给超细金纳米粒子做“外科手术”

正近年来在纳米科学研究中,金属纳米团簇(metal nanoclusters,超细的金属纳米粒子,尺寸约1-3 nm)这一领域逐渐兴起并引起了研究者们的广泛关注~(1,2)。与尺寸更大且多分散的纳米粒子相比,纳米团簇取得了原子尺度上的精确,具有确定的分子式和X射线单晶结构~(3,4)。因此,研究纳米团簇使得人们可以从根本上理解一些纳米结构与性能的关系~(1-3),以及跟踪纳米世界里的某些     

"Decoking" of a "coked" zeolite catalyst in a glow discharge

'Decoking' of a 'coked' zeolite catalyst in a glow discharge in oxygen is investigated. The 'decoking' process involves reactions of atomic oxygen (O atoms) with 'coke' and yields gases such as CO, CO₂ as well as other gaseous products that could be easily pumped out.Three different modes of discharge were investigated including a static mode, a flowing-gas mode, and a periodic-purge mode where the oxygen and other gaseous products of the discharge were replaced by fresh O₂ gas after short but regular intervals of time. In some cases, additional heating was also used to provide base temperatures of the order of 100 °C to facilitate penetration of oxygen atoms into the inner layers and cages of the zeolite catalyst.This paper presents some results of spectroscopic analytical techniques used to monitor the atomization of oxygen, oxidation of 'coke', and to confirm the process of 'decoking'. More specifically, radiation emission on the 3 s ⁵S– 3p ⁵P transitions of O around 777.2–777.5 nm were selected for monitoring the atomization of O₂. On the other hand, X-ray photo-electron spectroscopy (XPS) was used to determine the amount of residual carbon and extent of 'decoking'. Furthermore, evolution of CO and CO₂ gases as a function of time was systematically monitored in real time. For CO, the 451.1 nm band head belonging to the B¹ - A¹ bands of the Angstrom system of the CO spectrum was used, while for CO₂, the band head at 353.4 nm belonging to the CO₂⁺ spectrum was used. The rates of evolution of CO and CO₂ were related to the rate of 'decoking' of the catalyst. It is noted that in the periodic-purge mode, about 63% of the total yield of CO from a given sample of the catalyst appears in the first 3-min exposure to discharge whereas it takes up to 15 min to remove nearly 94% of the removable carbon under our experimental conditions.     

Investigation of "on water" conditions using a biphasic fluidic platform

Converting the DEAD: A fluidic approach to generate precisely defined water-oil interfaces was used to quantify the influence of the water surface (blue drops) on chemical reactions between quadricyclane or β-pinene and diethyl azodicarboxylate (DEAD). This method allows for easy investigation of the "on water" effect.     

Preface to a special issue centered on "ligand receptor interactions"

Starting with this issue, the Chemical Record will publish one or two special issues annually centered on special topics. As chemistry becomes increasingly interdisciplinary, bioorganic studies dealing with bioactive ligands necessarily result in accounting for their mode of action or more molecular biological aspects. The articles in this issue are from leading research groups addressing the dynamic aspects of bioactive compounds. Such studies, central in advancing our understanding of Nature, would not have been possible until recent years.     

Site-controlled application of electric potential on a conducting polymer "canvas"

A novel patterning method for conducting polymer films was successfully demonstrated using the concept of bipolar electrochemistry. The local application of an anodic potential to poly(3-methylthiophene) (PMT) and poly(3,4-ethylenedioxythiophene) (PEDOT) on a bipolar electrode (BPE) realized local electrochemical doping and reaction depending on the supporting salt used. The potential applied on the BPE was measured and corresponded well to the patterns. The array-type driving electrode system was able to draw complex patterns in a site-controlled manner.     

Self-induced "electroclick" immobilization of a copper complex onto self-assembled monolayers on a gold electrode

We report the self-induced "electroclick" immobilization of the [Cu(II)(6-ethynyl-TMPA)(H(2)O)](2+) complex, by its simple electro-reduction, onto a mixed azidoundodecane-/decane-thiol modified gold electrode. The redox response of the grafted [Cu(II/I)(TMPA)] at the modified electrode is fully reversible indicating no Cu coordination change and a fast electron transfer.     

Oxygen is electroreduced to water on a "wired" enzyme electrode at a lesser overpotential than on platinum

The first enzyme-based catalyst that is superior to platinum in the four-electron electroreduction of oxygen to water is reported. The smooth Pt cathode reached half and 90% of the mass transport-limited current density at respective overpotentials of -0.4 and -0.58 V in 0.5 M sulfuric acid, and only at even higher overpotentials in pH 7.2 phosphate buffer. In contrast, the smooth "wired" bilirubin oxidase cathode reached half and 90% of the mass transport-limited current density at respective overpotentials as low as -0.2 and -0.25 V. The mass transport-limited current density for the smooth "wired" enzyme cathode in PBS was twice that with smooth Pt in 0.5 M sulfuric acid. Under 1 atm O2 pressure, O2 was electroreduced to water on a polished carbon cathode, coated with the "wired" BOD film, in pH 7.2 saline buffer (PBS) at an overpotential of -0.31 V at a current density of 9.5 mA cm-2. At the same overpotential, the current density of the polished platinum cathode in 0.5 M H2SO4 was 16-fold lower, only 0.6 mA cm-2.     

化学原理精品课程建设探索与教学实践

化学基础课程新体系在南京大学已经试行近10年,化学原理是该体系中的第一门课程。本文简要介绍了化学原理精品课程的建设背景、课程目标、教学团队、教学资源建设与现代教育技术的运用,并对教学实践中的若干问题进行了总结和思考。     

Biofunctionalization of a "clickable" organic layer photochemically grafted on titanium substrates

We have developed a general method combining photochemical grafting and copper-catalyzed click chemistry for biofunctionalization of titanium substrates. The UV-activated grafting of an α,ω-alkenyne onto TiO(2)/Ti substrates provided a "clickable" thin film platform. The selective attachment of the vinyl end of the molecule to the surface was achieved by masking the alkynyl end with a trimethylgermanyl (TMG) protecting group. Subsequently, various oligo(ethylene glycol) (OEG) derivatives terminated with an azido group were attached to the TMG-alkynyl modified titanium surface via a one-pot deprotection/click reaction. The films were characterized by X-ray photoelectron spectroscopy (XPS), contact angle goniometry, ellipsometry, and atomic force microscopy (AFM). We showed that the titanium surface presenting click-immobilized OEG substantially suppressed the nonspecific attachment of protein and cells as compared to the unmodified titanium substrate. Furthermore, glycine-arginine-glycine-aspartate (GRGD), a cell adhesion peptide, was coimmobilized with OEG on the platform. We demonstrated that the resultant GRGD-presenting thin film on Ti substrates can promote the specific adhesion and spreading of AsPC-1 cells.     

Lipase-catalyzed kinetic resolution on solid-phase via a "capture and release" strategy

The lipase-catalyzed kinetic resolution of (R/S)-3-phenylbutyric acid 2 using solid-supported cyclohexane-1,3-dione (CHD) 6 is described. In each case the predominant enantiomer observed, after cleavage from the resin, was (R)-(-)-3-phenylbutyric acid (R)-2 (ee > 99%) rather than the expected (S)-enantiomer of 2. This observation is in contrast to the fact that Chromobacterium viscosum lipase shows high enantiospecificity for the (S)-enantiomer in the corresponding solution-phase hydrolysis reactions. The (R)-acyl group was subsequently released from the resin by NaOH hydrolysis, and the yield of the reaction could be improved by triple acylation of the resin.     

Photoionization dynamics of glycine adsorbed on a silicon cluster: "on-the-fly" simulations

Dynamics of glycine chemisorbed on the surface of a silicon cluster is studied for a process that involves single-photon ionization, followed by recombination with the electron after a selected time delay. The process is studied by "on-the-fly" molecular dynamics simulations, using the semiempirical parametric method number 3 (PM3) potential energy surface. The system is taken to be in the ground state prior to photoionization, and time delays from 5 to 50 fs before the recombination are considered. The time evolution is computed over 10 ps. The main findings are (1) the positive charge after ionization is initially mostly distributed on the silicon cluster. (2) After ionization the major structural changes are on the silicon cluster. These include Si-Si bond breaking and formation and hydrogen transfer between different silicon atoms. (3) The transient ionization event gives rise to dynamical behavior that depends sensitively on the ion state lifetime. Subsequent to 45 fs evolution in the charged state, the glycine molecule starts to rotate on the silicon cluster. Implications of the results to various processes that are induced by transient transition to a charged state are discussed. These include inelastic tunneling in molecular devices, photochemistry on conducting surfaces, and electron-molecule scattering.     

交联型"纳米花"酶用于拟除虫菊酯农药的高效水解研究

该文制备了交联型猪肝酯酶杂化“纳米花”酶（CL－PLE－NFs）,并对其制备条件进行了优化。在最佳条件下,CL－PLE－NFs的酶活为游离酶的231%,最大反应速率（Vmax）是游离酶的134%。同时,将交联型纳米花酶在4 ℃下贮藏320 d后,仍能保留70.85%的活力,表现出良好的贮藏稳定性。此外,将CL－PLE－NFs应用于拟除虫菊酯类农药的水解实验,发现其对Ⅰ型和Ⅱ型的拟除虫菊酯类农药均有较优的水解能力,在5 min内对11种拟除虫菊酯农药的水解率均在55%以上。同时,循环使用12次后,CL－PLE－NFs对溴氰菊酯农药的水解效率仍然可达65.37%。     

"Click-fluors": modular fluorescent saccharide sensors based on a 1,2,3-triazole ring

A carbohydrate sensing "click-fluor" is reported which displays a nontypical binding preference with sample saccharides. That a fluorescent sensor is generated as a result of triazole formation (click reaction), rather than simply bringing the sensor and reporter units together via a triazole linkage, and the potential applicability of the wide range of easily accessible acetylene units means a simple strategy for the development of modular fluorescent sensor arrays for rapid screening of target saccharides will be available.     

"Click" on tubes: a versatile approach towards multimodal functionalization of SWCNTs

Organic functionalization of carbon nanotube sidewalls is a tool of primary importance in material science and nanotechnology, equally from a fundamental and an applicative point of view. Here, an efficient and versatile approach for the organic/organometallic functionalization of single-walled carbon nanotubes (SWCNTs) capable of imparting multimodality to these fundamental nanostructures, is described. Our strategy takes advantage of well-established Cu-mediated acetylene-azide coupling (CuAAC) reactions applied to phenylazido-functionalized SWCNTs for their convenient homo-/heterodecoration with a number of organic/organometallic frameworks, or mixtures thereof, bearing terminal acetylene pendant arms. Phenylazido-decorated SWCNTs were prepared by chemoselective arylation of the CNT sidewalls with diazonium salts under mild conditions, and subsequently used for the copper-mediated cycloaddition protocol in the presence of terminal acetylenes. The latter reaction was performed in one step by using either single acetylene derivatives or equimolar mixtures of terminal alkynes bearing either similar functional groups (masked with orthogonally cleavable protecting groups) or easily distinguishable functionalities (on the basis of complementary analytical/spectroscopic techniques). All materials and intermediates were characterized with respect to their most relevant aspects/properties by TEM microscopy, thermogravimetric analysis coupled with MS analysis of volatiles (TG-MS), elemental analysis, cyclic voltammetry (CV), Raman and UV/Vis spectroscopy. The functional loading and related chemical grafting of both primary amino- and ferrocene-decorated SWCNTs were spectroscopically (UV/Vis, Kaiser test) and electrochemically (CV) determined, respectively.     

Dinitrogen: a selective probe for tri-coordinate Al "defect" sites on alumina

Dinitrogen selectively binds to tri-coordinate Al(III) sites of the (110) termination of γ- and δ-alumina, the "defects" responsible for the low temperature dissociation of methane. Similar observations on η-Al(2)O(3) and extra framework aluminium of microporous aluminosilicates also suggest the presence of Al(III) sites on these materials.     

Simultaneous sample washing and concentration using a "trapping-and-releasing" mechanism of magnetic beads on a microfluidic chip

Simultaneous washing and concentration of functionalized magnetic beads in a complex sample solution were demonstrated by applying a rotational magnetic actuation system to a microfluidic chip under continuous flow conditions. The rotation of periodically arranged small permanent magnets close to the fluidic channel carrying a magnetic bead suspension allows trapping and releasing of the beads along the fluidic channel in a periodical manner. Each trapping and releasing event resembles one washing cycle. A purification efficiency of magnetic beads out of a mixed magnetic and non-magnetic bead sample solution of 83±4% at a flow rate of 0.5 μL min(-1), and a magnetic bead recovery or concentration efficiency of 91±5% were achieved using a flow rate of 0.2 μL min(-1). The detection performance of the device was experimentally evaluated with two different bioassays, using either streptavidin-coated magnetic beads in combination with biotinylated fluorescent isothiocyanate (FITC), or a mouse antigen (Ag)-antibody (Ab) system.     

"Green" pyrotechnics: a chemists' challenge

Fireworks are probably the application of chemistry which resonates best with the general public. However, fireworks and (civil and military) pyrotechnic applications cause environmental pollution and thus have given rise to the development of new, environmentally friendly pyrotechnic compounds and formulations. Nitrogen-rich energetic materials, such as the derivatives of tetrazoles and tetrazines, are about to revolutionize traditional pyrotechnic compositions. This Review summarizes the sources of pollution in current formulations and recent efforts toward "green" pyrotechnics.