三块弯铁消色散磁聚焦结构最小发射度

通过采用二极铁之间色散函数的相空间匹配所带来的约束条件,从而无需依赖具体的磁聚焦结构,利用Mathematica软件进行计算,得到了在三块二极铁弯转半径相等情况下,两种应用普遍的三块弯铁消色散（TBA）磁聚焦结构的最小发射度所对应的最小结构比例参数。得到了在TBA结构三块二极铁长度及弯转半径任意的情况下,TBA结构能取得的最小结构比例参数,以及TBA结构中三块二极铁长度及弯转半径所要满足的关系。由于计算中无需考虑具体的磁聚焦结构,得到的理论结果及其分析过程具有较强的通用性。     

Predicted emittance and brightness of the pseudospark electron-beam

The emittance and brightness of the electron beam generated during the hollow cathode phase of pseudospark operation are calculated using the two-dimensional hybrid fluid-particle model previously developed to study the time and space development of the plasma in a pseudospark discharge. Two distinct energy components exist in the electron beam; a high-energy component with an energy equivalent to the full discharge voltage and another, broad, low-energy component. In the 100 ns following breakdown and for the conditions of the calculations, the emittance of the high energy component decreases by an order of magnitude and the brightness of the high energy component reaches almost 10¹⁰ A/m² rad². This work demonstrates the feasibility of using the model to guide the optimization of the pseudospark electron beam properties and shows that the optimum beam properties are achieved after the plasma has filled the hollow cathode and begun to expand radially in the main gap     

Measurement of the directional emittance of polycrystalline beryllium oxide

The spectral emittance of polycrystalline beryllium oxide has been measured at four different angles from 0° to 75°, at a temperature of 150°C. From the spectral measurements the average band emittance in the 8–13 μm window has been calculated. The results show that the band emittance decreases from 0.44 at the angle of 0°, down to 0.23 at an angle 75° off the normal. The low band emittance is caused by a strong reststrahlen band in the wavelength region 9.2–14 μm. This reststrahlen band has been modelled by a Lorentz one-oscillator model. Experiment and calculations show that this band of low emittance increases its width towards shorter wavelengths at inclined angles and covers almost the entire upper atmospheric window 8–13 μm at the angle of 75°.     

多脉冲电子束发射度测量

采用多孔板并结合电子束在石英片相互作用产生的契仑柯夫辐射,对以天鹅绒为阴极发射的强流多脉冲电子束发射度和亮度进行了实验研究和测量。实验观测到了有外加磁场条件下的电子束发生旋转现象。对于电子能量为600 kV左右的电子束,多孔板处的磁场小于2.7 mT时,电子束元的偏离已经小于2°。分别测量了天鹅绒阴极发射的强流四脉冲电子束和双脉冲电子束的积分亮度,分别为7.5×107A/(m.rad)2和4.14×108A/(m.rad)2。结果表明,双脉冲电子束的积分亮度明显优于四脉冲电子束的积分亮度,进而验证了阴极等离子体对多脉冲电子束亮度具有重要影响,降低了电子束的品质。     

加速运动动态黑洞的瞬时辐出度

利用加速黑洞视界面附近的熵密度，导出黑洞的瞬时辐出度，得到了任一时刻黑洞沿某一方向的瞬时辐出度总是正比于在该方向上黑洞事件视界温度的四次方的结论. 导出的广义Stefan-Boltzmann系数不再是一个恒量，而是一个与黑洞视界的变化率、黑洞视界面附近的时空度规及黑洞的吸收与辐射系数有关的动比例系数. 揭示了黑洞周围的引力场与其热辐射之间存在着必然的内在联系. 关键词： 薄膜模型 瞬时辐出度 广义Stefan-Boltzmann系数     

Bunching of particles with nonzero longitudinal emittance

The dynamics of the bunching of particles with nonzero longitudinal emittance is studied in plane geometry. A self-consistent solution to the model time-dependent kinetic equation is obtained for a collisionless system of particles. The solution is shown to be nonunique. Two acceleration modes resulting in the creation of a virtual cathode and, therefore, in the bunching of particles are basically possible.     

Influence of structural parameters on electroluminescent emittance

On the basis of the measurements made in [1], [2], [3], [4], [5], [6] and [7], and from the relation derived by Goldberg [8] and empirically improved in [6] and [7], a new relation is derived for the dependence of the electroluminescent emittance on the structural parameters of electroluminescent material. The relation, which is in qualitative agreement with the experimentally obtained dependence of electroluminescent emittance, leads to conclusions for improving the preparation of electroluminescent powders and layers.     

Possibility of lowering the effective emittance of neutralized ion beams

Self-similarity conditions are determined for the steady states of a quasineutral beam plasma generated during the transport of ion beams in a gaseous medium. The self-consistent radial distribution of the beam and plasma densities is taken into account. Under the resulting conditions the radial electric field of the beam-plasma system is linear, and it is possible for beams to be transported without nonlinear distortion of their phase response characteristics or an increase in the effective emittance. Zh. Tekh. Fiz. 68, 112–115 (April 1998)     

Ultra-low emittance X-band photocathode RF gun

In this paper, we present the simulation results of a 1.6 cell X-band photocathode RF gun for ultra-low emittance electron beams. It will work at 9.3 GHz. The emittance, bunch length, electron energy and energy spread at the gun exit are optimized at bunch charge of 1pC using PARMELA. Electron bunches with emittance about 0.1 mm·mrad and bunch length less than 100 fs can be obtained from this gun. A PITZ type coupler is adopted in this gun and an initial simulation by MAFIA is also given in this paper.     

Single-bunch emittance dilution in the perfect ILC main linac

In the ILC (International Linear Collider) main linac, low emittance preservation is the most important issue for beam dynamics study. As the main sources of emittance dilution, the dispersive and wakefield effects were studied in this paper. The theoretical calculations and numerical simulations of these two effects on single-bunch emittance dilution, without any misalignment errors, are presented in detail.     

Ultra-low emittance X-band photocathode RF gun

In this paper, we present the simulation results of a 1.6 cell X-band photocathode RF gun for ultra-low emittance electron beams. It will work at 9.3 GHz. The emittance, bunch length, electron energy and energy spread at the gun exit are optimized at bunch charge of 1pC using PARMELA. Electron bunches with emittance about 0.1 mm·mrad and bunch length less than 100 fs can be obtained from this gun. A PITZ type coupler is adopted in this gun and an initial simulation by MAFIA is also given in this paper.     

Single-bunch emittance dilution in the perfect ILC main linac

In the ILC(International Linear Collider)main linac, low emittance preservation is the most important issue for beam dynamics study. As the main sources of emittance dilution, the dispersive and wakefield effects were studied in this paper. The theoretical calculations and numerical simulations of these two effects on single-bunch emittance dilution, without any misalignment errors, are presented in detail.     

Minimum emittance in TBA and MBA lattices

For reaching a small emittance in a modern light source, triple bend achromats(TBA), theoretical minimum emittance(TME) and even multiple bend achromats(MBA) have been considered. This paper derived the necessary condition for achieving minimum emittance in TBA and MBA theoretically, where the bending angle of inner dipoles has a factor of 3~(1/3) bigger than that of the outer dipoles. Here, we also calculated the conditions attaining the minimum emittance of TBA related to phase advance in some special cases with a pure mathematics method. These results may give some directions on lattice design.     

束流发射度对太赫兹微电真空折叠波导行波管性能的影响

采用理论分析与数值模拟相结合的方法,分别对140,220和345 GHz折叠波导行波管中的束流发射度的影响因素及其对直流导通率的影响进行了分析,总结了发射度随频率、结构参数和电子束参数的变化规律。研究发现,在太赫兹频段束流发射度直接决定着聚焦磁场的选取设计, 是表征太赫兹频段束流品质的一个重要参量。     

Development of high intensity beam emittance measurement unit

Three sets of High Intensity Beam Emittance Measurement Units (HIBEMUs) are being developed at Peking University. They are HIBEMU-2 (slit-wire type, one direction), HIBEMU-3 (Allison scanner type, one direction) and HIBEMU-4 (slit-wire type, two directions). For HIBEMU-2 and HIBEMU-3, more recent work has been done on software redesign in order to measure beam emittance and to draw phase diagram more efficiently and precisely. Software for control and data processing of them were developed in Labveiw environment, trying to improve calculation rationality and to offer user-friendly interface. Mechanical modification was also done for HIBEMU-3, mainly concentrating on the protection of Faraday cups from being overheated by the high intensity beam and also from interference of secondary electrons. This paper will also cover the mechanical structure as well as the software development of HIBEMU-4, which is a two-direction emittance scanner newly designed and manufactured for the high energy beam transport (HEBT) of Peking University Neutron Imaging FaciliTY (PKUNIFTY). At the end of this paper, comparison and analysis of the three HIBEMUs are given to draw forth better design of the future emittance measurement facility.

     

Courant-Snyder invariant density screening method for emittance analysis

Emittance is an important characteristic of describing charged particle beams. In hadron accelerators, we often meet irregular beam distributions that are not appropriately described by a single rms emittance or 95% emittance or total emittance. In this paper,it is pointed out that in many cases a beam halo should be described with very different Courant-Snyder parameters from the ones used for the beam core. A new method — the Courant-Snyder invariant density screening method - is introduced for analyzing emittance data clearly and accurately. The method treats the emittance data from both measurements and numerical simulations. The method uses the statistical distribution of the beam around each particle in phase space to mark its local density parameter, and then uses the density distribution to calculate the beam parameters such as the Courant-Snyder parameters and emittance for different beam boundary definitions. The method has been used in the calculations for beams from different sources, and shows its advantages over other methods. An application code based on the method including the graphic interface has also been designed.