Broadband near-infrared fibers dispersion measurement using white-light spectral interferometry

A new technique for an experimental determination of the effective refractive index, group refractive index and dispersion of fibers in a broad near-infrared spectral range is presented. The method is based on a white-light spectral interference which utilizes an unbalanced Michelson interferometer. The effective refractive index is obtained by a direct fitting the cosine function to the spectral interference pattern recorded by a low resolution spectrometer. The method has been tested in the spectral range of 1000-1700 nm both with standard telecommunication fibers and a sample of a photonic fiber. The accuracy of dispersion measurement () exceeds those from the previously reported near-infrared white-light spectral interference methods.     

Electronic speckle pattern interferometry using optical fibers

Initial experiments using electronic speckle pattern interferometry with fiberoptic imaging and illumination are described.     

Broadband dispersion compensation using microstructure fibers

Beijing University of Posts and Telecommunications, Beijing 100876Dispersion and dispersion slope compensation of 10-Gb/s pulses using microstructure fibers (MFs) is demonstrated experimentally. A 26-m MF is used to compensate the dispersion of 2-km standard singe mode fiber in a 20-nm range in C band. The experimental results show that a significant improvement can be achieved in the quality of the observed pulses with the dispersion compensation. Moreover, the further research shows that the MF can compensate the anomalous dispersion of a single mode fiber within ±0.27 ps/(nm·km) over a 50-nm wavelength range from 1520 to 1570 nm.     

Fiber-modes and fiber-anisotropy characterization using low-coherence interferometry

An optical low-coherence interferometry technique has been used to simultaneously resolve the mode profile and to measure the intermodal dispersion of guided modes of a few-mode fiber. Measurements are performed using short samples of fiber (about 50 cm). There is no need for a complex mode-conversion technique to reach a high interference visibility. Four LP mode groups of the few-mode fiber are resolved. Experimental results and numerical simulations show that the ellipticity of the fiber core leads to a distinct splitting of the degenerate high-order modes in group index. For the first time, to the best of our knowledge, it has been demonstrated that degenerate LP11 modes are much more sensitive to core shape variations than the fundamental modes and that intermodal dispersion of high-order degenerate modes can be used for characterizing the anisotropy of an optical waveguide.     

Broadband dispersion compensation of conventional single mode fibers using microstructure optical fibers

This paper presents a microstructure optical fiber for dispersion compensation in a wide range of wavelengths. The finite-element method with perfectly matched absorbing layers boundary condition is used to investigate the guiding properties. The designed novel dispersion compensating fiber shows that it is possible to obtain a larger negative dispersion coefficient of about −130 to −360 ps/(nm km), better dispersion slope compensation, better compensation ratio, and lower confinement losses less than 10⁻² dB/km in the entire telecommunication (1400–1600 nm) band by using a modest number of design parameters and very simple cladding design.     

Correction of quadratic phase error in two-wavelength digital holographic interferometry using laser diodes

We present the correction of a quadratic phase error in two-wavelength digital holographic interferometry using laser diodes. This phase error arises from numerical reconstructions of wavefronts from digital holograms based on the Fresnel diffraction integral. To correct the quadratic phase error, it is numerically produced by computer on the basis of the theoretical prediction and is subtracted from the phase difference map in two-wavelength digital holographic interferometry. Experimental results show that the method of correction in this paper is useful for two-wavelength digital holographic interferometry using laser diodes.     

多量子阱波导的传输和色散特性

本文用Floquet理论分析了多量子阱(阱垒数N>>1)波导的传输和色散特性,给出了适用于TE和TM两种偏振态的等效三层平板波导芯子折射率的解析公式,该公式清楚地说明了多量子阱波导的本征双折射行为。     

Direct measurement of group dispersion of optical components using white-light spectral interferometry

We present a simple white-light spectral interferometric technique employing a low-resolution spectrometer for a direct measurement of the group dispersion of optical components over a wide wavelength range. The technique utilizes an unbalanced Mach-Zehnder interferometer with a component under test inserted in one arm and the other arm with adjustable path length. We record a series of spectral interferograms to measure the equalization wavelength as a function of the path length difference. We measure the absolute group refractive index as a function of wavelength for a quartz crystal of known thickness and the relative one for optical fiber. In the latter case we use a microscope objective in front and a lens behind the fiber and subtract their group dispersion, which is measured by a technique of tandem interferometry including also a Michelson interferometer.     

Optical low-coherence reflectometry for complete chromatic dispersion characterization of few-mode fibers

A phase-sensitive optical low-coherence reflectometry (OLCR) technique is demonstrated to simultaneously measure the absolute chromatic dispersion values of each guided LP mode of a few-mode fiber. We show that the OLCR technique requires only short samples of fiber (<1 m) and has no need for high-ratio mode converters to reach an accurate wavelength-dependent group delay evolution of every mode. As an example we present for the first time to our knowledge a direct and complete analysis of few-mode fibers with high, low, positive, and negative modal dispersion values, leading to chromatic dispersion parameters in good agreement with theoretical predictions.     

Novel technique for connecting waveguides and fibers

A practical technique with low coupling loss has been developed for connecting waveguides and fibers by adjusting and fixing them one by one. A thin strip of glass is permanently cemented on the side of the fiber near the tip to be joined. This strip is used as a manipulator, after which it is cemented to the substrate.     

Mode dispersion characteristics of graded-index optical waveguides

A method to compute the propagating modes of graded index waveguides with an arbitrary refractive index distribution is proposed, based on the variational method applied to the integral wave equation. The method is applied to two refractive index distributions: a Gaussian index distribution and a complementary error-function index distribution. The results are compared with the predictions of perturbation analysis and are experimentally verified by measuring the mode spectrum of a Ti-diffused LiNbO₃ waveguide.     

Measurement of fiber chromatic dispersion using spectral interferometry with modulation of dispersed laser pulses

We propose and experimentally demonstrate a method for fiber dispersion measurement based on the modulation of laser pulses stretched by the fiber under test. The measured spectrum of the modulated pulses is the result of the interference between the stretched pulse spectra shifted by the modulation harmonics. The interference pattern is processed as in Fourier transform spectral interferometry. Unlike to conventional spectral interferometry, environmental conditions do not affect the interferogram due to the lack of any interferometer; additionally, large dispersions can be characterized by the method proposed. Its high accuracy is demonstrated in experimental comparison with the widely used phase shift technique.     

Analysis for dispersion characteristics of elliptic- and parabolic-groove waveguides

In this paper, the dispersion characteristics of elliptic-and parabolic-groove guides are analysed by using the equivalent network method with rectangular step approximation. The results have important values in the studying of the transmission characteristics of curvilineal-groove guides as well as its manufacture and application.     

Fabrication and characterization of double-diffused waveguides

An experimental study of two-step Ag⁺/Na⁺ ion exchange in BK-7 glass substrates in molten solutions consisting of AgNO₃/NaNO₃ mixtures is presented. This paper describes a method for evaluating the measured mode index spectra and the index profile of double-diffused semiburied waveguides. They are first diffused at 320°C in 2% melt and are then converted to semiburied waveguides by a second diffusion step consisting of a short-time reimmersion in a 0.25% melt.     

Grating-assisted coupling of optical fibers and photonic crystal waveguides

We propose and analyze a highly efficient method of coupling light from optical fibers to two-dimensional photonic crystal waveguides. Efficient coupling is achieved by positioning of a tapered fiber parallel to the linear defect, where the photonic crystal's cladding functions as a grating coupler and provides field confinement as well. Numerical simulations indicate that better than 90% transmission is possible with a full width at half-magnitude bandwidth of 12nm. It is shown that one can increase the bandwidth by increasing the field overlap between the two waveguides.     

Field transfer decay and interferometry in coupled waveguides with stochastic sources

Coupled waveguides, such as those used as optical filters, switches, or couplers, are investigated in the context of coherence theory. A stochastic source is introduced to the standard coupled-mode model. Decay in the power transferred between the waveguides as a function of distance is predicted. Application of this result in the form of an interferometric spectrometer is explored.     

Approximate analysis of mode dispersion in diffused-channel waveguides

We propose an approximate mode analysis using the effective index method for calculating mode dispersion in diffused channel waveguides. The method uses the minimum computing time and gives good agreement with other published results.     

微环耦合谐振光波导中的色散控制模型与数值仿真

本文利用传输矩阵法得到了微环耦合谐振光波导的色散关系,讨论了耦合损耗、传输损耗及耦合系数对微环耦合谐振光波导色散的影响,改变耦合损耗、传输损耗及耦合系数可控制其色散曲线的形状、位置、以及带宽,色散曲线的变化及控制对微环耦合谐振光波导在滤波、光信号延迟及缓存等方面的应用有重要意义. 关键词： 光波导 微环光波导 传输矩阵法     

Modeling dispersion in optical fibers: applications to dispersion tailoring and dispersion compensation

The phenomenon of temporal pulse dispersion, which is a key characteristic of an optical fiber communication system is described from the first principles. Beginning with the basics of dispersion in a bulk medium, these concepts are then applied to propagation of a pulse in an optical fiber. Details of modeling dispersion are then described in the context of dispersion tailoring and dispersion compensation with a view to form the foundation for subsequent chapters on dispersion compensation that follow in this report. Basic physics behind the design target for dispersion compensating fibers is discussed, which should be useful to fiber designers.