Photoemission studies of clean and oxygen-covered Pt 6(111) × (100)

Employing the enhanced sensitivity obtained by using synchrotron radiation near the Cooper minimum for the 5d valence electrons, we have located the oxygen 2p and 2s levels for oxygen chemisorbed on a Pt 6(111) × (100) crystal. We find the oxygen 2p level located ?6 eV with a FWHM of 3 eV and the 2s at ?21.6 eV. A factor of four difference in saturation coverage is measured between temperatures of 300 and 120 K, but the position and width of the 2p level is independent of temperature. We observe also the 1b₁ orbital of weakly adsorbed H₂O molecules, which has pure O 2p parentage; from the intensity of this orbital, we are able to suggest why it is difficult to observe the oxygen 2p signal at low photon energies. In addition, we note a strong preferential attenuation in the Pt states near E_f for the adsorbed H₂O in spite of the weak nature of the bond.     

Adsorption and desorption of hydrogen on bare and Xe-covered Cu(111)

Using polarization-modulated ellipsometry to monitor adsorbate coverage in-situ, we studied the activated adsorption of filament-heated molecular hydrogen on Cu(111) and subsequent isothermal desorption of hydrogen adatoms. The adsorption is characterized by a zeroth-order kinetic with a constant sticking probability of S₀=0.0062 up to θ=0.25, followed by a Langmuir kinetic until the saturation coverage θ_s=0.5 is reached. The desorption follows a second-order kinetic with an activation energy of 0.63 eV and a pre-exponential factor of 1×10⁹ /s. A pre-adsorbed monolayer of Xe atoms on Cu(111), with a desorption activation energy of 0.25 eV and a pre-exponential factor of 8×10¹⁴ /s, efficiently blocks the subsequent adsorption of hot molecular hydrogen, making physisorbedXe useful as templates for spatial patterning of hydrogen adatom density on Cu(111). PACS 68.43.Jk; 78.68.+m; 81.15.-z; 82.40.Np     

Small rafts of xenon physisorbed on Pt(111)

The behavior of small rafts of xenon (<50 particles) is illustrated. Events which involve collective motion of raft atoms are shown to occur. These events are persistent below a transition temperature and are not persistent above this temperature. A video of the events is available.     

Electronic transitions of Ar,Xe, N2, CO physisorbed on Ag(111) and Al(111)

High Resolution Electron Energy Loss Spectroscopy has been extended to study also the excitonic (low lying electronic) transitions of physisorbed rare gas atoms (Ar, Xe) and diatomic molecules (N₂, CO) on Ag(111) and Al(111) surfaces at ～20K. Electron Loss Spectra were performed using a pair of hemispherical analyzers mounted at a fixed scattering angle (90°). This spectrometer allowed high transmission in the range of 0–15eV loss energies and incident beam energies up to 2OeV. AES, LEED and UV Photoemission (HeI) were also used in situ to characterize these surfaces and to identify the adsorbed gases and delineate their absolute coverage regimes.In contrast to optical absorption experiments, we observe both, optical (dipole) forbidden and allowed electronic transitions which show vibrational line structure for condensed multilayers. By comparison to gas phase data we find only weak perturbations in the condensed state. The observed electronic excitations show changes in intensity and FWHM depending on the coverage of the adsorbed gases.The FWHM of the electronic excitations of CO and N₂ adsorbed in the monolayer regime is larger than in multilayers. Nitrogen, on both surfaces exhibits an increase from 60meV to 120meV (FWHM) whereas for CO the vibronic features are broadened out leaving peaks with FWHM of ～1eV.The intensities of the electronic losses for all gases are smaller in the first monolayer than in the second or in multilayers. At submonolayer coverage the loss intensifies due to electronic excitations are strongly reduced and no longer observable although vibrational bands and photoelectron spectra show the presence of physisorbed adsorbates.Our results will be compared to optical absorption experiments (ref.1) on similar systems and to atom-on-jellium calculations (ref.2).     

Superficial migration of tritium physisorbed on monocrystalline nickel (111)

The aim of this study is the measurement of superficial migration coefficient of tritium physisorbed on monocrystalline nickel without chemisorbed sublayer. The chosen crystalline orientation was (111) because it offers the greatest concentration of adsorption sites per square centimeter. A clean surface sample is obtained by mechanical polishing, chemical etching and finally ionic bombardment by high purity argon gas. The pressure in the experimental vessel is maintained below 10^?9 torr, by liquid helium cryopumping after zeolite sorption pumping.A little spot of adsorbed tritium is produced by introduction of a finite amount of tritium gas on the clean surface of the nickel sample through a stainless steel tube. Temperatures of nickel and of the gas introduction tube are respectively regulated at 5 K and 35 K. Tritium is used as a radioactive marker and its 10 keV β-radiation is measured by a channeltron type detector which permits the localization of the deposit without acting on the surface. We observed that tritium sorbed at 5 K is quite immobile (at the time scale of our experiment). After heating up to a fixed temperature T chosen between 10 K and 20 K, the deposite profile variation in function of time is observed to determine the superficial diffusion coefficient D. For the values of T from 13 K to 20 K, D varies from 10×10^?6 to 150×10^?6 cm² sec^?1. A diffusion activation energy of 200 cal mole^?1 is deduced from the exponential increase of the curve. A vibrational frequency can be evaluated to 3×10¹² sec^?1. The rate of desorption permits the evaluation of sorption energy at about 1800 cal mole^?1 in good agreement with usual results concerning physorption of H₂ on metals.     

用角分辨光电子能谱研究Co/Cu(111)外延超薄膜的电子结构

利用同步辐射角分辨光电子能谱研究了分子束外延生长的Co/Cu(111)超薄膜电子结构的变化.Cu(111)的位于表面布里渊区Γ点的表面态在覆盖度为两单层时仍然可以分辨,说明薄膜生长模式不是二维层状生长.在一单层和二单层时,动量沿Cu体布里渊区ΓΛL方向变化,Co的最明显的峰包有能量色散.在覆盖度从一单层到两单层的变化过程中,固定光子能量测谱发现Co的能带的能量调整.实验测得的Co膜的电子结构与已有理论计算的结果对比,初步确定Co原子在生长初期阶段为两层岛生长,而且在一单层时已经具有铁磁性.     

Photoemission from Co on Pt(111) using synchrotron radiation in the range 40 eV ω 150 eV

Photoelectron spectra for CO adsorbed on the (111)-face of Pt have been measured using synchrotron radiation of energy 40 eV ω 150 eV. A dramatic increase of the molecular orbital (MO) intensity relative to the intensity of the Pt 5d valence band (VB) is observed for ω > 100 eV, to a ratio at that is a factor of three higher than at . The energy variation of the Pt 5d VB photoemission peak intensity has been derived independently in the 40–200 eV range from measurements on clean Pt. The 5d peak intensity is found to decrease steeply (by more than an order of magnitude) between 100 and 150 eV. The observed increase of the MO peak intensity relative to that of the 5d VB is attributed to this cross-section effect. The Pt VB peak nearest the Fermi energy which is mainly t_2g in character, is found to decrease in intensity on adsorption of CO. In the present case synchrotron radiation in the ω > 100 eV range appears to be especially valuable for studies of adsorbates.     

Photoemission studies of the alkali-covered Ge (111) surface

Photoelectron energy distribution measurements have been used to monitor changes in the surface potential of the Ge(111) surface as a function of cesium and sodium coverage. The specimen was sputter-cleaned, intrinsic (45 ohm-cm) germanium. It was found that the surface was p-type throughout the entire stable coverage range. In the case of cesium deposition, strong evidence of emission from occupied surface states was observed for coverages less than 0.15 monolayer. Exposure of the cesium-covered specimen to oxygen caused the surface to become less p-type. Structure in the surface potential versus coverage curve for sodium correlates with structure in the work function versus coverage curve and with a surface reconstruction observed by LEED.     

The adsorption of N2: Chemisorbed on Ni(110) and physisorbed on Pd(111)

The bonding of molecular N₂ has been investigated with angle resolved photoelectron spectroscopy and inelastic electron scattering. The spectra obtained from N₂ chemisorbed onto a Ni(110) surface are compared to CO chemisorbed onto Ni(110) and to N₂ physisorbed onto Pd(111). The N₂ molecular axis was found to be normal to the crystal surface for the chemisorbed state on Ni(110) and random for the physisorbed state on Pd(111). The NN and NiN₂ stretching frequecies indicate that the N₂ molecule is terminally bonded to a single Ni atom on Ni(110). The binding energies of the two outer σ states and one π state of chemisorbed N₂ were measured, indicating that the bonding of N₂ to a metal surface is different than CO. Both σ states drop in energy compared to the π level due to the fact that both of them are involved in the N₂ substrate bond. The symmetry of the gas phase N₂ molecule is reduced upon adsorption. The consequences of this are seen in the dipole active NN vibrational mode, the large intensity of the Ni-N₂ vibrational mode and the coupling of the adsorbate 4σ(2σ_u) level to the final state resonance which is forbidden by symmetry in the gas phase. Many electron excitation satellite lines are observed in the valence spectra of both the chemisorbed and physisorbed N₂. The physisorbed satellite lines are nearly identical to those seen in gas phase N₂, while the chemisorbed N₂ spectra has new satellite structure, due to the interaction with the substrate.     

Co desorption and adsorption on Pt(111)

The kinetics of the desorption of CO from a Pt(111) crystal between 419 and 505 K is reported using a Low-Energy Molecular-Beam-Scattering (LEMS) technique with a helium probe beam and a CO dosing beam. The resulting first-order Arrhenius rate constant is $\text{k = 2.7 × 10}{}^{13}\text{exp(?31.1}\text{kcal}\text{mole}\text{· RT) s}{}^{\mathrm{?1}}$. We also report a study of the equilibriumadsorbed CO between 400 and 600 K using LEMS. These results, fitted to a Temkin isotherm model, indicate that the adsorption energy decreases linearly with surface coverage with the average value equal to $\text{31.1 + 1.2}\text{kcal}\text{mole}$ over the coverage range 0 < θ ? 0.5. The average harmonic oscillator frequency of the adsorbed CO molecules is 191 ± 76 cm^?1.     

Photoemission studies of Ar,Kr and Xe adsorbed on Al(111): Dipole moments,polarizabilities and spatial distributions

Submonolayers of rare gases adsorbed on Al(111) have been studied using photoemission techniques. Coverage-dependent core level binding energy shifts and work function changes have been measured; polarizabilities and dipole moments are deduced. Results indicate that adatom spatial distributions for Xe submonolayers adsorbed on Al(111) at 40 K are best described by a random 2-dimensional distribution, and there is negligible charge transfer from the Al substrate onto the Xe adatoms in the photoionization process.     

Photoemission yield spectroscopy of electronic surface states on germanium (111) surfaces

The electronic surface states of cleaved and annealed Ge(111) surfaces have been investigated by photoemission yield spectroscopy and contact potential measurements on a set of differently doped samples. On the 2 × 1 cleaved surface, a surface state band centered about 0.7 eV below the valence band maximum is found. The variations of the work function with the doping level show that an empty surface state band exists above the Fermi level. After annealing at temperatures of the order of 350°C, this surface exhibits a 2 × 8 superstructure. A new surface state band is then found closer to the valence band maximum. This variation of the surface state distribution is correlated to a change in the surface potential. The variation of the electronic characteristics upon oxygen adsorption are also reported and an evaluation of the sticking coefficient is made for both structures.     

LEED intensities from clean and hydrogen covered Ni(100) and Pd(111) surfaces

Hydrogen adsorbs on Ni(100) and Pd(111) surfaces without the formation of additional diffraction spots in the LEED patterns. Measurements of LEED intensities revealed that adsorbed hydrogen layers cause considerable changes even in such cases where displacements of surface atoms (“reconstructive adsorption”) may be excluded. After hydrogen adsorption on Ni(100) the intensities of Bragg beams are uniformly lowered whereas the background intensity increases which is attributed to the formation of a disordered adsorbed layer. With Pd(111) adsorbed hydrogen causes a slight decrease of the background intensity and characteristic modifications of the intensity/voltage curve of the (0,0) beam, suggesting the formation of an ordered 1 × 1 structure. In the latter case energy shifts of the primary Bragg maxima were observed and are interpreted as being caused by an expansion of the layer spacing in the surface region by about 2% owing the partial dissolution of the hydrogen.