Anchored palladium bipyridyl complex in nanosized MCM-41: a recyclable and efficient catalyst for the Kumada-Corriu reaction

A palladium bipyridyl complex anchored onto nanosized mesoporous silica MCM-41 catalyzed the cross-coupling of aryl iodides or bromides with Grignard reagents to provide the corresponding biaryls in high yields. The reaction proceeded smoothly with an equal molar amount of substrate and Grignard reagent in the presence of 0.2-0.02 mol % of catalyst in THF at 50 °C or under refluxing conditions. The catalyst prepared may be used in a very low percentage, recovered after reaction, and re-used.     

Copper-catalyzed decarboxylative coupling reactions for the synthesis of propargyl amines

When aryl alkynyl carboxylic acids were allowed to react with amines and aldehydes in CH₃CN at 80 °C in the presence of 10 mol % CuI, the desired propargyl amines were formed in good yields. This coupling reaction demonstrated to work across a broad range of reagents including functionalized aryl alkynyl carboxylic acids, aliphatic and aromatic aldehydes, and cyclic and acyclic amines.     

Simple and efficient copper-catalyzed S-arylation of diaryl disulfides with triarylbismuthanes under aerobic conditions

Novel and simple copper-catalyzed C(aryl)-S bond formation of diaryl disulfides with bismuth reagents is described. Reactions of diaryl disulfides with triarylbismuthanes in the presence of CuOAc (10 mol %) and 1,10-phenanthroline (10 mol %) under aerobic conditions led to the formation of unsymmetrical diaryl sulfides in satisfactory yields. The reaction is atom-economic and all three aryl groups of the triarylbismuthanes and both sulfanyl groups of the diaryl disulfides could be transferred to the coupling products.     

Electrophilic amination of diorganozinc reagents by oxaziridines

Electrophilic amination of organozinc reagents by oxaziridines has been studied. Diorganozinc reagents R₂Zn (R = alkyl or aryl) react with N-Boc oxaziridine to afford N-Boc protected primary amines BocNHR in moderate to good yields. No additives are needed in this reaction, which proceeds at 0 °C. We suggest that the presence of two heteroatoms in oxaziridine allows Lewis base activation of the diorganozinc reagent.     

Fluoride-Promoted Ligand Exchange in Diaryliodonium Salts

Diaryliodonium salts are shown to undergo rapid, fluoride-promoted aryl exchange reactions at room temperature in acetonitrile. Aryl exchange is shown to be exquisitely sensitive to the concentration of fluoride ion in solution; fast exchange is observed as the fluoride concentration approaches a stoichiometric amount at 50 mM substrate concentration. The reaction is slowed, but not halted if benzene is the solvent, indicating that free fluoride ion or a four-coordinate anionic I(III) species may be responsible for the exchange. The fluoride-promoted aryl exchange reaction is general and allows direct measurement of the relative stabilities of diaryliodonium salts featuring different aryl substituents. The aryl exchange reaction may be of practical use for the preparation of hitherto inaccessible diaryliodonium salts, thus it also has implications for labeling radiotracers for molecular imaging with ¹⁸F-fluoride (t_1/2 = 109.7 min).     

A one-pot procedure for trifluoroacetylation of arylamines using trifluoroacetic acid as a trifluoroacetylating reagent

A convenient procedure for the preparation of aryl trifluoroacetamides from aryl amines is described that employs 2-4 M equiv of trifluoroacetic acid in refluxing xylene as a trifluoroacetylating agent. Addition of an amount of pyridine that is equimolar to the amount of trifluoroacetic acid present in the reaction mixture facilitates the trifluoroacetylation of rather basic arylamines.     

Preparation of γ-trimethylsilylallyldibutylstannane grafted on solid support: a clean and easily recyclable reagent for the synthesis of 2,6-disubstituted dihydropyrans

The synthesis of the γ-trimethylsilyldibutylallylstannane grafted on an insoluble macroporous polymer is reported. This bimetallic reagent was treated with aldehydes in the presence of indium trichloride to afford in good yields both symmetrical and unsymmetrical cis-2,6-disubstituted dihydropyrans, practically uncontaminated with organotin residues (less than 20 ppm). The potential for regeneration and reuse of this supported bimetallic reagent is pointed out.     

An efficient and mild ortho-zincation of aromatics and heterocycles by using TMP2Mg·2LiCl in the presence of ZnCl2

A variety range of functionalized aryl and heteroaryl zinc reagents were efficiently generated by using TMP₂Mg·2LiCl (TMP = 2,2,6,6-tetramethylpiperamidyl) in the presence of ZnCl₂. The subsequently functionalization gave after reaction with electrophiles the expected polyfunctionalized products in good yields. A detailed study concerned on the point how we found the protocol and how we optimized it was depicted.     

Microwave-assisted palladium-catalyzed allylation of aryl halides with homoallyl alcohols via retro-allylation

The palladium-catalyzed allylation of aryl halides with homoallyl alcohols via retro-allylation proceeds at 200-250 °C in a toluene-DMF mixed solvent using microwave heating. Even at such high temperatures, the regio- and stereospecificity of the allyl transfer reaction is still satisfactory. The amount of the palladium catalyst can be reduced to 0.5 or 0.05 mol %.     

Palladium-catalyzed Mizoroki-Heck reaction of allyl aryl ethers with aryl iodides using phosphine-free hydrazone ligands

Palladium-catalyzed Mizoroki-Heck reaction of allyl aryl ethers with aryl iodides gave aryl cinnamyl ethers using a catalytic amount of Pd(OAc)₂ in DMF at 50 °C with phosphine-free hydrazone as a ligand in good yields.     

Fluorogenic derivatization of aryl halides based on the formation of biphenyl by Suzuki coupling reaction with phenylboronic acid

The fluorogenic derivatization method for aryl halide was developed for the first time. This method was based on the formation of fluorescent biphenyl structure by Suzuki coupling reaction between aryl halides and non-fluorescent phenylboronic acid (PBA). We measured the fluorescence spectra of the products obtained by the reaction of p-substituted aryl bromides (i.e., 4-bromobenzonitrile, 4-bromoanisole, 4-bromobenzoic acid ethyl ester and 4-bromotoluene) with PBA in the presence of palladium (II) acetate as a catalyst. The significant fluorescence at excitation maximum wavelength of 275–290 nm and emission maximum wavelength of 315–350 nm was detected in all the tested aryl bromides. This result demonstrated that non-fluorescent aryl bromides could be converted to the fluorescent biphenyl derivatives by the coupling reaction with non-fluorescent PBA. We tried to determine these aryl bromides by HPLC-fluorescence detection with pre-column derivatization. The aryl bromide derivatives were detected on the chromatogram within 30 min without any interfering peak derived from the reagent blank. The detection limits (S/N = 3) for aryl bromides were 13–157 fmol/injection.     

Gold(I)-catalyzed direct C-H arylation of pyrazine and pyridine with aryl bromides

An efficient procedure for the direct C-H arylation of electron-poor aromatics such as pyrazine and pyridine with aryl bomides is described. In the presence of catalytic amount of Cy₃PAuCl and with the use of t-BuOK as base, pyrazine undergoes the direct C-H arylation with aryl bromides at 100 °C, and the yields of the arylated products depend on the nature of aryl bromides. In the cases of electron-rich aryl bromides used, the arylated pyrazines can be obtained in good to high yields. For electron-poor aryl bromides, the addition of AgBF₄ is the crucial point to accelerate the coupling reaction to give the arylated products in moderate yields. Pyridine also reacts with electron-rich aryl bromides catalyzed by Cy₃PAuCl to give a mixture of arylated regioisomers in moderate yield. However, in order to realize the direct C-H arylation of pyridine with electron-poor aryl bromides, the addition of silver salt as additive and a milder reaction temperature (60 °C) are required.     

[PdCl2{8-(di-tert-butylphosphinooxy)quinoline)}]: a highly efficient catalyst for Suzuki-Miyaura reaction

The complex [PdCl₂(P-N)] containing the basic and sterically demanding 8-(di-tert-butylphosphinooxy)quinoline ligand (P-N) is a highly efficient catalyst for the coupling of phenylboronic acid with aryl bromides or aryl chlorides. The influence of solvent and base has been investigated, the highest rates being observed at 110 °C in toluene with K₂CO₃ as the base. With aryl bromides the reaction rates are almost independent on the electronic properties of the para aryl substituents, on the contrary, reduced reaction rates are observed when bulky substituents are present on the substrate. Nevertheless the coupling of 2-bromo-1,3,5-trimethylbenzene with phenylboronic acid can be carried out to completion in 2 h using a catalyst loading of 0.02 mol %. Under optimized reaction conditions, turnover frequencies as high as 1900 h⁻¹ can be obtained in the coupling of 4-chloroacetophenone with phenylboronic acid; lower reaction rates are obtained with substrates bearing EDG substituents on the aryl group.     

CuO nanoparticles: an efficient and recyclable catalyst for cross-coupling reactions of organic diselenides with aryl boronic acids

We present here an efficient and ligand-free cross-coupling reaction of organic diselenides with aryl boronic acids using a catalytic amount of CuO nanoparticles in DMSO at 100 °C under air atmosphere. This is a general cross-coupling reaction and was performed with organic diselenides and aryl boronic acids bearing electron-withdrawing and electron-donating groups affording the corresponding selenides in good to excellent yields. The CuO nanoparticles can be easily recovered and utilized for further catalytic reactions.     

An atom-efficient palladium-catalyzed cross-coupling reaction of triarylbismuths with acid chlorides: synthesis of diaryl and alkyl aryl ketones

The cross-coupling reaction of triarylbismuths with acid chlorides using a catalytic amount of PdCl₂/PPh₃ afforded the corresponding ketones in high yields. The reactions of aromatic and aliphatic acid chlorides occurred with atom efficiency, as 3 equiv of acid chlorides coupled effectively with 1 equiv of triarylbismuths to yield 3 equiv of the corresponding diaryl and alkyl aryl ketones.     

Palladium catalyzed alkynylation of aryl halides (Sonogashira reaction) in water

The palladium catalyzed alkynylation of aryl halides (Sonogashira reaction) has been achieved in pure water without any additives or phase transfer catalysts. The reaction, which requires only 0.5 mol % of Pd(PPh₃)₄ catalyst, is remarkably fast (30 min at 70 °C) producing high yields of the aryl alkyne products.     

Synthesis of α-trifluoromethylstyrene derivatives via Ni-catalyzed cross-coupling of 2-bromo-3,3,3-trifluoropropene and aryl Grignard reagents

The Ni-catalyzed cross-coupling of 2-bromo-3,3,3-trifluoropropene and aryl Grignard reagents was investigated. When NiCl₂(PPh₃)₂ was used as a catalyst, the highest yield of α-trifluoromethylstyrene (89%) from 2-bromo-3,3,3-trifluoropropene and PhMgBr was obtained in 1,3-dimethyl-2-imidazolidinone at 50 °C for 30 min. Various α-trifluoromethylstyrene derivatives could be produced in satisfactory yields by NiCl₂(PPh₃)₂-catalyzed coupling using aryl Grignard reagents.     

Palladium/copper-catalyzed sila-Sonogashira reactions of aryl iodides with alkynylsilanes via a direct C-Si bond activation

The palladium-catalyzed cross-coupling reactions of aryl iodides with alkynylsilanes in the presence of a substoichiometric amount (50 mol %) of copper(I) chloride as an activator in DMF under strictly non-basic reaction conditions afford the corresponding unsymmetrical diarylethynes in moderate to excellent yields. A wide range of substrates bearing an electron-donating or an electron-withdrawing substituent on the aromatic ring are compatible.     

Polystyrene-supported triphenylarsines: useful ligands in palladium-catalyzed aryl halide homocoupling reactions and a catalyst for alkene epoxidation using hydrogen peroxide

The utility of both soluble (non-cross-linked) and insoluble (cross-linked) polystyrene-supported triphenylarsine reagents were examined. These reagents were prepared by standard radical polymerization methodology and used in palladium-catalyzed homocoupling reactions of aryl halides. The insoluble reagent was also used as a catalyst precursor in heterogeneous alkene epoxidation reactions in which aqueous hydrogen peroxide was the stoichiometric oxidant. For the aryl halide homocoupling reactions, both reagents worked well and afforded similar results. Unhindered aryl iodides afforded the best yields in the shortest reaction times compared to aryl bromides. The epoxidation reactions of unfunctionalized alkenes were not very efficient. This was probably due to the hydrophobicity of the polystyrene matrix, which did not swell in the reaction medium. Thus, since a microporous, gel-type polystyrene matrix was used, the majority of the arsine groups were inaccessible to the reaction components and therefore incapable of participating in catalysis.     

Hiyama reaction of aryl bromides with arylsiloxanes catalyzed by a reusable palladium(II)/cationic bipyridyl system in water

A Pd(NH₃)₂Cl₂/cationic bipyridyl catalytic system catalyzed the cross-coupling reaction of aryl bromides with arylsiloxanes in water under aerobic conditions in the presence of NaOH to afford biaryls in good to high yields. The reaction was performed at 120 °C and the loading amount of catalyst can be as low as 0.001 mol %. After extraction, the residual aqueous phase can be reused several times with only a slight decrease in activity.