Predicting the Deformability of Expanded Polystyrene in Short-Term Compression

A regressive model is presented for the relationship between the compressive stress and strain of expanded polystyrene (EPS) on a 0–35% strain range. On the whole, the model agrees well with experimental data. A practical way is suggested for determining the coefficients of the model from the known density of EPS plates and their compressive stress at a 10% strain. The model allows one to predict the critical compressive stress and the elastic modulus of EPS.__________Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 157–162, March–April, 2005.     

Polyethylene deformation under proportional and sequential tension and torsion

Experiments were conducted to determine the components of the elasticity tensor of higher orders within a 10–60°C temperature range. It was determined that the characteristics of the material obtained by simple stress fail to describe the deformation process under complex stress.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 3, pp. 399–403, May–June 1970.     

Evaluating the effectiveness of structural stress concentrators on the surface of polymethylmethacrylate glasses produced by an equivalent mechanical stress raiser

The possibility of determining the parameters of a notch-type mechanical stress raiser which is equal in effectiveness to structural stress concentrators on the surface of flat glasses is indicated.Lenin Young Communist's League Institute of Civil Aviation Engineers, Riga. Translated from Mekhanika Polimerov, No. 1, pp. 181–182, January–February, 1972.     

Experimental investigation of the impact strength of Caprolon in linear and plane stress

An apparatus for investigating the impact strength of materials in plane stress is described. The results of testing Caprolon in plane stress and linear tension over a broad range of strain rates are presented.Leningrad Kalinin Polytechnic Institute. Translated from Mekhanika Polimerov, No. 2, pp. 332–334, March–April, 1971.     

Statistical interpretation of the temperature and stress shift factors

Expressions for the temperature and stress shift factors are derived on the basis of a statistical-probability treatment of the segmental motion of the macromolecules using the theory of energy level transitions. It is shown that in the general case the temperature shift factor should depend on stress, and the stress shift factor on temperature.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 3, pp. 528–531, May–June, 1976.     

Experimental investigation of the propagation of longitudinal stress waves in optically active polymeric rods

A photoelastic technique has been used to investigate the propagation of longitudinal stress waves in free rods. The experiments have made it possible to establish the mechanism of stress wave formation under impulsive loading, explore the dynamic state of stress of the rod, and estimate the effect of the inelastic resistance of the material.B. E. Vedeneev All-Union Scientific-Research Institute of Hydroengineering, Leningrad. Translated from Mekhanika Polimerov, No. 1, pp. 68–75, January–February, 1970.     

Effect of supermolecular structure on the relaxation properties of polyformaldehyde in tension and compression

An experimental investigation of the stress relaxation at various strain values in polyformaldehyde blocks has revealed two regions with different stress relaxation mechanisms. The effect of the supermolecular structure on each of these regions is discussed.Scientific Research Institute of Plastics, Moscow. Translated from Mekhanika Polimerov, No. 5, pp. 787–792, September–October, 1969.     

Analogues of the Kolosov–Muskhelishvili General Representation Formulas and Cauchy–Riemann Conditions in the Theory of Elastic Mixtures

Analogues of the well-known Kolosov–Muskhelishvili formulas of general representations are obtained for nonhomogeneous equations of statics in the case of the theory of elastic mixtures. It is shown that in this theory the displacement and stress vector components, as well as the stress tensor components, are represented through four arbitrary analytic functions.The usual Cauchy–Riemann conditions are generalized for homogeneous equations of statics in the theory of elastic mixtures.     

Volume strains of polymers under short-time loading

The effect of the magnitude of the stress, the type of stress, and the previous loading history on the nonlinear deformation characteristics, the lateral strain coefficient, and the volume strains of two crystalline polymers has been investigated.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 5, pp. 828–833, September–October, 1974.     

Methods of exploiting natural internal stresses to strengthen composites

A method of strengthening nonuniformly reinforced composites is proposed. A rational scheme for coordinating the external stress field, the resistance field, and the internal stress field is examined in relation to the case when the internal stresses are caused by shrinkage of the resin.Ural Kirov Polytechnic Institute, Sverdlovsk. Translated from Mekhanika Polimerov, No. 5, pp. 870–875, September–October, 1970.     

State of stress and strain of plates with two equal openings in the presence of high-elastic deformation

The apparatus of the nonlinear theory of elasticity [1–3] is used to investigate the high-elastic deformation of a plate with two equal circular openings and a massive block with two cylindrical channels. Computer-calculated stress concentration factors are given for compressible and incompressible materials.Translated from Mekhanika Polimerov, No. 4, pp. 687–692, July–August, 1969.     

On the construction of a variant of the theory of fracture

A theory of long-time strength that takes into account the accumulation of damage in the material in different directions is used as a basis for obtaining isochronous fatigue strength curves in stress space for complex states of stress.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 4, pp. 648–653, July–August, 1970.     

Creep of polymer materials under periodically varying loads

A method is proposed for constructing the creep curves of a material whose nonlinear memory properties are described by Rozovskii's nonlinear integral equation [2] (with allowance for the stress dependence of the relaxation time) under given periodic loading from known creep curves recorded at constant stress. In deriving the theoretical relation certain simplifying assumptions are made (the creep strain accumulated in 1–2 cycles is small, no vibration [4–6]). An experimental check shows that the proposed method can be used to predict the behavior of a material under periodic loading with an accuracy sufficient for practical purposes.Mekhanika Polimerov, Vol. 2, No. 3, pp. 330–336, 1966     

Strength of glass laminates at low temperatures and high strain rates

The tensile strengths of glass laminates of various compositions under standard, high-speed and impact loading have been experimentally investigated in relation to the effect of low-temperature and stress raisers. As the loading rate increases (from 0.7 to 253 · 10³ kgf/cm². · sec) and the temperature falls to –196° C, the effective stress concentration coefficient decreases, which indicates that the glass laminates will perform adequately under these conditions.All-Union Scientific-Research Institute of Aviation Materials, Moscow. Translated from Mekhanika Polimerov, No. 5, pp. 836–841, September–October, 1970.     

Questions relating to the design of multilayer glass-reinforced-plastic systems in compression

The stability and states of stress and strain of five-layer orthogonally reinforced and unidirectional systems loaded in compression are investigated. The calculations are based on the system of differential-difference equilibrium equations for a multilayer composite in a complex state of stress [1, 2].All-Union Scientific-Research Institute of Glass-Reinforced Plastics and Glass Fiber, Moscow Region. Translated from Mekhanika Polimerov, No. 6, pp. 1019–1028, November–December, 1973.     

Stresses in a hollow rotating cylindrically orthotropic tube

Explicit stress distributions for a hollow cylindrically orthotropic tube due to spinning are presented for immediate use in everyday engineering work. The solutions are obtained directly without using the stress function concept. Various boundary condition combinations present in practical applications are considered. Examples are given in order to indicate how the degree of anisotropy influences the stress distributions.Department of Mechanical Engineering, University of Oulu, P.O. Box 444, 90571 Oulu, Finland. Published in Mekhanika Kompozitnykh Materialov, Vol. 32, No. 6, pp 835–841, November–December, 1996.     

Analysis of the state of stress of massive multichannel high-pressure chambers

The state of stress of multichannel high-pressure chambers made of polymeric materials with low rigidity is analyzed using the apparatus of the nonlinear theory of elasticity [1, 2].Translated from Mekhanika Polimerov, No. 4, pp. 732–733, July–August, 1969.     

Automated system for investigating the short-time stress relaxation of viscoelastic materials

An automated system for investigating the short-time stress relaxation in viscoelastic materials, in which the testing apparatus is computer-controlled, is described. The system makes it possible to perform two-component testing of tubular specimens in simple and complex states of stress under simple and combined tensile and torsional loading.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 1, pp. 149–153, January–February, 1976.     

Deformation of teflon in linear and plane states of stress

Teflon specimens have been deformed in accordance with various laws of variation of stress and strain with time under plane stress conditions. Fairly simple expressions describing the relation between the stresses and large (up to 60% relative to the initial dimensions) strains are constructed for a broad class of loading regimes.Scientific-Research Institute of Mathematics and Mechanics, A. A. Zhdanov Leningrad State University. Translated from Mekhanika Polimerov, Vol. 4, No. 4, pp. 742–746, July–August.     

The vibration-time analogy

The vibrocreep of low-density polyethylene has been investigated in nonisothermal deformation regimes on the frequency range 150–400 Hz at variable stress amplitudes from 3.1 to 5.8 kgf/cm². The validity of the time-vibration superposition principle has been tested.Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, Vol. 4, No. 5, pp. 793–798, September–October, 1968.