The turbulent/non-turbulent interface in an adverse pressure gradient turbulent boundary layer

The turbulent/non-turbulent interface (TNTI) in an adverse pressure gradient (APG, β = 1.45) turbulent boundary layer (TBL) is explored here by using direct numerical simulation (DNS) data; β is the Clauser pressure gradient parameter. For comparison, the DNS data for a zero pressure gradient (ZPG) TBL is included. The interface is extracted with an approach based on enstrophy criteria. Depending on the enstrophy, the outer boundary layer flow can be classified into the free stream, boundary layer wake, and intermittent flow regimes. The fractal dimension of the interface is obtained by using the box-counting algorithm, and was found to be constant over a long range of box sizes. The TNTI shows a monofractal behavior. The geometric complexity of a TNTI can be determined in terms of the genus, which is defined as the number of handles in a geometric object. We examine the volume and projection area of the genus of the TNTI to analyze the entrainment process. The geometric complexity of the APG TBL interface and the local entrainment are greater than those of the ZPG TBL, as is evident in the increases in the genus near the interface. The local entrainment velocity is dominantly affected by the viscous diffusion at the interface.     

Transitionally rough zero pressure gradient turbulent boundary layers

Near-wall measurements are performed to study the effects of surface roughness and viscous shear stresses on the transitionally rough regime (5 < k ⁺ < 70) of a zero pressure gradient turbulent boundary layer. The x-dependence is known from the eleven consecutive measurements in the streamwise direction, which allows for the computation of the streamwise gradients in the boundary layer equations. Thus, the skin friction is computed from the integrated boundary layer equation with errors of 3 and 5% for smooth and rough, respectively. It is found that roughness destroys the viscous layer near the wall, thus, reducing the contribution of the viscous stress in the wall region. As a result, the contribution in the wall shear stress due to form drag increases, while the viscous stress decreases. This yields Reynolds number invariance in the skin friction as k ⁺ increases into the fully rough regime. Furthermore, the roughness at the wall reduces the high peak of the streamwise component of the Reynolds stress in the near-wall region. However, for the Reynolds wall-normal and shear stress components, its contribution is not significantly altered for sand grain roughness.     

LES of the adverse-pressure gradient turbulent boundary layer

We describe large-eddy simulations (LES) of the flat-plate turbulent boundary layer in the presence of an adverse pressure gradient. The stretched-vortex subgrid-scale model is used in the domain of the flow coupled to a wall model that explicitly accounts for the presence of a finite pressure gradient. The LES are designed to match recent experiments conducted at the University of Melbourne wind tunnel where a plate section with zero pressure gradient is followed by section with constant adverse pressure gradient. First, LES are described at Reynolds numbers based on the local free-stream velocity and the local momentum thickness in the range 6560–13,900 chosen to match the experimental conditions. This is followed by a discussion of further LES at Reynolds numbers at approximately 10 times and 100 times these values, which are well out of range of present day direct numerical simulation and wall-resolved LES. For the lower Reynolds number runs, mean velocity profiles, one-point turbulent statistics of the velocity fluctuations, skin friction and the Clauser and acceleration parameters along the streamwise, adverse pressure-gradient domain are compared to the experimental measurements. For the full range of LES, the relationship of the skin-friction coefficient, in the form of the ratio of the local free-stream velocity to the local friction velocity, to both Reynolds number and the Clauser parameter is explored. At large Reynolds numbers, a region of collapse is found that is well described by a simple log-like empirical relationship over two orders of magnitude. This is expected to be useful for constant adverse-pressure gradient flows. It is concluded that the present adverse pressure gradient boundary layers are far from an equilibrium state.     

Numerical study of adverse pressure gradient generation over a flat plate using a rotating cylinder

Generating an adverse pressure gradient (APG), using a rotating cylinder in the proximity of a plane wall under a laminar freestream flow, is studied numerically in this work. The magnitude of the generated APG is a function of the gap, G, between the cylinder and the wall, and the rotational speed of the cylinder, Ω. The flow in such a configuration is characterized by periodic transient vortex shedding at high Reynolds number. A numerical model for the computation of the transient flow for this configuration is developed using the ANSYS CFD simulation tool. The model is validated against published experimental and numerical data for similar flow configurations and excellent agreement is observed. A parametric study is carried out for different combinations of G and Ω for two different Reynolds numbers of 200 and 1000 to examine the development of the resulting separation bubble due to the generated APG. The mechanism of the boundary layer separation over the plane wall and the corresponding wake dynamics is investigated. Results are presented in terms of the distribution of the pressure coefficient as well as skin friction coefficient along the wall and flow patterns around and downstream of the cylinder in the proximity of the wall. The results of these computations confirm that using a rotating cylinder over a plane wall in a freestream flow is an effective technique to generate a controlled range of adverse pressure gradients.     

Heat transfer and skin-friction in a turbulent boundary layer under a non-equilibrium longitudinal adverse pressure gradient

The experimental data on the effect of weak and moderate non-equilibrium adverse pressure gradients (APG) on the parameters of dynamic and thermal boundary layers are presented. The Reynolds number based on the momentum thickness at the beginning of the APG region was Re^** = 5500. The APG region was a slot channel with upper wall expansion angles from 0 to 14°. The profiles of the mean and fluctuation velocity components were measured using a single-component hot-wire anemometer. The friction coefficients were determined using two methods, namely, the indirect Clauser method and the direct method of weighting the lower wall region on a single-component strain-gage balance. The heat transfer coefficients were determined by a transient method using an IR camera. It is noticed that in the pressure gradient range realized the universal logarithmic region in the boundary layer profile is conserved. The values of the relative (divided by the parameters in zero gradient flow at the same value of Re^**) friction and heat transfer coefficients, together with the Reynolds analogy factor, are determined as functions of the longitudinal pressure gradient. The values of the relative friction coefficient reduced to c_f/c_f0 = 0.7 and those of the heat transfer to St/St₀ = 0.9. A maximum value of the Reynolds analogy factor (St/St₀)/(c_f/c_f0) = 1.16 was reached for the pressure gradient parameter β = 2.9.     

Near-wall scaling for turbulent boundary layers with adverse pressure gradient

A new extended inner scaling is proposed for the wall layer of wall-bounded flows under the influence of both wall shear stress and streamwise pressure gradient. This scaling avoids problems of the classical wall coordinates close to flow separation and reattachment. Based on the proposed extended velocity and length scales a universal nondimensional family of velocity profiles is derived for the viscous region in the vicinity of a wall that depend on wall distance and a parameter α quantifying the importance of the streamwise pressure gradient with respect to the wall shear stress in the momentum balance. The performance of the proposed extended scaling is investigated in two different flow fields, a separating and reattaching turbulent boundary layer and a turbulent flow over a periodic arrangement of smoothly contoured hills. Both flows are results of highly resolved direct numerical simulation (DNS). The results show that the viscous assumptions are valid up to about two extended wall units. If the profiles are scaled by the extended inner coordinates, they seem to behave in a universal way. This gives rise to the hope that a universal behavior of velocity profiles can be found in the proposed extended inner coordinates even beyond the validity of the extended viscous law of the wall.      

Effect of an adverse pressure gradient on the streamwise Reynolds stress profile maxima in a turbulent boundary layer

It is widely accepted that in a turbulent boundary layer （TBL） with adverse pressure gradient （APG） an outer peak usually appears in the profile of streamwise Reynolds stress. However, the effect of APG on this outer peak is not clearly understood. In this paper, the effect of APG is analysed using the numerical and experimental results in the literature. Because the effect of upstream flow is inherent in the TBL, we first analyse this effect in TBLs with zero pressure gradient on flat plates. Under the individual effect of upstream flow, an outer peak already appears in the profile of streamwise Reynolds stress when the TBL continues developing in the streamwise direction. The APG accelerates the appearance of the outer peak, instead of being a trigger.     

Turbulence structure in non-equilibrium boundary layers with favorable and adverse pressure gradients

An experimental study was conducted to document the turbulence in boundary layers on smooth walls subject to a favorable pressure gradient followed by a zero pressure gradient recovery and an adverse pressure gradient. Two component velocity profiles were acquired along the spanwise centerline of the test section, and velocity fields were obtained at the same locations in streamwise wall-normal and streamwise–spanwise planes using PIV. The FPG was shown to reduce the turbulence in the outer part of the boundary layer, reducing the transport of this turbulence and the effect of sweeps toward the wall. This reduced the inclination angle of the large structures and increased their length scale, particularly in the streamwise and spanwise directions. Recovery from the FPG to a ZPG was rapid. The APG reduced the near wall shear, resulting in a reduced effect of ejections relative to sweeps. The APG had an opposite but smaller effect on the shape and size of structures compared to the FPG.     

逆压梯度边界层未分离情况下的湍流模式适用性研究Turbulence model applicability for boundary layer flow with adverse pressure gradient in attached case

边界层逆压梯度作用下的流动是许多工程中的一个基础问题,由于逆压梯度作用,流动形态复杂,使得数值模拟有很大的难度。基于雷诺平均纳维‐斯托克斯RANS（Reynolds Averaged Navier‐Stokes）方程对二维平板逆压梯度边界层作数值计算研究,选取6种代表性的湍流模式,得到局部摩擦系数的数值解,与实验值比较,发现k‐ω模式具有很好的精度。基于该湍流模式,给出了湍动能分布,该结果有助于认识逆压梯度边界层流动的复杂特征。     

Some new results of the observation on the coherent structures of turbulent boundary layer in flow with adverse pressure gradient

By a suitable manipulation of hydrogen bubble generation, some new results were obtained: (1) The long-streaks are generated along the interfaces between low and high-speed streaks. The long-streaks are generally stretching and are moving faster than its neighboring high-speed streaks. The hydrogen bubbles in long-streaks have longer life. (2) The stream-wise vortices are also generated along the interfaces. The project is supported by the National Natural Science Foundation of China.     

Riblet drag reduction in mild adverse pressure gradients: A numerical investigation

Riblet films are a passive method of turbulent boundary layer control that can reduce viscous drag. They have been studied with great detail for over 30 years. Although common riblet applications include flows with Adverse Pressure Gradients (APG), nearly all research thus far has been performed in channel flows. Recent research has provided motivation to study riblets in more complicated turbulent flows with claims that riblet drag reduction can double in mild APG common to airfoils at moderate angles of attack. Therefore, in this study, we compare drag reduction by scalloped riblet films between riblets in a zero pressure gradient and those in a mild APG using high-resolution large eddy simulations. In order to gain a fundamental understanding of the relationship between drag reduction and pressure gradient, we simulated several different riblet sizes that encompassed a broad range of s⁺ (riblet width in wall units), similarly to many previously published experimental studies. We found that there was only a slight improvement in drag reduction for riblets in the mild APG. We also observed that peak values of streamwise turbulence intensity, turbulent kinetic energy, and streamwise vorticity scale with riblet width. Primary Reynolds shear stresses and turbulence kinetic energy production however scale with the ability of the riblet to reduce skin-friction.     

Low- and high-speed structures in the outer region of an adverse-pressure-gradient turbulent boundary layer

Large- and very large-scale structures in the form of elongated regions of low and high streamwise momentum have been studied in the outer region of a turbulent boundary layer subjected to a strong adverse pressure gradient. Large sets of streamwise–spanwise instantaneous velocity fields are acquired by particle image velocimetry at three wall-normal positions (0.2δ, 0.5δ, 0.8δ) at three different streamwise locations and at 0.1δ at the last streamwise location which allows us to study the wall-normal and streamwise variations of the structures. Subsequently, a pattern-recognition method and a classification scheme are employed in order to detect, classify and characterize the structures in an efficient and rigorous manner. Like in the case of zero-pressure-gradient turbulent boundary layers, long meandering streaky regions of low and high momentum are observed in the outer region of the present flow but they appear less frequently; especially in the lower part (at 0.1δ and 0.2δ) of the large-velocity-defect zone, i.e. near detachment. The dimensions of these large structures scale on boundary-layer thickness (δ) and are generally comparable to those previously reported for such structures in the overlap region of zero-pressure-gradient turbulent boundary layers. Interestingly, the adverse pressure gradient does not significantly affect the dimensions and arrangement of the large-scale structures in the upper part (at 0.5δ and 0.8δ) a segment of the outer region where the scaled Reynolds stresses also remain fairly self-similar.     

The structure of a three-dimensional boundary layer subjected to streamwise-varying spanwise-homogeneous pressure gradient

A spatially-evolving three-dimensional boundary layer, subjected to a streamwise-varying spanwise-homogeneous pressure gradient, equivalent to a body force, is investigated by way of direct numerical simulation. The pressure gradient, prescribed to change its sign half-way along the boundary layer, provokes strong skewing of the velocity vector, with a layer of nearly collateral flow forming close to the wall up to the position of maximum spanwise velocity. A wide range of flow-physical properties have been studied, with particular emphasis on the near-wall layer, including second-moments, major budget contributions and wall-normal two-point correlations of velocity fluctuations and their angles, relative to wall-shear fluctuations. The results illustrate the complexity caused by skewing, including a damping in turbulent mixing and a significant lag between strains and stresses. The study has been undertaken in the context of efforts to develop and test novel hybrid LES–RANS schemes for non-equilibrium near-wall flows, with an emphasis on three-dimensional near-wall straining. Fundamental flow-physical issues aside, the data derived should be of particular relevance to a priori studies of second-moment RANS closure and the development and validation of RANS-type near-wall approximations implemented in LES schemes for high-Reynolds-number complex flows.     

Comparison of organized motions in a constant and an adverse pressure gradient turbulent flow

The distribution of the statistical properties of coherent motions across a fully developed feed pipe is observed to change drastically as adverse pressure gradient is applied in a conical diffuser. These changes are associated with distortion of the turbulence structure and becomes more pronounced as the flow approaches detachment. A conceptual model based on present measurements effectively accounts for major turbulence characteristics in the diffuser.     

Bursting frequency in turbulent boundary layers

Employing laser Doppler anemometry and VITA techniques, the bursting frequency in turbulent boundary layers has been measured over the Reynolds-number range 320 to 1470. The result indicates that the mean and non-dimensional bursting frequency scaled with the variables appropriate for the wall region was constant and independent of Reynoids number. When the same data are plotted using the outer variables of boundary layer to normalize the bursting frequency, the non-dimensional frequency increases as the Reynolds number increases. This is in agreement with the results of Blackwelder et al. (1983) who used hot wire anemometry and VITA technique. The project is supported by the National Natural Science Foundation of China