Sn激光共振电离质谱分析中电离通道理论探讨

Sn激光共振电离质谱同位素分析中电离通道的选择非常关键.采用Dirac–Hartree–Fock(MCDHF)方法和相对论组态相互作用的Grasp VU原子结构计算程序,计算了Sn、Te原子的低激发态能级结构、光谱跃迁几率.通过对Sn质谱分析用灯丝样品进行热蒸发实验,确定了Sn原子在蒸发条件下基态能级粒子布局.结合理论计算跃迁数据和布局数据,从选择性电离角度出发,推荐了Sn激光共振电离质谱分析中Sn电离光谱通道.     

铈原子偶宇称自电离态激光共振电离光谱

给出了利用三色三光子激光共振电离光谱技术研究铈原子偶宇称自电离态的结果。27个有较大跃迁截面高奇宇称激发态被用作第二激发态。第三台染料激光波长在634～670nm范围内扫描,发现了141个偶宇称自电离态能级。为了寻求最佳电离方案,对有较大自电离态能级跃迁截面的各电离路径进行了初步的判定,推荐了8条较佳的电离路径。     

双共振多光子电离光谱的新进展

分子的多光子电离光谱是超灵敏激光光谱的一种,它产生于七十年代中期.最近几年,由于将多光子电离和双共振跃迁过程结合起来,使这种双共振多光子电离光谱技术的探测灵敏度和选择性都大大提高了.目前,它已广泛应用于研究气态分子的激发态、三重态和高里德堡态,包括研究这些态的光谱、能级结构,寿命,弛豫以及化学反应.这些研究所获得的新信息和数据对于探寻新激光体系和新的激光分离同位素方法,对于了解高层大气化学和天体物理过程等都具有重要意义.本文将介绍此种光谱的原理、实验技术及其若干应用..一、共振多光子电离(REMPI)光谱 的原理和…     

激光脉冲延时方案对原子多步共振光致电离的影响

针对宁西京教授提出激光脉冲延时方案,在含时薛定谔方程理论框架下探讨了各种参数对激光共振电离效率的影响;并以镥原子共振电离为例,探讨了该方案用于激光共振电离质谱(LRIMS)同位素分析的可行性.结果表明:由于超精细结构能级激励拉比频率很难满足匹配条件,该方案很难用于宽带激光激励电离LRIMS同位素分析中.在理论分析基础上,给出了基于窄带激光激励电离的LRIMS同位素分析的光致电离方案.     

锌掺杂半导体材料的共振电离质谱分析

本文简要地描述了激光共振电离质谱的实验装置和测量方法,给出了用共振电离质谱方法对锌掺杂化合物半导体材料进行分析的光谱和质谱图,并估计了用这种方法进行痕量分析可能达到的检测限.     

用激光共振电离光谱测定铈原子奇宇称高激发态(Ⅰ):32 042～34 575 cm-1

激光共振电离光谱是一种十分适合于高能量区重元素复杂原子结构研究的技术。为寻找原子最佳的共振电离通道，利用这一技术对铈原子奇宇称高激发态进行了研究。在32042－34575cm^-1范围内，用两步共振激发和非共振电离方法，首次观察到了83条铈原子奇宇称高激发态能级，测量了这些新能级的能量和给出了可能的总角动量J值。     

锌掺杂产导体材料的共振电离质谱分析

本文简要地描述了激光共振电离质谱的实验装置的测量方法,给出了用共振电离质谱方法对锌掺杂化合物半导体材料进行分析的光谱和质谱图,并估计了用这种方法进行奶量分析可能达到的检测限     

镁原子3pns自电离光谱

利用多通道量子数学亏损理论对镁原子３ｐｎｓ自电离态的光谱特性进行了研究。首次报道了包括精细结构分辨的３ｐｎｓ态的能级位置和宽度，分析了所涉及的各通道之间的相互耦合现象，探索了相关的物理机制。关于镁原子３ｐｎｓ自电离跃迁线形的计算与最近报道的相关实验进行了比较。     

钡准分子共振电离光谱及离化机制研究

本文报道用激光共振电离法获得一个新的钡准分子结构.在染料激光波长扫描范围内观察到钡原子双光子共振跃迁、双光子混合跃迁和钡准分子谱带.我们提出一种用热离子二极管信号特性分析原子和分子里德伯态的离化机制的方法,并以此对钡原子和钡分子的离化通道进行讨论.     

氯代苯分子3d Rydberg态的共振多光子电离光谱研究

用共振多光子电离（ＭＰＩ）技术，结合飞行时间质谱（ＴＯＦＭＳ），对氯代苯（Ｃｌ）分子的３ｄＲｙｄｂｅｒｇ态进行了研究。在λ＝（４７３．０ｎｍ～４８３．０ｎｍ）范围内所获得的光离子光谱呈现出明显的可分辨的结构。经分析为３ｄ态的（３＋１）共振多光子电离，光谱结构可能为３ｄ态振动能级的反映，考虑跃迁选律，对这些结构进行了尝试性指认。     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.