurement. A reproducibility of ±0,05 i.u. can be easily achieved with modern gas chromatographic equipment, provided the retention times can be measured with an accuracy of at least ±0.01%. This can be shown by error propagation analysis of retention-index calculation performed with the aid of a programmable pocket calculator.     

基于分子结构预测气相色谱程序升温保留指数

从拓扑指数出发,研究了分子结构与气相色谱程序升温保留指数之间的关系。对所选择的部分分子结构,利用主成分回归(PCR)的相关系数R=0.9998,标准偏差S=9.987,交互检验(leave one out cross-valida-tion)所得标准偏差S=11.17。同时,对同一柱型不同升温速率条件下的保留指数之间的关系、同一升温速率不同柱型条件下保留指数之间的关系进行了初步探讨,建立的模型线性关系明显。     

Dual column gas chromatographic system for use in mass spectral determination of nitrosamines.

A packed gas chromatographic column and a support coated open tubular (SCOT) column are connected in series. Between the columns are two micro-volume switching valves, one enabling solvent to be vented. Short retention nitrosamines are passed through both columns, whereas longer retention nitrosamines by-pass the SCOT column by means of the other switching valve.     

A novel multi-column gas chromatographic system

Constructional and operating details are given of a special valve permitting selection of any one of four columns for connection to the detection system of a gas chromatograph, all four columns being connected to the carrier gas stream. If the retention times permit it, the columns may be used simultaneously for chromatographic separations and switched in turn into series with the detector for determination of the eluted components.     

An homologous series of benzodiazepine retention index standards for gas chromatography

An homologous series of benzodiazepine retention index standards (the R-series) has been synthesized and the gas chromatographic behavior of the series investigated on NB-54 and NB-1701 capillary columns. The compounds were stable, exhibited symmetrical peak shapes, and fairly linear retention behavior was observed on both columns. The series can be coinjected with every sample to enable the high precision analysis of toxicological samples; screening for 20 benzodiazepine drugs was possible in 23 minutes (including cooling). The R-series method was compared with a retention index method based on a series of benzodiazepine drugs as standards and with a method employing relative retention times. The precision of the R-series method was found to be generally better than that of the two other methods in both long- and short-term studies.     

气相色谱保留指数定性方法研究进展

综述了程序升温气相色谱保留指数,I^T与Kovats恒温保留指数,之间的关系、I^T的标准化和重现性问题以及定量结构保留指数关系(QSRR)研究进展;对于应用特殊检测器和极性柱定性、对多环芳烃和多氯联苯类物质利用保留指数定性的情况,选择非正构烷烃类同系物作为参考标准时准确性大为提高,比较了由此得到的保留指数与Kovats保留指数的关系;展望了利用保留指数定性的前景。     

Modelling the gas chromatographic separation of multicomponent samples on a system of three open-tubular columns coupled in series

A procedure was developed for modelling the gas chromatographic separation on a system of columns coupled in series. This procedure can be used for computer based optimization of lengths and order of serially coupled columns at isothermal conditions. The sample component retention factors and column resistances needed for the model can easily be measured on each individual column. The proposed procedure was verified by analyzing a 52 component hydrocarbon mixture on three columns of different polarity coupled in series by various column orders. Good agreement between experimental and calculated retention data was found. The procedure is also well suited for optimization of the chromatographic selectivity by coupling columns with different selectivity in series.Dedicated to Professor Dr. h.c. mult. J.F.K. Huber on the occasion of his 70th birthday     

Chemometric studies of retention in capillary gas chromatographic separation of hydrocarbons in coupled columns

This paper describes how different multivariate analysis and classification methods can be used, to characterize the gas chromatographic separation of complex hydrocarbon mixtures in three columns coupled in series. Principal component analysis (PCA), correspondence factor analysis (CFA), and hierarchical ascending classification (HAC) were used as potential tools for evaluating the experiments on single columns and on column series. It has been demonstrated that: (1) multivariate analysis with PCA and CFA offers a powerful strategy to search for the main factors influencing the separation of hydrocarbons without a priori knowledge of the key factors of the separation. (2) With CFA the contribution of retention due to vapour pressure can be minimized. The use of retention indices, which use the n-alkanes as reference compounds, also helps to decrease the dominant focus on vapour pressure in favor of the more selectivity-based interaction forces. (3) CFA helps to analyze the degree of relevance of the chosen experimental design to the most important factors, controlling chromatographic selectivity.     

气相色谱柱对多溴联苯醚分析的影响

基于气相色谱-电子捕获检测器法对11种代表性多溴联苯醚进行分析,考察不同类型气相色谱柱对多溴联苯醚分离分析的影响. 结果表明:色谱柱极性是影响分离和响应的主要因素,极性较大的固定相上多溴联苯醚各单体的保留时间变长,响应降低,尤其是高取代多溴联苯醚的响应受到的影响最大. 柱长较短、液膜较薄的色谱柱有助于高取代多溴联苯醚的分析. 不同品牌的色谱柱受生产工艺的影响,对多溴联苯醚的响应产生较大影响.     

The advantage of dual-column approach and retention indices combined with refined reporting in gas chromatographic drug screening

A dual-column gas chromatographic retention index method was evaluated for the toxicological screening for basic drugs in autopsy blood samples. The dual-column approach with DB-5 and DB-1701 capillary columns doubles the Identification Power of the corresponding single column methods. The long-term intralaboratory variation of the dialkylfluoroaniline series based retention indices of drugs in blood ranged from 0.03% to 0.2% which was generally better than that obtained using the relative retention time. Novel software is described for the processing and reporting of the dual-column chromatographic data in analytically useful form. Besides retention data, the response factors served as an additional identification factor.     

Extrapolation and interpolation of gas chromatographic retention times

Summary An empirical method of extrapolating and interpolating gas chromatographic retention times obtained at three equally spaced isothermal temperatures is described. The accuracy of the method was evaluated from retention time data obtained using packed glass columns. A procedure for constructing retention time tables for homologous series and the derivation of an equation for calculating retention times as a function of temperature is also presented.     

Distribution coefficients of n-alkanes measured on wall-coated capillary columns

Distribution coefficients K of n-alkanes were determined in wide ranges of temperature and carbon numbers from gas chromatographic retention data measured on wall-coated poly(dimethylsiloxane) commercial capillary columns. A discussion is centered on how to mitigate the difficulties for an accurate determination of K when using weakly retentive columns, as those bearing very high phase ratios or short lengths. Particularly, the errors associated with the estimation of the gas hold-up and the phase ratio of the column are considered. The chromatographic importance for determining K of n-alkanes relies on the fact that these are the most commonly applied references for reporting relative thermodynamic parameters such as the Kovats Index and the relative retention. A great amount of information has been compiled in this form. If K of the reference is known, absolute values of distribution coefficients for a myriad of substances are readily obtainable. The knowledge of K(T) functions of solutes in wide ranges of temperature is a primary necessity in temperature-programmed gas chromatography. This knowledge is needed for the prediction of absolute retention times and for computing separation optimizations of mixtures containing several critical pairs of analytes.