烟草中有机氯类农药多残留分析前处理方法对比研究

以烟草中有机氯类农药为研究对象,从检出限、回收率、重复性和色谱图4个方面系统比较了机械振荡萃取法、超声波溶剂萃取法、微波辅助萃取法和加速溶剂萃取法4种常用前处理方法。由于加速溶剂萃取法是在高温高压下进行萃取,在提取出残留农药的同时,也提取出更多的干扰物。机械振荡法、超声波溶剂萃取法和微波辅助萃取法各项结果差别较小,其中机械振荡萃取法回收率和重复性最好,但提取时间较长。考虑溶剂消耗和提取时间等方面的因素,微波辅助萃取是较理想的样品前处理方法。     

Characterization of molecularly imprinted polymers for the extraction of tobacco alkaloids and their metabolites in human urine

Molecularly imprinted polymers (MIPs) are synthetic polymers designed to selectively extract target analytes from complex matrices (including biological matrices). The literature shows that MIPs have a degree of cross-selectivity from analytes within the same class of compounds. A commercially available MIP for tobacco-specific nitrosamines (TSNAs) is designed to be class selective for four TSNA compounds. This study sought to characterize the extent of cross-selectivity of the TSNA MIPs with other tobacco alkaloids. Cross-selectivity and recovery of the SupelMIP™ TSNA SPE cartridges was assessed with N-nitrosonornicotine (NNN), nicotine, cotinine and morphine. Their recoveries were compared with the recoveries of a nonimprinted polymer SPE cartridge, and two traditional SPE cartridges: a Waters mixed-mode cation exchange cartridge and a Waters hydrophilic–lipophilic balance cartridge. NNN and cotinine had the highest recoveries with the MIP cartridge, over 80%, and cotinine samples in urine had >80% recoveries. Nicotine had highly variable recoveries, possibly owing to differing chemical properties from the TSNAs. All three analytes had significantly different recoveries with the MIP cartridges compared with the traditional SPE cartridges. Morphine displayed nonspecific interactions with the MIP cartridges. Utilization of the TSNAs’ cross-selectivity allows for simultaneous extraction and identification of multiple tobacco biomarkers using one extraction technique.     

Comparison of different trapping methods for pressurised hot water extraction

Four trapping methods for pressurised hot water extraction were compared in terms of recovery and selectivity. Also, robustness, repeatability and solvent consumption of the trapping systems were investigated. The trapping methods were collection into solvent following liquid-liquid extraction, solid-phase trapping into Tenax TA (SPE), flat sheet microporous membrane liquid-liquid extraction and hollow fibre microporous membrane liquid-liquid extraction. Polycyclic aromatic hydrocarbons were extracted with these systems from four soil and sediment matrices and the extracts were analysed by GC-MS and size-exclusion chromatography. Clear differences were observed in the selectivity and extraction efficiencies of the trapping systems.     

Optimization of microwave-assisted solvent extraction for volatile organic acids in tobacco and its comparison with conventional extraction methods

In the present study, a new method using microwave-assisted solvent extraction (MASE) technique followed directly GC analysis was developed for the extraction of volatile organic acids (VOAs) in tobacco. The MASE conditions (heating time, volume of extracting solvent and extraction temperature) were optimized by means of an orthogonal array design (OAD) procedure. The results suggested that extractant, temperature and heating time were statistically the most significant factors. The extracts were directly analyzed with capillary GC operating in splitless-injection mode on an Agilent HP-FFAP capillary column. Under optimum operating conditions, MASE showed significantly better recoveries than those obtained by the conventional extraction method (ultrasonic and reflux extraction), ranging from 90.6% to 103.2%. In addition, a drastic reduction of the extraction time (20 min versus 4 h) and solvent consumption (20 mL versus 100 mL) was achieved with an outstanding reproducibility (CV ≤5%).     

Comparison of extraction methods for volatile compounds of Muscat grape juice

Typical flavour of Muscat d’Alexandrie wines is mainly due to volatile compounds coming from grapes of this variety. Therefore, the choice of grapes is crucial to obtain musts with a great aromatic potential, which will contribute to the final aroma of wines derived from those musts. In this study, three sampling techniques, liquid-liquid extraction (LLE), solid phase extraction (SPE) and simultaneous distillation-extraction (SDE), were compared for the analysis of volatile compounds in Muscat grape juice. Results showed that although the three techniques can be recommended for the quantitative analysis of volatile compounds from musts, LLE and SPE are better sample preparation techniques than SDE, mainly for determination of polar compounds such as acids or alcohols.     

Comparison of two methods for the extraction of fat from human milk

We compared two methods for the extraction of fat from human milk. Pure fat extraction techniques are necessary for qualitative and quantitative analysis of milk fat, of which triglycerides account for more than 98%. Method I was a conventional liquid-liquid system for the fat extraction while method II was a faster approach using a haematocrit technique. No significant differences were observed between both methods neither in the fat content determined gravimetrically, nor in qualitative and quantitative analysis of triglycerides by high-performance liquid chromatography (HPLC) with evaporative light-scattering detection (ELSD). We conclude that method II offers substantial advantages over the conventional method (method I). The former requires less reagents and material and is simpler and less time-consuming (approximately 30 min instead of 90 min). Therefore, a new method will make it possible to extract fat of more human milk in the same time.     

Comparison of four extraction methods for the analysis of pharmaceuticals in wastewater

As one category of the most urgent emerging pollutants, pharmaceuticals have provoked much public and scientific attention due to widespread contamination in aquatic environment. In this study, two active methods by Oasis HLB and MCX and two passive methods by XAD-16 and XAD-16/7 were evaluated for determining the concentrations of 10 pharmaceuticals (carbamazepine, clofibric acid, diclofenac, gemfibrozil, ibuprofen, ketoprofen, naproxen, paracetomol, terbutaline and triclosan) in reclaimed wastewater. Recoveries of the target pharmaceuticals extracted by MCX were higher than HLB except for diclofenac and ketoprofen. For the passive methods, the addition of polar resin XAD-7 improved the recovery compared with the addition of XAD-16 only. The mean recoveries of the target analytes by XAD-16/7 ranged from 22 to 75.8%. The limit of quantification (LOQ) ranged between 25 and 280 ng/L. In addition, by comparing the accuracy and precision of XAD-16/7 method and MCX method, we further demonstrated that the XAD-16/7 method can be satisfactorily used for the analysis of pharmaceuticals in wastewater samples. We applied the method to some wastewater samples from sewage treatment plant (STP) nearby Riverside, CA to track the concentration change of pharmaceuticals in the treatment processes. The result shown that pharmaceuticals were effective reduced in STP mostly by activated sludge.     

烟用香精中风味成分的提取条件的优化与测定

分别采用溶剂萃取、同时蒸馏萃取、固相微萃取和水蒸汽蒸馏等4种方法提取烟用香精B3样品中的挥发性和半挥发性风味成分,并采用信息量和重现性两个指标考察最优提取方案。正己烷溶剂萃取法具有相对较高的信息量和理想的重现性。通过GC和GC-MS进行定性定量分析,共鉴定了34种成分,定性了的成分占总成分的85．4％。     

Comparison of different extraction methods: steam distillation, simultaneous distillation and extraction and headspace co-distillation, used for the analysis of the volatile components in aged flue-cured tobacco leaves

Steam distillation (SD), simultaneous distillation and extraction (SDE) and headspace co-distillation (HCD) were compared here for their effectiveness in the extraction of volatile compounds from tobacco. The different grades of aged flue-cured tobacco leaves extracted by the three methods respectively were analyzed using GC-MS. Mass spectra or authentic compounds were used to identify around 408 components in various volatile fractions. On the one hand, the qualitative comparison showed that more compounds were detected in HCD extract (391 components) than in SDE extract (377 components), and the approximately quantitative analysis showed that the total amount of volatile components in SDE extract (445.48 microg/g) was much more than that in HCD extract (315.72 microg/g). But on the other hand, HCD was the most efficient for nearly all the highly volatile compounds among the three methods. As to low-volatile compounds such as lactones, long chain aldehydes, ketones, alcohols, and esters, more was detected in SDE extract than in HCD extract. The SD method (322 components, total amount 228.42 microg/g) was the lowest sensitive to all compounds except semi-volatile fatty acids among the three methods.     

Comparison of different extraction and detection methods for sugars using amino-bonded phase HPLC

In this study, different methods are compared in order to quantitate individual sugars extracted from apple samples using methanol and water. Glucose, fructose, and sucrose are separated in 20 min using an amino-bonded carbohydrate column and a 75:25 acetonitrile-water mobile phase, followed by UV (190 nm) and refractive index detection. Variations in the sugar profiles are observed using different extraction or detection methods (or both) at a 1.4-mL/min flow rate. The data obtained show differences (p < 0.01) from both extraction or detection methods. The highest contents of free sugars studied occur in samples extracted with water.     

Comparison of different methods of extraction for the determination of polychlorinated dibenzo-p-dioxins in soil

Summary The application of five different extraction methods including the extraction with liquid and supercritical carbon dioxide were tested on various soil samples with regard to their extraction efficiency. The carbon dioxide liquid extraction has proven to be not suitable for these applications.

---

Vergleich verschiedener Extraktionsverfahren zur Bestimmung von polychlorierten Dibenzo-p-dioxinen in Böden

     

Comparison of different extraction methods for the determination of polycyclic aromatic hydrocarbons in soil

Two different extraction methods for the determination of polycyclic aromatic hydrocarbons in soil are compared: the extraction in combination with ultrasonic treatment, and the Soxhlet extraction method according to DIN-draft 38414 Part 21. Different types of real soil were extracted and analysed by HPLC with diode-array detector and fluorescence detection. The results show that the efficiency of the ultrasonic method is comparable to the Soxhlet method.     

Update on analytical methods for toxic pyrrolizidine alkaloids

Methods for the determination of toxic pyrrolizidine alkaloids in plants and foods are described with emphasis on the important aspects of sample extraction and clean-up and the now preferred determination by liquid chromatography–mass spectrometry. The efficiencies of different extraction solvents and methods are described, as are the methods of reduction of N-oxides. Appropriate liquid chromatography–mass spectrometry conditions are tabulated. This concise review is intended to guide analysts towards adopting a more unified and reliable approach to the analysis of these important toxins.     

Comparison of normal and reversed-phase solid phase extraction methods for extraction of beta-blockers from plasma using molecularly imprinted polymers

A molecularly imprinted polymer (MIP) prepared using propranolol as template, methacrylic acid (MA) and ethylene glycol dimethacrylate (EGDMA) was used to develop SPE methods in "reversed-" and normal phase mode for an analogue of propranolol (M47070) with another analogue (M45655) used as an internal standard. The compounds were also extracted in reversed-phase mode onto a non-imprinted polymer. It was necessary to employ a protein precipitation step ahead of MIP-SPE in order to facilitate downstream analysis. High extraction efficiencies and linear calibration ranges were achieved using both reversed-phase (RP) and normal phase (NP) MIP-based methods. Extraction efficiencies were lower on the non-imprinted polymer indicating stronger retention by the MIP. This stronger retention was attributed to selective imprint-based binding by the MIP that was not available for the non-imprinted polymer. Although clean extracts were obtained in both RP and NP modes, low level interference from template-related impurities or degradation products compromised detection of M47070 at low concentrations for the MIP-based methods. This interference made accuracy of the MIP-based methods poorer at low concentrations. The reversed-phase method showed marginally better accuracy and precision than the normal phase method.     

Comparison of extraction and derivatization methods for fatty acid analysis in solid environmental matrixes

This study involved comparison of different extraction and derivatization methods for determining FAs in soil and in four highly organic matrixes (cattle manure, pig slurry, compost, and vermicompost), by application of a multifactor categorical design. Although some studies have been carried out regarding the application of FA analysis to highly organic matrixes, comparison and verification are still required to test which methods of extraction and derivatization of FAs function best for these matrixes. We compared three extraction methods (one in which the same extraction mixture as used in the Folch method was employed, a modification of the Bligh and Dyer method, and a microwave-assisted extraction) and two derivatization procedures (alkaline methanolysis and derivatization with trimethylsulfonium hydroxide (TMSH)). The highest yields of FAs belonging to different structural classes, and of individual FAs used as microbial biomarkers were obtained by application of the same extraction mixture as in the Folch method and use of TMSH as derivatization agent. These methods also involved a significant reduction in the complexity and time involved in sample preparation.