Owing to their excellent properties, such as transparency, resistance to oxidation, and high adhesivity, acrylic pressure-sensitive adhesives (PSAs) are widely used. Recently, solvent-free acrylic PSAs, which are typically prepared via photopolymerization, have attracted increasing attention because of the current strict environmental regulations. UV light is commonly used as an excitation source for photopolymerization, whereas visible light, which is safer for humans, is rarely utilized. In this study, we prepared solvent-free acrylic PSAs via visible light-driven photoredox-mediated radical polymerization. Three α-haloesters were used as additives to overcome critical shortcomings, such as the previously reported low film curing rate and poor transparency observed during additive-free photocatalytic polymerization. The film curing rate was greatly increased in the presence of α-haloesters, which lowered the photocatalyst loadings and, hence, improved the film transparency. These results confirmed that our method could be widely used to prepare general-purpose solvent-free PSAs—in particular, optically clear adhesives for electronics. 相似文献
Pressure-sensitive adhesives (PSAs) are made from soft, irreversibly lightly crosslinked polymers. Even after removal from surfaces, they retain insoluble networks which pose problems during the recycling of glass and cardboard. Herein, degradable PSAs are presented that provide the required performance in use but have networks that can be degraded after use. A series of copolymers was prepared through radical copolymerization of n-butyl acrylate, 4-acryloyloxy benzophenone (ABP) photo-crosslinker, and dibenzo[c,e]oxepin-5(7H)-thione (DOT) to provide degradable backbone thioesters. The optimum tack and peel strengths were found for molar contents of 0.05 mol% ABP and 0.25 mol% DOT. Degradation of the backbone thioesters through aminolysis or thiolysis led to the full dissolution of the networks, loss of adhesive properties of films (decreases in the measured tack and peel strengths), and the quick detachment of model labels from a substrate. Inclusion of DOT into PSAs offers a viable route toward degradable and recyclable packaging labels. 相似文献
The copolymerizations of a gaseous monomer (ethylene) and a liquid monomer (vinyl acetate) via emulsion and miniemulsion polymerizations are reported. Reactions in which the vinyl acetate was introduced in both batch and semibatch modes are carried out. (Ethylene introduction is always in a semibatch model since the polymerization is carried out under a constant pressure of ethylene in the reactor headspace.) The results are compared, drawing the conclusion that miniemulsion copolymerization has an advantage over conventional emulsion polymerization for monomers with very low water solubility (including gaseous monomers) due to their nucleation in monomer droplets without transport through the aqueous phase.
