类氖锗X射线激光光学特性研究

本工作测量了类氖锗3s-3p X射线激光的23.2nm和23.6nm两条强激光跃迁线水平方向和垂直方向的空间分布,当靶长20mm时,X射线激光水平方向束发散角约为12mrad,主束指向偏离线状等离子体轴线约8mrad;垂直方向束发散角约为22mrad,本工作还采用钼/硅多层膜平面反射镜,对X射线激光进行正反射,获得了X射线激光双程放大的光学特性。 关键词：     

类氖锗的X射线激光增益及其传输特性研究

在神光(10¹²W)装置上,用1.06μm激光加热片状锗靶,用袖珍式掠入射光栅谱仪测量了类氖锗离子的3S—3P激光跃迁线的增益系数和X射线激光的传输特性,得到的结果为:波长为19.638,23.224,23.627,24.743和28.643nm的5条激光跃迁线的增益系数分别为3.06,3.99,3.72,2.36和4.59cm^-1;当等离子体长度为18mm时,相应的X射线激光的发散角约为12mrad,发射X射线激光的等离子体厚度约为200μm,X射线激光峰值强 关键词：     

X射线激光场图测量方法

X射线激光具有波长短、脉冲短、亮度高而又具有良好相干性的优点，因此在很多领域有潜在的应用前景。了解X射线激光输出的特性是对X射线激光应用研究的前提，也有必要进行深人的研究。通常情况，都是利用平焦场光栅谱仪来进行X射线激光的探测，测量诸如输出强度、发散角、折射角等参数，并且作为优化驱动条件和输出特性的依据。但是现在这种方法却有很大的局限性：因为它给出的只是在某个方向上、某个局部位置的结果，所以很难获得全面的关于X射线激光输出特性。而利用场图测量的方法，     

激光同步辐射源原理性实验的理论计算

 利用强激光和相对论性电子束在任意相互作用方向发生的非线性Thomson散射理论,计算了平面偏振激光在相互作用角为180°、178.5°和90°三种条件下发生Thomson散射所产生的X射线波长、相互作用时间等结果,并作出了178.5°散射时X射线强度的空间和频域分布图。利用YAG倍频激光器和25MeV电子束对正向散射部分进行了实验验证。     

激光等离子体X射线能谱的测量

分别用K边滤波和滤波-荧光法测量了激光等离子体发射的1.5—100keV的X射线连续谱。文中叙述了激光等离子体X射线能谱的测量方法和多道X射线能谱仪,介绍了激光聚变实验结果。     

倍频纳秒激光驱动类氖锗X射线激光的研究

利用JB19等程序分别对基频和倍频激光驱动条件下类氖锗X射线激光进行了模拟计算,结果表明利用倍频激光驱动同样也能够获得高强度的类氖锗X射线激光输出,只是对驱动激光的输出要求要高3.3倍.尽管如此,这也为将来在大型激光装置上开展类氖系列X射线激光研究指明了方向.初步的实验研究也证实了利用倍频纳秒激光驱动能够获得类氖锗X射线激光输出的结果. 关键词： X射线激光 类氖锗 数值模拟     

基于自相似模型的二维X射线激光等离子体流体力学

从自相似方法出发,建立了简化的二维X射线激光等离子体流体动力学模型. 利用该模型研究了平板靶X射线激光的二维流体力学行为. 研究表明,当激光作用结束后,经过一段时间的演化电子密度和温度沿线聚焦方向逐渐达到平衡,该结果对X射线激光的优化设计具有重要意义. 关键词： X射线激光 二维流体力学计算 自相似方法     

长脉冲keV X射线源的辐射特征

 利用神光Ⅱ第九路2 ns长脉冲激光束作用厚钛固体靶,研究了产生的keV X射线源的辐射区域和总辐射功率的时间行为。结果表明：在长脉冲激光作用厚固体靶时,硬X射线线辐射功率的时间行为以及辐射体积的时间行为与激光脉冲波形一致;长脉冲时,等离子体2维膨胀效应非常显著,keV X射线线辐射的径向辐射区域在激光焦斑尺寸附近达到饱和,导致X射线线辐射功率出现饱和,且keV X射线线辐射的辐射体积正比于焦斑尺寸的3次方。从理论和实验角度研究了在同样入射激光能量下,辐射功率随激光焦斑尺寸的变化关系,发现keV X射线线辐射的饱和辐射功率正比于焦斑尺寸的5/3次方,理论结果与实验结果一致。并讨论了相同基频输出激光能量下,keV X射线辐射总功率随激光波长的变化关系,发现即使考虑了倍频效率的影响,短波长激光仍然有利于keV X射线的发射。     

全光汤姆逊散射X光源数值模拟

 使用蒙特卡罗数值模拟程序研究了不同电子束和激光强度下,尾场电子束与超短脉冲激光发生汤姆逊散射获得的X光子能谱、角分布等,初步探索了180°散射下高质量X射线光源所需要的电子束与激光强度。数值模拟结果显示,为了尽量提高光子产额并抑制非线性效应,激光归一化强度应为1的量级。为了获得方向性和单色性好、亮度高的X射线脉冲,需要较高的电子能量和较小的电子能散,电子束脉冲尽量短,且发散角尽量小。     

双预脉冲驱动X射线激光实验研究

 在“星光-Ⅱ”激光装置上进行了双预脉冲驱动类氖铬X射线激光实验，介绍了实验方法和实验结果，并对结果进行了简短讨论。由于目前“星光”装置输出能量较低，所进行的双预脉冲驱动未能显著提高X射线激光强度，改变预脉冲幅度时X射线激光强度也未有显著变化。利用MED103程序进行了模拟计算，其结果与实验结果一致。     

抗爆容器内爆炸流场数值模拟

 采用计算流体动力学中的二阶精度TVD差分格式和特殊算子分裂法,按轴对称问题,对半球顶圆柱筒密闭式抗爆容器内部爆炸流场进行了数值模拟。计算得到的容器壁面载荷分布与实验结果基本一致。不同时刻爆炸流场压力分布图像清晰地描述了容器壁面的冲击波加载过程。     

Melting of xenon monolayers - computer simulations

The results of Monte Carlo simulations of xenon monolayers deposited on graphite are presented. Systems of various surface densities and in a wide range of temperatures are investigated. The results are compared to the experimental data and to the previous results for nitrogen. The results of simulations are in good agreement with the experimental ones and confirm that melting in two dimensions is vacancy-driven. Typical real-space configurations of Xe atoms and calculated specific heat results are shown.     

水位骤变时的饱和-不饱和渗流数值计算

本文应用全隐式交替方向迭代法对水位骤变时的饱和-不饱和渗流问题求出了数值解。对于赤井模型,计算结果与实验结果十分接近,比有限元法的计算结果好。对于大尺度的驹田蓄水池模型,计算结果与有限元法的结果基本一致。     

Pre-sheath formation in an oblique magnetic field: fluid model and PIC simulation

We present some results of a one-dimensional fluid model with a floating electrode immersed in plasma with magnetic field applied at an oblique angle. The model equations are integrated numerically in order to find the space profiles of the ion velocities and electrostatic potential for various strenghts and angles of the magnetic field. We assume a collisionless magnetized pre-sheath with isothermal ions. The results are then compared with the spatial profiles obtained by a computer simulation. We use a BIT1 particle-in-cell code. The simulations input parameters are chosen in the way, that they resemble the fluid model as much as possible. Because the results of the simulation are given in the absolute SI units, they have to be normalized correctly. We evaluate the model results and compare them with the computer simulation results. Special attention is brought on formation of the pre-sheath with magnetic field applied at intermediate angles. The results of the simulation are in good qualitative agreement with the model.     

Meson-Meson Scattering on Anisotropic Lattices

Using the tadpole improved Wilson quark action on small, coarse, and anisotropic lattices, meson-meson scattering lengths are calculated within quenched approximation. The study covers pion-pion scattering in the I=2 channel and kaon-pion scattering in the I=3/2 channel. The results are extrapolated towards the chiral limit. Finite volume and finite lattice spacing errors are also analyzed and results in the infinite volume and continuum limit are obtained. Our results are compared with the results obtained using Roy equations, chiral perturbation theory, dispersion relations, and the experimental data. We also compare our results with other lattice results on the scattering lengths.     

Computation of triple differential cross-sections with the inclusion of exchange effects in atomic K-shell ionization by relativistic electrons for symmetric geometry

The triple differential cross-section for K-shell ionization of silver and copper atoms by relativistic electrons have been computed in the coplanar symmetric geometry with the inclusion of exchange effects following the multiple scattering theory of Das and Seal [1] multiplied by suitable spinors. Present computed results are marginally improved in some cases from the previous computed results [2]. Present results are compared with measured values [3] and with previous computation results [2]. Some other theoretical computational results are also presented here for comparison.      

Impact on short length bars

A finite element method for the solution of an axisymmetric wave propagation problem of a bar of finite length is proposed. The results are obtained for a uniform bar with (i) a displacement input and (ii) a stress input. Also results are obtained for a discontinuous bar with stress input. They are compared with the existing finite difference solutions and experimental results. It is observed that the results are in close agreement. The study is then extended to the case of bars with an hemispherical end. The advantage of using the finite element method for such problems is indicated. Finally the results for a composite bar comprising a hallow cylinder and hemisphere are obtained by using the finite element method. Experiments are conducted to verify these results.     

频率对热声制冷机影响的研究

分析和研究了频率对热声制冷机声压、温差和声功的影响 ;使用网络模型计算的结果与实验结果相吻合 ;该研究也是对网络模拟和声功测量方法的验证。     

HL-1M装置撕裂模不稳定性的相位比对法研究

采用相位比对法模拟分析了HL-1M装置的磁扰动模式,模拟结果同预期的一致。在具有撕裂模不稳定性的典型放电中,探测到独立模m=2、3、4,耦合模m=2、3,并与用空间傅立叶分析方法得到的扰动模式的分析结果进行了比较。讨论了这些方法在实验分析中的可行性和有效性。     

Ground State Properties of Superheavy Nuclei in Macroscopic-Microscopic Model

The ground state properties of superheavy nuclei are systematically calculated by the macroscopic-microscopic (MM) model with the Nilsson potential. The calculations well produced the ground state binding energies, α-decay energies, and half lives of superheavy nuclei. The calculated results are systematically compared with available experimental data. The calculated results are also compared with theoretical results from other MM models and from relativistic mean-field model. The calculations and comparisons show that the MM model is reliable in superheavy region and that the MM model results are not very sensitive to the choice of microscopic single-particle potential.