Improvements in preconcentration methods for determining trace impurities in ultra-pure gases by gas chromatography

Summary The blanks in preconcentration methods for determining trace amounts of impurities in ultra-pure gases, which include the preconcentration volume of sample gases, carrier gas impurities and atmospheric contamination are discussed and three concentration methods for eliminating blank errors are proposed. These are, the differential volume method by concentrating at the same flow-rate but different times (DVMSF), the differential time method by concentrating the same volumes at different flow-rates (DTMSV) and the differential volume method by concentrating for the same times but different flow-rates (DVMST). DVMST is proposed as the best method for its ability to eliminate all blank errors described. The methods are used to determine trace amounts of Ar+O₂ and N₂ in ultra-pure hydrogen. Calculations demonstrate that the methods can effectively improve analytical accuracy.     

Rapid analysis of hydrocarbons and inert gases by a multidimensional gas chromatograph

A combination of a pressure switching system with multiple columns and photoionization detectors makes possible rapid analysis of a mixture of inorganic gases and hydrocarbons. Hydrocarbons are separated by a narrow bore capillary column. An alumina PLOT column is used for the separation of lower molecular weight hydrocarbons, especially C4 isomers, while a combination of a micro-packed column with Porapak N and a PLOT capillary column with Molecular Sieve 5A is used for the fast separation of inorganic gases. A photoionization detector is a powerful additional tool for organic gas analysis.     

Simultaneous determination of trace amounts of sulphur hexafluoride and cyclic perfluorocarbons in reservoir samples by gas chromatography

Summary Both sulphur hexafluoride and a group of compounds among the perfluorinated cyclic hydrocarbons: perfluorodimethyl cyclobutane, perfluoromethyl cyclopentane, perfluoromethyl cyclohexane and the 1,2- and 1,3-isomers of perfluordimethyl cyclohexane are well known to be good gas tracers, in various applications. Unfortunately different methods have been used for the analysis of SF₆ and the perfluorocarbons. Therefore, in many cases, the analytical costs may have hindered the use of both SF₆ and the perfluorocarbons in the same tracer experiments. The analytical method described in this paper enables the determination of both types of gas tracer in one single run. The new method has already replaced two former methods and was used to run the gas tracer analysis routinely, proving the reliability of the method.     

A continuous preconcentration/extraction method for organic trace analysis by capillary gas chromatography

Summary A slightly modified steam distillation-extraction device is described for the continuous extraction and preconcentration of organic traces in aqueous samples, prior to capillary G.C.-analysis. The quantitative performance, both theoretically and practically, is studied using phenols as the test substances. The final recovery is determined by the flow-ratio of the water and the extracting solvent and by the extraction coefficient. The process is found to be highly reproducible even at low concentration levels (ppb’s). Using 30 ml. samples with a concentration of 30 ppb (1:10^9), 100 % recoveries are obtained for the phenolic substances studied, with a relative standard deviation of about 3 %, both for methylene chloride and ethylacetate as the extracting solvents. Using methylene chloride as the extracting solvent, for phenol a maximum recovery of 80 % was obtained. Presented at the 15th International Symposium on Chromatography, Nürnberg, October 1984     

Dynamic headspace analysis of trace volatile components in polymeric materials by wide bore capillary gas chromatography

A novel dynamic headspace gas chromatographic system equipped with a wide bore capillary column was constructed for direct analysis of less volatile components in polymeric materials such as coating paints. With this system, the determination of typical paint additives such as hindered amine light stabilizers and ultraviolet absorbers could be carried out within a short time.     

Viscosity of gases used as the mobile phase in gas chromatography

The vicosity-temperature relationship of the three gases (helium, nitrogen and hydrogen) most frequenly used as the carrier gas in gas chromatography is studied. Based on available data, equaitions are derived to describe this relationship. Using these equations viscosity data are tabulated for the chromatographically important temperature range.Dedicated to Professor A. Zlatkis on the occasion of his 60th birthday.     

Use of backflushing and peak-cutting technique in gas chromatographic trace analysis

Summary A backflusing, peak-cutting method was developed for the analysis of trace components present in the tail of a major component peak. Using a helium-ionization detector, the minimum detectable concentration (MDC) was: oxygen in hydrogen, 0.5ppm; nitrogen in oxygen or argon, 1ppm; and methane and carbon monoxide in nitrogen, 1ppm. The corresponding MDC values for the conventional single-column method were 7.2ppm, 8.3ppm, and 14 and 5ppm, respectively. Equations used to predict the retention time are given. The accuracy of the predicted retention time is about two percent compared to experimental results.     

Analysis of seven chlorobiphenyl congeners by multidimensional gas chromatography

Chlorobiphenyl congeners (CBs) are used as indicator compounds in analysis performed to determine whether or not PCB concentrations in food products, waste mineral oil, and environmental samples comply with the maximum levels permitted by legislation. Seven of these compounds have been checked for coelution with other CB congeners by means of a multidimensional gas chromatographic method utilizing a combination of two narrow bore columns, one coated with a conventional non-polar stationary phase and the other with a liquid crystalline (smectic) stationary phase. Peaks of the relevant CBs have been transferred, by heart cutting, from the non-polar column to the liquid crystal column, on which unambiguous separation from possible coeluting CB congeners was obtained. It has been shown that if the seven congeners are analyzed solely on a single, non-polar capillary column the results obtained for two of them may be affected by coelution of other compounds.     

Comprehensive two-dimensional gas chromatography: a powerful and versatile analytical tool

Comprehensive two-dimensional gas chromatography (GC×GC) is a novel technique which is rapidly gaining importance for the analysis of complex samples. In the present review, attention is devoted to the principle and advantages, and main characteristics such as modulation, column combinations, detector requirements and data processing, of the technique. Specifically, GC×GC of a variety of real-life samples is discussed to demonstrate the applicability of the technique, with emphasis on the usefulness of the ordered-structure principle and on the analyte-identification power provided by a combination with time-of-flight mass spectrometric detection.     

水中痕量苯酚的微波萃取气相色谱分析

A method of microwave-assisted extraction and gas chromatography for determination of trace phenol in water was established.The conditions of microwave extraction and derivation were optimized.Acetone-cyclohexane(1∶1) mixture was used as extracting agent for water sample containing phenol and acetic anhydride was employed for the direct acetylation of phenol.Petroleum ether was used as the extracting agent to extract the derivative of phenol.Detection was carried out in GC-FID equipped with DB-17(30 m×0.53 ...     

Trace analysis of organics in aqueous samples by concentration in plastic tubing and multiplex gas chromatography

Summary The inside wall of an uncoated polyethylene capillary traps organic substances from a water sample pumped through it by a nitrogen gas stream. Heating the capillary in a chromatographic oven slowly releases the trapped organic substances from the wall. Nitrogen carrier gas transports sample substances released through a thermal desorption modulator and onto a chromatographic column. Pulsing the temperature of the modulator modulates the concentrations of sample components as they enter the column. Computing the cross correlation of the detector output signal against the applied modulation signal generates the chromatogram. Detection limits below 1 ppb are possible using a flame ionization detector. No sample pretreatment or cold trap is required.     

New uses of thermionic ionization detectors in gas chromatography

Summary A newly designed thermionic detector was operated in two modes of thermionic ionization detection (TID), and a third mode of catalytic flame ionization detection (CFID). Operating modes were varied by changing the composition of the electrically-heated thermionic/catalytic source, and the composition of gases supplied to the detector. A TID-2 source activated by a low concentration of Cs/ceramic was operated in a dilute H₂/air environment and provided specific responses to nitrogen and phosphorus compounds. A TID-1 source activated by a high concentration of Cs/ceramic was operated in a N₂ environment and provided very high specificities and picogram detectivities to compounds containing electronegative functional groups such as the NO₂ group. A CFID source formed from Ni/ceramic was operated in a H₂/air flame environment and provided universal responses to all organics with enhanced responses to some heteroatom compounds.Presented at the 14th International Symposium on Chromatography London, September, 1982     

Cryofocusing in the combination of gas chromatography with equilibrium headspace sampling

Summary When headspace gas chromatography utilizing capillary columns is used for trace analysis, sample enrichment is often needed. This involves splitless sample injection of fairly large gas volumes and relatively long sampling times. As a result of this, the band of the sample vapor may be too large causing peak distortion and poor resolution. This problem can be easily overcome by the use of cryogenic trapping. While this can be accomplished by cooling the whole column to subambient temperature during sample introduction, a more convenient way is to utilize part of the first coil of the capillary column as a cryogenic trap.The paper discusses the theoretical background and instrumentation of cryogenic trapping and demonstrates the possibilities through a number of examples.Enlarged text of a paper presented at the 37th Pittsburgh Conference on Analytical Chemistry and Applied Spectroscopy, Atlantic City, NJ, March 10–14, 1986.     

High resolution gas chromatographic determination of permanent gases with a helium ionization detector

The capability of the helium ionization detector (HID) to operate in connection with capillary columns for trace gas analyses has been evaluated. Two different capillary columns were considered: a PLOT fused silica column with molecular sleve and a thick film WCOT glass column with PS-255. The determination of trace impurities in gases can be achieved with evident advantages over classical adsorption columns, even using a split injection system. Direct on-column injections also have been investigated with promising results.     

Application of copper sulfate pentahydrate as an ammonia removal reagent for the determination of trace impurities in ammonia by gas chromatography

Rapid analysis of trace permanent gas impurities in high purity ammonia gas for the microelectronics industry is described, using a gas chromatograph equipped with a phtoionization detector. Our system incorporates a reactive precolumn in combination with the analytical column to remove the ammonia matrix peak that otherwise would complicate the measurements due to baseline fluctuations and loss of analytes. The performance of 21 precolumn candidate materials was evaluated. Copper sulfate pentahydrate (CuSO₄·5H₂O) was shown to selectively react with ammonia at room temperature and atmospheric column pressures, without affecting the hydrogen, oxygen, nitrogen, methane or carbon monoxide peak areas. To prevent loss of trace carbon dioxide, an additional boron trioxide reactant layer was inserted above the copper sulfate pentahydrate bed in the reactive precolumn. Using the combined materials, calibration curves for carbon dioxide proved to be equivalent in both ammonia and helium matrix gases. These curves were equivalent in both matrix gases. The quantitative performance of the system was also evaluated. Peak repeatabilities, based on eight injections, were in the range of 4.1–8.2% relative standard deviation; and detection limits were 6.9 ppb for H₂, 1.8 ppb for O₂, 1.6 ppb for N₂, 6.4 ppb for CH₄, 13 ppb for CO, and 5.4 ppb for CO₂.     

Monitoring of trace levels of p-dioxan in high purity benzene feedstock by capillary gas chromatography

Summary A procedure has been standarized for the determination of p-dioxan (1,4-dioxan) in benzene feedstock in the range of 1 to 100 ppm by capillary GC. The GC conditions such as oven temperature, length of the column etc were optimized to achieve better resolution of p-dioxan from hydrocarbons. The standard addition method of quantitation, was used to determine the amount of p-dioxan and was found to give better results than those obtained by external standardization. Prior to analysis the identity of the p-dioxan peak was established by GC-MS. The proposed method has been applied for the monitoring of p-dioxan in high purity benzene feedstock produced by the Udex extraction process in the refinery. The data were used for optimization of plant conditions for the production of high purity benzene feedstock. By using this method, the p-dioxan content down to 0.5 ppm can be determined in the benzene feedstock.     

Some applications of multidimensional gas chromatography to the enrichment of minor components in essential oil analysis

The use of multidimensional gas chromatography (MDGC) for the analysis of essential oils is gaining in importance. A rarely used application consists in the enrichment of minor components through a MDGC system provided with a cold trap between trap column and analytical column. Under suitable conditions, in fact, the cold-trap can store a trapped compound (or a fraction) for a long time. Consequently, the same fraction can be heart-cut from several successive chromatographic runs on the first column and stored together in order to accumulate trace compounds; afterwards the accumulated fraction can be injected in the analytical column. The possibilities of this technique will illustrated through some examples of analysis of complex essential oils.