Performance analysis of dual-pump optical parametric amplifiers in silicon waveguide

Nondegenerate Four Wave Mixing (FWM) process in a silicon waveguide is influenced by two photon absorption (TPA), TPA induced free carrier absorption (FCA) besides self-phase modulation (SPM), cross-phase modulation (XPM), SRS, GVD and linear scattering losses. Influences of pump parameters of the dual-pump parametric amplifier (OPA) in the silicon waveguide on gain spectrum and noise figure are numerically investigated. Compared with single-pump configuration, dual-pump silicon OPA indicates a flat gain and noise figure. Then impact of waveguide dispersion on bandwidth and ripples for dual-pump silicon optical parametric amplifiers is discussed. Optimal pump configurations are evaluated. The results show that polarization independent net gain of silicon OPA can be achieved by using circular and orthogonally polarized pump.     

37.2 dB small-signal gain from Er/Yb Co-doped fiber amplifier with 20 mW pump power

An efficient erbium–ytterbium-doped fiber amplifier (EYDFA) is demonstrated by forward and backward pumping a 3 m erbium/ytterbium co-doped fibers (EYDF) in single- and double-pass configurations using a 20 mW pump. At the input signal wavelength of 1536 nm, the forward- and backward-pumped double-pass amplifiers achieved a maximum low-signal gain of 37.2 and 28.6 dB and a corresponding noise figure of 5.4 and 10.8 dB, respectively. Whereas, the forward- and backward-pumped single-pass amplifiers (at the same wavelength) achieved a maximum low-signal gain of 20.0 and 22.2 dB and a corresponding noise figure of 4.6 and 10.3 dB, respectively. The double-pass design offers an economical solution to high-efficiency and high-gain optical amplifiers.     

Low-noise-figure optical parametric amplifier with a continuous-wave frequency-modulated pump

We present what are to our knowledge the first gain and noise-figure measurements of a fiber optical parametric amplifier pumped by a simple frequency-modulated source. The maximum gain was 27.2 dB and the average noise figure was 4.2 dB. We achieved the low noise figure by filtering the pump to remove the broadband amplified spontaneous-emission pedestal on the pump spectrum.     

Raman-noise-induced noise-figure limit for chi(3) parametric amplifiers

The nonzero response time of the Kerr [chi(3)] nonlinearity determines the quantum-limited noise figure of chi(3) parametric amplifiers. This nonzero response time of the nonlinearity requires coupling of the parametric amplification process to a molecular-vibration phonon bath, causing the addition of excess noise through Raman gain or loss at temperatures above 0 K. The effect of this excess noise on the noise figure can be surprisingly significant. We derive analytical expressions for this quantum-limited noise figure for phase-insensitive operation of a chi(3) amplifier and show good agreement with published noise-figure measurements.     

抽运方式对混合拉曼光纤放大器性能的影响

通过实验比较了前向抽运拉曼光纤放大器与掺铒光纤放大器组成的混合放大器、后向抽运拉曼光纤放大器与掺铒光纤放大器组成的混合放大器的性能。实验采用75km标准单模光纤作为增益介质。采用20信道(符合ITU-T建议的波分复用信号)，波长为1537．377～1560．605nm，作为混合放大器的测试信号。20信道总功率-2．86dBm，每一信道用2．5Gb／s、码长2^7-1的非归零码通过电吸收调制器(EA)进行外调制。实验结果表明，前向抽运方式混合放大器的性能优于后向抽运方式的混合放大器，其中噪声系数的改善值为2．28～6．55dB。采用前向抽运时，各信道的增益同后向抽运相比，增加值均大于5dB。但不论采取那种抽运方式，采用混合放大的形式，各信道的光信噪比均大于26．9dB。     

Noise-figure limit of fiber-optical parametric amplifiers and wavelength converters: experimental investigation

Recent theoretical work predicts that the quantum-limited noise figure of a x(3)-based fiber-optical parametric amplifier operating as a phase-insensitive in-line amplifier or as a wavelength converter exceeds the standard 3-dB limit at high gain. The degradation of the noise figure is caused by the excess noise added by the unavoidable Raman gain and loss occurring at the signal and the converted wavelengths. We present detailed experimental evidence in support of this theory through measurements of the gain and noise-figure spectra for phase-insensitive parametric amplification and wavelength conversion in a continuous-wave amplifier made from 4.4 km of dispersion-shifted fiber. The theory is also extended to include the effect of distributed linear loss on the noise figure of such a long-length parametric amplifier and wavelength converter.     

High-gain and low-noise-figure erbium-doped fiber amplifier employing dual stage quadruple pass technique

A high-gain and low-noise-figure (NF) erbium-doped fiber amplifier (EDFA) was demonstrated utilizing a new technique called the dual-stage quadruple pass (DSQP) with filters. An efficient amplification occurs at the signal wavelength of 1550 nm when it travels along the DSQP amplifier. The highest gain of 62.56 dB with a low noise figure of 3.98 dB was achieved for an input signal power of −50 dBm and pump powers of 10 and 165mW in the second and first stage amplifiers respectively.     

基于ADS的2.25GHz低噪声放大器的设计与制作

首先介绍用ADS软件仿真设计S波段低噪声放大器的方法,在仿真过程中,采用带封装模型的原理图-版图联合仿真的方法;然后对制作出的放大器在工作频段2.15—2.35GHz内测试,测试结果和电路仿真结果基本一致:输入输出驻波比均小于1.2,增益达到25dB,且带内增益波动为±0.4dB,噪声为0.7dB;最后对放大器进行了低温(液氮环境)测试,结果表明该放大器在低温下也能正常工作。     

Yb3+sensitized Er3+-doped waveguide amplifiers: a theoretical approach

Silicate and phosphate glass waveguide amplifiers doped with Er³⁺, and co-doped with Er³⁺/Yb³⁺ are theoretically studied. Configurations for core and core–cladding doped waveguide amplifiers are considered. It is shown that gain in the core–cladding doped amplifiers is considerably higher than core doped amplifiers. It is also shown that with input signal power up to 1 and 200mW pump power, a 12.5dB gain can be achieved in a 3cm long waveguide amplifier, with a noise figure of 3dB.     

Optical parametric chirped-pulse-amplification contrast enhancement by regenerative pump spectral filtering

We demonstrate an approach to fundamentally improve the contrast of optical parametric chirped-pulse amplifiers (OPCPA). The instantaneous parametric gain couples the temporal variations of the pump-pulse intensity to spectral variations of the intensity of the stretched signal pulse being amplified, which significantly degrade the temporal contrast of the amplified pulse after recompression. Simple and efficient pump-intensity noise reduction in an OPCPA system using a volume Bragg grating in a regenerative amplifier demonstrates contrast improvements up to 30 dB.     

Effect of Cascading Amplification Stages on the Performance of Serial Hybrid Fiber Amplifier

Abstract

This study demonstrates simulation and experimental validation of a wideband serial hybrid Raman/erbium-doped fiber amplifier. Two configurations are adopted; in type A, a Raman amplifier is the first stage, and in type B, an erbium-doped fiber amplifier is the first stage. At low input signal power, the average gain level is 20 dB with a flat gain bandwidth of 40 nm for both configurations. The noise figure in type B is dominated by the erbium-doped fiber amplifier and produces lower values and flatter spectra than in type A. The gain of the proposed hybrid amplifiers is affected more by the second amplification stage.     

Pump-noise transfer in dual-pump fiber-optic parametric amplifiers: walk-off effects

Transfer of intensity noise from pumps to signal in dual-pump fiber-optic parametric amplifiers is simulated numerically for a realistic configuration in which both pumps are amplified and filtered before they enter the fiber. The walk-off effects induced by different group velocities of pumps, signal, and idler are fully taken into account. It is found that the optical signal-to-noise ratio can be as low as 15 dB when the amplifier length is close to 0.5 km, but it can be improved by 3 dB or so by use of longer fibers.     

Dynamic Gain-Clamped Amplifier with Backward-Injection of a Fabry-Perot Laser

We have been experimentally demonstrated an active control technique of dynamic gain-clamped spectra for the erbium-doped fiber amplifiers (EDFA's) by a backward-injected Fabry-Perot (F-P) laser into this EDFA. In addition, employing a short length erbium-doped fiber (EDF) that not cause any gain saturation for preamplification in front of this amplifier module, it can reduce the noise figure degradation and simultaneously achieve gain variation from 11.1 dB to 0.5 dB for 10 dB input power level change.     

Low noise double pass L-band erbium-doped fiber amplifier

A new double pass long wavelength band erbium-doped fiber amplifier with enhanced noise figure characteristics is demonstrated. The noise figure is improved by about 2.6 dB with the incorporation of broadband conventional-band fiber Bragg grating (FBG) in between the two segments of erbium-doped fiber. By incorporating both the pre-amplifier and the FBG, the noise figure is further improved, which varies from 4.0 to 5.0 dB in the flat gain region from 1570 to 1600 nm. The gain varies from 32.0 to 33.4 dB within this region. The new amplifier with high gain and low noise figure can be useful as an inline amplifier in a wavelength division multiplexing transmission system.     

高场核磁共振波谱仪宽带前置放大器的研制

宽带前置放大器是磁共振仪器的重要部件,其性能决定了整个仪器X核通道的检测灵敏度. 根据射频电路理论以及磁共振波谱仪整体性能指标的要求,设计并实现了可应用于高场核磁共振波谱仪的高性能宽带前置放大器. 实测结果表明,所研制的核磁共振波谱仪宽带前置放大器在15 MHz~300 MHz频率范围内,其工作性能达到：带内增益>38 dB,带内平坦度<1.5 dB,噪声系数基本保持在1.2 dB以下,射频开关切换时间<1.5 μs,具有带内增益平坦度高,噪声系数小,发射状态下放大器前端保护电路隔离度高,以及工作状态检测电路准确、简洁的特点. 同时高场核磁共振碳和磷等杂核实验显示,利用所研制的宽带前置放大器可检测到具有较高信噪比的NMR信号.     

场效应器件低温特性与低噪声放大器

高温超导滤波器与低噪声放大器(LNA)组成的射频接收机前端设备具有高选择性、高灵敏度和极低的噪声,因而展现出广阔的应用前景.本文研究了场效应器件的低温物理特性和电学参数,研制了一种适用于高温超导微波接收系统的低温低噪声放大器,在60K工作温度下,具有很好的噪声特性.包括高电子迁移率场效应晶体管在内的元件参数均在60K温度下进行了实际测量.放大器的各项指标与设计值吻合,工作频段为800MHz～850MHz,增益大于18dB,输入输出驻波比小于1.2,噪声系数小于0.22dB.     

Experimental demonstration of unconditional entanglement swapping for continuous variables

The unconditional entanglement swapping for continuous variables is experimentally demonstrated. Two initial entangled states are produced from two nondegenerate optical parametric amplifiers operating at de-amplification. Through implementing the direct measurement of the Bell-state between two optical beams from each amplifier the remaining two optical beams, which have never directly interacted with each other, are entangled. The quantum correlation degrees of 1.23 and 1.12 dB below the shot noise limit for the amplitude and phase quadratures resulting from the entanglement swapping are measured straightly.     

A gain-clamped-semiconductor-optical-amplifier combined with a distributed Raman-fiber-amplifier: a good candidate as an inline amplifier for WDM networks

A gain-clamped semiconductor optical amplifier (SOA) is used as an inline amplifier in combination with a distributed Raman fiber amplifier. The combined amplifier has 20 dB gain and a noise figure below 2.7 dB. The optical signal to noise ratios after five spans of 20 dB loss, equivalent to 5 × 80 km, are over 25.2 dB for eight-channel transmissions. In addition, the potentially compact amplifier shows negligible transients under dynamic add-drops.     

Measurement of the photon statistics and the noise figure of a fiber-optic parametric amplifier

We report measurement of the noise statistics of spontaneous parametric fluorescence in a fiber parametric amplifier with single-mode, single-photon resolution. We employ optical homodyne tomography for this purpose, which also provides a self-calibrating measurement of the noise figure of the amplifier. The measured photon statistics agree with quantum-mechanical predictions, and the amplifier's noise figure is found to be almost quantum limited.