Dynamic response of doubly curved honeycomb sandwich panels to random acoustic excitation. Part 1: Experimental study

A set of four doubly curved, composite honeycomb sandwich panels has been tested with broad band, random acoustic excitation in a progressive wave tube facility. This paper presents the experimental results in the form of dynamic face plate strain measurements taken from various points close to the centre of the panels, on both the inner and outer face plates. The panels were tested at overall sound pressure levels up to (ref. , over a frequency bandwidth of 60-). The response was found to be linear, with a maximum measured root mean square strain of 250με. The doubly curved geometry was found to have a profound effect on the ratio of inner-to-outer face plate strain, which was compared with ratios reported for flat and singly curved geometries. The second part of this study concentrates on three methods for predicting the response of the doubly curved panels to random acoustic excitation.     

Application and assessment of laser Doppler velocimetry for underwater acoustic measurements

The majority of traditional methods for making underwater acoustic pressure measurements involve placing all or part of a measurement transducer in the acoustic field. A variety of optical metrology techniques have been developed in an attempt to reduce or remove any perturbing effects. An example of this is the use of laser interferometry which has been developed as the primary method of calibrating hydrophones in the frequency range - at the National Physical Laboratory (NPL). This technique involves suspending a thin Mylar pellicle in the acoustic field and recording the displacement of the pellicle surface using a Michelson Interferometer. This study details a comparison of a Laser Doppler Velocimeter (LDV) with the NPL Laser Interferometer, which gives a good correlation where agreement is within approximately 4% and 7% for two different power levels from a plane piston transducer and within 2.5% and 1% for the same power levels from a plane piston transducer. A novel, non-perturbing method of recording temporally resolved acoustic pressure distributions in water using an LDV is also described. The technique is shown to benefit from the consistent frequency response of the LDV detection system, such that the measured output resembles the drive voltage input to the transducer more closely than a similar hydrophone measurement. For the experimental arrangement described, the LDV system is shown to be sensitive to minimum pressure amplitudes of nominally .     

Feedback control of sound transmission through a double glazed window

One way to tackle the control of stochastic noise in three dimensions is to reduce the sound transmission to the zone of interest. In buildings, windows are often the weak link in protecting the interior from outside noise. In particular, double glazed windows have a poor sound insulation at low frequency around the mass-air-mass resonance (double wall resonance). Since passive means for windows are exhausted, an active controller that increases the transmission loss in the low-frequency range is an attractive approach to reduce the noise level in buildings. Previously suggested feedforward controllers need reference microphones to measure the disturbance outside and error microphones for the adaptation somewhere in the room. For a real window this is unpractical or even unfeasible. These limitations can be overcome with the feedback controller presented here, which only uses sensors and actuators in the cavity of the double glazed window. Four different controllers—two feedforward and two feedback strategies—are designed, implemented and compared. With feedback the noise transmission around the mass-air-mass resonance can be reduced by , compared to with a feedforward controller.