Racemization behavior of l,l-lactide during heating

To control the depolymerization process of poly(l-lactic acid) into l,l-lactide for feedstock recycling, the racemization of l,l-lactide as a post-depolymerization reaction was investigated. In the absence of a catalyst, the conversion to meso-lactide increased with increase in the heating temperature and time at a higher rate than the conversion into oligomers. The resulting high composition of meso-lactide suggests that the direct racemization of l,l-lactide had occurred in addition to the known racemization mechanism that occurs on the oligomer chains. In the presence of MgO, the oligomerization rapidly proceeded to reach an equilibrium state between monomers and oligomers. The equilibrium among l,l-, meso-, and d,d-lactides was found to be a convergent composition ratio l,l-:meso-:d,d-lactides = 1:1.22:0.99 (wt/wt/wt) after 120 min at 300 °C. This composition ratio also indicates that in addition to the known racemization reaction on the oligomer chains, direct racemization among the lactides is also a frequent occurrence.     

A convenient synthesis of l-ribose from d-fructose

An efficient method for the stereoselective synthesis of l-ribose was accomplished starting from commercially inexpensive d-fructose. The intermediates in the process can serve as versatile precursors for the preparation of l-nucleoside analogues.     

New low-molecular weight gelators based on l-valine and l-isoleucine with various terminal groups

New low-molecular weight gelators based on l-valine and l-isoleucine, which have various terminal groups such as ester, carboxyl, and carboxylate, function as a good organogelator that form an organogel in many organic solvents. In addition, the sodium salt compounds form not only organogels but also a hydrogel in the presence of a cationic surfactant.     

A highly efficient synthesis of unnatural l-sugars from d-ribose

A preparative and short synthesis of l-ribose and l-apiose was accomplished starting from d-ribose via stereoselective cis-dihydroxylation and C2-hydroxymethylation, respectively. These l-sugars can serve as versatile intermediates for the synthesis of l-nucleosides.     

Synthesis of l,l-puromycin

l,l-Puromycin, a diastereomer of the natural peptidyl nucleoside antibiotic puromycin, has been synthesized from l-xylose in 13 steps.     

New building blocks for peptide and depsipeptide synthesis: hexafluoroacetone protected l-homoisoserine and d,l-homoisocysteine derivatives

Efficient syntheses of l-homoisoserine and d,l-homoisocysteine derivatives starting from l-malic and d,l-thiomalic acid using hexafluoroacetone as protecting and activating agent are described. The new compounds are interesting building blocks for the preparation of non-natural peptides and depsipeptides as well as for the construction of new GABA derivatives.     

Intermolecular/interionic interactions in l-isoleucine-, l-proline-, and l-glutamine-aqueous electrolyte systems

Speed of sound and density values for ternary systems (amino acid + salt + water): l-isoleucine/l-proline/l-glutamine in aqueous solutions of 1.5 M KCl, 1 M KNO₃, and 0.5 M K₂SO₄ have been measured for several concentrations of amino acids at different temperatures (303.15, 308.15, 313.15, 318.15, and 323.15 K). Using speed of sound and density data, the thermodynamic parameters such as isentropic compressibility (κ_s), change in isentropic compressibility (Δκ_s) and relative change (Δκ_s/κ₀) in isentropic compressibility have been computed. The isentropic compressibility values decrease with increase in the amino acid concentration as well as with temperature. The decrease in κ_s values with increase in concentration of l-isoleucine/l-proline/l-glutamine in 1.5 M KCl, 1 M KNO₃, and 0.5 M K₂SO₄ has been ascribed to an increase in the number of incompressible zwitterions in solutions, and the formation of ‘zwitterions-ions’ and ‘zwitterions-water dipole’ entities in solutions. The decrease in κ_s values with increase in temperature has been attributed to the corresponding decrease of κ_relax (a relaxational part of compressibility), which is dominant over the corresponding increase of κ_∞ (an instantaneous part of compressibility). The trends of variation of Δκ_s and Δκ_s/κ₀ with variations in solute concentration and temperature have also been discussed in terms of solute-solute and solute-solvent intermolecular/interionic interactions operative in the systems.     

Oxidative and enzymatic degradations of l-tyrosine based polyurethanes

Oxidative and enzymatic degradations of l-tyrosine based polyurethanes were studied for biomaterial applications. Oxidative degradation was performed with 0.1 M cobalt chloride (CoCl₂) in hydrogen peroxide solutions at 37 °C and the degradation was assessed by ATR-FTIR. Results indicate that polyurethane with polyethylene glycol (PEG) shows soft segment degradation while polyurethane based on polycaprolactone (PCL) shows hard segment degradation. Enzymatic degradation of the polyurethanes was studied using proteolytic enzyme α-chymotrypsin in phosphate buffer solution (pH 7.4) at 37 °C. The enhanced degradability of l-tyrosine based polyurethanes is due to both the presence of amino acid based chain extender and the action of enzyme. The changes in the morphology of polyurethanes were analyzed by SEM. The results of the degradation study were correlated to the structure of the polyurethanes.     

Enhancing microdialysis recovery of metal ions by incorporating poly-l-aspartic acid and poly-l-histidine in the perfusion liquid

A study of the evaluation of poly-l-aspartic acid and poly-l-histidine as binding agents to enhance microdialysis recovery of metal ions is presented. Investigations were carried out to compare microdialysis recovery for Cr, Cu, Ni, and Pb when using water as the perfusion liquid as well as when using various concentrations of poly-l-aspartic acid and poly-l-histidine in the perfusion liquid. All experiments were carried out under quiescent conditions using a concentric type of microdialysis probe fitted with a polysulfone membrane having a 30 kDa molecular weight cut-off and a 10 mm effective dialysis length. The metal ions were determined using an electrothermal atomic absorption spectrometer equipped with a Zeemann background corrector. Incorporation of 0.032% (w/v) of poly-l-aspartic acid enhanced the recovery of Cu and Pb by factors of 90 and 64%, respectively (%RSD<3). The recovery of Cr was enhanced by 5%, but that of Ni never exceeded values achieved using ultra pure water. The use of 20% (w/v) of poly-l-histidine resulted in enhancement factors of 66 and 4% for Cu and Pb, respectively (%RSD<2). For both Cr and Ni, the recovery never exceeded that achieved with water. The data from these studies demonstrate the suitability of poly-l-aspartic and poly-l-histidine as selective and effective binding agents that enhance the microdialysis recovery of metal ions. Application of the optimised conditions to the determination of Pb and Cu in a wastewater sample confirmed the versatility of microdialysis, as higher recoveries of Cu were obtained with poly-l-aspartic acid compared to direct determination.     

One-pot inversion of d-mannono-1,4-lactone for the practical synthesis of l-ribose

l-Ribose was synthesized in a concise manner from d-mannono-1,4-lactone using one-pot inversion conditions. Treatment of d-mannono-1,4-lactone with piperidine, followed by mesylation-induced S_N2-type O-alkylation, afforded the desired one-pot inversion in an optimum yield, and the following straightforward transformations provided l-ribose in good yields.     

Novel synthesis of 5-thio-hexopyranoside: preparation of 5-thio-d- and l-glucose and 1,6-anhydro-5-thio-l- and d-altrose

Asymmetric synthesis of both d- and l-isomers of 5-thioglucose and 1,6-anhydro-5-thioaltrose are described. The key intermediates, l- and d-threose diethylacetal derivatives, were derived by chemical transformation from d-xylose or d-arabinose and by Sharpless asymmetric dihydroxylation from γ-hydroxycrotylaldehyde diethylacetal. They transformed to γ-thiiranyl diethylacetal via trans-2,3-epoxy alcohol in seven steps. Acetic acid-promoted cyclization of γ-thiiranyl diethylacetal gave 5-thiopyranoside. Removal of the protected groups under the acidic conditions afforded 5-thio-d- and l-glucose and 1,6-anhydro-5-thio-l- and d-altrose, respectively.     

Synthesis of 1-deoxy-l-gulonojirimycin and 1-deoxy-l-talonojirimycin

De novo synthesis of noncompetitive glycosidase inhibitors l-gulo-DNJ and l-talo-DNJ has been achieved in 9-10 steps starting from Garner’s aldehyde. Key to the success of this procedure was the construction of the 2,3-unsaturated piperidine 14, which syn dihydroxylation under Kishi’s and Donohoe’s conditions led to the desired iminosugars.     

A new and short synthesis of naturally occurring 1-deoxy-l-gulonojirimycin from tri-O-benzyl-d-glucal

A new and short synthesis of naturally occurring 1-deoxy-l-gulonojirimycin from tri-O-benzyl-d-glucal, via a regioselective intramolecular cyclization of an amino triol intermediate, is described. Its absolute configuration was deduced from the single crystal X-ray analysis of compound 11.     

Synthesis of homochiral 2-C-perfluoroalkyl substituted d- and l-riboses

Homochiral 2-C-perfluoroalkyl substituted d- and l-riboses were synthesized via Barbier, Grignard and Ruppert type reactions. The influence of the size of the perfluoroalkyl groups, attached to C-2, on the furanose/pyranose as well as on the α-furanose/β-furanose and α-pyranose/β-pyranose ratio in solution was studied.     

An efficient synthesis of l-allono-1,4-lactone from 2,3:5,6-di-O-isopropylidene-d-mannono-1,4-lactone

We reported herein an efficient synthesis of l-allono-1,4-lactone from 2,3:5,6-di-O-isopropylidene-d-mannono-1,4-lactone in five steps. The key feature of this method involved a one-pot, ‘double inversion’ procedure at the stereocenters of C-4 and C-5 of d-mannono-1,4-lactone to afford the target molecule.     

Microbial screening in hydroxylation of l-proline

Microbial screening of 250 wild type strains resulted in identification of five strains with the activity of prolyl hydroxylase. All five strains hydroxylated regioselectively and enantioselectively l-proline into 4(R)-trans-hydroxy-l-proline 1. The best conversions were obtained with a wild type of Aeromonas caviae. 3-Hydroxylase activity was not detected.     

Thermal and electrical properties of poly(l-lactide)-graft-multiwalled carbon nanotube composites

The dispersion of the nanometer-sized carbon nanotubes in a polymer matrix leads to a marked improvement in the properties of the polymer. This approach can also be applied to biodegradable synthetic aliphatic polyesters such as poly(l-lactide) (PLLA), which has received a great deal of attention due to environmental concerns. In this study, PLLA was melt compounded with multiwalled carbon nanotubes (MWCNTs). A high degree of dispersion of the MWCNTs in the composites was obtained by grafting PLLA onto the MWCNTs (PLLA-g-MWCNTs). After oxidizing the MWCNTs by treating them with strong acids, they were reacted with l-lactide to produce the PLLA-g-MWCNTs. The morphology of the composite was observed with scanning electron microscopy. The mechanical properties of the PLLA/PLLA-g-MWCNT composite were higher than those of the PLLA/MWCNT composite. The thermal stability of the composites was studied using thermogravimetric analysis and their activation energy during thermal degradation was determined using the Kissinger and Flynn-Wall-Ozawa methods. The activation energy of PLLA/PLLA-g-MWCNT was higher than that of PLLA/MWCNT, which indicates that the composite made with the PLLA-g-MWCNTs was more thermally stable than the composite made with the MWCNTs.     

Influence of cellulose nanowhiskers on the hydrolytic degradation behavior of poly(d,l-lactide)

This paper reports the preparation of bionanocomposites based on poly(d,l-lactide) and cellulose nanowhiskers (PDLLA/CNWs) and studies the influence of the CNWs on the hydrolytic degradation behavior of the polylactide. The hydrolytic degradation process was studied in a phosphate buffer medium through the sample weight loss and also by FTIR, DSC and TGA measurements. The presence of CNWs induced a strong delay in the hydrolytic degradation of the PDLLA, even when the concentration of the nanofillers was only 1%. This effect was related to the physical barrier created by the highly crystalline CNWs that inhibited water absorption and hence retarded the hydrolytic degradation of the bionanocomposites. In addition, the incorporation of cellulose nanocrystals in the PDLLA also made the biopolymer more thermally stable, increasing the initial temperature of mass loss even after the degradation in phosphate medium. The results presented here show the possibility of controlling the biodegradability and prolonging the service life of a polylactide through the incorporation of a small quantity of nanofillers obtained from renewable materials.     

Construction of a new firefly bioluminescence system using l-luciferin as substrate

l-Luciferin can be converted into d-luciferin with an enzyme/co-factor system consisting of firefly luciferase, an esterase, ATP, Mg²⁺, and coenzyme A. By this means, a new firefly bioluminescence system can be constructed that uses l-luciferin as the substrate.