An experimental study of the acoustic impedance characteristics of human hair

Previous analytical and empirical studies of the human auditory system have shown that the cues used for localization are modified by the inclusion of nonrigid scattering surfaces (clothing, hair etc). This paper presents an investigation into the acoustic impedance properties of human hair. The legitimacy of a locally reactive surface assumption is investigated, and an appropriate boundary condition is formulated to account for the physiological composition of a human head with hair. This utilizes an equivalent impedance parameter to allow the scattering boundary to be defined at a reference plane coincident with the inner rigid surface of the head. Experimental examination of a representative synthetic hair material at oblique incidence is used to show that a locally reactive surface assumption is legitimate. Additional experimental analysis of a simple scattering problem illustrates that the equivalent impedance must be used in favor of the traditional surface impedance to yield physically correct pressure magnitudes. The equivalent acoustic impedance properties of a representative range of human hair samples are discussed, including trends with sample thickness, fiber diameter, bulk density, and mass.     

Bosonic zero modes in discretized light-cone field theory

It is shown that for theories with bosonic fields a constrained zero mode is a necessary ingredient for a consistent discretized light-cone quantization (DLCQ). Inclusion of this zero mode is shown to remove a non-covariant, quadratically divergent contribution to the fermion self-energy in 3+1 dimensional Yukawa theory which would otherwise be present. It is further shown to result in a fully consistent set of Heisenberg equations. The possibility of maintaining parity in DLCQ is discussed.     

波纹板式空冷器阻力与传热特性实验研究

在可改变风量和热水流量的实验条件下,对波纹板式空冷器的阻力与传热特性进行实验研究。得到了空气侧的阻力降关联式以及两侧的对流换热系数关联式,其适用于热水雷诺数在2000-8000之间、空气雷诺数在2000-10000之间。在相同工况下,比较了波纹板式、光管式和翅片管式空冷器的性能指标,结果表明:迎面风速在2.45-4.1 m/s之间,波纹板式空冷器传热系数达到100-160 W/m2/℃;约比光管式提高70%,但只有以管束外表面为基准的翅片管式传热系数的六分之一;板式空冷器单位体积换热量约是翅片管式空冷器的1.5倍,是光管式的15倍;板式空冷器单位功耗换热量约是光管式空冷器的5.5倍,而翅片管式空冷器与光管式空冷器则相差不大。     

High contrast air-coupled acoustic imaging with zero group velocity lamb modes

The well known zero in the group velocity of the first-order symmetric (S1) plate wave mode has been exploited in air-coupled ultrasonic imaging to obtain significantly higher sensitivity than can be achieved in conventional air-coupled scanning. At the zero group velocity point at the frequency minimum of the S1 mode, a broad range of wavenumbers couple into the first-order symmetric mode at nearly a constant frequency, greatly enhancing transmission at that frequency. Coupled energy remains localized near the coupling point because the group velocity is zero. We excite the mode with a broadband, focussing, air-coupled transducer at the frequency of the zero group velocity point in the S1 mode. By exploiting the efficient coupling at the zero group velocity frequency, we have easily imaged a single layer of Scotch tape attached to a 6.4-mm thick Plexiglas plate and 3.2-mm Teflon inserts in a composite laminate.     

An experimental study on the acoustic absorption of sand panels

Potentially sand panels could be used as novel sound absorbing materials that are fire resistant, environmentally friendly, mechanically strong and have good durability. However, the performance of sand panels as sound absorbers has not yet been studied. Results of measurements in a reverberation chamber of the random-incidence absorption coefficients of 13 different sand panel compositions and configurations with air gaps are reported. Also the flow resistivities and bulk densities have been measured. The results prove that sand panels could offer effective and wide-band acoustic absorption. As is the case with conventional sound absorbing materials, adding an air space is found to be the most effective way to widen the absorption bands and improve the overall absorption. Comparisons of the measured sand panel absorption data with predictions of the Delany and Bazley and Voronina models reveal that, while neither model is very accurate, the former gives more accurate predictions especially for sand panels with lower flow resistivity and smaller thickness.     

非轴对称结构井孔声场的实验研究

本实验为轴对称井孔结构和非轴对称井孔结构声场的对比实验,通过分别记录这两种结构井孔上不同源距的接收波形来完成。对接收波列作了二维谱处理并和应用有限差分法得到的相应结果作对比,获得了比较一致的结果。由此证明我们应用有限差分法来研究非轴对称井孔声场的方法是正确可靠的。     

Calculation of amplitudes of acoustic normal modes from the reciprocity principle

Recently, J. D. Achenbach [J. Acoust. Soc. Am. 116, 1481-1487 (2004)] put forward, on heuristic grounds, an elegant technique to calculate amplitudes of guided waves in an elastic solid. The technique is based on application of the reciprocity principle. In this article, the technique is applied to acoustic waveguides. A mathematical justification of the technique is obtained. The technique is extended to enable calculation of excitation coefficients of modes of both discrete and continuous spectra by a given sound source. The results are shown to be identical to those derived with the traditional methods that rely on integral transforms.     

Flexural vibrations of a rectangular plate for the lower normal modes

Theoretical and experimental results for flexural waves of a rectangular plate with free ends are obtained. Both the natural frequencies and mode shapes are analyzed for the lower normal modes. To take into account the boundary conditions, a plane wave expansion method is used to solve the thin plate theory also known as the 2D Kirchhoff-Love equation. The excitation and detection of the normal modes of the out-of-plane waves are performed using non-contact electromagnetic-acoustic transducers. We conclude that this experimental technique is highly reliable due to the good agreement between theory and experiment.     

An experimental study of the fluctuations of acoustic signals reflected from ships

Results of an experimental study of amplitude fluctuations in echo signals received from ships and their wakes are presented for the cases of vertical and horizontal sounding in a wide range of high sonic and ultrasonic frequencies. Dependences of the amplitude variation coefficients of echo signals on the speed of ship motion, the sounding frequency, the duration of sounding pulses, and the height of wind waves on the sea surface are analyzed. The probability characteristics of echo signals reflected from ship hulls and from wakes at different depths are discussed.     

Edge resonance and zero group velocity Lamb modes in a free elastic plate

The local resonances of a free isotropic elastic plate are investigated using laser ultrasonic techniques. Experimental results are interpreted in terms of zero group velocity Lamb modes and edge mode. At a distance from the edge larger than the plate thickness a sharp resonance is observed at the frequency where the group velocity of the first symmetrical Lamb mode vanishes. Close to the edge of the plate, the resonance due to the edge mode dominates. Both zero group velocity and edge resonances appear at the theoretically predicted frequencies. These frequencies do not vary with the distance from the edge of the plate and the transition between the two modes of vibration, at about the plate thickness, is abrupt. Using a laser excitation on the edge, the amplitude profile of the normal displacement at the edge resonance frequency was determined.     

An experimental study of the effects of resilient bars on plate vibration

Resilient bars can provide a low-cost, effective improvement to sound insulation performance. They are commonly used in timber-framed floor/ceiling assemblies in North America and Europe. Resilient bars are often modelled as springs isolating the two connected plates thereby forming a mass-spring-mass system. However, as a furring system of plates, resilient bars may modify the vibration energy distribution across a connected plate by acting as stiffeners. The authors investigate this issue by measuring acceleration levels at different locations relative to the fixing positions and thereby derive vibration waveforms for the connected plate in a small-scale structural simulation of a floor-ceiling system. The results were compared with timber-joist-ribbed, and timber-brander-ribbed, structures. The vibration modes of a suspended plate were also measured for comparative purposes. The results indicated that resilient bars did not perform as stiffeners whereas joists and timber branders did effectively stiffen their connected plates. Resilient bars neither forced orthotropic plate behaviour at low frequencies, nor separated the plate into sub-plates at higher frequencies. Resilient-bar-ribbed plates may also differ from independent plates. The modal behaviour of resilient-bar-ribbed plates is more complex and their effect on modal density and radiation efficiency are worthy of further research.     

A numerical method for acoustic normal modes for shear flows

The normal modes and their propagation numbers for acoustic propagation in wave guides with flow are the eigenvectors and eigenvalues of a boundary value problem for a non-standard Sturm-Liouville problem. It is non-standard because it depends non-linearly on the eigenvalue parameter. (In the classical problem for ducts with no flow, the problem depends linearly on the eigenvalue parameter.) In this paper a method is presented for the fast numerical solution of this problem. It is a generalization of a method that was developed for the classical problem. A finite difference method is employed that combines well known numerical techniques and a generalization of the Sturm sequence method to solve the resulting algebraic eigenvalue problem. Then a modified Richardson extrapolation method is used that dramatically increases the accuracy of the computed eigenvalues. The method is then applied to two problems. They correspond to acoustic propagation in the ocean in the presence of a current, and to acoustic propagation in shear layers over flat plates.     

声场重构的声辐射模态阶数分析

利用声辐射模态法对椭球状声源辐射声场进行重构,分析了模态阶数对相对误差的影响,以及模态阶数与频率的关系;同时深入探讨了声源形状变化对模态阶数选取的影响。研究发现利用较少的模态阶数即可得到很好的重构效果,且声源形状的变化对重构所需模态阶数的影响较小,因此可将该方法用于任意形状声源的重构,体现了此方法在声场重构中的优越性。     

Propagation characteristics of zero field truncation of COS beam

The central spot of COS beam (CS-COS) can be obtained from COS beam by using the zero field truncation technique. The transversal intensity distributions of CS-COS through three different kinds of aperture functions are simulated numerically from the near field to the far field. It is shown that the CS-COS has the property of eliminating the diffraction fringes in the whole propagation process if a suitable aperture is introduced.     

An experimental study of acoustic scattering from thermocline in shallow sea

I.IntroductionThetemperature,salinityandstaticprcssureofscawaterchangewithdepth,whichformsthcsoundvelocityvertica1distributioninthesea.Duringsummcrscason,thercaren0n-uniformthermoclinelaycrsinthedepths0fshallowseaal0ngChinacoast.Wearenowabletodeducctheimpedanccproflle(pc)byechoesofacousticwavesfr0mvarioustherm0c1ine1ayers.Thewaterdcnsityvaricsonlyslight1y,hencetheac0usticve1ocityde-Pendsmainlyonthetemperatureofseawatcr,andthercfore,itispossiblctorecordthcdepthofthermoclinelaycrsbyusingacoust…     

利用源强密度声辐射模态重建声场

为了利用声场中少量测点声压数据精确重建复杂结构的辐射声场,提出了源强密度声辐射模态分析理论和声场重建公式.在结构表面定义的空间上,利用以源强密度分布函数为参量的结构辐射声功率泛函表达式定义了一个线性自伴正辐射算子,该算子的特征函数为结构的源强密度声辐射模态.然后通过对矩形平板和带有半球帽的圆柱体的源强密度声辐射模态的分析,证明了源强密度声辐射模态具有空间滤波特性,并利用该性质建立了声场重建公式.球体仿真和平板实验验证了所提出的声场重建方法的可行性和稳健性.基于源强密度声辐射模态的声场重建方法简单,利用较少测点数据就可以获得较高的声场重建精度,特别适合于复杂结构的低频声场重建.     

声辐射模态和球谐波函数在球源声场重建中的比较

声辐射模态和球谐波函数在球源声场重建中均有应用,两者具有很多相似性,都具有相同的多极子辐射模式和\     

A new type of acoustic modes of vibration of thin piezoelectric plates: Quasi-longitudinal normal modes

Using ST-cut quartz crystal plates as an example, a new type of normal modes of acoustic vibrations is described. The modes propagate along the x axis with a velocity close or equal to that of longitudinal bulk waves propagating in the same direction and have a longitudinal component of elastic displacement no less than two orders of magnitude greater than the two other components (the shear-horizontal and shear-vertical ones) throughout the whole plate thickness. The domain of existence of the quasi-longitudinal modes consists of a set of limited zones that contain the “allowed” values of the plate thickness H/λ (H is the plate thickness and λ is the wavelength) and are separated by “forbidden” zones corresponding to common Lamb modes. The closeness (or coincidence) of the velocities of a quasi-longitudinal mode in the plate and a longitudinal bulk wave in an unbounded crystal is a necessary but not sufficient condition for the existence of the aforementioned type of modes in ST,x quartz.