Ultrasonic waves induce rapid zeolite synthesis in a seawater solution

The synthesis of zeolites from fly ash was performed through a low-temperature hydrothermal process with seawater. Compared with the results obtained using the same hydrothermal method but in the absence of sonication, the application of an ultrasonic pre-treatment to the conventional hydrothermal process with seawater reduces the crystallization temperature below that observed when hydrothermal synthesis is performed using distilled water.     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

Growth and real time corrosion resistance monitoring of lead decanoate coatings

Lead is very susceptible to corrosion in the presence of organic acids and humidity. A potential countermeasure is to apply a lead carboxylate coating by immersing the metal in a sodium carboxylate solution/suspension. In this work we report on the degree of surface coverage and the corrosion resistance of a lead decanoate Pb(C₁₀)₂ coating as a function of treatment time. Results show that the surface coverage reaches 91% after 15 min and about 100% after 1 h in a 0.05 M sodium decanoate solution. The corrosion resistance, as indicated by electrochemical impedance spectroscopy, continues to increase even after 6 h of immersion. In addition, we show that in the case of planar transport, a diffusion layer of 17 mm thickness exists, wherein the sodium decanoate concentration drops linearly from its bulk value to almost zero at the solid/surface interface.     

Ultrasonic assisted synthesis of Bikitaite zeolite: A potential material for hydrogen storage application

Li containing Bikitaite zeolite has been synthesized by an ultrasound-assisted method and used as a potential material for hydrogen storage application. The Sonication energy was varied from 150 W to 250 W and irradiation time from 3 h to 6 h. The Bikitaite nanoparticles were characterized by X-ray diffraction (XRD), infrared (IR) spectral analysis, and field-emission scanning electron microscopy (FESEM) thermo-gravimetrical analysis and differential thermal analysis (TGA, DTA). XRD and IR results showed that phase pure, nano crystalline Bikitaite zeolites were started forming after 3 h irradiation and 72 h of aging with a sonication energy of 150 W and nano crystalline Bikitaite zeolite with prominent peaks were obtained after 6 h irradiation of 250 W sonic energy. The Brunauer–Emmett–Teller (BET) surface area of the powder by N₂ adsorption–desorption measurements was found to be 209 m²/g. The TEM micrograph and elemental analysis showed that desired atomic ratio of the zeolite was obtained after 6 h irradiation. For comparison, sonochemical method, followed by the hydrothermal method, with same initial sol composition was studied. The effect of ultrasonic energy and irradiation time showed that with increasing sonication energy, and sonication time phase formation was almost completed. The FESEM images revealed that 50 nm zeolite crystals were formed at room temperature. However, agglomerated particles having woollen ball like structure was obtained by sonochemical method followed by hydrothermal treatment at 100 °C for 24 h. The hydrogen adsorption capacity of Bikitaite zeolite with different Li content, has been investigated. Experimental results indicated that the hydrogen adsorption capacities were dominantly related to their surface areas as well as total pore volume of the zeolite. The hydrogen adsorption capacity of 143.2 c.c/g was obtained at 77 K and ambient pressure of (0.11 MPa) for the Bikitaite zeolite with 100% Li, which was higher than the reported values for other zeolites. To the best of our knowledge, there is no report on the synthesis of a Bikitaite zeolite by sonochemical method for H₂ storage.     

Frequency locked micro disk resonator for real time and precise monitoring of refractive index

We experimentally demonstrate a frequency modulation locked servo loop, locked to a resonance line of an on-chip microdisk resonator in a silicon nitride platform. By using this approach, we demonstrate real-time monitoring of refractive index variations with a precision approaching 10(-7) RIU, using a moderate Q factor of 10(4). The approach can be applied for intensity independent, dynamic and precise index of refraction monitoring for biosensing applications.     

In situ control of nanowire resistance with real time monitoring by using self-heating induced oxidation

It was firstly demonstrated that the resistance of bridging GaN nanowires (NWs) can be in situ controlled via current driven self-heating. Owning to the absence of contact barrier at the electrodes of bridging NWs, the Joule-heating can be generated mainly on the NW itself rather than on the electrodes. With increase of NW bias-voltage (BiV) from 2.5 V to 10 V, the generated Joule-heating can make the NW oxidized in air, which leads to about 700 fold increase in NW resistance (from 82.5 Ω to 6 × 10⁴ Ω). Theoretical simulation indicated that a NW temperature of 649 K can realized with a BiV of 4 V, which agrees well with the observation of thermal emission microscope. Moreover, the measured oxygen composition in the NWs was increased with increasing BiV, which indicates that the NWs were oxidized by BiV induced self-heating. This work provides a simple method for precise control of NW resistance, which can be further applied to the formation of core/shell NWs with real time monitoring.     

Identifying financial crises in real time

Following the thermodynamic formulation of a multifractal measure that was shown to enable the detection of large fluctuations at an early stage, here we propose a new index which permits us to distinguish events like financial crises in real time. We calculate the partition function from which we can obtain thermodynamic quantities analogous to the free energy and specific heat. The index is defined as the normalized energy variation and it can be used to study the behavior of stochastic time series, such as financial market daily data. Famous financial market crashes–Black Thursday (1929), Black Monday (1987) and the subprime crisis (2008)–are identified with clear and robust results. The method is also applied to the market fluctuations of 2011. From these results it appears as if the apparent crisis of 2011 is of a different nature to the other three. We also show that the analysis has forecasting capabilities.     

Sonochemical synthesis of zeolite NaP from clinoptilolite

In the present work, natural clinoptilolite was converted to zeolite NaP using ultrasonic energy, in which the transformation time shortened remarkably. The effect of post-synthesis treatment using conventional hydrothermal was also investigated. The synthesized powders were characterized by XRD, TGA/DTA, SEM, and PSD analysis. The results showed that, increasing the sonication time (energy) has no significant effect on the product’s morphology. The crystallinity of the synthesized samples increased slightly with increasing sonication time, but their yield remained relatively unchanged. Furthermore, post-synthesis hydrothermal treatment showed very little influence on properties of the final product. Because the ultrasonic irradiation creates acoustic cavitation cracks on the surface structure of clinoptilolite particulates and increases the concentration of soluble alumino-silicate species, which favors the prevailing super-saturation, crystallization and crystal growth of zeolite NaP happen faster. The particles of zeolite NaP synthesized by ultrasonic irradiation consist of small crystallites of uniform size.     

Characterization of the road surfaces in real time

The main factor in the propagation of traffic noise is the road surface, where the vehicles generate noise due to the contact between tire and pavement, in addition to the noise produced by the engine.     

Dynamics of water in real space and time

Owing to marked advances in instrumentation in X-ray and neutron scattering the time-dependent pair correlation function, the Van Hove function, can now be determined by inelastic X-ray and neutron scattering measurements. The local dynamics of water in real space and time is visualised by this approach. We discuss how the dynamic properties, such as viscosity and diffusion, can be elucidated through the Van Hove function of water.     

Ultrasonic monitoring of malolactic fermentation in red wines

The progress of malolactic fermentation in red wines has been monitored by using ultrasonic techniques. The evolution of ultrasonic velocity of a tone burst 1 MHz longitudinal wave was measured, analyzed and compared to those parameters of oenological interest obtained simultaneously by analytical methods. Semi-industrial tanks were used during measurements pretending to be in real industrial conditions. Results showed that the ultrasonic velocity mainly changes as a result of the conversion by lactic acid bacteria of malic acid into lactic acid and CO₂. Overall, the present study has demonstrated the potential of the ultrasonic technique in monitoring the malolactic fermentation process.     

Removal of sidebands in double-rotation NMR in real time

Double-rotation (DOR) is the only technique generally capable of yielding high-resolution NMR spectra of half-integer quadrupolar nuclei in one dimension for solids without the need for sophisticated coherence pathway selection. Unfortunately, due to the low outer rotor spinning frequencies currently available, the spectra often contain a large number of spinning sidebands which may overlap with the resonances of interest. We implement a simple, robust, and easy to use family of pulse sequences, which in practice are fully analogous to the 'total suppression of sidebands' (TOSS) sequences, to suppress all sidebands arising from the spinning of the outer rotor in DOR experiments. By removing the rotor phase dependence of the evolution of the sidebands, the sidebands destructively interfere with one another during the course of signal averaging to yield 'solution-like' spectra of half-integer quadrupolar nuclei in solids. Advantages and shortcomings of the method compared to other DOR sideband suppression methods are explored with the aid of simulations.     

A real time infrared scene simulator

A real time simulator for infrared scenes is required to evaluate the performances of recognition and tracking of information processing machine in seeker. A real time simulator for infrared scenes composed of two Intel i860 processors is described in the paper. We first describe the hardware architecture of our system, then we give out schematic diagram illustrating how to compute the image sequences of infrared scenes based on our hardware system. Finally, experimental results indicate that the simulator can meet the needs of application in practice.     

Index summation in real time statistical field theory

We have written a Mathematica program that calculates the integrand corresponding to any amplitude in the closed-time-path formulation of real time statistical field theory. The program is designed so that it can be used by someone with no previous experience with Mathematica. It performs the contractions over the tensor indices that appear in real time statistical field theory and gives the result in the 1-2, Keldysh or RA basis. The program treats all fields as scalars, but the result can be applied to theories with dirac and lorentz structure by making simple adjustments. As an example, we have used the program to calculate the ward identity for the QED 3-point function, the QED 4-point function for two photons and two fermions, and the QED 5-point function for three photons and two fermions. In real time statistical field theory, there are seven 3-point functions, 15 4-point functions and 31 5-point functions. We produce a table that gives the results for all of these functions. In addition, we give a simple general expression for the KMS conditions between n-point green functions and vertex functions, in both the Keldysh and RA bases. PACS 11.10.Wx; 11.15.-q     

Parallel confocal detection of single molecules in real time

The confocal detection principle is extended to a highly parallel optical system that continuously analyzes thousands of concurrent sample locations. This is achieved through the use of a holographic laser illumination multiplexer combined with a confocal pinhole array before a prism dispersive element used to provide spectroscopic information from each confocal volume. The system is demonstrated to detect and identify single fluorescent molecules from each of several thousand independent confocal volumes in real time.     

Ultrasonic initiation of polystyrene latex synthesis

Polystyrene latex samples have been synthesised from an oil-in-water (o/w) emulsion of the monomer using ultrasonic irradiation as the initiation source. No added chemical initiators were used in any of the reactions. The free radicals formed from the cavitation process under the action of the ultrasound are sufficient to initiate the polymerisation. In the current study, the effects of varying the input intensity of the ultrasound were investigated. A marked increase in the monomer conversion rate as a function of time was seen as the power was increased. Despite this increase in conversion rate, the increasing intensity did not affect the resultant latex particle sizes. In all cases, the particle diameters at the conclusion of a polymerisation were seen to be in the range of 40 to 50 nm. The effects of changing the concentration of surfactant in the polymerisation medium and of changing the temperature were also probed. Increases in both were seen to lead to an increased rate of conversion at a fixed input intensity. Again, the particle diameters were invariant as a function of changing conditions. The small particle sizes and high conversion rates are thought to be due to a continuous nucleation process that is caused by the scavenging of free radicals throughout the polymerisation by freshly formed small oil droplets.     

Strategies for high throughput,templated zeolite synthesis

The design and redesign of high throughput experiments for zeolite synthesis are addressed. A model that relates materials function to the chemical composition of the zeolite and the structure directing agent is introduced. Using this model, several Monte Carlo-like design protocols are evaluated. Multi-round protocols are bound to be effective, and strategies that use a priori information about the structure-directing libraries are found to be the best.     

Ultrasonic monitoring of suspension polymerization of vinyl chloride

Attenuation and velocity of bulk longitudinal ultrasonic waves were measured during the commercial suspension polymerization of vinyl chloride in the frequency range of a few hundred kHz to one MHz. The reproducibility of ultrasonic measurements is determined mainly by the reproducibility of polymerization technology. Measurements of attenuation during the polymerization process indicate such effects as local cavitation, boiling or foaming of the vinyl chloride polymerization system. The ultrasonic attenuation against polymerization time curve predicts morphological properties of the final polyvinyl chloride product. It was found that the magnitude of the ultrasonic velocity is in close correlation with the degree of conversion of vinyl chloride, and ultrasonic velocimetry can effectively be used for continuous monitoring of conversion degree during polymerization.