Study on the retention behaviour of platinum metal complexes in reversed-phase high-performance liquid chromatography

The separation and determination of Os(IV), Ir(IV), Pt(II), Ru(III), Co(II) and Ni(II) complexes with 2-(6-methyl-2-benzo-thiazolylazo)-5-diethylaminophenol (MBTAE) was studied on RP-HPLC. The effects of methanol concentration, pH-value of the mobile phase, column temperature (T), total flow rate and foreign ions on the retention behaviour have been investigated in detail. It has been shown that the logarithm of the capacity factor (ln k) is in linear relation to the methanol concentration of the mobile phase and the reciprocal of the column temperature (T). The six complexes can be separated within 30 min in a methanol-buffer system.     

Investigation of thermodynamic properties of hyperbranched aliphatic polyesters by inverse gas chromatography

Thermodynamic properties of a series of commercial hyperbranched aliphatic polyesters (Boltorn^® H20, H30 and H40) were examined for the first time by inverse gas chromatography (IGC) using 13 different solvents at infinite dilution as probes. Retention data of probes were utilized for an extensive characterization of polymers, which includes the determination of the Flory–Huggins interaction parameter, the weight fraction activity coefficient as well as the total and partial solubility parameters. Analysis of the results indicated that the total and partial solubility parameters decrease with increase of temperature. Furthermore, upon increase of the molecular weight, while the hydrogen bonding component decreases, no influence on the total solubility parameter is noticed within the experimental error margins. Results from the present study while providing new insight to the thermodynamic characteristics of the examined systems, they are also expected to reflect more general aspects of the behavior of hyperbranched polymers bearing similar end-groups.     

反相液相色谱中溶质保留与溶剂化结构参数间的定量关系

本文研究了等度条件下反相液相色谱中溶质保留与溶剂化结构参数间的定量关系;考察了反相液相色谱保留值变化规律式lnk'=a+cC~b中参数a.c 与溶剂化结构参数间的定量关系,结果表明能较好地预测等度和不同冲洗剂组成下溶质的保留值,将乙腈-水和甲醇-水冲洗剂下的a.c值定量关联,表明在考虑溶质的氢键作用参数后,其相关性有所提高.     

Matrix effect on the retention in reversed-phase liquid chromatography

Summary A polymer-based, reversed-phase column (VA-C18), prepared by grafting octadecyl chain onto vinyl alcohol copolymer gel, was investigated for its chromatographic characteristics. n-Alkanes and n-alkyl alcohols were found to be retained only by hydrophobic interaction between the solutes and the octadecyl chain. In the case of aromatic hydrocarbons, in addition to the hydrophobic interaction, - interaction between the solutes and the based material was elucidated to contribute to the retention. For aromatic tertiary amines which are known to strongly interact with the residual silanol group of the silica-based reversed-phase columns to produce broadened and skewed peakes, the VA-C18 column also retained these substrates strongly by the combination of hydrophobic, -, and ionic interactions. In this case, however, symmetrical peaks were observed. From these results, it was determined that in the case of VA-C18, the base material was found not to produce undesirable effect although the solutes interact with the base. Further conclusion obtained was that in reversed phase liquid chromatography, chromatographic properties of base matrix is highly responsible for the overall retention.     

HPLC of synthetic polymers characterization of polystyrenes by high performance precipitation liquid chromatography (HPPLC)

Summary The advantages and disadvantages of high performance precipitation liquid chromatography have been demonstrated for polystyrene homopolymers. Depending on the mobile phase composition at the dissolution point of the polymeric sample and surface properties of the stationary phase, elution is governed either by a solution process or by adsorption. A contribution by adsorption was noticed on silica as well as on reversed phases based on silica with a normal phase gradient of increasing polarity (heptane to dichloromethane). Elution was solely governed by solubility of the polymers on both types of stationary phase for polystyrenes with a molecular weight above 35 000 and reversed phase gradient of decreasing polarity (methanol to dichloromethane). Under these conditions an identical dependence of elution solvent composition on sample size was found as for turbidity titrations. Due to differences in the velocity of the eluent front and the polymeric sample with porous stationary phases the polymers can be eluted as colloidal solutions Non-porous stationary phases are superior in this respect because the velocities of eluent and solutes are identical.     

The retention of selenium chains in reversed-phase liquid chromatography

Summary Organic polyselenides in which the selenium chains are terminated at both ends by ethyl-thio, butyl-thio, phenylthio, or phenyl groups were prepared. Their chromatographic behavior in HPLC on a bonded octadecyl phase with entirely or mainly methanolic eluents was investigated and compared with the corresponding polysulphides. The retention increment per Se atom is greater than that for S atoms. The ratio of Se to S increments is equal to the ratio of surface area increments. The S−Se bond does not have an appreciable influence on retention. Bonded to phenyl, selenium increases retention to the same extent as sulphur does. Some of the RSSe_nSR solutes were identified by mass spectrometry and other techniques.     

Comparison of selected retention models in reversed-phase liquid chromatography

Retention models are usually compared by how well the model equation fits retention data for one solute taken over a range of mobile phase compositions. Even when retention data for multiple solutes are used, the quality of the fit is often judged by the statistical goodness-of-fit alone. This study compared four different RPLC retention models, encompassing three distinct mathematical forms. Each model was fit to the retention data of multiple solutes and the sets of best-fit parameters were examined in terms of the underlying physico-chemical assumptions of the models. Next, for the linear and quadratic models, some of the model parameters were calculated a priori and the rest of the model parameters were then obtained in subsequent fittings. The sets of best-fit parameters obtained in this manner were more consistent with the underlying assumptions of these models than were the sets of parameters obtained entirely through regressions to the experimental data. Thus, the extraction of parameters by fitting a model to the retention data of a single solute may result in unreliable values for those parameters, even in the case of a fit that would be considered good when judged by conventional statistical criteria. That is, although parameters extracted in such a fashion may be suitable for optimization or similar uses, they may not be suitable for determining the appropriateness of the underlying assumptions of retention models.     

The retention of some azoles in reversed-phase liquid chromatography

The influence of the structure-related physicochemical properties of derivatives of nitrogen-containing heterocyclic compounds on their retention under the conditions of reversed-phase liquid chromatography was studied. The dependence of the chromatographic retention of azole derivatives on the composition of the mobile phase was determined. The presence of azole protonated forms was substantiated by conductometric data.     

Modeling the effect of solvation on solute retention in reversed-phase liquid chromatography

The retention of a homologous series of alkylbenzenes was determined on octyl and octadecyl reversed-phase columns in several polar organic liquids. Free energies of transfer were calculated by the SM5.0R classical solvation model for each organic liquid tested and for several alkanes. The relationships between the measured retention factors and the calculated free energies of transfer were then investigated. Although the natural logarithms of the retention factor and the calculated free energies of transfer were linearly correlated, the obtained free energies of transfer of the solutes did not completely explain the retention behavior of the solutes. Nonetheless, even in these pure organic liquids, the energetics of RPLC retention behaved very similarly to those of partitioning.     

Application of the reversed-phase liquid chromatographic model to describe the retention behaviour of polydisperse macromolecules in gradient and isocratic liquid chromatography

This paper illustrates how conventional models of chromatographic behaviour can be used to predict the separation behaviour of polydisperse macromolecules. Using polystyrene and polymethylmethacrylate homo- and co-polymeric standards, the models were validated by comparing experimental retention behaviour with that predicted by the chromatographic model. The experimental retention time of each of the samples was entered into a spreadsheet application, which calculated the parameters that best described retention (for a given model). When a correlation between the relevant parameters and molecular mass was established, that correlation was used to predict the change in retention behaviour over the molecular-mass range. An expression introduced in a previous paper, to calculate the critical mobile-phase composition of a homopolymer was validated using polystyrene homopolymers. A second expression, which can predict the elution behaviour of copolymers, was also validated. This expression can predict the retention of a copolymer, based solely onthe retention of the homopolymeric units that make up the copolymer.     

Separation of polyesters by gradient reversed-phase high-performance liquid chromatography on a 1.5 microm non-porous column

Efficient separation of polyesters composed of a large number of individual oligomers was achieved on a 1.5 microm "non-porous" octadecylsilyl (ODS) silica support by gradient high-performance reversed-phase liquid chromatography (gRP-HPLC) with a mobile phase of acetonitrile, aqueous trifluoroacetic acid (0.2%) and tetrahydrofuran at ambient temperature and signal monitoring by UV absorption at 280 nm. Substantial signal splitting of oligomers in the low molecular weight (Mr) region is indicative that separation not only occurs with respect to molecular weight distribution (MWD) but also to chemical composition distribution (CCD) and functionality type distribution (FTD). Although separation according to CCD and FTD decreases with increasing number of oligomers, co-elution of species with identical number of repeat units but differing in either structure of repeat units or end-groups can be assumed from the relatively broad signals succeeding the aforementioned peaks showing at least partial resolution. Despite the observation that high Mr oligomers elute as sharp signals, the preceding observations suggest that each of these peaks presumably composes of more than one individual component. The polyester oligomers are eluted in the range of increasing Mr and therefore, either separation according to MWD or CCD/FTD was at least achieved for the low Mr sample constituents. Some principal mechanistic aspects of separation are discussed and adsorption seems to play the dominant role. The detection limit, defined as that sample amount yielding an unequivocal recognition on the base of its characteristic chromatographic fingerprint pattern was about 5,000 ppm for the pair Alftalat 3258 - Alftalat 3352 and 10,000 ppm for the pair Crylcoat 430 - Crylcoat 801.     

Models of retention of adamantylamidrazones in reversed-phase high-performance liquid chromatography

Rules governing the chromatographic behavior of some amidrazones of the adamantane series were studied under the conditions of reversed-phase high-performance liquid chromatography. The characteristics of the retention of sorbates in elution by aqueous-acetonitrile phases with various compositions were calculated. Correlations between the structure and physicochemical characteristics of sorbate molecules and their retention were studied.     

Convergence of retention for small solutes in reversed-phase liquid chromatography

Summary It is shown theoretically that when the concentration of organic solvent in the mobile phase increases, or solute size decreases, log k values of small solutes in reversed-phase liquid chromatography (RPLC) will tend to have a minimum value called the convergence point. A theoretical model for evaluating the convergent coordinates of small solutes is presented by using a stoichiometric displacement model for retention (SMDR). The physical meaning of the coordinates of each kind of convergence are also elucidated. The convergence points have either two-dimensional coordinates with a common ordinate (the logarithm of the phase ratio of the column, log ) or threedimensional corrdinates with two common axes: — log and the logarithm of the molar concentration of the pure displacing agent in mobile phase, log a_D. The other axis relates to the nature of the solutes, such as carbon number of a homolog, van der Waal's surface area, hydrophobic fragment constant etc. for the latter and those and/or concentration axis for the former. The model was tested with published data and found to give a good fit.     

Retention behaviour of polystyrene oligomers in reversed-phase liquid chromatography

Reversed-phase liquid chromatography (RPLC) was employed to investigate the behaviour of low-molecular-mass polystyrene oligomers with three different end groups, n-butyl, sec-butyl, and tert.-butyl polystyrenes. Exothermodynamic retention studies on the polystyrene oligomers were carried out using a C18 stationary phase column and 100% methanol mobile phase over the temperature range 15 to 60 degrees C. The resulting van't Hoff plots were linear over the entire temperature range for all three end group polystyrenes. Enthalpy-entropy compensation (EEC) showed a linear compensation for the higher-order oligomers, but was non-linear for the lower-order oligomers, indicating a change in the mechanism of retention. Differences in the extent of retention for each of the three end groups were also apparent. The ramifications of these differences are discussed.     

Determination of poly(ethylene glycol)s by both normal-phase and reversed-phase modes of high-performance liquid chromatography

A normal-phase HPLC system using an amino column has been developed to characterise oligomers of poly(ethylene glycol)s (PEGs) of average M_r 400 to 2000 with derivatisation by dinitrobenzoate. Normal-phase HPLC with gradient elution using ternary solvents of hexane, dichloromethane and methanol has produced a baseline resolution for oligomers of PEG 400, 600 and 1000, while PEG 1000 and 2000 were analysed by using binary solvents of acetonitrile and water. Mixtures of PEGs have been determined by these HPLC systems. PEG 400 in a textile finish has also been determined with satisfactory recovery. It has been found that the hydroxyl group of solvents in normal-phase HPLC plays an important role in resolution and retention of PEG oligomers. Derivatisation efficiency for PEGs by dinitrobenzoyl chloride and quantitative determination of derivatised PEGs by HPLC have been studied. A reversed-phase (RP) mode of HPLC was examined for determination of PEG 400 oligomers. The normal-phase system provided greater resolution for oligomers of PEGs.     

Reversed phase behaviour of high molar mass polystyrenes in acetonitrile with halogenated methane solvent mixtures

Summary The reversed phase behaviour of high molecular mass polystyrenes was investigated on a C18 bonded phase column using acetonitrile as the polar mobile phase component and dichloromethane, chloroform and carbon tetrachloride, as separate nonpolar components. Solvent solubility compositions, elution compositions and resolutions of the various molar mass polystyrenes were measured and compared for each of the three mobile phases. Anomalous behaviour of the polystyrenes was not observed in any of the three mobile phases and only minor differences in resolution were observed. By comparing these results with previously published work, it is suggested that any mobile phase component that is both nonpolar and a good solvent for the polymer can be combined with acetonitrile for effective separations of polystyrenes by mass and that it is the poor solvent component of the mobile phase that is responsible for the anomalous behaviour that is sometimes observed in this type of chromatography.